Characterizing dissolved organic matter and evaluating associated nanofiltration membrane fouling

Natural organic matter (NOM) characteristics were determined for three ground waters exhibiting different water quality conditions. The water quality of the three feed waters collected at various water table depths was characterized by XAD-8/-4 resin adsorption, high performance size exclusion chromatography with ultraviolet and dissolved organic carbon (DOC) detections, and Fourier transform infrared spectroscopy (FTIR) to determine NOM fractionation, molecular weight, and NOM functional groups, respectively. Systematic studies were conducted to identify potential NOM foulants in ground water for nanofiltration (NF) membrane fouling. The results show that the hydrophobic fraction of NOM in all of the samples was significantly high (71-93%) compared to the hydrophilic (1.7-22.6%) and transphilic (5.3-6.6%) fractions. However, insignificant flux-decline (less than 5%) was observed for the highest DOC (36.9 mg l(-1)) and hydrophobic NOM (93%) containing groundwater compared to the other lesser DOC and hydrophobic NOM containing ground waters. This is presumably due to either higher fractions of hydrophilic and transphilic NOM or inorganic interactions that may be major foulants. Based on FTIR, aromatic foulants were observed at 1662 cm(-1) (CO-NH2 or CO conjugated with aromatic rings) for the fouled NF membrane with the relatively low DOC source waters. The contact angle of the clean membrane (52 degrees ) decreased with fouling up to 42-47 degrees for fouled membranes with the various samples.     

Practices in dioxin emission reduction by special regulatory enforcement and utilizing advanced control technologies for incinerators in Korea

This study strives to estimate the emission of dioxin and furthermore attempts to find the best technological control methods available for waste incinerators by investigating the emission status thereof. In order to incorporate the Stockholm Convention, a particular stringent law was promulgated in Korea and in recent years incinerators were forced to utilize better technological control. After the enforcement of special dioxin emission regulation in 2003, the average concentration of dioxin emitted from municipal and industrial waste incinerators decreased from 15.25 and 12.86 ng TEQ Nm(-3) to 5.53 and 4.96 ng TEQ Nm(-3) in 2001 and 2004, respectively. Based on test results at commercial plants, several best arranged sets of air pollution control devices (APCDs) were suggested in order to provide guidelines to help operators. These sets included combinations of spray dry absorbers, bag type filters, wet scrubbers, selective catalytic reductions and electrostatic precipitators. Different suggestions and real installations of APCD arrangement were investigated during the years around the regulation in effective. The results were presented depending on the capacity of the incinerators and different waste streams to observe the efforts to reduce dioxin emission by operators of incineration plants. The annual amount of dioxin emission from the incinerators is expected to be 212.5 g-TEQ in 2011 and 234.3g-TEQ in 2015, respectively, compared to 891.6g-TEQ recorded in 2001. The enforcement of new regulation and the installation of better APCDs showed the significant effect on such reduction. This reduction in dioxin emission from incinerators confirmed the nation's commitment to the regulatory requirement set by the Stockholm Convention.     

Studies on electrochemical recovery of silver from simulated waste water from Ag(II)/Ag(I) based mediated electrochemical oxidation process

In the Ag(II)/Ag(I) based mediated electrochemical oxidation (MEO) process, the spent waste from the electrochemical cell, which is integrated with the scrubber columns, contains high concentrations of precious silver as dissolved ions in both the anolyte and the catholyte. This work presents an electrochemical developmental study for the recovery of silver from simulated waste water from Ag(II)/Ag(I) based MEO process. Galvanostatic method of silver deposition on Ti cathode in an undivided cell was used, and the silver recovery rate kinetics of silver deposition was followed. Various experimental parameters, which have a direct bearing on the metal recovery efficiency, were optimized. These included studies with the nitric acid concentration (0.75-6M), the solution stirring rate (0-1400 rpm), the inter-electrode distance between the anode and the cathode (2-8 cm), the applied current density (29.4-88.2 mA cm(-2)), and the initial Ag(I) ion concentration (0.01-0.2M). The silver recovered by the present electrodeposition method was re-dissolved in 6M nitric acid and subjected to electrooxidation of Ag(I) to Ag(II) to ascertain its activity towards Ag(II) electrogeneration from Ag(I), which is a key factor for the efficient working of MEO process. Our studies showed that the silver metal recovered by the present electrochemical deposition method could be reused repeatedly for MEO process with no loss in its electrochemical activity. Some work on silver deposition from sulfuric acid solution of different concentrations was also done because of its promising features as the catholyte in the Ag(II) generating electrochemical cell used in MEO process, which include: (i) complete elimination of poisonous NO(x) gas liberation in the cathode compartment, (ii) reduced Ag(+) ion migration across Nafion membrane from anolyte to catholyte thereby diminished catholyte contamination, and (iii) lower cell voltage and hence lesser power consumption.     

Impact of nonaqueous phase liquid (NAPL) source zone architecture on mass removal mechanisms in strongly layered heterogeneous porous media during soil vapor extraction

An existing multiphase flow simulator was modified in order to determine the effects of four mechanisms on NAPL mass removal in a strongly layered heterogeneous vadose zone during soil vapor extraction (SVE): a) NAPL flow, b) diffusion and dispersion from low permeability zones, c) slow desorption from sediment grains, and d) rate-limited dissolution of trapped NAPL. The impacts of water and NAPL saturation distribution, NAPL-type (i.e., free, residual, or trapped) distribution, and spatial heterogeneity of the permeability field on these mechanisms were evaluated. Two different initial source zone architectures (one with and one without trapped NAPL) were considered and these architectures were used to evaluate seven different SVE scenarios. For all runs, slow diffusion from low permeability zones that gas flow bypassed was a dominant factor for diminished SVE effectiveness at later times. This effect was more significant at high water saturation due to the decrease of gas-phase relative permeability. Transverse dispersion contributed to fast NAPL mass removal from the low permeability layer in both source zone architectures, but longitudinal dispersion did not affect overall mass removal time. Both slow desorption from sediment grains and rate-limited mass transfer from trapped NAPL only marginally affected removal times. However, mass transfer from trapped NAPL did affect mass removal at later time, as well as the NAPL distribution. NAPL flow from low to high permeability zones contributed to faster mass removal from the low permeability layer, and this effect increased when water infiltration was eliminated. These simulations indicate that if trapped NAPL exists in heterogeneous porous media, mass transfer can be improved by delivering gas directly to zones with trapped NAPL and by lowering the water content, which increases the gas relative permeability and changes trapped NAPL to free NAPL.     

Toxicity of carbaryl, diquat dibromide, and fluoranthene, individually and in mixture, to larval grass shrimp, Palaemonetes pugio

This study examined the toxicity of two pesticides (carbaryl and diquat dibromide) and one polycyclic aromatic hydrocarbon (fluoranthene), both singly and in mixture, to grass shrimp larvae (Palaemonetes pugio). These three chemicals are all present in coastal environments and can easily enter estuarine ecosystems. Fluoranthene was the most toxic chemical with a 96-h LC50 value of 32.45 microg/L, followed by carbaryl (43.02 microg/L) and diquat dibromide (1624 microg/L). In the chemical mixture tests, the binary carbaryl/diquat dibromide mixture and the ternary carbaryl/diquat dibromide/fluoranthene mixture had additive results.     

Determination of the applicable exhaust airflow rate through a ventilation shaft in the case of road tunnel fires

In this study, a model experiment in a long road tunnel employing the longitudinal ventilation system with a ventilation shaft is carried out during a fire accident to determine the optimum exhaust airflow rate through the ventilation shaft. The appropriate operation of the shaft fan according to the position of fire is investigated, and the optimum exhaust airflow rate for prevention of smoke spreading through the tunnel is determined based on the entire exhaust of both smoke and airflow generated by fire and jet fan operation, respectively. As a result of using the amount of smoke, the critical air velocity produced by jet fans, the effective cross-sectional area of a tunnel and the correction factor, a formula for exhaust airflow rate is drived. In addition, a correction factor (α = 1.1) for the thermal expansion caused by heat of a 20 MW fire is determined theoretically and experimentally. It is expected that this study will contribute to plan the shaft operation for the emergency ventilation as well as provide the preliminary data to design the airflow rate of shaft.     

Medical waste management in Korea

The management of medical waste is of great importance due to its potential environmental hazards and public health risks. In the past medical waste was often mixed with municipal solid waste and disposed of in residential waste landfills or improper treatment facilities (e.g. inadequately controlled incinerators) in Korea. In recent years, many efforts have been made by environmental regulatory agencies and waste generators to better manage the waste from healthcare facilities. This paper presents an overview of the current management practices of medical waste in Korea. Information regarding generation, composition, segregation, transportation, and disposal of medical wastes is provided and discussed. Medical waste incineration is identified as the most preferred disposal method and will be the only available treatment option in late 2005. Faced with increased regulations over toxic air emissions (e.g. dioxins and furans), all existing small incineration facilities that do not have air pollution control devices will cease operation in the next few years. Large-scale medical waste incinerators would be responsible for the treatment of medical waste generated by most healthcare facilities in Korea. It is important to point out that there is a great potential to emit air toxic pollutants from such incinerators if improperly operated and managed, because medical waste typically contains a variety of plastic materials such as polyvinyl chloride (PVC). Waste minimization and recycling, control of toxic air emissions at medical waste incinerators, and alternative treatment methods to incineration are regarded to be the major challenges in the future.     

Construction of a test embankment using a sand-tire shred mixture as fill material

Use of tire shreds in construction projects, such as highway embankments, is becoming an accepted way of beneficially recycling scrap tires. However, in the last decade there was a decline in the use of pure tire shreds as fill materials in embankment construction, as they are susceptible to fire hazards due to the development of exothermic reactions. Tire shred-sand mixtures, on the other hand, were found to be effective in inhibiting exothermic reactions. When compared with pure tire shreds, tire shred-sand mixtures are less compressible and have higher shear strength. However, the literature contains limited information on the use of tire shred-soil mixtures as a fill material. The objectives of this paper are to discuss and evaluate the feasibility of using tire shred-sand mixtures as a fill material in embankment construction. A test embankment constructed using a 50/50 mixture, by volume, of tire shreds and sand was instrumented and monitored to: (a) determine total and differential settlements; (b) evaluate the environmental impact of the embankment construction on the groundwater quality due to leaching of fill material; and (c) study the temperature variation inside the embankment. The findings in this research indicate that mixtures of tire shreds and sand are viable materials for embankment construction.     

COMPARATIVE STUDY OF DROUGHT PREDICTION TECHNIQUES FOR RESERVOIR OPERATION1

ABSTRACT: Predicting the likelihood of a drought markedly enhances the efficiency of reservoir operations. This study applies the kriging method and time series analysis to predict inflows to Shihmen Reservoir in northern Taiwan. A subsequent reservoir operation simulation is employed to determine the drought lead time (DLT), the time before the onset of a drought. A more efficient reservoir operational strategy can be established with the aid of DLT and the probability of successful drought prediction (P s). Simulation results of reservoir operation over a period of three decades demonstrate that, at one month DLT, the kriging approach achieves 0.86 of P s for moderate droughts and 0.94 of P s for severe droughts. The kriging approach generally outperformed the time series approach in terms of DLT, P s of drought prediction, and the number of correctly predicted drought events.