Mineralization of phenol by Ce(IV)-mediated electrochemical oxidation in methanesulphonic acid medium: a preliminary study

The mediated electrochemical oxidation (MEO) process using cerium(IV) in methanesulphonic acid (MSA) as the oxidizing medium was employed for the mineralization of phenol in batch and continuous feeding modes. Although nitric acid was an extensively studied electrolyte for organic mineralization reactions in MEO processes it does possess the problem of NO(x) gas production during the reduction of nitric acid in the cathode compartment of the electrochemical cell. This problem could be circumvented by proper choice of the electrolyte medium such as MSA. The mediator cerium in MSA solution was first oxidized to higher oxidation state using an electrochemical cell. The produced Ce(IV) oxidant was then used for the destruction of phenol. It was found that phenol could be mineralized to CO2 by Ce(IV) in MSA. The evolved CO2 was continuously measured and used for the calculation of destruction efficiency. The destruction efficiency was observed to be 85% based on CO2 evolution for 1000 ppm phenol solution at 80 degrees C in continuous feed mode.     

Removal of hydrogen sulfide and sulfur dioxide by carbons impregnated with triethylenediamine

Activated carbon (AC) adsorption has long been considered to be a readily available technology for providing protection against exposure to acutely toxic gases. However, ACs without chemical impregnation have proven to be much less efficient than impregnated ACs in terms of gas removal. The impregnated ACs in current use are usually modified with metalloid impregnation agents (ASC-carbons; copper, chromium, or silver) to simultaneously enhance the chemical and physical properties of the ACs in removing specific poisonous gases. These metalloid agents, however, can cause acute poisoning to both humans and the environment, thereby necessitating the search for organic impregnation agents that present a much lower risk. The aim of the study reported here was to assess AC or ASC-carbon impregnated with triethylenediamine (TEDA) in terms of its adsorption capability for simulated hydrogen sulfide (H2S) and sulfur dioxide (SO2) gases. The investigation was undergone in a properly designed laboratory-scale and industrial fume hood evaluation. Using the system reported here, we obtained a significant adsorption: the removal capability for H2S and SO2 was 375 and 229 mg/g-C, respectively. BET measurements, element analysis, scanning electron microscopy, and energy dispersive spectrometry identified the removal mechanism for TEDA-impregnated AC to be both chemical and physical adsorption. Chemical adsorption and oxidation were the primary means by which TEDA-impregnated ASC-carbons removed the simulated gases.     

Spatial Analysis of Volatile Organic Compounds from a Community-Based Air Toxics Monitoring Network in Deer Park,Texas, USA

In the summer of 2003, ambient air concentrations of volatile organic compounds (VOCs) were measured at 12 sites within a 3-km radius in Deer Park, Texas near Houston. The purpose of the study was to assess local spatial influence of traffic and other urban sources and was part of a larger investigation of VOC spatial and temporal heterogeneity influences in selected areas of Houston. Seventy 2-h samples were collected using passive organic vapor monitors. Most measurements of 13 VOC species were greater than the method detection limits. Samplers were located at 10 residential sites, a regulatory air monitoring station, and a site located at the centroid of the census tract in which the regulatory station was located. For residential sites, sampler placement locations (e. g., covered porch vs. house eaves) had no effect on concentration with the exception of methyl tertiary-butyl ether (MTBE). Relatively high correlations (Pearson r > 0.8) were found between toluene, ethylbenzene, and o,m,p-xylenes suggesting petroleum-related influence. Chloroform was not correlated with these species or benzene (Pearson r < 0.35) suggesting a different source influence, possibly from process-related activities. As shown in other spatial studies, wind direction relative to source location had an effect on VOC concentrations.     

A Numerical and Experimental Study of Pollutant Dispersion in a Traffic Tunnel

Three-dimensional turbulent flow and dispersion of gaseous pollutants carbon monoxide (CO) and nitrogen oxides (NOx) in a road tunnel was modeled using the standard k–ε turbulence model and solved numerically using the finite volume method. Vehicle emissions were estimated from the measured traffic flow rates and modeled as banded line sources along the tunnel floor. The effects of fan ventilation and piston effect of moving vehicles on the airflow and pollutant dilution were examined. The numerical results reveal that a peak velocity exists near the tunnel floor due to the piston effect of vehicles. The cross-sectional concentrations of air pollutants are non-uniformly distributed and concentrations rise with downstream distance. The piston effect of vehicles can alone provide 25%–34% dilution of air pollutants in the tunnel, compounded 43%–70% dilution effect according to the ventilation condition.     

Comparing removal of trace organic compounds and assimilable organic carbon (AOC) at advanced and traditional water treatment plants

Stability of drinking water can be indicated by the assimilable organic carbon (AOC). This AOC value represents the regrowth capacity of microorganisms and has large impacts on the quality of drinking water in a distribution system. With respect to the effectiveness of traditional and advanced processing methods in removing trace organic compounds (including TOC, DOC, UV₂₅₄, and AOC) from water, experimental results indicate that the removal rate of AOC at the Cheng Ching Lake water treatment plant (which utilizes advanced water treatment processes, and is hereinafter referred to as CCLWTP) is 54%, while the removal rate of AOC at the Gong Yuan water treatment plant (which uses traditional water treatment processes, and is hereinafter referred to as GYWTP) is 36%. In advanced water treatment units, new coagulation–sedimentation processes, rapid filters, and biological activated carbon filters can effectively remove AOC, total organic carbon (TOC), and dissolved organic carbon (DOC). In traditional water treatment units, coagulation–sedimentation processes are most effective in removing AOC. Simulation results and calculations made using the AutoNet method indicate that TOC, TDS, NH₃-N, and NO₃-N should be regularly monitored in the CCLWTP, and that TOC, temperature, and NH₃-N should be regularly monitored in the GYWTP.     

Lethal and sublethal effects of simvastatin,irgarol, and PBDE-47 on the estuarine fish,Fundulus heteroclitus

This study investigated the effects of simvastatin, a lipid-regulating drug; irgarol, an antifouling biocide; and PBDE-47, a brominated flame retardant, on the estuarine fish, Fundulus heteroclitus. Sublethal effects (changes in glutathione (GSH), lipid peroxidation (LPx), acetylcholinesterase (AChE), and cholesterol (CHL) levels) and lethal effects (survival) were determined after individual exposure to the three compounds. There were no significant differences in GSH or CHL levels in fish exposed to any of the test compounds. LPx levels significantly decreased with increasing irgarol concentrations. AChE levels were significantly lower in fish exposed to simvastatin at the 1.25 mg/L concentration and significantly higher at the PBDE-47 concentration of 0.0125 mg/L. The LC50 values were 2.68, 3.22, and > 0.1 mg/L for simvastatin, irgarol and PBDE-47, respectively.     

Bacteria additives to the changes in gaseous mass transfer from stored swine manure

Abstract

A bacteria additives treatment experiment in assessing the changes in gaseous mass transfer from stored swine manure is presented. The experiment is tested for ammonia, methane, hydrogen sulfide, and carbon dioxide emission data sampled from pilot swine manure columns and analyzed by GC/MS. The result shows that bacteria additives slightly reduce the methane and carbon dioxide releases, while the same additives do not show any effect on the reduction of ammonia. The hydrogen sulfide contents of stored swine manure continued to be low. Gas concentrations emitted from treated and untreated stored swine manure were: 3.76 and 2.2 ppm for methane, 0.35 and 0.11 ppm for ammonia, and 1000 and 470 ppm for carbon dioxide, respectively. A simple model to estimate gas emission rates is also developed from the viewpoint of two‐film resistance theory. The average emission rates calculated from the model for methane, ammonia, and carbon dioxide are respectively: 0.01, 0.0005, and 13.98 g/min from untreated stored manure; while 0.07, 0.096, and 0.55 g/min from treated manure. The emission model also indicates that for most gaseous pollutants of environmental concern, liquid phase transfer coefficient controls the rate of volatile compounds emitted from stored swine manure and gas phase transfer coefficient has insignificant effect in the calculation of overall mass transfer coefficient.     

A Model to Predict the System Performance of an Electrostatic Precipitator for Collecting Polydisperse Particles

Abstract

This paper presents a model for predicting the performance of an electrostatic precipitator (ESP) for collecting polydisperse particles. The particle charge was obtained by modifying Cochet’s charge equation; the particle size distribution was approximated by a lognormal function; and then the statistic method of moments was employed to obtain a set of the first three moment equations. The continuous evolution of the particle size distribution in an ESP is easily taken into account by the first three moment equations. The performance of this model was validated by comparing its predictions with the existing data available in the literature. Effects of the particle size distribution on the ESP performance were examined, and the results indicated that both overall mass and number efficiencies are lower for inlet particles with a larger mass median diameter and a higher geometric standard deviation. The methodology introduced may be applied to develop design criteria and determine optimal operating conditions of an ESP for improving the collection efficiency of the submicron particles.     

Modeling effects of moisture content and advection on odor causing vocs volatilization from stored swine manure

Abstract

Two models for evaluating the contents and advection of manure moisture on odor causing volatile organic compounds (VOC‐odor) volatilization from stored swine manure were studied for their ability to predict the volatilization rate (indoor air concentration) and cumulative exposure dose: a MJ‐I model and a MJ‐II model. Both models simulating depletion of source contaminant via volatilization and degradation based on an analytical model adapted from the behavior assessment model of Jury et al. In the MJ‐I model, manure moisture movement was negligible, whereas in the MJ‐II model, time‐dependent indoor air concentrations was a function of constant manure moisture contents and steady‐state moisture advection. Predicted indoor air concentrations and inhaled doses for the study VOC‐odors of p‐cresol, toluene, and p‐xylene varied by up to two to three orders of magnitude depending on the manure moisture conditions. The sensitivity analysis of both models suggests that when manure moisture movement exists, simply MJ‐I model is inherently not sufficient to represent a more generally volatilization process, which can even become stringent as moisture content increases. The conclusion illustrates how one needs to include a wide variety of manure moisture values in order to fully assess the complex volatilization mechanisms that are present in a real situation.     

Factors controlling groundwater quality in the Yeonjegu District of Busan City,Korea, using the hydrogeochemical processes and fuzzy GIS

The hydrogeochemical processes and fuzzy GIS techniques were used to evaluate the groundwater quality in the Yeonjegu district of Busan Metropolitan City, Korea. The highest concentrations of major ions were mainly related to the local geology. The seawater intrusion into the river water and municipal contaminants were secondary contamination sources of groundwater in the study area. Factor analysis represented the contamination sources of the mineral dissolution of the host rocks and domestic influences. The Gibbs plot exhibited that the major ions were derived from the rock weathering condition. Piper’s trilinear diagram showed that the groundwater quality was classified into five types of CaHCO₃, NaHCO₃, NaCl, CaCl₂, and CaSO₄ types in that order. The ionic relationship and the saturation mineral index of the ions indicated that the evaporation, dissolution, and precipitation processes controlled the groundwater chemistry. The fuzzy GIS map showed that highly contaminated groundwater occurred in the northeastern and the central parts and that the groundwater of medium quality appeared in most parts of the study area. It suggested that the groundwater quality of the study area was influenced by local geology, seawater intrusion, and municipal contaminants. This research clearly demonstrated that the geochemical analyses and fuzzy GIS method were very useful to identify the contaminant sources and the location of good groundwater quality.