Surface ozone comparison conducted in two rural areas in central-southern Spain

Purpose  

The purpose of this work is to contribute to the understanding of the photochemical air pollution analysing the levels and temporal variations of surface ozone in two rural areas situated in central-southern Spain.     

Suitability of Scirpus maritimus for petroleum hydrocarbons remediation in a refinery environment

Purpose  

In the ambit of a project searching for appropriate biological approaches for recovering a refinery soil contaminated with petroleum hydrocarbons (PHC), we compared results obtained in the absence and in the presence of the salt marsh plant Scirpus maritimus or Juncus maritimus or an association of these two plants, which were tested in the refinery environment. Synergistic effects caused by addition of a non-ionic surfactant and/or a bioaugmentation product were also investigated. Major challenges of this study were: field conditions and weathered contamination.     

Characterization of On-Road Vehicle NO Emissions by a TILDAS Remote Sensor

ABSTRACT

A tunable infrared laser differential absorption spectrometer (TILDAS) was used to remotely sense the nitric oxide (NO) emissions from 1,473 on-road vehicles. The real-world measurement precision of this instrument in the limit of low NO concentration is 5 ppm of the vehicle exhaust, which corresponds to a 3o detection limit of 15 ppm. Our analysis of the distribution of negative concentration measurements produced during this experiment supports this claim, showing that the instrumental noise for this set of measurements was at most 8 ppm in the limit of low NO concentration. The high sensitivity of this instrument allowed us to measure the NO emissions of even the cleanest vehicles. The measured vehicle fleet NO emissions closely fit a gamma distribution with 10% of the fleet contributing about 50% of the total fleet emissions. Newer vehicles had lower NO emissions than older ones, but high NO emitters were found in every vehicle age cohort. On a vehicle-by-vehicle basis, NO emissions correlated very weakly with vehicle velocity, acceleration, power per unit mass, carbon monoxide (CO) emissions, and hydrocarbon (HC) emissions. High NO emitting vehicles could not be identified by remote sensing of CO or HC emissions and vice versa. When we compared the NO emissions for 117 vehicles measured more than one time, about half of the high NO emitters were found to be very consistent, while the other half varied significantly.     

Determination of Motor Vehicle Profiles for Non-Methane Organic Compounds in the Mexico City Metropolitan Area

ABSTRACT

Non-methane organic compound (NMOC) profiles for on-road motor vehicle emissions were measured in a downtown tunnel and parking garages in Mexico City during 1996. Hydrocarbon samples from the tunnel and ambient air samples (C2-C12) were collected using stainless steel canisters, and carbonyl compounds were collected using 2,4-dinitrophenylhydrazine (DNPH) impregnated cartridges. Canister samples were analyzed by gas chromatog-raphy/flame ionization detection (GC/FID) to ascertain detailed hydrocarbon composition. DNPH samples were analyzed by high performance liquid chromatography (HPLC). NMOC source profiles were quantified for evaporative emissions from refueling, cold start, and hot soak, and on-road operating conditions. The ultimate purpose will be to determine the apportionment of ambient NMOC concentrations using the Chemical Mass Balance (CMB) model. The tunnel profile contained 42.3 ppbC% of alkanes, 20.6 ppbC% of unsaturated compounds, and 22.4 ppbC% of aromatics. The most abundant species were acetylene with 7.22 ppbC%, followed by ipentane with 5.69 ppbC%, and toluene with 5.42 ppbC%. These results were compared with those from studies in the United States. The cold start profile was found to be similar to the tunnel profile, although there were differences in the content of acetylene, isopentane, and oxygenates. The abundance of saturated NMOC in the hot soak profile was similar to gasoline head space profiles; it was also much larger than saturated NMOC in the roadway profile.     

Short-term impact of olive mill wastewater (OMWW) applications on the physico-chemical and microbiological soil properties of an olive grove in Argentina

The purpose of this work was to investigate the effects of spreading olive oil mill wastewater (OMWW) on soil biochemical parameters and olive production in an organically managed olive orchard. The experiment was carried out with three different doses of OMWW (80, 160 and 500 m³ ha^?1) and a control (untreated soil). Three samplings were done at 10, 30 and 90 days after the administration of the byproduct. OMWW application differentially modified the biochemical properties of the soil analyzed. Organic matter, organic carbon, total nitrogen and extractable phosphorus soil contents increased proportionally with each increasing dose. The values of these parameters decreased gradually with time. Total microbial activity was altered and the OMWW 500 m³ ha^?1 treatment proved to be the most active when compared with the other applied doses. OMWW agricultural application also modified the structure of soil microbial communities, particularly affecting Gram positive and negative bacteria, while fungal biomass did not show consistent changes. Although there was a salinity increase in the treated soil, especially at the highest dose, the productive parameters analyzed (fruit and oil tree^?1) were not affected. In light of the obtained results, we consider that low dose of OMWW could be considered an alternative farming practice for semiarid regions.     

Behaviour and variability of local and regional oxidant levels (OX = O3 + NO2) measured in a polluted area in central-southern of Iberian Peninsula

The purpose of this work is to contribute to the understanding of the photochemical air pollution in central-southern of the Iberian Peninsula, analysing the behaviour and variability of oxidant levels (OX?=?O₃?+?NO₂), measured in a polluted area with the highest concentration of heavy industry in central Spain. A detailed air pollution database was observed from two monitoring stations. The data period used was 2008 and 2009, around 210,000 data, selected for its pollution and meteorological statistics, which are very representative of the region. Data were collected every 15 min, however hourly values were used to analyse the seasonal and daily ozone, NO, NO₂ and OX cycles. The variation of OX concentrations with NO _x is investigated, for the first time, in the centre of the Iberian Peninsula. The concentration of OX was calculated using the sum of a NO _x -independent ‘regional’ contribution (i.e. the O₃ background), and a linearly NO _x -dependent ‘local’ contribution. Monthly dependence of regional and local OX concentration was observed to determine when the maximum values may be expected. The variation of OX concentrations with levels of NO _x was also measured, in order to pinpoint the atmospheric sources of OX in the polluted areas. The ratios [NO₂]/[OX] and [NO₂]/[NO _x ] vs. [NO _x ] were analysed to find the fraction of OX in the form of NO₂, and the possible source of the local NO _x -dependent contribution, respectively. The progressive increase of the ratio [NO₂]/[OX] with [NO _x ] observed shows a greater proportion of OX in the form of NO₂ as the level of NO _x increases. The higher measured values in the ratio [NO₂]/[NO _x ] should not be attributed to NO _x emissions by vehicles; they could be explained by industrial emission, termolecular reactions or formaldehyde and HONO directly emitted by vehicles exhausts. We also estimate the rate of NO₂ photolysis, J _NO2?=?0.18–0.64 min^?1, a key atmospheric reaction that influence O₃ production and then the regional air quality. The first surface plot study of annual variation of the daily mean oxidant levels, obtained for this polluted area may be used to improve the atmospheric photochemical dynamic in this region of the Iberian Peninsula where there are undeniable air quality problems.     

Impact of chronic exposure to low doses of chlorpyrifos on the intestinal microbiota in the Simulator of the Human Intestinal Microbial Ecosystem (SHIME®) and in the rat

The impact of the insecticide chlorpyrifos (CPF) on the mammalian digestive system has been poorly described. The present study aimed at evaluating the effect of chronic, low-dose exposure to CPF on the composition of the gut microbiota in a Simulator of the Human Intestinal Microbial Ecosystem: the SHIME® and in rats. The SHIME® comprises six reactor vessels (stomach to colon). The colonic segments were inoculated with feces from healthy humans. Then, the simulator was exposed to a daily dose of 1 mg of CPF for 30 days. The changes over time in the populations of bacteria were examined at different time points: prior to pesticide exposure (as a control) and after exposure. In parallel, pregnant rats were gavaged daily with 1 mg/kg of CPF (or vehicle) until the pups were weaned. Next, the rats were gavaged with same dose of CPF until 60 days of age (adulthood). Then, samples of different parts of the digestive tract were collected under sterile conditions for microbiological assessment. Chronic, low-dose exposure to CPF in the SHIME® and in the rat was found to induce dysbiosis in the microbial community with, in particular, proliferation of subpopulations of some strains and a decrease in the numbers of others bacteria. In compliance with European guidelines, the use of the SHIME® in vitro tool would help to (1) elucidate the final health effect of toxic agents and (2) minimize (though not fully replace) animal testing. Indeed, certain parameters would still have to be studied further in vivo.     

Suitability of oil bioremediation in an Artic soil using surplus heating from an incineration facility

A 168-day period field study, carried out in Sisimiut, Greenland, assessed the potential to enhance soil remediation with the surplus heating from an incineration facility. This approach searches a feasible ex situ remediation process that could be extended throughout the year with low costs. Individual and synergistic effects of biostimulation were also tested, in parallel. An interim evaluation at the end of the first 42 days showed that biostimulation and active heating, as separate treatments, enhanced petroleum hydrocarbon (PHC) removal compared to natural attenuation. The coupling of both technologies was even more effective, corroborating the benefits of both techniques in a remediation strategy. However, between day 42 and day 168, there was an opposite remediation trend with all treatments suggesting a stabilization except for natural attenuation, where PHC values continued to decrease. This enforces the “self-purification” capacity of the system, even at low temperatures. Coupling biostimulation with active heating was the best approach for PHC removal, namely for a short period of time (42 days). The proposed remediation scheme can be considered a reliable option for faster PHC removal with low maintenance and using “waste heating” from an incineration facility.     

Heavy metal accumulation by recombinant mammalian metallothionein within Escherichia coli protects against elevated metal exposure

In an effort to minimize the impact on the environment or improve the properties of choice, most engineered nanoparticles used for commercial applications are surface functionalized. The release of these functionalized engineered nanoparticles (FENPs) into the environment can be either deliberate or accidental. Scientific research to date has tended to focus on evaluating the toxicity of FENPs, with less attention being given to exposure assessments or to the study of their general behavior in natural environments. We have therefore investigated the effects of environmental parameters such as pH, NaCl concentration, and natural organic matter concentration on the aggregation kinetics of FENPs with time resolved dynamic light scattering, using functionalized gold nanoparticles (FAuNPs) as a representative of these particles. We also investigated the effects of average particle size, the type of surface capping agent, and particle concentration on FAuNP aggregation kinetics. Our results show that the physico-chemical properties of the capping agent have a greater influence on the aggregation behavior of FAuNPs than either their core composition or their particle size.     

Controls on coarse wood decay in temperate tree species: birth of the LOGLIFE experiment

Dead wood provides a huge terrestrial carbon stock and a habitat to wide-ranging organisms during its decay. Our brief review highlights that, in order to understand environmental change impacts on these functions, we need to quantify the contributions of different interacting biotic and abiotic drivers to wood decomposition. LOGLIFE is a new long-term 'common-garden' experiment to disentangle the effects of species' wood traits and site-related environmental drivers on wood decomposition dynamics and its associated diversity of microbial and invertebrate communities. This experiment is firmly rooted in pioneering experiments under the directorship of Terry Callaghan at Abisko Research Station, Sweden. LOGLIFE features two contrasting forest sites in the Netherlands, each hosting a similar set of coarse logs and branches of 10 tree species. LOGLIFE welcomes other researchers to test further questions concerning coarse wood decay that will also help to optimise forest management in view of carbon sequestration and biodiversity conservation.