An Assessment of the Economic Effects of Ozone on U.S. Agriculture

Past attempts to measure the economic consequences of ozone on agriculture have been based on limited plant science information. This paper reports on an economic assessment of ozone on U.S. agriculture using recent crop response data from the National Crop Loss Assessment Network (NCLAN). The results are derived from a U.S. agricultural sector model that includes major crop and livestock production as well as domestic consumption, livestock feeding and export uses. The economic effects of four hypothetical ambient ozone levels are investigated. The analysis Indicates that the benefits to society of moderate (25%) ozone reductions are approximately $1.7 billion. A 25% Increase in ozone pollution results in costs (negative benefits) of $2.1 billion. These estimates do not reflect compliance costs of achieving the ozone changes and hence are not net benefits.     

Marine organisms as heavy metal bioindicators in the Persian Gulf and the Gulf of Oman

In the present study, cadmium and lead concentrations were compared in barnacles, ghost shrimps, polychaetes, bivalves, and sediment from ten different locations along the intertidal zone of the Persian Gulf and the Gulf of Oman. The results revealed significant differences in the heavy metal concentrations between the organisms with barnacles showing, by far, the highest metal concentrations. The bioaccumulation factor of Cd in different animals follows this pattern with barnacles?>?bivalves?>?polychaetes?>?ghost shrimps, while the pattern for Pb was barnacles?>?polychaetes?>?bivalves?>?ghost shrimps. In most of the stations, sediments showed the lowest lead and cadmium concentrations. Therefore, it is concluded that barnacles with Pb concentrations between 0.17 and 2,016.1 μg/g and Cd concentrations ranging from 0.4 to 147.1 μg/g are the best organisms to be employed in monitoring programs designed to assess pollution with bioavailable metals in the Persian Gulf and the Gulf of Oman.     

Micropollutants in urban stormwater: occurrence,concentrations, and atmospheric contributions for a wide range of contaminants in three French catchments

This study aimed at: (a) providing information on the occurrence and concentration ranges in urban stormwater for a wide array of pollutants (n?=?77); (b) assessing whether despite the differences between various catchments (land use, climatic conditions, etc.), the trends in terms of contamination level are similar; and (c) analyzing the contribution of total atmospheric fallout (TAF) with respect to sources endogenous to this contamination. The studied contaminants include conventional stormwater contaminants (polycyclic aromatic hydrocarbons (PAHs), Zn, Cu, Pb, etc.), in addition to poorly or undocumented pollutants such as nonylphenol and octylphenol ethoxylates (NPnEO and OPnEO), bisphenol A (BPA), polybrominated diphenyl ethers (PBDEs), a wide variety of pesticides, and various metals of relevance (As, Ti, Sr, V). Sampling and analysis were performed using homogeneous methods on three urban catchments with different land use patterns located in three distinct French towns. For many of these pollutants, the results do not allow highlighting a significant difference in stormwater quality at the scale of the three urban catchments considered. Significant differences were, however, observed for several metals (As, Cr, Cu, Ni, Sr and Zn), PAHs, and PBDEs, though this assessment would need to be confirmed by further experiments. The pollutant distributions between dissolved and particulate phases were found to be similar across the three experimental sites, thus suggesting no site dependence. Lastly, the contributions of TAF to stormwater contamination for micropollutants were quite low. This finding held true not only for PAHs, as previously demonstrated in the literature, but also for a broader range of molecules such as BPA, NPnEO, OPnEO, and PBDEs, whose high local production is correlated with the leaching of urban surfaces, buildings, and vehicles.     

Arctic Tipping Points: Governance in Turbulent Times

Interacting forces of climate change and globalization are transforming the Arctic. Triggered by a non-linear shift in sea ice, this transformation has unleashed mounting interest in opportunities to exploit the region’s natural resources as well as growing concern about environmental, economic, and political issues associated with such efforts. This article addresses the implications of this transformation for governance, identifies limitations of existing arrangements, and explores changes needed to meet new demands. It advocates the development of an Arctic regime complex featuring flexibility across issues and adaptability over time along with an enhanced role for the Arctic Council both in conducting policy-relevant assessments and in promoting synergy in interactions among the elements of the emerging Arctic regime complex. The emphasis throughout is on maximizing the fit between the socioecological features of the Arctic and the character of the governance arrangements needed to steer the Arctic toward a sustainable future.     

Graduate Education for Air Pollution Control Personnel

Tendergreen bean plants were grown from seeding to seed maturity under continuous exposure to HF gas at fairly uniform concentrations averaging 0.58, 2.1, 9.1, and 10.5 µg F/m³. Progeny of these plants and of comparable control plants were grown in a clean atmosphere to determine if subsequent generations were affected by HF treatment of the parents.

No effects of HF were found among the progeny of the plants grown at 0.58 µg F/m³. The F₁ generation progeny of the other HF treated plants were less vigorous than control plant progeny, as shown by later emergence, smaller primary leaves, and slower stem growth. This probably was a consequence of the lower starch content of the seed of the HF treated plants. The primary leaves of some F₁ progeny of the plants grown in the three highest HF treatments were severely stunted and distorted. This also may have been due to the low starch content of the seed, or perhaps it resulted from damage to the plumules in shriveled, distorted seed produced in these treatments.

Some of the early trifoliate leaves of many F₁ generation progeny of the plants grown at 2.1 µg F/m³ and higher were abnormal in the separation and number of their leaflets. This abnormality apparently was heritable, for in the next (F₂) generation it occurred most frequently among plants whose parents were abnormal. However, considerably fewer F₃ generation plants had abnormal trifoliate leaves, indicating rapid reversal to the normal form.     

New Approaches to the Design of Afterburners for Varnish Cookers

The best method of controlling varnish kettle emissions is by thermal incineration. Two new approaches have been developed; these utilize the integral-blower burner and the non-powered raw gas burner. Both of these new approaches offer significant advantages over conventional methods of incineration. Installation, operating, and maintenance costs are substantially reduced when either approach is utilized.

When compared to conventional methods, the new approaches achieve an increase of 100% in mixing velocity or turbulence. This results in a reduction of 20% in fuel consumption. Residence time is reduced by 29% via the non-powered raw gas burner approach. An average reduction of 65% is obtained in the length to diameter ratio. Choice of which approach depends upon several factors, primarily the type of fuel available and the minimum oxygen concentration in the fume stream.     

The Effect of Fuel Composition on Atmospheric Aerosol Due to Auto Exhaust

Aerosols attributable to automobile exhaust can be classified as two types—primary aerosol (initially present in the exhaust) and secondary aerosol (generated photochemically from hydrocarbons and nitrogen oxides in the exhaust). In this study, investigation was made of possible effects of motor-fuel composition on the formation of these aerosols. Secondary aerosol, of principal interest in this work, was produced by irradiating auto exhaust in Battelle-Columbus’ 610 ft³ environmental chamber. A limited number of determinations of primary aerosol in diluted auto exhaust was made at the exit of a 36 ft dilution runnel. Determination of both primary and secondary aerosol was based on light-scattering measurements.

Exhaust was generated with seven full-boiling motor gasolines, both leaded and nonleaded, in a 1967 Chevrolet which was not equipped with exhaust-emission control devices. Changes in fuel composition produced a maximum factor of three difference in light scattering due to primary aerosol. Aerosol yields, for consecutive driving cycles on the same fuel, vary considerably; as a result, ranking the fuels on the basis of average primary aerosol yield was not very meaningful. In addition to fuel composition, the more important independent variables are initial SO₂ concentration, relative humidity and initial hydrocarbon concentration. Statistical analysis of the data indicates that the seven test fuels can be divided into two arbitrary groups with regard to secondary aerosol-forming potential. The fuels in the lower light-scattering group had aromatic contents of 15 and 21%, while those in the higher light-scattering group had aromatic contents of 25, 48, and 55%. Although the fuels can be grouped on the basis of a compositional factor, the grouping of fuels with aromatic content ranging from 25 to 55% indicates that this compositional factor cannot be equated simply with aromatic content. In an associated study of the aerosol-forming potential of individual hydrocarbons prominent in auto exhaust, it was observed that aromatics produce substantially more photochemical aerosol than olefins and paraffins. However, experiments with binar/hydrocarbon mixtures containing aromatjcs, as well as in these exhaust experiments, a strong dependence of aerosol yield on the aromatic components is is not observed. Thus, the data indicate that the dependence of secondary aerosol formation on fuel factors is a complex one and cannot be predicted solely on the basis of a sirigle hydrocarbon component reactivity scale.

The two types of automobile aerosol did not have the same dependence on fuel, composition. The variation in total light scattering attributable to primary plus secondary aerosol was less than that due to either component alone. It therefore was concluded that the light scattering due to automobile exhaust emissions in these experiments was not significantly affected by changing fuel composition.     

Chlortetracycline and tylosin runoff from soils treated with antimicrobial containing manure

This study assessed the runoff potential of tylosin and chlortetracycline (CTC) from soils treated with manure from swine fed rations containing the highest labeled rate of each chemical. Slurry manures from the swine contained either CTC at 108 μ g/g or tylosin at 0.3 μ g/g. These manures were surface applied to clay loam, silty clay loam, and silt loam soils at a rate of 0.22 Mg/ha. In one trial, tylosin was applied directly to the soil surface to examine runoff potential of water and chemical when manure was not present. Water was applied using a sprinkler infiltrometer 24-hr after manure application with runoff collected incrementally every 5 min for about 45 min. A biofilm crust formed on all manure-treated surfaces and infiltration was impeded with > 70% of the applied water collected as runoff. The total amount of CTC collected ranged from 0.9 to 3.5% of the amount applied whereas tylosin ranged from 8.4 to 12%. These data indicate that if surface-applied manure contains antimicrobials, runoff could lead to offsite contamination.     

Duplicate sampling reproducibility of atmospheric residues of herbicides for paired pan and high-volume air samplers

The reproducibility of collection of atmospheric residues of the herbicides 2,4-D and triallate as bulk (wet plus dry) deposition samples by paired pan samplers and as particulate (filter) and vapour (PUF/XAD-2 resin cartridge) samples by paired high-volume air samplers was determined. Variability of herbicide concentrations in paired bulk deposition samples was within 25% for 65 and 80% of the samples for 2,4-D and triallate, respectively, with approximately 90% of the paired samples being within a factor of 2 for both herbicides. The vapour samples of 2,4-D and triallate showed similar reproducibilities. The highest reproducibility was observed for the filter samples with 92% of the paired data sets for 2,4-D being within 25% variability. No triallate was detected in the filter samples.     

An evaluation of flare combustion efficiency using open-path Fourier transform infrared technology

Open-path Fourier transform infrared (OP-FTIR) technology was used to evaluate the combustion efficiency of a flare for comparison to several combustion models. Most flares have been considered an effective method for destroying organic compounds and anything that burns. As the Btu content of the flare gas is reduced, the combustion efficiency may also be reduced. Recent studies have suggested that lower Btu flares may have efficiencies as low as 65%. In addition, models have been developed to predict the effect of wind speed and stack discharge velocity on the combustion efficiency. This study was conducted on a low-Btu flare gas that is primarily CO. While the models would predict efficiencies as low as 30%, the sampling using OP-FTIR showed most combustion efficiencies well above 90%. Three methods were used to track combustion efficiency: monitoring the ratio of CO to CO2, monitoring the ratio of CO to tracer gas, and dispersion modeling. This study was complicated by the presence of two flare stacks, thus two tracer gases were used--SF6 and CF4. A method was developed for distinguishing between the two stacks and quantifying the efficiency in each stack.