Long-term coal gasification-based power with near-zero emissions. Part B: Zecomag and oxy-fuel IGCC cycles

In this second part of the work, two other long-term technologies for power generation from coal are investigated. The Zecomag plant has the same syngas production system of the Zecomix plant, described in the first part of this paper, but hydrogen-rich syngas is here burned with air in an open-cycle gas turbine. The aim is a simplification of the power island, more similar to a combined cycle; however, CO₂ capture falls from 100% to about 90% and NO_x emissions are present.An advanced oxy-fuel IGCC is the second plant investigated in this paper, presenting the same zero-emission potential of Zecomix. Syngas is produced in a high pressure, dry feed, oxygen blown gasifier and cleaned in a hot-gas-clean-up system. Clean syngas is then burned with oxygen and expanded in a turbine, using compressed recirculated CO₂ to moderate firing temperature and to cool turbine blades.The loss of net efficiency, with respect to Zecomix, is very limited (1–2 points) with both configurations. In order to better evaluate the performances obtained, a comparison with reference state-of-the art IGCCs and a long-term IGCC without CO₂ capture is also presented.     

Sisal/Carbon Fibre Reinforced Hybrid Composites: Tensile, Flexural and Chemical Resistance Properties

The variation of mechanical properties such as tensile and flexural properties of randomly oriented unsaturated polyester based sisal/carbon fibre reinforced hybrid composites with different fibre weight ratios have been studied. The chemical resistance test of these hybrid composites to various solvents, acids and alkalies were studied. The effect of NaOH treatment of sisal fibres on the tensile, flexural and chemical resistance properties of these sisal/carbon hybrid composites has also been studied. The hybrid composites showed an increase in tensile and flexural properties with increase in the carbon fibre loading. The tensile properties and flexural properties of these hybrid composites have been found to be higher than that of the matrix. Significant improvement in tensile properties and flexural properties of the sisal/carbon hybrid composites has been observed by alkali treatment. The chemical resistance test results showed that these untreated and alkali treated hybrid composites are résistance to all chemicals except carbon tetra chloride. Hand lay-up technique was used for making the composites and tests are carried out by using ASTM methods.     

South Pole Antarctica observations and modeling results: New insights on HOx radical and sulfur chemistry

Measurements of OH, H₂SO₄, and MSA at South Pole (SP) Antarctica were recorded as a part of the 2003 Antarctic Chemistry Investigation (ANTCI 2003). The time period 22 November, 2003–2 January, 2004 provided a unique opportunity to observe atmospheric chemistry at SP under both natural conditions as well as those uniquely defined by a solar eclipse event. Results under natural solar conditions generally confirmed those reported previously in the year 2000. In both years the major chemical driver leading to large scale fluctuations in OH was shifts in the concentration levels of NO. Like in 2000, however, the 2003 observational data were systematically lower than model predictions. This can be interpreted as indicating that the model mechanism is still missing a significant HO_x sink reaction(s); or, alternatively, that the OH calibration source may have problems. Still a final possibility could involve the integrity of the OH sampling scheme which involved a fixed building site. As expected, during the peak in the solar eclipse both NO and OH showed large decreases in their respective concentrations. Interestingly, the observational OH profile could only be approximated by the model mechanism upon adding an additional HO_x radical source in the form of snow emissions of CH₂O and/or H₂O₂. This would lead one to think that either CH₂O and/or H₂O₂ snow emissions represent a significant HO_x radical source under summertime conditions at SP. Observations of H₂SO₄ and MSA revealed both species to be present at very low concentrations (e.g., 5 × 10⁵ and 1 × 10⁵ molec cm^?3, respectively), but similar to those reported in 2000. The first measurements of SO₂ at SP demonstrated a close coupling with the oxidation product H₂SO₄. The observed low concentrations of MSA appear to be counter to the most recent thinking by glacio-chemists who have suggested that the plateau's lower atmosphere should have elevated levels of MSA. We speculate here that the absence of MSA may reflect efficient atmospheric removal mechanisms for this species involving either dynamical and/or chemical processes.     

Use of CALPUFF for exposure assessment in a near-field,complex terrain setting

CALPUFF is an atmospheric source-receptor model recommended by the U.S. Environmental Protection Agency for use on a case-by-case basis in complex terrain and wind conditions. The ability of the model to provide useful information for exposure assessments in areas with those topographical and meteorological conditions has received little attention. This is an important knowledge gap for use of CALPUFF outside of regulatory applications, such as exposure analyses conducted in support of risk assessments and health studies. We compared deposition of cadmium (Cd), lead (Pb), and zinc (Zn) calculated with CALPUFF as a result of emissions from a zinc smelter with corresponding concentrations of the metals measured in attic dust and soil samples obtained from the surrounding area. On a point-by-point analysis, predictions from CALPUFF explained 11% (lead) to 53% (zinc) of the variability in concentrations measured in attic dust. Levels of heavy metals in soil interpolated to 100 residential addresses from the distribution of concentrations measured in soil samples also agreed well with deposition predicted with CALPUFF: R² of 0.46, 0.76, and 079 for Pb, Cd, and Zn, respectively. Community-average concentrations of Cd, Pb, and Zn measured in soil were significantly (p < 0.0001) and strongly correlated (R² ranged from 0.77 to 0.98) with predicted deposition rates. These findings demonstrate that CALPUFF can provide reasonably accurate predictions of the patterns of long-term air pollutant deposition in the near-field associated with emissions from a discrete source in complex terrain. Because deposition estimates are calculated as a linear function of air concentrations, CALPUFF is expected to be reliable model for prediction of long-term average, near-field ambient air concentrations in complex terrain as well.     

Comparison of land-use regression models between Great Britain and the Netherlands

Land-use regression models have increasingly been applied for air pollution mapping at typically the city level. Though models generally predict spatial variability well, the structure of models differs widely between studies. The observed differences in the models may be due to artefacts of data and methodology or underlying differences in source or dispersion characteristics. If the former, more standardised methods using common data sets could be beneficial. We compared land-use regression models for NO₂ and PM_10, developed with a consistent protocol in Great Britain (GB) and the Netherlands (NL).Models were constructed on the basis of 2001 annual mean concentrations from the national air quality networks. Predictor variables used for modelling related to traffic, population, land use and topography. Four sets of models were developed for each country. First, predictor variables derived from data sets common to both countries were used in a pooled analysis, including an indicator for country and interaction terms between country and the identified predictor variables. Second, the common data sets were used to develop individual baseline models for each country. Third, the country-specific baseline models were applied after calibration in the other country to explore transferability. The fourth model was developed using the best possible predictor variables for each country.A common model for GB and NL explained NO₂ concentrations well (adjusted R² 0.64), with no significant differences in intercept and slopes between the two countries. The country-specific model developed on common variables for NL but not GB improved the prediction.The performance of models based upon common data was only slightly worse than models optimised with local data. Models transferred to the other country performed substantially worse than the country-specific models. In conclusion, care is needed both in transferring models across different study areas, and in developing large inter-regional LUR models.     

Characterisation of particulate exposure during fireworks displays

Little is known about the level and content of exposure to fine particles (PM_2.5) among persons who attend fireworks displays and those who live nearby. An evaluation of the levels of PM_2.5 and their elemental content was carried out during the nine launches of the 2007 Montréal International Fireworks Competition. For each event, a prediction of the location of the firework plume was obtained from the Canadian Meteorological Centre (CMC) of the Meteorological Service of Canada. PM_2.5 was measured continuously with a photometer (Sidepak?, TSI) within the predicted plume location (“predicted sites”), and integrated samples were collected using portable personal samplers. An additional sampler was located on a nearby roof (“fixed site”). The elemental composition of the collected PM_2.5 samples from the “predicted sites” was determined using both a non-destructive energy dispersive ED-XRF method and an ICP-MS method with a near-total microwave-assisted acid digestion. The elemental composition of the “fixed site” samples was determined by the ICP-MS with the near-total digestion method. The highest PM_2.5 levels reached nearly 10 000 μg m^?3, roughly 1000 times background levels. Elements such as K, Cl, Al, Mg and Ti were markedly higher in plume-exposed filters. This study shows that 1) persons in the plume and in close proximity to the launch site may be exposed to extremely high levels of PM_2.5 for the duration of the display and, 2) that the plume contains specific elements for which little is known of their acute cardio-respiratory toxicity.     

On-road traffic emissions in a megacity

A new annual bottom–up emission inventory of criteria pollutants and greenhouse gases from on-road mobile sources was developed for 2006 for the metropolitan area of Buenos Aires, Argentina, within a four-year regional project aimed at providing tools for chemical weather forecast in South America. Under the scarcity of local emission factors, we collected data from measuring campaigns performed in Argentina, Brazil, Chile and Colombia and compiled a data set of regional emission factors representative of Latin American fleets and driving conditions. The estimated emissions were validated with respect to downscaled national estimates and the EDGAR global emission database. Our results highlight the role of older technologies accounting in average for almost 80% of the emissions of all species. The area exhibits higher specific emissions than developed countries, with figures two times higher for criteria pollutants. We analyzed the effect on emissions of replacing gasoline by compressed natural gas, occurring in Argentina since 1995. We identified (i) a relationship between number of vehicles and a compound socioeconomic indicator, and (ii) time-lags in vehicle technologies between developed and developing countries, which can be respectively applied for spatial disaggregation and the development of projections for other Latin American cities. The results may also be employed to complement global emission inventories and by local policy makers as an environmental management tool.     

Air pollutants and health outcomes: Assessment of confounding by influenza

We assessed confounding of associations between short-term effects of air pollution and health outcomes by influenza using Hong Kong mortality and hospitalization data for 1996–2002.Three measures of influenza were defined: (i) intensity: weekly proportion of positive influenza viruses, (ii) epidemic: weekly number of positive influenza viruses ≥4% of the annual number for ≥2 consecutive weeks, and (iii) predominance: an epidemic period with co-circulation of respiratory syncytial virus <2% of the annual positive isolates for ≥2 consecutive weeks. We examined effects of influenza on associations between nitrogen dioxide (NO₂), sulfur dioxide (SO₂), particulate matter with aerodynamic diameter ≤10 μm (PM₁₀) and ozone (O₃) and health outcomes including all natural causes mortality, cardiorespiratory mortality and hospitalization. Generalized additive Poisson regression model with natural cubic splines was fitted to control for time-varying covariates to estimate air pollution health effects. Confounding with influenza was assessed using an absolute difference of >0.1% between unadjusted and adjusted excess risks (ER%).Without adjustment, pollutants were associated with positive ER% for all health outcomes except asthma and stroke hospitalization with SO₂ and stroke hospitalization with O₃. Following adjustment, changes in ER% for all pollutants were <0.1% for all natural causes mortality, but >0.1% for mortality from stroke with NO₂ and SO₂, cardiac or heart disease with NO₂, PM₁₀ and O₃, lower respiratory infections with NO₂ and O₃ and mortality from chronic obstructive pulmonary disease with all pollutants. Changes >0.1% were seen for acute respiratory disease hospitalization with NO₂, SO₂ and O₃ and acute lower respiratory infections hospitalization with PM₁₀. Generally, influenza does not confound the observed associations of air pollutants with all natural causes mortality and cardiovascular hospitalization, but for some pollutants and subgroups of cardiorespiratory mortality and respiratory hospitalization there was evidence to suggest confounding by influenza.     

Spatial variability of carbonaceous aerosols and associated source tracers in two cites in the Midwestern United States

Semi-continuous and 24-h averaged measurements of fine carbonaceous aerosols were made concurrently at three sites within each of two U.S. Midwestern Cities; Detroit, Michigan and Cleveland, Ohio; during two, one-month intensive campaigns conducted in July of 2007 and January & February of 2008. A comparison of 24-h measurements revealed substantial intra-urban variability in carbonaceous aerosols consistent with the influence of local sources, and excesses in both PM_2.5 organic carbon (OC) and elemental carbon (EC) were identified at individual sites within each city. High time-resolved black carbon (BC) measurements indicated that elemental carbon concentrations were higher at sites adjacent to freeways and busy surface streets, and temporal patterns suggested that excess EC at sites adjacent to freeways was dominated by mobile source emissions while excesses in EC away from traffic corridors was dominated by point/area source emissions. The site-to-site variability in OC concentrations was approximately 7% within the neighborhood scale (0.5–4 km) and between 4 and 27% at the urban scale (4–100 km). In contrast, measurements of organic source tracers, in conjunction with a Chemical Mass Balance (CMB) source-apportionment model, indicated that the spatial variation in the contribution of both mobile and stationary sources to PM_2.5 OC often exceeded the variation in OC mass concentration by a factor of 3 or more. Markers for mobile sources, biomass smoke, natural gas, and coal combustion differed by as much as 60% within the neighborhood scale and by greater than 200% within the urban scale. The observations made during this study suggest that the urban excess of carbonaceous aerosols is much more complex than has been previously reported and that a more rigorous, source-oriented approach should be taken in order to assess the risk associated with exposure to carbonaceous aerosols within the industrialized environments of the Midwestern United States.     

Using a reduced Common Representative Intermediates (CRIv2-R5) mechanism to simulate tropospheric ozone in a 3-D Lagrangian chemistry transport model

A reduced chemical scheme (CRIv2-R5) which describes ozone formation from the tropospheric degradation of methane and 22 emitted non-methane hydrocarbons and oxygenated volatile organic compounds has been applied in a global-3D chemistry transport model (STOCHEM). The scheme, which contains 220 species in 609 reactions, has been used to simulate ozone and its precursors for the meteorological year of 1998 and the results have been compared with those from STOCHEM runs with its original chemistry. Compared with the original chemistry scheme, the degradation of a larger number of more reactive VOCs in the CRI scheme results in the formation (and their consequent transportation) of more NO_x active reservoirs thus leading to formation of more ozone away from land-based sources. Conversely, the more reactive VOCs also lead to greater removal of OH in continental areas and greater formation of OH in marine environments. STOCHEM run with the CRI scheme simulates more ozone (by up to 10 ppb), which results in better agreement with observed vertical ozone profiles. The CRI scheme transforms the globally and annually integrated ozone budget for the considered year in STOCHEM from a net loss of ?55 Tg yr^?1 to a net gain of +50 Tg yr^?1.