Extensive aerosol optical properties and aerosol mass related measurements during TRAMP/TexAQS 2006 – Implications for PM compliance and planning

Extensive aerosol optical properties, particle size distributions, and Aerodyne quadrupole aerosol mass spectrometer measurements collected during TRAMP/TexAQS 2006 were examined in light of collocated meteorological and chemical measurements. Much of the evident variability in the observed aerosol-related air quality is due to changing synoptic meteorological situations that direct emissions from various sources to the TRAMP site near the center of the Houston-Galveston-Brazoria (HGB) metropolitan area. In this study, five distinct long-term periods have been identified. During each of these periods, observed aerosol properties have implications that are of interest to environmental quality management agencies. During three of the periods, long range transport (LRT), both intra-continental and intercontinental, appears to have played an important role in producing the observed aerosol. During late August 2006, southerly winds brought super-micron Saharan dust and sea salt to the HGB area, adding mass to fine particulate matter (PM_2.5) measurements, but apparently not affecting secondary particle growth or gas-phase air pollution. A second type of LRT was associated with northerly winds in early September 2006 and with increased ozone and sub-micron particulate matter in the HGB area. Later in the study, LRT of emissions from wildfires appeared to increase the abundance of absorbing aerosols (and carbon monoxide and other chemical tracers) in the HGB area. However, the greatest impacts on Houston PM_2.5 air quality are caused by periods with low-wind-speed sea breeze circulation or winds that directly transport pollutants from major industrial areas, i.e., the Houston Ship Channel, into the city center.     

Evaluation of methylene blue and riboflavin for the photosensitized degradation of ethylene glycol

Degradation rates ranging from 0.22 ± 0.11 to 1.52 ± 0.50 mg/L-h were measured for ethylene glycol in riboflavin solutions exposed to natural sunlight. Significant degradation rates were noted in systems using 6 and 10 mg/L riboflavin at pH values of 4, 7, and 10. No significant degradation was found in systems using methylene blue as the photosensitizing agent. Possible mechanisms for ethylene glycol degradation include a combination hydrogen or electron abstraction by an excited photosensitizer and reaction with singlet oxygen or reaction with superoxide radicals.     

Echolocation call design and limits on prey size: a case study using the aerial-hawking bat Nyctalus leisleri

The echolocation calls used by Nyctalus leisleri during search phase in open air space are between 9 and 14 ms long, with the peak energy between 24 and 28 kHz. The pulses are shallowly frequency-modulated with or without an initial steep frequency-modulated component. The diet consists primarily of small flies (Diptera), including many chironomids (wingspan 9–12 mm) and yellow dung flies (Scatophaga; wingspan 24 mm), but also of some larger insects such as dung beetles (Coleoptera; Scarabaeoidea), caddis-flies (Trichoptera) and moths (Lepidoptera). The echo target strength of some prey items was measured. Contrary to models based on standard targets such as spheres or disks, the echo strength of real insects was found to be virtually independent of the emitted frequency within the 20–100 kHz frequency range. A model was used to calculate probable detection distances of the prey by the bat. Using narrow-band calls of 13.7 ± 2.7 ms duration, a bat would detect the two smallest size classes of insect at greatest range using calls of 20 kHz. The results may therefore explain why many species of large and medium sized aerial-hawking bats use low-frequency calls and still eat mostly relatively small insects. The data and model challenges the assumption that small prey are unavailable to bats using low-frequency calls.     

Toxicity of organic mixtures saturated in water to Daphnia magna. Effect of compositional changes

The toxicity of aqueous solutions saturated with mixtures of hydrophobic organic liquids is contrasted to that of solutions prepared from solids. Data for a variety of mixtures are presented and are related to the solubilities of the components. It is shown that in the absence of biological interactive effects, the toxicity of a component in a saturated mixture of liquids will be equal to or less than that of a corresponding solution of its most toxic component. In contrast, for solutions derived from a mixture of solids, the toxicity will equal or exceed that of a corresponding saturated solution of its most toxic component, and will tend to increase with the complexity of the mixture.     

An assessment of the bioavailability of persistent organic pollutants from contaminated soil

A procedure to assess the bioavailability of persistent organic pollutants (POPs) from soil samples has been developed. The procedure is based on the use of simulated in vitro gastrointestinal extraction to remove POPs from soil matrices. The level of recovery, using this approach, is assessed following liquid-liquid extraction (LLE) and analysis by gas chromatography-mass selective detection (GC-MSD). The remaining soil residue is then extracted using pressurised fluid extraction (PFE) followed by GC-MSD analysis to assess the residual fraction. The residual fraction is monitored to determine the unavailable fraction i.e. not available for absorption in the gastrointestinal tract of humans. The procedure was applied to four soil samples i.e. an aged, spiked soil and three certified reference materials (CRMs) contaminated with POPs. Recoveries of pesticides (lindane, endosulfan I, endrin, DDE, DDD and endosulfan II), phenols (cresol, TCP and PCP), and base neutral compounds (hexachloroethane, acenaphthene, dibenzofuran, fluorene and hexachlorobenzene) from aged, spiked soil following extraction with gastric fluid ranged from 0.8 to 8.3% while following intestinal extraction ranged from 5.5 to 13.5%, irrespective of POP. Recoveries of pesticides (lindane, endosulfan I, endrin, DDE, DDD and endosulfan II) from CRM 805-050 following extraction with gastric fluid were below the limit of detection while following intestinal extraction ranged from 5.3 to 12.8%. Recoveries of phenols (cresol, TCP and PCP) from CRM 401-225 following extraction with gastric fluid ranged from 1.6 to 2.0% while following intestinal extraction ranged from 4.1 to 5.4%. Recoveries of base neutral acid analytes (hexachloroethane, acenaphthene, dibenzofuran, fluorene and hexachlorobenzene) from CRM 107-100 following extraction with gastric fluid ranged from 1.4 to 4.0% while following intestinal extraction ranged from 6.6 to 12.7%. It has been found that the majority of POPs present i.e. >75%, would be excreted if consumed and not be absorbed in the gastrointestinal tract of humans.     

Adsorption characteristics of benzene on biosolid adsorbent and commercial activated carbons

This study selected biosolids from a petrochemical waste-water treatment plant as the raw material. The sludge was immersed in 0.5-5 M of zinc chloride (ZnCl2) solutions and pyrolyzed at different temperatures and times. Results indicated that the 1-M ZnCl2-immersed biosolids pyrolyzed at 500 degrees C for 30 min could be reused and were optimal biosolid adsorbents for benzene adsorption. Pore volume distribution analysis indicated that the mesopore contributed more than the macropore and micropore in the biosolid adsorbent. The benzene adsorption capacity of the biosolid adsorbent was 65 and 55% of the G206 (granular-activated carbon) and BPL (coal-based activated carbon; Calgon, Carbon Corp.) activated carbons, respectively. Data from the adsorption and desorption cycles indicated that the benzene adsorption capacity of the biosolid adsorbent was insignificantly reduced compared with the first-run capacity of the adsorbent; therefore, the biosolid adsorbent could be reused as a commercial adsorbent, although its production cost is high.