Particulate matter emission rates from beef cattle feedlots in Kansas-reverse dispersion modeling

Open beef cattle feedlots emit various air pollutants, including particulate matter (PM) with equivalent aerodynamic diameter of 10 microm or less (PM10); however limited research has quantified PM10 emission rates from feedlots. This research was conducted to determine emission rates of PM10 from large cattle feedlots in Kansas. Concentrations of PM10 at the downwind and upwind edges of two large cattle feedlots (KS1 and KS2) in Kansas were measured with tapered element oscillating microbalance (TEOM) PM10 monitors from January 2007 to December 2008. Weather conditions at the feedlots were also monitored. From measured PM10 concentrations and weather conditions, PM10 emission rates were determined using reverse modeling with the American Meteorological Society/U.S. Environmental Protection Agency Regulatory Model (AERMOD). The two feedlots differed significantly in median PM10 emission flux (1.60 g/m2-day for KS1 vs. 1.10 g/m2-day for KS2) but not in PM10 emission factor (27 kg/1000 head-day for KS1 and 30 kg/1000 head-day KS2). These emission factors were smaller than published U.S. Environmental Protection Agency (EPA) emission factor for cattle feedlots.     

Investigating phosphorus limitation in a fixed bed filter with phosphorus and nitrogen profile measurements

In 2000, the European Union adopted the European Water Framework Directive (WFD) (European Commission, 2000). The WFD focuses on increasingly stringent nutrient standards including ultra low nitrogen (< 2.2 mg N-total/L) and phosphorus concentrations (< 0.15 mg total phosphorus/L) in receiving surface waters and in relevant point sources like wastewater treatment plant (WWTP) effluent. Expansion of WWTPs with advanced post-treatment processes, like effluent filtration, is widely proposed to meet possible future effluent discharge standards. When combining biological nitrate-nitrogen and chemical phosphorus removal in one filter, phosphorus limitation in the denitrifying process may occur. This study investigated where in the filter bed and under which conditions phosphorus limitation occurs. Profile measurements for nitrate, nitrite, and orthophosphorus (PO4-P) combined with chemical oxygen demand (COD) and 02 were conducted. Results showed that the required PO4-P/NOx-N ratio is approximately 0.006 mg/mg after phosphorous precipitation and flocculation. Profile measurements have proven to be an applicable and useful tool. It showed how nitrate and orthophosphorus are removed through the filter bed based on the PO4-P/NOx-N ratio. When orthophosphorus is removed more rapidly and efficiently compared to nitrate, the PO4-P/NOx-N ratio decreases. When PO4-P/NOx-N ratio thresholds are approximately 0.006 mg/mg for a certain period of time and water temperatures varied significantly, orthophosphorus limitation may occur. Changing the filter-bed configuration or decreasing the coagulant dosage can prevent limitation of the denitrifying process because of a phosphorous shortage.     

Identification of microcystins from three collection strains of Microcystis aeruginosa

Microcystins (MCs) are toxic cyclic heptapeptides produced by various cyanobacteria genera, especially Microcystis. We identified 10 out of 12 MCs produced by three Microcystis aeruginosa strains from cyanobacteria collections, UTEX 2666, UTEX 2670 and UAM 1303, by using two analytical methods: Matrix-assisted Laser Desorption Ionization Time of Flight Mass Spectrometry (MALDI-TOF/MS) and HPLC Photodiode Array Detector coupled to a hybrid Quadrupole Time of Flight Mass Spectrometry (HPLC-PDA-QTOF/MS). MALDI-TOF/MS failed to detect non-polar MCs, such as MC-LY and MC-LW. HPLC-QTOF/MS permitted the accurate identification of most MCs present in methanolic extracts. Besides, three new MCs, namely: [D-Glu(OCH₃)⁶, D-Asp³] MC-LAba, MC-YL and MC-YM were detected by HPLC-QTOF/MS.     

Quantifying trace gas emissions from composite landscapes: A mass-budget approach with aircraft measurements

Quantifying trace gas emissions and the influence of surface exchange processes on the atmosphere is a necessary step towards the control of global greenhouse gas emissions and reliability of air quality models. This paper proposes a procedure based on the mass balance method and implemented on highly resolved aircraft data. It allows one to estimate surface exchanges on areas of several km² and heterogeneous features exploiting the characteristics of convective boundary layer during steady state conditions that permit the estimation of emission/absorption terms as functions of advective fluxes only. A nonparametric approach is adopted and the fluxes on the surface of a virtual box surrounding the area of interest are reconstructed on the basis of scalar densities and wind vectors using Shepard functions. Two different techniques are also proposed to face lack of data on the top surface of the box. The method has been applied to experimental data coming from measurement campaigns on two different sites. It provides realistic estimates of the CO₂ emission/absorption in the considered areas that are in good agreement with CO₂ fluxes evaluated by Airborne Eddy Covariance and confirm the suitability of the proposed approach for the assessment of turbulent exchange of trace gases by composite landscapes. Uncertainties on the estimated emissions due to both propagation of the experimental error and interpolation have been quantified by bootstrap analysis as 6%.     

Sea salt concentrations across the European continent

The oceans are a major source for particles that play an important role in many atmospheric processes. In Europe sea salt may contribute significantly to particulate matter concentrations. We have compiled sodium concentration data as a tracer for sea salt for 89 sites in Europe to provide more insight in the distribution of sea salt across Europe. The annual average sea salt concentrations above land were estimated to range between 0.3 and almost 13 μg m^?3. Maximum concentrations are found at the Irish coast. At coastal sites along the Atlantic and North Sea coast concentrations tend to be around 5 μg m^?3. More inland locations up to about 300 km away from the coast tend to show concentrations between 2 and 5 μg m^?3, whereas sites further away from the coast are characterized by lower concentrations. An analysis of the representativity of the data with respect to a long term average showed that the long average is associated with a standard deviation of around 15%. The compilation of observations provides an improved overview of sea salt concentrations in Europe as well as an improved basis for model validation. Verification of the results of the LOTOS-EUROS model learned that the model represents well the spatial variability of the observed sea salt concentrations very well. However, the absolute concentrations are significantly overestimated due to large uncertainties in the emission and dry deposition parameterizations. Using the high explained variability in the gradients across Europe, the bias-corrected modelled distribution serves as a best estimate of the sea salt distribution across Europe for 2005.     

Urban tracer dispersion experiments during the second DAPPLE field campaign in London 2004

As part of the DAPPLE programme two large scale urban tracer experiments using multiple simultaneous releases of cyclic perfluoroalkanes from fixed location point sources was performed. The receptor concentrations along with relevant meteorological parameters measured are compared with a three screening dispersion models in order to best predict the decay of pollution sources with respect to distance. It is shown here that the simple dispersion models tested here can provide a reasonable upper bound estimate of the maximum concentrations measured with an empirical model derived from field observations and wind tunnel studies providing the best estimate. An indoor receptor was also used to assess indoor concentrations and their pertinence to commonly used evacuation procedures.     

Plant availability of bound anilazine residues in a degraded loess soil

Abstract

The relative biological availability of [benzene ring‐U‐¹⁴C] and Ctriazine‐U‐¹⁴C] anilazine for maize plants was studied in a degraded loess soil in a standardized microecosystem. The total uptake of radiocarbon in the course of the 4‐week experiment was 3.1 and 4 % respectively of the radioactivity applied if anilazine was uniformly mixed into the soil immediately before beginning the experiment. However, if anilazine was subjected to a degradation at 65 % of the maximum water holding capacity of the soil and temperatures varying daily between 16 and 27°C for 100 days before the plant experiment then the uptake was reduced to 0.4 or 0.7 % respectively. The uptake from soil with non‐extractable (bound) anilazine residues was similarly low. The mineralization rate of aged and bound anilazine residues was below 0.1 % of the radioactivity applied. Up to 2/3 of the radioactivity present in the soil after the plant experiment remained in the humic fraction.     

Phytoavailability and extractability of potassium,magnesium and manganese in calcareous soil amended with olive oil wastewater

Abstract

Land disposal of olive oil wastewater using it as a soil amendment requires a knowledge of the effects that its application may produce on the status of the mineral nutrients in the plant‐soil system. A pot experiment using calcareous soil was performed in a growth chamber to examine the effects of olive oil wastewater on the availability and postharvest soil extractability of K, Mg and Mn. The experiment included 6 treatments: two rates of olive oil wastewater, two mineral fertilizer treatments containing K (which supplied K in amounts equivalent to the K supplied by the olive oil wastewater treatments), a K‐free mineral fertilizer treatment, and a control. The pots were sown with ryegrass as the test plant, harvesting 3 times at intervals of one month. Olive oil wastewater has demonstrated a considerable capacity for supplying K that can be assimilated by the plant, tending in fact to surpass the mineral potassium fertilizer tested. The application of olive oil wastewater tends to reduce the concentration of Mg in the plant, similarly to the effect of adding mineral potassium fertilizer. An enhancement of Mn availability takes place in the soil amended with olive oil wastewater, which on occasion has produced Mn concentrations in plant that could be considered phytotoxic or at least excessive. After harvesting, we observed an increase in the amount of exchangeable K in soil with added industrial wastewater. However, these increases are lower than those in soil treated with mineral potassium fertilizer. The levels of exchangeable, carbonate‐bound, organic‐bound and residual Mg in soil were higher in treatments incorporating olive oil wastewater than in those with added mineral K, with the opposite tendency occurring in the amount of Fe‐Mn oxides‐bound Mg in soil. Treatments based on olive oil wastewater, especially in high doses, increased the amount of exchangeable and carbonate‐bound Mn in soil, in comparison with treatments adding mineral fertilizers with or without K. In contrast, the addition of industrial wastewater caused a drop in the amount of Fe‐Mn oxides‐bound and organic‐bound Mn in soil.