Biological nitrogen and carbon removal in a gravity flow biomass concentrator reactor for municipal sewage treatment

A novel membrane system, the Biomass Concentrator Reactor (BCR), was evaluated as an alternative technology for the treatment of municipal wastewater. Because the BCR is equipped with a membrane whose average poresize is 20 μm (18–28 μm), the reactor requires low-pressure differential to operate (gravity). The effectiveness of this system was evaluated for the removal of carbon and nitrogen using two identical BCRs, identified as conventional and hybrid, that were operated in parallel. The conventional reactor was operated under full aerobic conditions (i.e., organic carbon and ammonia oxidation), while the hybrid reactor incorporated an anoxic zone for nitrate reduction as well as an aerobic zone for organic carbon and ammonia oxidation. Both reactors were fed synthetic wastewater at a flow rate of 71 L d^?1, which resulted in a hydraulic retention time of 9 h. In the case of the hybrid reactor, the recycle flow from the aerobic zone to the anoxic zone was twice the feed flow rate. Reactor performance was evaluated under two solids retention times (6 and 15 d). Under these conditions, the BCRs achieved nearly 100% mixed liquor solids separation with a hydraulic head differential of less than 2.5 cm. The COD removal efficiency was over 90%. Essentially complete nitrification was achieved in both systems, and nitrogen removal in the hybrid reactor was close to the expected value (67%).     

PM2.5 source apportionment with organic markers in the Southeastern Aerosol Research and Characterization (SEARCH) study

Positive matrix factorization (PMF) and effective variance (EV) solutions to the chemical mass balance (CMB) were applied to PM_2.5 (particulate matter with an aerodynamic diameter <2.5 μm) mass and chemically speciated measurements for samples taken from 2008 to 2010 at the Atlanta, Georgia, and Birmingham, Alabama, sites. Commonly measured PM_2.5 mass, elemental, ionic, and thermal carbon fraction concentrations were supplemented with detailed nonpolar organic speciation by thermal desorption-gas chromatography/mass spectrometry (TD-GC/MS). Source contribution estimates were calculated for motor vehicle exhaust, biomass burning, cooking, coal-fired power plants, road dust, vegetative detritus, and secondary sulfates and nitrates for Atlanta. Similar sources were found for Birmingham, with the addition of an industrial source and the separation of biomass burning into open burning and residential wood combustion. EV-CMB results based on conventional species were qualitatively similar to those estimated by PMF-CMB. Secondary ammonium sulfate was the largest contributor, accounting for 27–38% of PM_2.5, followed by biomass burning (21–24%) and motor vehicle exhaust (9–24%) at both sites, with 4–6% of PM_2.5 attributed to coal-fired power plants by EV-CMB. Including organic compounds in the EV-CMB reduced the motor vehicle exhaust and biomass burning contributions at both sites, with a 13–23% deficit for PM_2.5 mass. The PMF-CMB solution showed mixing of sources within the derived factors, both with and without the addition of speciated organics, as is often the case with complex source mixtures such as those at these urban-scale sites. The nonpolar TD-GC/MS compounds can be obtained from existing filter samples and are a useful complement to the elements, ions, and carbon fractions. However, they should be supplemented with other methods, such as TD-GC/MS on derivitized samples, to obtain a wider range of polar compounds such as sterols, sugars, and organic acids. The PMF and EV solutions to the CMB equations are complementary to, rather than replacements for, each other, as comparisons of their results reveal uncertainties that are not otherwise evident.

Implications:?Organic markers can be measured on currently acquired PM_2.5 filter samples by thermal methods. These markers can complement element, ion, and carbon fraction measurements from long-term speciation networks. Applying the positive matrix factorization and effective variance solutions for the chemical mass balance equations provides useful information on the accuracy of the source contribution estimates. Nonpolar compounds need to be complemented with polar compounds to better apportion cooking and secondary organic aerosol contributors.     

IAPCS: A Computer Model that Evaluates Pollution Control Systems for Utility Boilers

The IAPCS model, developed by U.S. EPA’s Air and Energy Engineering Research Laboratory and made available to the public through the National Technical Information Service, can be used by utility companies, architectural and engineering companies, and regulatory agencies at all levels of government to evaluate commercially available technologies for control of SO₂, NO_x, and particulate matter emissions from coal-fired utility boilers with respect to performance and cost. The model is considered to be a useful tool to compare alternative control strategies to be used by utilities to comply with the requirements of the CAA, and to evaluate the sensitivity of control costs with respect to many of the significant variables affecting costs.

To illustrate the use of the model for site-specific studies, the authors used the model to estimate control costs for SO₂ and NO_x control at Detroit Edison’s Monroe plant and two hypothetical plants under consideration and at three plants operated by New York State Electric and Gas Corporation. The economic and technical assumptions used to drive the model were those proposed by the utilities if cited, and if not cited, the model default values were used. The economic format and methodologies for costs cited in the Electric Power Research Institute’s Technical Assessment Guide are used in the IAPCS model. Depending on the specific conditions and assumptions for the cases evaluated, SO₂ control costs ranged from $417 to $3,159 per ton of SO₂ removed, and NO_x control costs ranged from $461 to $3,537 per ton of NO_x removed or reduced.     

Biofiltration Control of Hydrogen Sulfide 1. Design and Operational Parameters

Laboratory scale biological filter systems for control of hydrogen sulfide (H₂S) in waste gas have been studied and the optimum design and operating parameters determined. Extensive tests have been conducted to evaluate the effect of various filter bed operating parameters such as temperature, retention time, H₂S concentration, and H₂S loading rate. Variable properties of new and used composts such as sulfate content, acidity, and water content have been studied for their influence on H₂S removal efficiency. The effects of compost particle size distribution on system pressure drop and the maximum H₂S elimination capacity were examined. Biofiltration systems containing various types of yard waste compost as the filter material have been observed to remove hydrogen sulfide with efficiencies greater than 99.9 percent for H₂S inlet concentrations in the range from 5 to 2650 ppmv.     

Experimental exposure of juvenile savannah monitors (Varanus exanthematicus) to an environmentally relevant mixture of three contaminants: effects and accumulation in tissues

Using varanids as indicators of pollution in African continental wetlands was previously proposed. The present study aimed at understanding experimentally how monitors absorb and accumulate pollutants and how they are affected. The relevance of non-destructive sampling was also evaluated. Savannah monitors (Varanus exanthematicus) were orally exposed during 6 months to a mixture of lead, 4,4′-dichlorodiphenyltrichloroethane (4,4′-DDT) and chlorpyrifos-ethyl (CPF) or to the vehicle only. Proportionally to their mass, exposed monitors received the same dose: 20 then 10 mg lead?kg^?1, 2 then 0.5 mg CPF?kg^?1 and 4 mg 4,4′-DDT?kg^?1. Individuals surviving contamination were euthanized after 4 or 6 months of experiment. Tissues were analysed for lead by atomic absorption spectrophotometry and for DDT and CPF by gas chromatography. Exposed monitors absorbed all three pollutants but only lead (essentially in bone, tail tips and phalanxes) and 4,4′-DDT plus its main metabolites (essentially in fat and liver) accumulated. CPF killed ten individuals. Clear correlations occurred between the total quantity of lead or 4,4′-DDT administered and concentrations in tissues. Tail tips and skin samples are recommended non-destructive indicators for lead and organochlorine pesticides contamination, respectively. This work confirms that monitors can be used as relevant indicators of environmental pollution by lead and organochlorine pesticides. Although varanids withstand heavy lead and DDT contamination, our results suggest that CPF can be lethal at very low doses to the herpetofauna and emphasize the importance of considering all taxa in impact assessment studies, including reptiles.     

Stakeholder engagement and knowledge exchange in environmental research

It is commonly put forward that effective uptake of research in policy or practice must be built upon a foundation of active knowledge exchange and stakeholder engagement during the research. However, what is often lacking is a systematic appreciation of the specific practices of knowledge exchange and their relative merits. The paper reports on a 2009 survey of 21 research projects within the UK Research Councils' Rural Economy and Land Use Programme regarding the involvement and perceived impact of over a thousand stakeholders in the research. The survey reveals that most stakeholders were involved as research subjects or as event participants. Large numbers were also engaged in the research process itself, including involvement in shaping the direction of research. Stakeholder engagement is perceived as bringing significant benefits to the process of knowledge production. A close relationship is found between mechanisms and approaches to knowledge exchange and the spread of benefits for researchers and stakeholders. Mutual benefits are gained from exchange of staff or where stakeholders are members of research advisory groups. Different stakeholder sectors are also associated with different patterns of engagement, which lead to contrasting impact patterns. Any efforts to alter knowledge exchange processes and outcomes must overcome these differing engagement tendencies. Overall, much greater attention should be given to early processes of knowledge exchange and stakeholder engagement within the lifetime of research projects.     

Whole-stream response to nitrate loading in three streams draining agricultural landscapes

Physical, chemical, hydrologic, and biologic factors affecting nitrate (NO3(-)) removal were evaluated in three agricultural streams draining orchard/dairy and row crop settings. Using 3-d "snapshots" during biotically active periods, we estimated reach-level NO3(-) sources, NO3(-) mass balance, in-stream processing (nitrification, denitrification, and NO3(-) uptake), and NO3(-) retention potential associated with surface water transport and ground water discharge. Ground water contributed 5 to 11% to stream discharge along the study reaches and 8 to 42% of gross NO3(-) input. Streambed processes potentially reduced 45 to 75% of ground water NO3(-) before discharge to surface water. In all streams, transient storage was of little importance for surface water NO3(-) retention. Estimated nitrification (1.6-4.4 mg N m(-2) h(-1)) and unamended denitrification rates (2.0-16.3 mg N m(-2) h(-1)) in sediment slurries were high relative to pristine streams. Denitrification of NO3(-) was largely independent of nitrification because both stream and ground water were sources of NO3(-). Unamended denitrification rates extrapolated to the reach-scale accounted for <5% of NO3(-) exported from the reaches minimally reducing downstream loads. Nitrate retention as a percentage of gross NO3(-) inputs was >30% in an organic-poor, autotrophic stream with the lowest denitrification potentials and highest benthic chlorophyll a, photosynthesis/respiration ratio, pH, dissolved oxygen, and diurnal NO3(-) variation. Biotic processing potentially removed 75% of ground water NO3(-) at this site, suggesting an important role for photosynthetic assimilation of ground water NO3(-) relative to subsurface denitrification as water passed directly through benthic diatom beds.     

Natural resource abundance in Nigeria: From dependence to development

There are several strategies open to an economy in its attempt to attain sustainable economic development depending on its historical background and resource endowment. One of such is the resource-led strategy. Nigeria is superabundantly rich in crude oil and has reaped billions of petrodollars. However, the country seems to be facing the problem of successfully translating this huge oil wealth into sustainable development. This paper employs the vector error-correction methodology in examining the long-run impact of the huge oil wealth accruing to Nigeria on its economic development. Indicators such as per capita GDP (PGDP), household consumption, infrastructural development (electricity), and agricultural and manufacturing output growth rates are examined. The results suggest a significant positive long-run impact of per capita oil revenue on per capita household consumption and electricity generation, while a negative relationship is established for GDP, agriculture and manufacturing. Even for those variables with negative relationship at current period, there exist positive relationships at subsequent lags. Thus, oil revenue, if properly managed and invested, could be effectively used to induce oil-led development in Nigeria provided the current inhibitions of corruption, lack of transparency, accountability and fairness in its use and distribution are removed.