Soil contamination of heavy metals in the Katedan Industrial Development Area, Hyderabad, India

Studies on quantitative soil contamination due to heavy metals were carried out in Katedan Industrial Development Area (KIDA), south of Hyderabad, Andhra Pradesh, India under the Indo-Norwegian Institutional Cooperation Programme. The study area falls under a semi-arid type of climate and consists of granites and pegmatite of igneous origin belonging to the Archaean age. There are about 300 industries dealing with dyeing, edible oil production, battery manufacturing, metal plating, chemicals, etc. Most of the industries discharge their untreated effluents either on open land or into ditches. Solid waste from industries is randomly dumped along roads and open grounds. Soil samples were collected throughout the industrial area and from downstream residential areas and were analysed by X-ray Fluorescence Spectrometer for fourteen trace metals and ten major oxides. The analytical data shows very high concentrations of lead, chromium, nickel, zinc, arsenic and cadmium through out the industrial area. The random dumping of hazardous waste in the industrial area could be the main cause of the soil contamination spreading by rainwater and wind. In the residential areas the local dumping is expected to be the main source as it is difficult to foresee that rain and wind can transport the contaminants from the industrial area. If emission to air by the smokestacks is significant, this may contribute to considerable spreading of contaminants like As, Cd and Pb throughout the area. A comparison of the results with the Canadian Soil Quality Guidelines (SQGL) show that most of the industrial area is heavily contaminated by As, Pb and Zn and local areas by Cr, Cu and Ni. The residential area is also contaminated by As and some small areas by Cr, Cu, Pb and Zn. The Cd contamination is detected over large area but it is not exceeding the SQGL value. Natural background values of As and Cr exceed the SQGL values and contribute significantly to the contamination in the residential area. However, the availability is considerably less than anthropogenic contaminants and must therefore be assessed differently. The pre- and post-monsoon sampling over two hydrological cycles in 2002 and 2003 indicate that the As, Cd and Pb contaminants are more mobile and may expect to reach the groundwater. The other contaminants seem to be much more stable. The contamination is especially serious in the industrial area as it is housing a large permanent residing population. The study not only aims at determining the natural background levels of trace elements as a guide for future pollution monitoring but also focuses on the pollution vulnerability of the watershed. A plan of action for remediation is recommended.     

Measurement of particulate phase polycyclic aromatic hydrocarbon (PAHs) around a petroleum refinery

A study on concentrations of ambient particulates viz. total suspended particulate matters (TSP), respirable suspended particulate matter (RSPM) and polycyclic aromatic hydrocarbons (PAH) were carried out at six sites around the Asia’s largest, 12 MMTPA, petroleum refinery in west coast of India. PAH concentrations are correlated with each other in these sites, suggesting that they have related sources and sinks. The present article discusses the monitoring aspects such as sample collection, pretreatment and analytical methods and compares the monitored levels for assessing the source receptor distribution pattern. The main sources of RSPM and PAHs in urban air are automobile exhaust (CPCB, Polycyclic aromatic hydrocarbons (PAHs) in air and their effects on human health. “”, 2003; Manuel et al., Environmental Science and Technology, 13: 227–231, 2004) and industrial emissions like petroleum refinery (Vo-Dinh, Chemical analysis of polycyclic aromatic hydrocarbons, Wiley: New York, 1989; Wagrowaski and Hites, Environmental Science and Technology, 31: 279–282, 1997). Polycyclic aromatic hydrocarbons (PAH) are ubiquitous constituents of urban airborne particulate mostly generated by anthropogenic activities (Li et al., Environmental Science and Technology, 37:1958–2965, 2003; Thorsen et al., Environmental Science and Technology, 38: 2029–2037, 2004; Ohura et al., Environmental Science and Technology, 32: 450–455, 2004) and some of them are of major health concern mainly due to their well-known carcinogenic and mutagenic properties (Soclo et al., Marine Pollution Bulletin, 40: 387–396, 2000; Chen et al., Environment International, 28: 659–668, 2003; Larsen and Baker, Environmental Science and Technology, 32: 450–455, 2003). Limited information is available on PAHs contributions from refineries to ambient air. Hence this study would not only create a database but also provide necessary inputs towards dose-response relationship for fixing standards. Also, since it acts as precursor to green house gas, the data would be useful for climate change assessments. The objective of this article is to find out the concentration of PAHs in particulate matter around petroleum refinery and compare with their concentrations in major Indian urban centers.     

Micromorphology and chemistry of airborne particles in Brussels during agriculture working periods in surrounding region

The main objective of our research was to compare the airborne particle micromorphology and chemistry in the Brussels environment during agriculture working periods in the surrounding farming region. We used specific methods and instrumentation that are adapted to the climate peculiarities of the Brussels region, the period of investigations (12 months) and the proposed objectives. For the agricultural works we defined the following six periods: before sowing, sowing, after sowing, before harvest, harvest and after harvest. The results indicate a possible temporal correlation between agricultural work periods and airborne particle concentration, micromorphology and chemistry in the Brabant-Brussels region. For wheat and corn plant-growth periods, the average particle size, defined as the area obtained by a planar projection of the particulate, showed important variations in time. For sugar beet and endive, the average area size variations are less important. The roughness and sphericity parameters for the growth periods of the four different plants also showed significant differences. Many of the larger particulates (> 10 microm) are aggregates of even finer particles coated with many still finer ones. The airborne particle chemistry averages (atomic percentage At%), showed that three constituents (Si, S and Fe) dominate all the samples (except for particles 3-10 microm in size, which contain a relatively large percentage of Al). Applying similar investigation methods to study the correlations between airborne particle dynamics in urban zones and the agriculture working periods in their surrounding regions could be of interest to better understand the complexity of the PM problematic.     

Suitability assessment of groundwater for drinking, irrigation and industrial use in some North Indian villages

The study comprised suitability assessment of groundwater for drinking, irrigation, and industrial use. A total of 34 groundwater samples were collected from Rewari town and its perimeter from the land chiefly used for agriculture. Physico-chemical characterization of the samples revealed that groundwater from most of the sources was not fit for drinking owing to a high concentration of calcium, magnesium, hardness and fluoride. Suitability for irrigation, too, was low since most of the sources had high value of sodium adsorption ratio (SAR), residual sodium carbonate (RSC), soluble sodium percentage (SSP) and magnesium hazard which can render salinity and alkali hazard to soils on long term use in irrigation. No source of water was found to be suitable for industrial application since it had high concentration of calcium carbonate which can precipitate very easily. It was observed that sodium, sulphate, and chloride were the chief ions present in water and based on the abundance of ions and their correlation type, most of the groundwater samples are of sodium sulphate and/or sodium chloride type. The high concentration of the chemical constituents is attributed to the lithologic composition of the area. It was observed that the water of deep meteoric percolation type was of sodium sulphate type and the shallow of sodium chloride type.     

Is PM10 mass measurement a reliable index for air quality assessment? An environmental study in a geographical area of north-eastern Italy

The aim of this study was to measure the concentration of some metals (Cd, Cr, Cu, Fe, Mn, Ni, Pb, and Ti) in PM(10) samples collected in one urban and one industrial site and to assess that PM(10) total mass measurement may be not sufficient as air quality index due to its complex composition. Metals were determined by inductively coupled plasma-atomic emission spectroscopy (ICP-AES) and differential pulsed anodic stripping voltammetry (DPASV). The measured concentrations were used to calculate the content of metals in the PM(10) total mass, and to estimate the enrichment factors and the correlations between PM(10), metal concentrations and meteorological data for the two sites. The mean PM10 concentration during the sampling period in the urban site exceeded the annual European Union (EU) standard (40 microg/m(3)) and, for some sampling days, the daily EU standard (50 microg/m(3)) was also exceeded. In opposite, both EU standards were never exceeded in the industrial site. The overall metal content was nearly double in the industrial site compared to the urban one, and the mean Ni concentration exceeded the EU annual limit value (10 ng/m(3)). The metals with the highest enrichment factor were Cd, Cu, Ni and Pb for both sites, suggesting a dominant anthropogenic source for these metals. Metal concentrations were very low and typical of rural background during Christmas holidays, when factories were closed. PM(10) total mass measurement is not a sufficient air quality index since the metal content of PM(10) is not related to its total mass, especially in sites with industrial activities. This measurement should be associated with the analysis of toxic metals.     

Screening and identification of early warning algal species for metal contamination in fresh water bodies polluted from point and non-point sources

The water bodies of Lucknow, Unnao and Kanpur (U.P.), India polluted through various point and non point sources were found to be either eutrophic or oligotrophic in nature. These water bodies supported a great number of algal diversity, which varied seasonally depending upon the physico-chemical properties of water. Further, the water bodies polluted through non point sources supports diverse algal species, while the water bodies polluted through point sources supports growth of tolerant blue green algae. High biomass producing algal species growing in these water bodies have accumulated significant amount of metals in their tissues. Maximum amount of Fe was found accumulated by species of Oedogonium sp. II (20,523.00 mug g(-1) dw) and Spirogyra sp. I (4,520.00 mug g(-1) dw), while maximum Chromium (Cr) was found accumulated in Phormedium bohneri (2,109.00 mug g(-1) dw) followed by Oscillatoria nigra (1,957.88 mug g(-1) dw) and Oedogonium sp. I (156.00 mug g(-1) dw) and Ni in Ulothrix sp. (495.00 mug g(-1) dw). Results showed that some of these forms growing in polluted environment and accumulating high amounts of toxic metals may be used as bioindicator species, however, their performance in metal contaminated water under different ecological niche is to be ascertained.     

Emission of isoprene from common Indian plant species and its implications for regional air quality

Isoprene is most dominant volatile organic compounds (VOC) emitted by many plants. In this study 40 common Indian plant species were examined for isoprene emission using dynamic flow through enclosure chamber technique. Isoprene emission rates of plants species were found to vary from undetectable to 69.5 microg g(-1) h(-1) (Madhuca latifolia). Besides, an attempt has been made to evaluate suitability of 80 common Indian plant species for planting programmes. Out of 80 species, 29 species were moderate to high emitters (10 to < or =25 microg g(-1) h(-1)), 12 species were low emitter emitters (1 to < or =10 microg g(-1) h(-1)) and remaining 39 species were found to be negligible or non emitters (<1 microg g(-1) h(-1)) of isoprene. About 50% plant species selected for planting programmes in India were found to be moderate to high emitters of isoprene.     

Responses of Physical, Chemical, and Biological Indicators of Water Quality to a Gradient of Agricultural Land Use in the Yakima River Basin, Washington

The condition of 25 stream sites in the Yakima River Basin, Washington, were assessed by the U.S. Geological Survey's National Water-Quality Assessment Program. Multimetric condition indices were developed and used to rank sites on the basis of physical, chemical, and biological characteristics. These indices showed that sites in the Cascades and Eastern Cascades ecoregions were largely unimpaired. In contrast, all but two sites in the Columbia Basin ecoregion were impaired, some severely. Agriculture (nutrients and pesticides) was the primary factor associated with impairment and all impaired sites were characterized by multiple indicators of impairment. All indices of biological condition (fish, invertebrates, and algae) declined as agricultural intensity increased. The response exhibited by invertebrates and algae suggested a threshold response with conditions declining precipitously at relatively low levels of agricultural intensity and little response at moderate to high levels of agricultural intensity. This pattern of response suggests that the success of mitigation will vary depending upon where on the response curve the mitigation is undertaken. Because the form of the community condition response is critical to effective water-quality management, the National Water-Quality Assessment Program is conducting studies to examine the response of biota to gradients of land-use intensity and the relevance of these responses to water-quality management. These land-use gradient pilot studies will be conducted in several urban areas starting in 1999.     

Assessing the Impacts of Forests on Human Welfare: Preliminary Results from the Mid-Atlantic Integrated Assessment

This paper presents results from the first phase of the socio-economic assessment of forest ecosystems in the Mid-Atlantic Integrated Assessment (MAIA). First, we present results of the analysis of changes in the distribution of human population and forest land use in the region. Then, trends in wood products employment and income between 1975–95 are used to examine the economic contributions of forest-based industries in the Mid-Atlantic region. Between 1970–90 the population of the MAIA region increased by 14% (4.3 million people) resulting in the average population density increasing by 25 people per square mile from 179 to 204 people per square mile. Nevertheless, population density was lower in large parts of the region in 1990 than in 1950. Although forests dominate the MAIA landscape, the trend is toward more people owning smaller forest land holdings, with developed lands increasing by 21% and rural lands decreasing by 2.64% between 1982–94. All of this suggests increasing forest fragmentation in all states of the region except New York, Pennsylvania, and West Virginia. Forest industry has been an important contributor to the economy of the MAIA region, producing an average of a quarter million jobs (2.03% of all wage employment) and generating $4.5 billion in wages and salaries each year between 1975–95. If recent trends continue, forest industry will continue to be an important source of employment and income for parts of some states in the MAIA region; however, the forest industry's importance relative to the entire mid-Atlantic economy will likely continue to decline in the 21^st century.     

Physical Modeling of Emissions from Naturally Ventilated Underground Parking Garages

The dispersion of pollutants from naturally ventilated underground parking garages has been studied in a boundary layer wind tunnel. Two idealized model setups have been analysed, one was simulating pollutant dispersion around an isolated rectangular building and one was representing dispersion in a finite array of idealized building blocks. Flow and dispersion close to modelled ground level emission sources was measured. The results illustrate the complexity of the flow around buildings and provide insight in pollutant transport from ground level sources located directly on building surfaces. As a result, areas critical with respect to high pollutant concentrations could be visualized. Particularly, the results show high concentration gradients on the surface of the buildings equipped with modelled emission sources. Inside the boundary layers on the building walls, a significant amount of pollutants is transported to upwind locations on the surface of the building. The paper documents the potential of physical modelling to be used for the simulation and measurement of dispersion close to emission sources and within complex building arrangements.