Adjusting the effect of seasonal variability in the bioassessment of streams

Bioassessment tools should distinguish between the effects of anthropogenic degradation in communities and natural temporal changes. The present study tests the influence of natural seasonal variability on macroinvertebrate stream communities assessed by a predictive model (PORTRIV) and a multimetric index (IPtI) calibrated for spring. The scores of PORTRIV decreased significantly between spring and autumn, and between spring and winter (ca. 37 to 53 %, respectively), while those of IPtI did not change significantly between seasons. For non-reference samples, the results of the predictive model also indicate no significant differences. A correction factor (CF) was calculated to adjust the existing differences in the model assessments between seasons, based on the percentage of variation of reference site scores from spring to autumn and winter. After the application of the CF to the OE50 scores of spring reference samples, the differences were no longer significant. Independent reference validation sites confirmed this tendency. This method has the advantage of avoiding large efforts required for the construction of databases from other seasons and the development of new models to allow the assessment of streams in seasons other than spring. Further tests with models developed in regions with more marked seasonal changes should be done to confirm its wider applicability.     

Validation of atmospheric aerosols parallel sampling in a multifold device

In this work, particulate matter was collected using an active sampling system consisting of a PM₁₀ (<10 μm) inlet coupled to a multifold device containing six channels, connected to a vacuum pump. Each channel was equipped with a filter holder fitted with adequately chosen filters. The system was fixed on a metallic structure, which was placed on the roof of the laboratory building, at the Faculty of Sciences, in Lisbon. Sampling took place under flow-controlled conditions. Aerosols were extracted from the filters with water, in defined conditions, and the water-soluble fraction was quantified by ion chromatography (IC) for the determination of inorganic anions (Cl^?, NO₃ ^? and SO₄ ^2?). Equivalent sampling through the various channels was validated. Validation was based on the metrological compatibility of the content results for the various filters. Ion masses are metrologically equivalent when their absolute difference is smaller than the respective expanded uncertainty. When this condition is verified, the studied multifold device produces equivalent samples.     

A spectrophotometric assay method for vanadium in biological and environmental samples using 2,4-dinitrophenylhydrazine with imipramine hydrochloride

A simple, rapid, and sensitive method involving the interaction of 2,4-dinitrophenylhydrazine with imipramine hydrochloride in presence of vanadium (V) in sulfuric acid medium has been proposed for the determination of vanadium. The purple-colored product developed showed an absorption maximum at 560 nm and was stable for 24 h. The working curve was linear over the concentration range of 0.1–2.8 μg ml^− 1, with sensitivity of detection of 0.0124 μg ml^− 1. Molar absorptivity and Sandell’s sensitivity were found to be 2.6 × 10⁴ l/mol cm and 0.0039 μg cm^− 1, respectively. The accuracy of the proposed method was assessed by Student’s t test and variance ratio F test, and the results were on par with the reported method. The method was successfully used in the determination of V in water, human urine, soil, and plant samples, and it was free from interference by various concomitant ions.     

Mixed response in bacterial and biochemical variables to simulated sand mining in placer-rich beach sediments,Ratnagiri, West coast of India

We investigated the influence on bacterial community and biochemical variables through mechanical disturbance of sediment-akin to small-scale mining in Kalbadevi beach, Ratnagiri, a placer-rich beach ecosystem which is a potential mining site. Changes were investigated by comparing three periods, namely phase I before disturbance, phase II just after disturbance, and phase III 24 h after disturbance as the bacterial generation time is ≤7 h. Cores from dune, berm, high-, mid-, and low-tide were examined for changes in distribution of total bacterial abundance, total direct viability (counts under aerobic and anaerobic conditions), culturability and biochemical parameters up to 40 cm depth. Results showed that bacterial abundance decreased by an order from 10⁶ cells g^− 1 sediment, while, viability reduced marginally. Culturability on different-strength nutrient broth increased by 155% during phase II. Changes in sedimentary proteins, carbohydrates, and lipids were marked at berm and dune and masked at other levels by tidal influence. Sedimentary ATP reduced drastically. During phase III, Pearson’s correlation between these variables evolved from non-significant to significant level. Thus, simulated disturbance had a mixed effect on bacterial and biochemical variables of the sediments. It had a negative impact on bacterial abundance, viability and ATP but positive impact on culturability. Viability, culturability, and ATP could act as important indicators reflecting the disturbance in the system at short time intervals. Culturability, which improved by an order, could perhaps be a fraction that contributes to restoration of the system at bacterial level. This baseline information about the potential mining site could help in developing rational approach towards sustainable harnessing of resources with minimum damage to the ecosystem.     

Trace metals biogeochemistry of Kumaun Himalayan Lakes,Uttarakhand, India

The increasing urbanization, along with tourism, has posed a major threat to the Kumaun Himalayan Lakes, Uttarakhand, India. The total metal concentration in the water, interstitial water, and sediments along with the metal fractionation studies were carried out to understand the remobilization of the trace metals from the sediments of the lakes. The high concentration of the metals in the water column of the lakes generally decreases with depth and the metals release from the sediment is mainly due to the prevalence of anoxic condition at the sediment–water interface and sediment column. The sediment shows that metals Fe and Cr are derived from detrital source, whereas Co, Ni, and Zn are derived mainly from the organic matter dissolution. The sparse correlation of the trace metals with Ti shows most of the metals have chiefly re-precipitated from the water column. The metals speciation studies also supports that metals experience a high rate of anoxic dissolution and their precipitation onto the sediments are determined by the sediment composition and organic matter content. The high concentration of manganese in the interstitial water in the lakes indicates dissolution of organic matter. The released manganese is adsorbed/precipitated as carbonate phase (Nainital Lake) and oxide pahse (in other lakes). The study shows that the trace metals are regenerated from the sediments due to oxyhydroxide dissolution and organic matter decomposition.     

Organochlorine pesticide residues in drinking water in the rural areas of Haryana,India

Drinking water samples collected from rural areas of three districts of Haryana during pre-monsoon and post-monsoon periods were analysed for the presence of organochlorine pesticide residues. The main source of drinking water in rural areas, i.e. groundwater in Ambala and Gurgaon districts and surface water supply in Hisar district, was found to be contaminated with isomers of HCH and endosulfan and metabolites of DDT, whereas dieldrin remained below detection limits. During the study period, the mean values observed for total HCH, DDT and endosulfan were 87.6, 848.2, and 27.4 ng/L and 99.8, 275.3 and 164.2 ng/L, respectively, for Ambala and Gurgaon districts. In the case of Hisar district, the values were 78.5, 115.9, and 53.0 ng/L, respectively. During the study period, 37% of the samples exceeded the total pesticide level of 500 ng/L indicated in the EECD directive for drinking water. Seasonal variations of pesticide residues were also observed during the study period.     

Occurrence of estrogen hormones in biosolids,animal manure and mushroom compost

The presence of natural estrogen hormones as trace concentrations in the environment has been reported by many researchers and is of growing concern due to its possible adverse effects on the ecosystem. In this study, municipal biosolids, poultry manure (PM) and cow manure (CM), and spent mushroom compost (SMC) were analyzed for the presence of seven estrogen hormones. 17α-estradiol, 17β-estradiol, 17α-dihydroequilin, and estrone were detected in the sampled biosolids and manures at concentrations ranging from 6 to 462 ng/g of dry solids. 17α-estradiol, 17β-estradiol, and estrone were also detected in SMC at concentrations ranging from 4 to 28 ng/g of dry solids. Desorption experiments were simulated in the laboratory using deionized water (milli-Q), and the aqueous phase was examined for the presence of estrogen hormones to determine their desorption potential. Very low desorption of 0.4% and 0.2% estrogen hormones was observed from municipal biosolids and SMC, respectively. An estimate of total estrogen contribution from different solid waste sources is reported. Animal manures (PM and CM) contribute to a significant load of estrogen hormones in the natural environment.     

Numerical Modeling of a Potential Geological CO 2 Sequestration Site at Minden (Germany)

We study opportunities for CO₂ sequestration in geological formations of the state North Rhine Westphalia in Germany. Simulations are performed for evaluating a potential site within the Bunter sandstone formation near the town of Minden in a depth?of around 3,000 m using the numerical simulator TOUGHREACT. Our focus is on three CO₂ storage mechanisms: (1) hydrodynamic trapping, (2) dissolution trapping, and (3) mineral trapping. The results show that due to buoyancy the injected CO₂ phase initially migrates towards the top of the reservoir and is hydrodynamically trapped beneath the confining layer of the cap rock. Then, the CO₂ spreads laterally and dissolves partially in the formation water. The dissolution of CO₂ results in an increase of the density of the brine causing a downward migration until it settles after 10,000 years at the bottom of the reservoir. The simulations indicate that after 10,000 years, 15% (17 Mt) from a total of 114 Mt injected CO₂ are trapped hydrodynamically, 20% (23 Mt) are trapped by dissolution, and 65% (74 Mt) are fixed in newly formed carbonates such as dawsonite, ankerite, and siderite. Within our study pressure increases near the injection well by a factor of 1.1 which is lower than the upper limit usually accepted in gas storage operations. The mineral reactions cause a net decrease of porosity and in turn a decrease of permeability down to 9% of the initial value in parts of the reservoir.     

Interlaboratory evaluation of trace element determination in workplace air filter samples by inductively coupled plasma mass spectrometry

Inductively coupled plasma mass spectrometry (ICP-MS) is becoming more widely used for trace elemental analysis in the occupational hygiene field, and consequently new ICP-MS international standard procedures have been promulgated by ASTM International and ISO. However, there is a dearth of interlaboratory performance data for this analytical methodology. In an effort to fill this data void, an interlaboratory evaluation of ICP-MS for determining trace elements in workplace air samples was conducted, towards fulfillment of method validation requirements for international voluntary consensus standard test methods. The study was performed in accordance with applicable statistical procedures for investigating interlaboratory precision. The evaluation was carried out using certified 37-mm diameter mixed-cellulose ester (MCE) filters that were fortified with 21 elements of concern in occupational hygiene. Elements were spiked at levels ranging from 0.025 to 10 μg filter(-1), with three different filter loadings denoted "Low", "Medium" and "High". Participating laboratories were recruited from a pool of over fifty invitees; ultimately twenty laboratories from Europe, North America and Asia submitted results. Triplicates of each certified filter with elemental contents at three different levels, plus media blanks spiked with reagent, were conveyed to each volunteer laboratory. Each participant was also provided a copy of the test method which each participant was asked to follow; spiking levels were unknown to the participants. The laboratories were requested to prepare the filters by one of three sample preparation procedures, i.e., hotplate digestion, microwave digestion or hot block extraction, which were described in the test method. Participants were then asked to analyze aliquots of the prepared samples by ICP-MS, and to report their data in units of μg filter(-1). Most interlaboratory precision estimates were acceptable for medium- and high-level spikes (RSD <25%), but generally yielded greater uncertainties than were anticipated at the outset of the study.