Concentrations of mobile source air pollutants in urban microenvironments

Human exposures to criteria and hazardous air pollutants (HAPs) in urban areas vary greatly due to temporal-spatial variations in emissions, changing meteorology, varying proximity to sources, as well as due to building, vehicle, and other environmental characteristics that influence the amounts of ambient pollutants that penetrate or infiltrate into these microenvironments. Consequently, the exposure estimates derived from central-site ambient measurements are uncertain and tend to underestimate actual exposures. The Exposure Classification Project (ECP) was conducted to measure pollutant concentrations for common urban microenvironments (MEs) for use in evaluating the results of regulatory human exposure models. Nearly 500 sets of measurements were made in three Los Angeles County communities during fall 2008, winter 2009, and summer 2009. MEs included in-vehicle, near-road, outdoor, and indoor locations accessible to the general public. Contemporaneous 1- to 15-min average personal breathing zone concentrations of carbon monoxide (CO), carbon dioxide (CO₂), volatile organic compounds (VOCs), nitric oxide (NO), nitrogen oxides (NO_x), particulate matter (<2.5 μm diameter; PM_2.5) mass, ultrafine particle (UFP; <100 nm diameter) number, black carbon (BC), speciated HAPs (e.g., benzene, toluene, ethylbenzene, xylenes [BTEX], 1,3-butadiene), and ozone (O₃) were measured continuously. In-vehicle and inside/outside measurements were made in various passenger vehicle types and in public buildings to estimate penetration or infiltration factors. A large fraction of the observed pollutant concentrations for on-road MEs, especially near diesel trucks, was unrelated to ambient measurements at nearby monitors. Comparisons of ME concentrations estimated using the median ME/ambient ratio versus regression slopes and intercepts indicate that the regression approach may be more accurate for on-road MEs. Ranges in the ME/ambient ratios among ME categories were generally greater than differences among the three communities for the same ME category, suggesting that the ME proximity factors may be more broadly applicable to urban MEs.

Implications:Estimates of population exposure to air pollutants extrapolated from ambient measurements at ambient fixed site monitors or exposure surrogates are prone to uncertainty. This study measured concentrations of mobile source air toxics (MSAT) and related criteria pollutants within in-vehicle, outdoor near-road, and indoor urban MEs to provide multipollutant ME measurements that can be used to calibrate regulatory exposure models.     

Gene expression profiles in the testis associated with testis-ova in adult Japanese medaka (Oryziaslatipes) exposed to 17α-ethinylestradiol

The occurrence of oocytes in the testis (testis-ova) of several fish species is often associated with exposure of estrogenic chemicals. However, induction mechanisms of the testis-ova remain to be elucidated. To develop marker genes for detecting testis-ova in the testis, adult male medaka were exposed to nominal concentration of 100 ng L⁻¹ of 17α-ethinylestradiol (EE2) for 3-5 weeks, and 800 ng estradiol benzoate (EB) for 3 weeks (experiment I), and a measured concentration of 20 ng L⁻¹ EE2 for 1-6 weeks (experiment II). Histological analysis was performed for the testis, and microarray analyses were performed for the testis, liver and brain. Microarray analysis in the estrogen-exposed medaka liver showed vitellogenin and choriogenin as estrogen responsive genes. Testis-ova were induced in the testis after 4 weeks of exposure to 100 ng L⁻¹ EE2, 3 weeks of exposure to 800 ng EB, and 6 weeks of exposure to 20 ng L⁻¹ EE2. Microarray analysis of estrogen-exposed testes revealed up-regulation of genes related to zona pellucida (ZP) and the oocytes marker gene, 42Sp50. Using quantitative RT-PCR we confirmed that Zpc5 gene can be used as a marker for the detection of testis-ova in male medaka.     

Detection of dicofol and related pesticides in human breast milk from China, Korea and Japan

Previously, we demonstrated that the concentrations of DDTs were greater in breast milk collected from Chinese mothers than from Japanese and Korean mothers. To investigate dicofol as a possible source of the DDTs in human breast milk, we collected breast milk samples from 2007 to 2009 in China (Beijing), Korea (Seoul, Busan) and Japan (Sendai, Takarazuka and Takayama). Using these breast milk samples, we quantified the concentrations of dichlorobenzophenone, a pyrolysis product of dicofol (simply referred to as dicofol hereafter), dichlorodiphenyltrichloroethane and its metabolites (DDTs) using GC-MS. Overall, 12 of 14 pooled breast milk samples from 210 mothers contained detectable levels of dicofol (>0.1 ng g⁻¹ lipid). The geometric mean concentration of dicofol in the Japanese breast milk samples was 0.3 ng g⁻¹ lipid and significantly lower than that in Chinese (9.6 ng g⁻¹ lipid) or Korean breast milk samples (1.9 ng g⁻¹ lipid) (p < 0.05 for each). Furthermore, the ΣDDT levels in breast milk from China were 10-fold higher than those from Korea and Japan. The present results strongly suggest the presence of extensive emission sources of both dicofol and DDTs in China. However, exposure to dicofol cannot explain the large exposure of Chinese mothers to DDTs because of the trace levels of dicofol in the ΣDDTs. In the present study, dicofol was confirmed to be detectable in human breast milk. This is the first report to identify dicofol in human samples.     

Synthesis of hydrogarnet from molten slag and its hydrogen chloride fixation performance at high temperature

Hydrogarnet was synthesized hydrothermally below 200°C using molten slag obtained from municipal solid waste. For comparison, it was also synthesized using pure-phase CaO–Al₂O₃–SiO₂–H₂O, as reported previously. The structural and textural properties of this material were investigated using various analytical and spectroscopic techniques such as X-ray diffraction, X-ray fluorescence spectrometry, atomic absorption spectrometry (AAS), thermogravimetry/differential thermal analysis, Fourier transform infrared spectroscopy, and scanning electron microscopy. The Cl⁻ fixation ability of hydrogarnet was investigated in the temperature range 500–800°C in a fixed-bed flow reactor using a HCl concentration (1000 p.p.m.v.) similar to that of incinerator exhaust gas. Under these experimental conditions, the hydrogarnet was capable of reducing the HCl gas level to less than 1 p.p.m.v. Analysis of the spent catalyst revealed that the hydrogarnet was being transformed into wadalite and CaCl₂ at high temperatures. The elution test for chromium ions in hydrogarnet obtained from slag was also used, and it was found that chromium ions were not eluted from hydrogarnet. Received: January 27, 2001 / Accepted: October 11, 2001     

Comprehensive temperature monitoring in an in-vessel forced-aeration static-bed composting process

Comprehensive temperature monitoring was done in an in-vessel forced-aeration static-bed composting process using sewage sludge. The three layers that divided the compost pile horizontally showed different temperature distributions. The temperature of the top layer appeared not to be influenced by the ambient temperature. The temperature of the center area of the top layer was taken to be the representative temperature for evaluating composting start-up performance. The temperature of the bottom layer was strongly influenced by the ambient temperature, and the temperature of the center area of the bottom layer was taken to be the representative temperature for pathogen control as it was the minimum temperature in the reactor. Composting start-up performance was influenced by several factors when the ambient temperature was either below or above 20°C. When the ambient temperature was below 20°C, the time taken to reach 65°C (T ₆₅) was influenced by the temperature of inflowing air, but when the temperature was higher than 20°C, it was influenced by the ratio of sewage sludge to seed compost (F/S). T ₆₅ was least when F/S was 1–2. Received: January 9, 2001 / Accepted: October 10, 2001     

Uranium resource appraisal: Past trends and outlook for adequacy of supply

As uranium has practically no other industrial uses besides electricity generation, demand is determined by the requirements and stockpiling policies of electric utilities. The uranium market has experienced strong fluctuations and is currently affected by the reductions in nuclear forecasts resulting from the slowdown in electricity demand. Analysing supply/demand indicators proves, however, that in retrospect the development has been relatively smooth and it appears that oversupply is more a consequence of overly optimistic short-term expectations. In the future, especially in the long term, nuclear power policies continue to be concerned with striking a proper balance between increasing production capability and development of new reactor technologies which would be less dependent on the availability of uranium. A bounding scenario approach is applied in this article to the assessment of adequacy of supply under varying assumptions on the total installed nuclear capacity, available resource base and attainable production capability.     

Two extreme types of mixing of dust with urban aerosols observed in Kosa particles: ‘After’ mixing and ‘on-the-way’ mixing

Besides well-known episodic Kosa during spring, high concentrations of Ca²⁺ in aerosols were observed early in summer as well as in the semi-continuous data of the aerosols at the summit of Mt. Fuji. We further analysed the data to study the chemical characteristics of the high calcium event during early summer. The back trajectory analyses of the event indicated that Ca was transported from arid and semi-arid regions (e.g. the Taklamakan desert) through the westerly-dominated troposphere higher than the height of the summit of Fuji. The amount of SO₄^2? was always equivalent to that of NH₄⁺ unlike the case of the normal Kosa period where SO₄^2? is in excess with respect to NH₄⁺. This shows the ‘after’ mixing of unreacted CaCO₃ of Kosa origin with (NH₄)₂SO₄, which was only realized by the downward injection of Kosa particles from higher altitudes to the air masses of different origin. In the case of normal Kosa, the air bearing Kosa particles passed through the polluted area to absorb unneutralized acids (‘on-the-way’ mixing), whereas in the case of the Kosa-like phenomena in summer, the acids from the polluted area have been neutralized by NH₄⁺ and become inactive before mixing with CaCO₃ (“after” mixing). We have simplified the chemistry of aerosols using their three major components, Ca²⁺, SO₄^2? and NH₄⁺, and introduced a new triangle diagram with the three assumed end-members of CaCO₃, CaSO₄ and (NH₄)₂SO₄ to quantify the contribution of the ‘after’ mixing to the aerosols (AMI; ‘after’ mixing index). Based on the back trajectories of some high AMI cases, CaCO₃ in Kosa particles was transported through the middle troposphere (5000–7000 m) and descended to meet another air mass where SO₄^2? had been already neutralized by NH₃.     

Arizona Hazardous Air Pollutants Monitoring Program

ABSTRACT

In order to evaluate the existing risk to public health in Arizona related to hazardous air pollution, ambient air monitoring for selected hazardous air pollutants (HAPs) was carried out in 1994-1996 in several representative urban and rural areas of Arizona. A wide range of organic HAPs was monitored, requiring a variety of sampling and analysis methods. Stainless steel SUMMA canisters were used for collection of volatile hydrocarbons and halocarbons, which were analyzed by capillary gas chromatography with flame ionization and electron capture detection (GC-FID/ECD). Carbonyl compounds were collected using 2,4-dinitrophenylhydrazine-impregnated cartridges and analyzed by high performance liquid chromatog-raphy with ultraviolet detection. Semi-volatile and non-volatile polycyclic aromatic compounds were collected using a sampling train consisting of a filter followed by a PUF/XAD-4/PUF sandwich cartridge. Following extraction, samples were analyzed by capillary GC with mass spectrometric detection (GC-MS). Database software was developed for data processing and reporting functions. This paper describes the sampling strategy and the sampling and analysis methods employed in the monitoring program and presents a summary of all the results obtained during the duration of the sampling program.     

Venoms from six species of marine fish: lethal and hemolytic activities and their neutralization by commercial stonefish antivenom

A specimen of the stonefish Synanceja verrucosa was captured in Okinawa in March 1988. Live specimens of the scorpionfish Inimicus japonicus were purchased from the Tokyo Central Wholesale Market in November 1988 and those of four species of zebrafish Pterois lumulata, P. volitans, P. antennata and Dendrochirus zebra from an aquarium in December 1988. Crude venoms were extracted from dorsal spines of the six species. All venoms exhibited lethal activity against mice and hemolytic activity specific for rabbit erythrocytes. The lethal activity (or hemolytic activity) of each venom was very unstable to freezing, lyophilization and heating. Both lethal and hemolytic activities of S. verrucosa venom were remarkably neutralized by the commerical stonefish (Synanceja trachynis) antivenom. This antivenom was also effective, to some extent, in counteracting the other venom activities. The neutralizing capacities of the antivenom were calculated to be 7310 LD₅₀ ml^-1 for S. verrucosa venom and 1 220 to 2 990 LD₅₀ ml^-1 for the other venoms. Results of neutralization tests suggest that venoms from the six species were comparable in terms of antigenecity.     

Determination of photosynthetic pigment composition in an individual phytoplankton cell in seas and lakes using fluorescence microscopy; properties of the fluorescence emitted from picophytoplankton cells

To develop a method for the determination of photosynthetic pigment species in individual phytoplankton cells, especially natural picophytoplankton cells, the fluorescence spectra of intact cells were studied with cultured phytoplankton. The study was made mainly with phycoerythrin-containing picophytoplankton collected off Japan in 1982 with reference to diatomal species and phycoerythrin-free cyanophycean species. The spectra were measured for cell suspensions with an ordinary spectrofluorometer, and for individual cells with a microscope spectrofluorometer, paying special attention to the effect of cell-fixation. Results indicated that: (1) the cell-fixation with the glutaraldehyde and paraformaldehyde mixture modified phycoerythrin emission from picophytoplankton markedly in its wavelength location and intensity, but (2) the emission from phycocyanin was affected far less, and (3) the emission from chlorophyll a was not altered. However, the phycoerythrin emission modified by the fixation was found to be easily distinguished from other emissions, and kept its intensity high enough for detection with a fluorescence microscope. The fluorescence properties after the fixation were kept unaltered for a long period of time. Based on the results, we propose a simple method for the determination of photosynthetic pigments in individual phytoplankton cells in seas and lakes using fluorescence microscopy. Results of our tests with natural samples of phytoplankton are presented, and problems for further improvement are also discussed.