Valorization of solid waste products from olive oil industry as potential adsorbents for water pollution control—a review

The global olive oil production for 2010 is estimated to be 2,881,500 metric tons. The European Union countries produce 78.5 % of the total olive oil, which stands for an average production of 2,136,000 tons. The worldwide consumption of olive oil increased of 78 % between 1990 and 2010. The increase in olive oil production implies a proportional increase in olive mill wastes. As a consequence of such increasing trend, olive mills are facing severe environmental problems due to lack of feasible and/or cost-effective solutions to olive-mill waste management. Therefore, immediate attention is required to find a proper way of management to deal with olive mill waste materials in order to minimize environmental pollution and associated health risks. One of the interesting uses of solid wastes generated from olive mills is to convert them as inexpensive adsorbents for water pollution control. In this review paper, an extensive list of adsorbents (prepared by utilizing different types of olive mill solid waste materials) from vast literature has been compiled, and their adsorption capacities for various aquatic pollutants removal are presented. Different physicochemical methods that have been used to convert olive mill solid wastes into efficient adsorbents have also been discussed. Characterization of olive-based adsorbents and adsorption mechanisms of various aquatic pollutants on these developed olive-based adsorbents have also been discussed in detail. Conclusions have been drawn from the literature reviewed, and suggestions for future research are proposed.     

湖南省四水流域水沙周期特征及其影响因素分析

采用复小波变换和M K非参数检验的方法分析了湖南省四水流域主要控制站1951~2011年径流量与输沙量周期规律和突变特征。结果表明：(1)湖南四水径流量存在多个波动增加和波动减少的波动变化现象,但无显著变化趋势;而输沙量虽然有一定的波动,但总体上呈波动减少变化态势,而且下降趋势较显著;(2)湘潭站、桃江站和桃源站径流量和输沙量存在20~25 a的第一主周期,而石门站径流量和输沙量的第一主周期不具有一致性,径流量主周期为2 a,输沙量主周期为13 a,但其径流量和输沙量第二、三主周期变化规律相吻合,均为3~5 a的周期;(3)大量的水利工程建设是导致输沙量减少的主要原因,径流量的变化与降水的变化规律较为一致     

春季香溪河库湾CODMn时空分布及其影响因子初探

于2012年春季在香溪河库湾合理布置断面观测,分析水体高锰酸盐指数(CODMn)的时空分布特征,并对CODMn与水体中叶绿素a、溶解氧(DO)、水体垂向稳定系数、总氮(TN)和溶解性硅酸盐(D Si)进行相关分析,以期为香溪河流域有机污染的治理提供支持和指导。结果表明：春季香溪河库湾CODMn浓度变化范围为1.40～5.36 mg/L,4月CODMn均值明显高于3月和5月,为366 mg/L,整个春季CODMn浓度从下游至上游呈现明显增大的趋势。相关分析发现,春季水华暴发期间,CODMn与叶绿素a显著正相关(分别为072和074),而在未暴发水华的3月二者的相关性不显著。浮游植物和水体稳定系数是影响CODMn变化的主要因素。倒灌异重流使得高含氮、低CODMn浓度的长江干流水体进入库湾下游并稀释CODMn浓度。CODMn与DO在3月和5月的弱相关关系为香溪河CODMn特殊的分布特征提供了其它合理的解释,其分布特征受多种因素的共同影响。春季库湾上游有机污染趋于恶化,限制支流特别是上游污染物的排放是改善有机污染现状的有效途径     

水温分层对香溪河库湾浮游植物功能群季节演替的影响

三峡水库水环境问题近年来引起社会广泛关注,以浮游植物功能群为基础,通过对2010年1~12月香溪河库湾水温、浮游植物等进行跟踪监测,探究支流库湾浮游植物群落结构演替趋势及其影响因子。结果表明：香溪河库湾2010年共出现18个浮游植物功能群,其中B、X1、P、Y、X2、D、LO、J、MP、G是代表性功能群;水温分层的季节性发育和消失是浮游植物群落结构演替的主要影响因素;冬季以耐受水温及光照限制的CS/S策略藻种为主;春季弱分层时,CR/R策略藻种适宜生长;夏季汛期时,呈现CR/R/C/CS多种策略藻种混生格局,强分层时,适宜稳定生境的S型策略藻种占据优势;秋季分层被打破,群落结构演替为耐受频繁波动环境的R型群落格局占优势     

Source apportion of atmospheric particulate matter: a joint Eulerian/Lagrangian approach

PM_2.5 samples were collected during an annual monitoring campaign (January 2012–January 2013) in the urban area of Naples, one of the major cities in Southern Italy. Samples were collected by means of a standard gravimetric sampler (Tecora Echo model) and characterized from a chemical point of view by ion chromatography. As a result, 143 samples together with their ionic composition have been collected. We extend traditional source apportionment techniques, usually based on multivariate factor analysis, interpreting the chemical analysis results within a Lagrangian framework. The Hybrid Single-Particle Lagrangian Integrated Trajectory Model (HYSPLIT) model was used, providing linkages to the source regions in the upwind areas. Results were analyzed in order to quantify the relative weight of different source types/areas. Model results suggested that PM concentrations are strongly affected not only by local emissions but also by transboundary emissions, especially from the Eastern and Northern European countries and African Saharan dust episodes.     

The impact of infield biomass burning on PM levels and its chemical composition

In the South of Italy, it is common for farmers to burn pruning waste from olive trees in spring. In order to evaluate the impact of the biomass burning source on the physical and chemical characteristics of the particulate matter (PM) emitted by these fires, a PM monitoring campaign was carried out in an olive grove. Daily PM10 samples were collected for 1 week, when there were no open fires, and when biomass was being burned, and at two different distances from the fires. Moreover, an optical particle counter and a polycyclic aromatic hydrocarbon (PAH) analyzer were used to measure the high time-resolved dimensional distribution of particles emitted and total PAHs concentrations, respectively. Chemical analysis of PM10 samples identified organic and inorganic components such as PAHs, ions, elements, and carbonaceous fractions (OC, EC). Analysis of the collected data showed the usefulness of organic and inorganic tracer species and of PAH diagnostic ratios for interpreting the impact of biomass fires on PM levels and on its chemical composition. Finally, high time-resolved monitoring of particle numbers and PAH concentrations was performed before, during, and after biomass burning, and these concentrations were seen to be very dependent on factors such as weather conditions, combustion efficiency, and temperature (smoldering versus flaming conditions), and moisture content of the wood burned.     

Formation of indoor nitrous acid (HONO) by light-induced NO<Subscript>2</Subscript> heterogeneous reactions with white wall paint

Gaseous nitrogen dioxide (NO₂) represents an oxidant that is present in relatively high concentrations in various indoor settings. Remarkably increased NO₂ levels up to 1.5 ppm are associated with homes using gas stoves. The heterogeneous reactions of NO₂ with adsorbed water on surfaces lead to the generation of nitrous acid (HONO). Here, we present a HONO source induced by heterogeneous reactions of NO₂ with selected indoor paint surfaces in the presence of light (300 nm?<?λ?<?400 nm). We demonstrate that the formation of HONO is much more pronounced at elevated relative humidity. In the presence of light (5.5 W m^?2), an increase of HONO production rate of up to 8.6?·?10⁹ molecules cm^?2 s^?1 was observed at [NO₂]?=?60 ppb and 50 % relative humidity (RH). At higher light intensity of 10.6 (W m^?2), the HONO production rate increased to 2.1?·?10¹⁰ molecules cm^?2 s^?1. A high NO₂ to HONO conversion yield of up to 84 % was observed. This result strongly suggests that a light-driven process of indoor HONO production is operational. This work highlights the potential of paint surfaces to generate HONO within indoor environments by light-induced NO₂ heterogeneous reactions.     

Micropollutants in urban stormwater: occurrence,concentrations, and atmospheric contributions for a wide range of contaminants in three French catchments

This study aimed at: (a) providing information on the occurrence and concentration ranges in urban stormwater for a wide array of pollutants (n?=?77); (b) assessing whether despite the differences between various catchments (land use, climatic conditions, etc.), the trends in terms of contamination level are similar; and (c) analyzing the contribution of total atmospheric fallout (TAF) with respect to sources endogenous to this contamination. The studied contaminants include conventional stormwater contaminants (polycyclic aromatic hydrocarbons (PAHs), Zn, Cu, Pb, etc.), in addition to poorly or undocumented pollutants such as nonylphenol and octylphenol ethoxylates (NPnEO and OPnEO), bisphenol A (BPA), polybrominated diphenyl ethers (PBDEs), a wide variety of pesticides, and various metals of relevance (As, Ti, Sr, V). Sampling and analysis were performed using homogeneous methods on three urban catchments with different land use patterns located in three distinct French towns. For many of these pollutants, the results do not allow highlighting a significant difference in stormwater quality at the scale of the three urban catchments considered. Significant differences were, however, observed for several metals (As, Cr, Cu, Ni, Sr and Zn), PAHs, and PBDEs, though this assessment would need to be confirmed by further experiments. The pollutant distributions between dissolved and particulate phases were found to be similar across the three experimental sites, thus suggesting no site dependence. Lastly, the contributions of TAF to stormwater contamination for micropollutants were quite low. This finding held true not only for PAHs, as previously demonstrated in the literature, but also for a broader range of molecules such as BPA, NPnEO, OPnEO, and PBDEs, whose high local production is correlated with the leaching of urban surfaces, buildings, and vehicles.     

Survival of Escherichia coli in stormwater biofilters

Biofilters are widely adopted in Australia for stormwater treatment, but the reported removal of common faecal indicators (such as Escherichia coli (E. coli)) varies from net removal to net leaching. Currently, the underlying mechanisms that govern the faecal microbial removal in the biofilters are poorly understood. Therefore, it is important to study retention and subsequent survival of faecal microorganisms in the biofilters under different biofilter designs and operational characteristics. The current study investigates how E. coli survival is influenced by temperature, moisture content, sunlight exposure and presence of other microorganisms in filter media and top surface sediment. Soil samples were taken from two different biofilters to investigate E. coli survival under controlled laboratory conditions. Results revealed that the presence of other microorganisms and temperature are vital stressors which govern the survival of E. coli captured either in the top surface sediment or filter media, while sunlight exposure and moisture content are important for the survival of E. coli captured in the top surface sediment compared to that of the filter media. Moreover, increased survival was found in the filter media compared to the top sediment, and sand filter media was found be more hostile than loamy sand filter media towards E. coli survival. Results also suggest that the contribution from the tested environmental stressors on E. coli survival in biofilters will be greatly affected by the seasonality and may vary from one site to another.