Deposition of ozone to a mature spruce forest: measurements and comparison to models

Removal of ozone at terrestrial surfaces provides a major sink for tropospheric ozone and, therefore, a constraint on the peak concentrations achieved during photochemical episodes. This study reports results from 5 years of almost continuous measurements of vertical profiles of ozone and related meteorological variables over a mature spruce forest in Bavaria. Deposition velocities calculated from flux/gradient and eddy correlation flux measurements have been compared with estimates based on a resistance model and yield satisfactory agreement during fine weather conditions. The results also suggest that biogenic emissions of reactive hydrocarbons from the forest influence the vertical profile of ozone.     

Trace metals in interstitial waters from sandstones: acidic inputs to shallow groundwaters

There is some evidence from southern Britain that shallow groundwaters in non-carbonate lithologies may be affected by acidic deposition. To investigate this, interstitial water profiles down to 12 m have been obtained from unsaturated sands or semi-consolidated sandstones from the Folkestone Beds (Lower Greensand) of Surrey and the Sherwood Sandstone of the West Midlands. The pH of the interstitial waters generally increased with depth and reflected an increase in the base saturation of the exchange complex. Beneath the highly acidic surface soil horizons (pH 3.0-3.5), interstitial waters with a pH of 4.0-4.5 were found down to depths of several metres. The pH progressively increased to around pH 5.5 because of base cation desorption and the weathering of silicate minerals. High concentrations of aluminium (10-20 mg litre(-1)) and other metals (Fe, Mn, Cu, Ni, Co, Zn, Be) were found in the interstitial water in the upper unsaturated zone. Most metal concentrations were strongly pH-dependent but also reflected the geochemical characteristics of the parent sands or sandstones. H+ and trace element concentrations were slightly higher beneath areas of afforestation than beneath heathland. The downward fluxes of solutes have been estimated using rainfall-derived chloride as a non-reactive solute. The profiles retain a record of 10-20 years input allowing the past inputs from SO4 and other species to be estimated using solute/chloride ratios. Cation exchange sites are probably depleted over a period of decades and there can be a significant decrease in the unsaturated zone pH as a result of increased or sustained acidic deposition. The shallow groundwater environment (0-15 m) in non-carbonate terrains is therefore a sensitive environment where high metal concentrations may be generated and may ultimately lead to water quality problems in shallow water supplies.     

Training refugees as primary health care workers: Past imperfect, future conditional

Many problems have been encountered in the planning and implementation of health care in refugee camps, and more specifically in the training of refugees as primary health care workers. A review of the published literature and a "survey" of the opinions and experiences of refugee, national and international health personnel regarding training has therefore been undertaken to provide an overview of what has been done and to make recommendations for future work.
The review highlights the need to reallocate resources away from high visibility emergency aid to development activities, such as training, that will create an infrastructure for primary health care and promote self-reliance.     

‘Emulsion locks’ for the containment of hydrocarbons during surfactant flushing

Reversible double water in oil in water (W/O/W) emulsions were developed to contain subsurface hydrocarbon spills during their remediation using surfactant flushing. Double emulsions were prepared by emulsifying CaCl₂ solutions in canola oil, and subsequently by emulsifying the W/O emulsions in aqueous sodium alginate solutions. The formation of double emulsions was confirmed with confocal and optical microscopy. The double emulsions reversed and gelled when mixed with the surfactants sodium dodecyl sulfate (SDS) and cocamidopropyl betaine (CPB). Gels can act as ‘emulsion locks’ to prevent spreading of the hydrocarbon plume from the areas treated with surfactant flushing, as shown in sand column tests. Shear rheology was used to quantify the viscoelastic moduli increase (gelation) upon mixing the double emulsion with SDS and CPB. SDS was more effective than CPB in gelling the double emulsions. CPB and SDS could adsorb at the interface between water and model hydrocarbons (toluene and motor oil), lowering the interfacial tension and rigidifying the interface (as shown with a Langmuir trough). Bottle tests and optical microscopy showed that SDS and CPB produced W/O and O/W emulsions, with either toluene or motor oil and water. The emulsification of motor oil and toluene in water with SDS and CPB facilitated their flow through sand columns and their recovery. Toluene recovery from sand columns was quantitated using Gas-Chromatography Mass-Spectroscopy (GC-MS). The data show that SDS and CPB can be used both for surfactant flushing and to trigger the gelation of ‘emulsion locks’. Ethanol also gelled the emulsions at 100 mL/L.     

Removal and desorption of chromium in synthetic effluent by a mixed culture in a bioreactor with a magnetic field

Two chromium removal experiments were performed in bioreactors with and without a magnetic field under the same conditions.The release of the chromium present in the biomass was tested in two experiments one with the initial pH of the medium and one with pH 4.0.The objective was to remove Cr(Ⅵ) and total Cr from the effluent,this was carried out by placing biological treatments of synthetic effluent contaminated with 100 mg/L of Cr(Ⅵ) in a bioreactor with neodymium magnets that applied a magnetic field(intensity85.4 mT) to the mixed culture.The removal of Cr(Ⅵ) was approximately 100.0% for the bioreactor with a magnetic field and 93,3% for the bioreactor without a magnetic field for9 hr of recirculation of the synthetic effluent by the bioreactor.The removal of total Cr was61.6% and 48.4%,with and without a magnetic field,respectively;for 24 hr.The desorption of Cr(VI) in the synthetic effluent was 0.05 mg/L,which is below the limit established by Brazilian legislation(0.1 mg/L) for the discharge of effluent containing Cr(Ⅵ) into bodies of water.The results obtained for the removal of chromium in synthetic effluent suggested that there was no significant influence on the viable cell count of the mixed culture.The desorption of Cr(Ⅵ) in synthetic effluent after bioadsorption of chromium by the mixed culture in the process of removal of chromium in bioreactors with and without a magnetic field was not significant in either of the experiments with different initial pHs.     

Simulation of a 100-MW solar-powered thermo-chemical air separation system combined with an oxy-fuel power plant for bio-energy with carbon capture and storage (BECCS)

The combination of concentrated solar power–chemical looping air separation (CSP-CLAS) with an oxy-fuel combustion process for carbon dioxide (CO₂) capture is a novel system to generate electricity from solar power and biomass while being able to store solar power efficiently. In this study, the computer program Advanced System for Process Engineering Plus (ASPEN Plus) was used to develop models to assess the process performance of such a process with manganese (Mn)-based oxygen carriers on alumina (Al₂O₃) support for a location in the region of Seville in Spain, using real solar beam irradiance and electricity demand data. It was shown that the utilisation of olive tree prunings (Olea europaea) as the fuel—an agricultural residue produced locally—results in negative CO₂ emissions (a net removal of CO₂ from the atmosphere). Furthermore, it was found that the process with an annual average electricity output of 18 MW would utilise 2.43% of Andalusia’s olive tree prunings, thereby capturing 260.5 k-tonnes of CO₂, annually. Drawbacks of the system are its relatively high complexity, a significant energy penalty in the CLAS process associated with the steam requirements for the loop-seal fluidisation, and the gas storage requirements. Nevertheless, the utilisation of agricultural residues is highly promising, and given the large quantities produced globally (~?4 billion tonnes/year), it is suggested that other novel processes tailored to these fuels should be investigated, under consideration of a future price on CO₂ emissions, integration potential with a likely electricity grid system, and based on the local conditions and real data.