Zinc and cadmium accumulation and tolerance in populations of Sedum alfredii

To investigate the variation of Zn and Cd accumulation and tolerance of Sedum alfredii (a newly reported Zn/Cd hyperaccumulator), field surveys and hydroponic experiments were conducted among three populations of this species: two originating from old Pb/Zn mines in Zhejiang (ZJ) and Hunan (HN) Provinces and one from a "clean" site in Guangdong (GD) Province, China. Under field conditions, up to 12,524 and 12,253 mg kg(-1) Zn, and 1400 and 97 mg kg(-1) Cd in shoots of ZJ and HN plants were recorded respectively. Under hydroponic conditions, ZJ and HN plants accumulated significantly higher Zn and Cd in their leaves and stems, and possessed significantly higher Zn and Cd tolerance than GD plants. Among the two contaminated populations, ZJ plants showed higher Cd tolerance and accumulation (in leaves) than HN plants. The present results indicate that significant differences in Zn and Cd accumulation and tolerance exist in populations of S. alfredii.     

A batch study on the bio-fixation of carbon dioxide in the absorbed solution from a chemical wet scrubber by hot spring and marine algae

Carbon dioxide mass transfer is a key factor in cultivating micro-algae except for the light limitation of photosynthesis. It is a novel idea to enhance mass transfer with the cyclic procedure of absorbing CO(2) with a high performance alkaline abosorber such as a packed tower and regenerating the alkaline solution with algal photosynthesis. Hence, the algae with high affinity for alkaline condition must be purified. In this study, a hot spring alga (HSA) was purified from an alkaline hot spring (pH 9.3, 62 degrees C) in Taiwan and grows well over pH 11.5 and 50 degrees C. For performance of HSA, CO(2) removal efficiencies in the packed tower increase about 5-fold in a suitable growth condition compared to that without adding any potassium hydroxide. But ammonia solution was not a good choice for this system with regard to carbon dioxide removal efficiency because of its toxicity on HSA. In addition, HSA also exhibits a high growth rate under the controlled pHs from 7 to 11. Besides, a well mass balance of carbon and nitrogen made sure that less other byproducts formed in the procedure of carboxylation. For analysis of some metals in HSA, such as Mg, Mn, Fe, Zn, related to the photosynthesis increased by a rising cultivated pH and revealed that those metals might be accumulated under alkaline conditions but the growth rate was still limited by the ratio of bicarbonate (useful carbon source) and carbonate. Meanwhile, Nannochlopsis oculta (NAO) was also tested under different additional carbon sources. The results revealed that solutions of sodium/potassium carbonate are better carbon sources than ammonia carbonate/bicarbonate for the growth of NAO. However, pH 9.6 of growth limitation based on sodium was lower than one of HSA. The integrated system is, therefore, more feasible to treat CO(2) in the flue gases using the algae with higher alkaline affinity such as HSA in small volume bioreactors.     

Microbial degradation and impact of Bracken toxin ptaquiloside on microbial communities in soil

The carcinogenic and toxic ptaquiloside (PTA) is a major secondary metabolite in Bracken fern (Pteridium aquilinum (L.) Kuhn) and was hypothesized to influence microbial communities in soil below Bracken stands. Soil and Bracken tissue were sampled at field sites in Denmark (DK) and New Zealand (NZ). PTA contents of 2.1 +/- 0.5 mg g(-1) and 37.0 +/- 8.7 mg g(-1) tissue were measured in Bracken fronds from DK and NZ, respectively. In the two soils the PTA levels were similar (0-5 microg g(-1) soil); a decrease with depth could be discerned in the deeper B and C horizons of the DK soil (weak acid sandy Spodosol), but not in the NZ soil (weak acid loamy Entisol). In the DK soil PTA turnover was predominantly due to microbial degradation (biodegradation); chemical hydrolysis was occurring mainly in the uppermost A horizon where pH was very low (3.4). Microbial activity (basal respiration) and growth ([3H]leucine incorporation assay) increased after PTA exposure, indicating that the Bracken toxin served as a C substrate for the organotrophic microorganisms. On the other hand, there was no apparent impact of PTA on community size as measured by substrate-induced respiration or composition as indicated by community-level physiological profiles. Our results demonstrate that PTA stimulates microbial activity and that microorganisms play a predominant role for rapid PTA degradation in Bracken-impacted soils.     

Perfluorinated compounds in the Pearl River and Yangtze River of China

A total of 14 perfluorinated compounds (PFCs) were quantified in river water samples collected from tributaries of the Pearl River (Guangzhou Province, south China) and the Yangtze River (central China). Among the PFCs analyzed, perfluorooctane sulfonate (PFOS) and perfluorooctanoic acid (PFOA) were the two compounds with the highest concentrations. PFOS concentrations ranged from 0.90 to 99 ng/l and <0.01–14 ng/l in samples from the Pearl River and Yangtze River, respectively; whereas those for PFOA ranged from 0.85 to 13 ng/l and 2.0–260 ng/l. Lower concentrations were measured for perfluorobutane sulfonate (PFBS), perfluorohexane sulfonate (PFHxS), perfluorooctanesulfoamide (PFOSA), perfluorohexanoic acid (PFHxA), perfluoroheptanoic acid (PFHpA), perfluorononaoic acid (PFNA), perfluorodecanoic acid (PFDA), and perfluoroundecanoic acid (PFUnDA). Concentrations of several perfluorocarboxylic acids, including perfluorododecanoic acid (PFDoDA), perfluorotetradecanoic acid (PFTeDA), perfluorohexadecanoic acid (PFHxDA) and perfluorooctadecanoic acid (PFOcDA) were lower than the limits of quantification in all the samples analyzed. The highest concentrations of most PFCs were observed in water samples from the Yangtze River near Shanghai, the major industrial and financial centre in China. In addition, sampling locations in the lower reaches of the Yangtze River with a reduced flow rate might serve as a final sink for contaminants from the upstream river runoffs. Generally, PFOS was the dominant PFC found in samples from the Pearl River, while PFOA was the predominant PFC in water from the Yangtze River. Specifically, a considerable amount of PFBS (22.9–26.1% of total PFC analyzed) was measured in water collected near Nanjing, which indicates the presence of potential sources of PFBS in this part of China. Completely different PFC composition profiles were observed for samples from the Pearl River and the Yangtze River. This indicates the presence of dissimilar sources in these two regions.     

Bioremediation of kerosene I: A case study in liquid media

The ability of different local isolates in addition to some isolates from Germany to degrade kerosene in liquid medium was studied. The results showed that the percent of kerosene degradation varied among the different organisms and that 59–94% of kerosene was degraded after 21 d. Two local isolates (Pseudomonas sp. AP and Pseudomonas sp. CK) and one German isolate (Gordonia sp. DM) were selected for this study. The addition of wheat bran, as co-substrate, stimulated the kerosene degradation by the two local strains, while glucose inhibited the degradation rate using the three organisms with different rates. Ammonium nitrate and urea was the best nitrogen sources. The use of superphosphate (as phosphorus source) in the presence of urea stimulates the degradation rate. It was also observed that the addition of 1% surfactants, like Triton X-100, Igepal, Tergitol, or Tween 20 and 80 enhanced the kerosene degradation. The degradation percent lied between 94% and 98%. The ability of the tested organisms to degrade kerosene concentration from 2% to 8% was evaluated. It was found that the three organisms degraded about 65–85% from 8% kerosene after 21 d. The use of rice straw-immobilized cells reduced the time of degradation and enhanced the degradation ability of the organisms. The sodium dodecyl sulphate-polyacrylamide gel electrophoresis revealed the presence of a common protein band when the tested organisms were grown on kerosene.     

Effect of Fe (III) on acid degradation of methylparathion

A study was undertaken to determine the transformation kinetic of methylparathion (O, O, -dimethyl O-4 nitrophenylphosphorotioate) in the presence of Fe(III) between pH 2 and 7. The Fe(III) was not electroactive under the conditions used in this study, and polarographic signals were exhibited by methylparathion and main degradation product only. Data suggest that hydrolysis of methylparathion in an acid medium is catalyzed by Fe(III) and the pesticide did not degrade in this medium without this cation. Methylparathion degradation was observed at all the pHs studied and was independent of the predominant chemical form of Fe(III) in the aqueous medium. The reaction was first-order with pH-dependent rate constant (k) values ranging from 3.3 x 10(- 3) h(- 1) to 7.0 x 10(- 3) h(- 1). The k values increased as pH decreased, suggesting that Fe(III) acted as an electrophile in the reaction mechanism.     

Application of activated sludge model no. 3 for the modeling of organic matter biodegradation at thermophilic temperatures.

The primary aim of our research was to investigate the applicability of activated sludge models (ASM) for aerobic thermophilic processes, especially autothermal thermophilic aerobic digestion (ATAD). The ASM3 model (Gujer et al., 1999) theoretically seems to be the most suitable, because storage plays an important role in a batch-feed cycle system like ATAD. The ASM3 model was extended with an activation step of the thermophilic organisms. This model was calibrated and verified by independent test results, demonstrating its ability to describe the process. The growth (microH = 26.04 day(-1)), storage (k(STO) = 20.39 day(-1)), hydrolysis (kH = 11.15 day(-1)) and decay rates (b 9H,O2) = 1.28 day(-1), b(STO,O2 = 1.10 day-1)) obtained from calibration are significantly higher at 55 degrees C than at mesophilic temperatures, justifying the faster metabolism at higher temperatures. An inert fraction of the biomass (characterized by the model parameter f(i) = 0.4) was found to be significantly greater than in the mesophilic case. This can be attributed to the lower diversity of the thermophilic species and thus to their narrower substrate spectra.     

Refinery evaluation of optical imaging to locate fugitive emissions

Fugitive emissions account for approximately 50% of total hydrocarbon emissions from process plants. Federal and state regulations aiming at controlling these emissions require refineries and petrochemical plants in the United States to implement a Leak Detection and Repair Program (LDAR). The current regulatory work practice, U.S. Environment Protection Agency Method 21, requires designated components to be monitored individually at regular intervals. The annual costs of these LDAR programs in a typical refinery can exceed US$1,000,000. Previous studies have shown that a majority of controllable fugitive emissions come from a very small fraction of components. The Smart LDAR program aims to find cost-effective methods to monitor and reduce emissions from these large leakers. Optical gas imaging has been identified as one such technology that can help achieve this objective. This paper discusses a refinery evaluation of an instrument based on backscatter absorption gas imaging technology. This portable camera allows an operator to scan components more quickly and image gas leaks in real time. During the evaluation, the instrument was able to identify leaking components that were the source of 97% of the total mass emissions from leaks detected. More than 27,000 components were monitored. This was achieved in far less time than it would have taken using Method 21. In addition, the instrument was able to find leaks from components that are not required to be monitored by the current LDAR regulations. The technology principles and the parameters that affect instrument performance are also discussed in the paper.     

Seasonal variations of hydrophobic organic contaminant concentrations in the water-column of the Seine Estuary and their transfer to a planktonic species Eurytemora affinis (Calanoïda, copepoda). Part 1: PCBs and PAHs

Hydrophobic organic contaminants (HOC) (i.e. PAHs and PCBs) were measured in the water column and in Eurytemora affinis samples from the Seine Estuary collected from November 2002 to February 2005. Results showed seasonal variations of both total PCB and PAH levels in the suspended particulate matter (SPM) and in the copepods with maximum levels during winter times. PAH and PCB concentrations in the SPM ranged from 499 to 5819ngg(-1) and from 58 to 463ngg(-1), respectively. Phenanthrene, pyrene and benzo[b+j+k]fluoranthene (B[b+j+k]F) were the predominant PAH compounds in the water column, while CB 101, 118, 153 and 138 were the most abundant PCB congeners. PCBs and PAHs bioaccumulated by E. affinis (EA) varied between 383 and 1785ngg(-1) and 165-3866ngg(-1). CB101, 153, 138 and B[b+j+k] were, respectively, the major compounds of PCB and PAH fingerprints in EA. Thereby, the copepods could reach high accumulation factor (ACF) (91000 for PCBs and 17000 for PAHs). The principal component analyses of contaminant concentrations and environmental parameter datasets distinguished two groups of copepods. The winter time cluster, with high percentage of adult copepods, which bioaccumulated the highest PCB and PAH body-burdens, and the second cluster with juveniles showing the lowest HOC concentrations. Thus, PAH and PCB concentrations in EA exhibited significant correlations with the percentage of adults making up the samples.     

Study of using microfiltration and reverse osmosis membrane technologies for reclaiming cooling water in the power industry.

A study of using dual membrane technologies, microfiltration (MF) and reverse osmosis (RO), for reclaiming blowdown of the cooling tower was conducted at ZJK power plant, Hebei province, China. The study shows that the combined MF-RO system can effectively reduce water consumption in the power industry. The results indicate that MF process is capable of producing a filtrate suitable for RO treatment and achieving a silt density index (SDI) less than 2, turbidity of 0.2 NTU. The water quality of RO effluent is very good with an average conductivity of about 40 micros/cm and rejection of 98%. The product water is suitable for injection into the cooling tower to counteract with cooling water intrusion. After adopting this system, water-saving effectiveness as expressed in terms of cycles of concentration could be increased from 2.5-2.8 times to 5 times.