Greenhouse gas dynamics in an urbanized river system: influence of water quality and land use

Environmental Science and Pollution Research - Rivers act as a natural source of greenhouse gases (GHGs). However, anthropogenic activities can largely alter the chemical composition and microbial...     

Impact of air pollution on outdoor cultural heritage objects and decoding the role of particulate matter: a critical review

Environmental Science and Pollution Research - Atmospheric gases and particulate matter (PM) in contact with the material’s surface lead to chemical and physical changes, which in most cases...     

Settling and dewatering characteristics of granulated methane-oxidizing bacteria

We evaluated the settling ability and dewaterability of granulated methane-oxidizing bacteria (GMOB) after granulation using a continuous-flow reactor. A comparative analysis on settling and dewatering characteristics due to changes in sludge retention time (SRT, 10, 15 and 20 days) during cultivation of GMOB was conducted. In assessing dewaterability, the specific resistance to filtration (SRF) of activated sludge and GMOB was found to be 8.21×1013-2.38×1014 and 4.88 × 1012-1.98×1013 m/kg, respectively. It was confirmed that as SRT decreased, SRF of GMOB increased. In the case of bound extracellular polymeric substance (EPS), activated sludge registered 147.5 mg/g-VSS while GMOB exhibited 171-177.2 mg/g-VSS. In the case of extracellular polymeric substance soluble EPS in effluent, activated sludge measured 62 mg/L and GMOB had 17.4-21.4 mg/L. The particle size analysis showed that mean particle diameters of GMOB were 402, 369, and 350 μm, respectively, at SRTs of 20, 15 and 10 days. In addition, it was found that GMOB had a larger mean particle diameter and exhibited much better settleability and dewaterability than activated sludge did.     

Effects of NO2 and SO2 on selective catalytic reduction of nitrogen oxides by ammonia

The selective catalytic reduction (SCR) characteristics of NO and NO(2) over V(2)O(5)-WO(3)-MnO(2)/TiO(2) catalyst using ammonia as a reducing agent have been determined in a fixed-bed reactor at 200-400 degrees C. The presence of NO(2) enhances the SCR activity at lower temperatures and the optimum ratio of NO(2)/NO(x) is found to be 0.5. During the SCR reactions, there are some side reactions occurred such as ammonia oxidation and N(2)O formation. At higher temperatures, the selective catalytic oxidation of ammonia and the nitrous oxide formation compete with the SCR reactions. The denitrification (DeNO(x)) conversion decreases at lower temperatures but it increases at higher temperatures with increasing SO(2) concentration. The presence of SO(2) in the feeds inhibits N(2)O formation.     

Biodegradation rates of 2-methylisoborneol (MIB) and geosmin through sand filters and in bioreactors

Taste and odour (T&O) causing compounds, in particular, 2-methylisoborneol (MIB) and geosmin, are a problem for water authorities as they are recalcitrant to conventional water treatment. In this study, biological sand filtration was shown to be an effective process for the complete removal of MIB and geosmin, with removal shown to be predominantly through biodegradation. In addition, MIB and geosmin were also effectively degraded in batch bioreactor experiments using biofilm sourced from one of the sand filters as the microbial inoculum. The biodegradation of MIB and geosmin was determined to be a pseudo-first-order reaction with rate constants ranging between 0.10 and 0.58 d⁻¹ in the bioreactor experiments. Rate constants were shown to be dependent upon the initial concentration of the microbial inoculum but not the initial concentration of MIB and geosmin when target concentrations of 200 and 50 ng l⁻¹ were used. Furthermore, rate constants were shown to increase upon re-exposure of the biofilm to both T&O compounds. Enrichment cultures with subsequent community profile analysis using 16S rRNA-directed PCR-DGGE identified four bacteria most likely involved in the biodegradation of geosmin within the sand filters and bioreactors. These included a Pseudomonas sp., Alphaproteobacterium, Sphingomonas sp. and an Acidobacteriaceae member.     

Fatty acid fouling of forward osmosis membrane: Effects of pH, calcium, membrane orientation, initial permeate flux and foulant composition

Octanoic acid (OA) was selected to represent fatty acids in effluent organic matter (EOM). The effects of feed solution (FS) properties, membrane orientation and initial permeate flux on OA fouling in forward osmosis (FO) were investigated. The undissociated OA formed a cake layer quickly and caused the water flux to decline significantly in the initial 0.5 hr at unadjusted pH 3.56; while the fully dissociated OA behaved as an anionic surfactant and promoted the water permeation at an elevated pH of 9.00. Moreover, except at the initial stage, the sudden decline of water flux (meaning the occurrence of severe membrane fouling) occurred in two conditions: 1. 0.5 mmol/L Ca^2 +, active layer facing draw solution (AL-DS) and 1.5 mol/L NaCl (DS); 2. No Ca^2 +, active layer-facing FS (AL-FS) and 4 mol/L NaCl (DS). This demonstrated that cake layer compaction or pore blocking occurred only when enough foulants were absorbed into the membrane surface, and the water permeation was high enough to compact the deposit inside the porous substrate. Furthermore, bovine serum albumin (BSA) was selected as a co-foulant. The water flux of both co-foulants was between the fluxes obtained separately for the two foulants at pH 3.56, and larger than the two values at pH 9.00. This manifested that, at pH 3.56, BSA alleviated the effect of the cake layer caused by OA, and OA enhanced BSA fouling simultaneously; while at pH 9.00, the mutual effects of OA and BSA eased the membrane fouling.     

Construction and comparison of fluorescence and bioluminescence bacterial biosensors for the detection of bioavailable toluene and related compounds

Environmental pollution with petroleum products such as benzene, toluene, ethylbenzene, and xylenes (BTEX) has garnered increasing awareness because of its serious consequences for human health and the environment. We have constructed toluene bacterial biosensors comprised of two reporter genes, gfp and luxCDABE, characterized by green fluorescence and luminescence, respectively, and compared their abilities to detect bioavailable toluene and related compounds. The bacterial luminescence biosensor allowed faster and more-sensitive detection of toluene; the fluorescence biosensor strain was much more stable and thus more applicable for long-term exposure. Both luminescence and fluorescence biosensors were field-tested to measure the relative bioavailability of BTEX in contaminated groundwater and soil samples. The estimated BTEX concentrations determined by the luminescence and fluorescence bacterial biosensors were closely comparable to each other. Our results demonstrate that both bacterial luminescence and fluorescence biosensors are useful in determining the presence and the bioavailable fractions of BTEX in the environment.     

New methods of life expectancy estimation

Environmental and Ecological Statistics - Two novel methods of life expectancy estimation, applied to various annual reported demographic datasets, are proposed. First, for datasets that fully...     

Adsorptive removal of pollutants from water using magnesium ferrite nanoadsorbent: a promising future material for water purification

Environmental Science and Pollution Research - Nanoadsorbents having large specific surface area, high pore volume with tunable pore size, affordability and easy magnetic separation gained much...     

Health effects of PM2.5 constituents and source contributions in major metropolitan cities,South Korea

Ambient PM_2.5 is one of the major risk factors for human health, and is not fully explained solely by mass concentration. We examined the short-term associations of cause-specific mortality (i.e., all-cause, cardiovascular, and respiratory mortality) with the 15 chemical constituents and sources of PM_2.5 in four metropolitan cities of South Korea during 2014–2018. We found transition metals consistently showed significant associations with all-cause mortality, while the effects of other constituents varied across the cities and for cause of death. Carbonaceous components strongly affected the all-cause, cardiovascular, and respiratory mortality in Daejeon. Secondary inorganic aerosols, SO₄^2? and NH₄⁺, showed significant associations with respiratory mortality in Gwangju. We also found the sources from which species closely linked to mortality generally increased the relative mortality risks. Heavy metal markers from soil or industrial sources were significantly associated with mortality in all cities. However, several sources influenced mortality despite their marker species not being significantly associated with it. Secondary nitrate and secondary sulfate sources were linked to mortality in DJ. This could be attributed to the deep inland location, which might have facilitated formation of secondary inorganic aerosols. In addition, primary sources including mobile and coal combustion seemed to have acute impacts on respiratory mortality in Gwangju. Our findings suggest the necessity of positive matrix factorization (PMF)-based approaches for evaluating health effects of PM_2.5 while considering the spatial heterogeneity in the compositions and source contributions of PM_2.5.