Emission characteristics of granulated fuel produced from sewage sludge and coal slime

The neutralization of wastewater treatment residues is an issue for many countries. The European Union (EU) legal regulations have limited the use of the residues in agriculture and implemented a ban for their disposal. Therefore, urgent action should be taken to find solutions for the safe disposal of sewage sludge. The problem refers in particular to the new EU member countries, including Poland, where one can now observe an intensive development of sewage system networks and new sewage treatment plants. At the same time, these countries have few installations for thermal sewage sludge utilization (e.g., there is only one installation of that type in Poland). Simultaneously, there are many coal-fired mechanical stoker-fired boilers in some of these countries. This paper presents suggestions for the production of granulated fuel from sewage sludge and coal slime. Additionally, among others, lime was added to the fuel to decrease the sulfur compounds emission. Results are presented of research on fuel with two average grain diameters (approximately 15 and 35 mm). The fuel with such diameters is adapted to the requirements of the combustion process taking place in a stoker-fired boiler. The research was aimed at identifying the behavior of the burning fuel, with special attention paid to its emission properties (e.g., to the emissions of oxides of nitrogen [NO(x)], sulfur dioxide [SO2], and carbon monoxide [CO], among others). The concentration and emission values were compared with similar results obtained while burning hard coal. The combustion process was carried out in a laboratory stand where realization of the large-scale tests is possible. The laboratory stand used made simulation possible for a wide range of burning processes in mechanical stoker-fired boilers.     

Carbon dioxide and methane fluxes in the littoral zones of two lakes,east Antarctica

During the summertime of 2007/2008, carbon dioxide (CO₂) and methane (CH₄) fluxes across air–water interface were investigated in the littoral zones of Lake Mochou and Lake Tuanjie, east Antarctica, using a static chamber technique. The mean fluxes of CO₂ and CH₄ were ?70.8 mgCO₂ m^?2 h^?1 and 144.6 μgCH₄ m^?2 h^?1, respectively, in the littoral zone of Lake Mochou; The mean fluxes were ?36.9 mgCO₂ m^?2 h^?1 and 109.8 μgCH₄ m^?2 h^?1, respectively, in the littoral zone of Lake Tuanjie. Their fluxes showed large temporal and spatial dynamics. The CO₂ fluxes showed a significantly negative correlation with daily total radiation (DTR) and a weakly negative correlation with air temperature and water temperature, indicating that sunlight intensity controlled the magnitude of CO₂ fluxes from the open lakes. The CH₄ fluxes significantly correlated with local air temperature, water table and total dissolved solids (TDS), indicating that they were the predominant factors influencing CH₄ fluxes. Summertime CO₂ budgets in the littoral zones of Lake Mochou and Lake Tuanjie were estimated to be ?152.9 gCO₂ m^?2 and ?79.7 gCO₂ m^?2, respectively, and net CH₄ emissions were estimated to be 312.3 mgCH₄ m^?2 and 237.2 mgCH₄ m^?2, respectively. Our results show that shallow, open, alga-rich lakes might be strong summertime CO₂ absorbers and small CH₄ emitters during the open water in coastal Antarctica.     

Atmospheric deposition of phthalate esters in a subtropical city

In Chinese cities, air pollution has become a serious and aggravating environmental problem undermining the sustainability of urban ecosystems and the quality of urban life. Bulk atmospheric deposition samples were collected two-weekly, from February 2007 to January 2008, at three representative areas, one suburban and two urbanized, in the subtropical city, Guangzhou, China, to assess the deposition fluxes and seasonal variations of phthalate esters (PAEs). Sixteen PAE congeners in bulk deposition samples were measured and the depositional fluxes of ∑₁₆PAEs ranged from 3.41 to 190 μg m^?2 day^?1, and were highly affected by local anthropogenic activities. The significant relationship between PAEs and particulate depositional fluxes (correlation coefficient R² = 0.72, P < 0.001) showed PAEs are associated primarily with particles. Temporal flux variations of PAEs were influenced by seasonal changes in meteorological parameters, and the deposition fluxes of PAEs were obviously higher in wet season than in dry season. Diisobutyl phthalate (DiBP), Di-n-butyl phthalate (DnBP), and Di(2-ethylhexyl) phthalate (DEHP) dominated the PAE pattern in bulk depositions, which is consistent with a high consumption of the plasticizer market in China. PAE profiles in bulk deposition showed similarities exhibited in both time and space, and a weak increase of high molecular weight PAE (HMW PAE) contribution in the wet season compared to those in the dry season. Average atmospheric deposition fluxes of PAEs in the present study were significantly higher than those from other studies, reflecting strong anthropogenic inputs as a consequence of rapid industrial and urban development in the region.     

Using Si depletion in aerosol to identify the sources of crustal dust in two Chinese megacities

Depletion of Si in transported dust has been recognized for many years. It can be used to distinguish between transported and local dust in cities, although it rarely has been. Here we use the variations of the Si/Al ratio in 15 months of continuous PM_2.5 samples at Beijing (northern China) and Chongqing (southwestern China) to reveal the seasonal patterns of their dust sources. For both cities, peaks of concentration for Si and Al in PM_2.5 corresponded with minima of Si/Al, and could often be linked to pulsed air flow from deserts to the northwest. With significant depletion (up to 80%) and homogeneous distribution at urban and rural sites, Si/Al showed a clear seasonal evolution, which decreased from spring to summer, increased from fall to winter, and collapsed during Chinese Spring Festival, indicating the dominance of transported dust, local fugitive dust and firework influence, respectively. The low ratios implied that desert dust is a common source during spring at Chongqing, whereas its presence during cold season at Beijing was also more frequent than expected. Failing to recognize the depletion of Si may lead to an overestimate of desert dust by 15%–65% when using the average abundance of Al in crust (6%–8%), as in previous studies. The difference in Si/Al ratio between local and transported dust implies that >60% of the dust at Beijing came from outside the city during the springs of 2004–2006. This result can help resolve the contradictory findings on this topic that have been presented earlier.     

Prediction of the adsorption capability onto activated carbon of a large data set of chemicals by local lazy regression method

Accurate quantitative structure–property relationship (QSPR) models based on a large data set containing a total of 3483 organic compounds were developed to predict chemicals’ adsorption capability onto activated carbon in gas phrase. Both global multiple linear regression (MLR) method and local lazy regression (LLR) method were used to develop QSPR models. The results proved that LLR has prediction accuracy 10% higher than that of MLR model. By applying LLR method we can predict the test set (787 compounds) with Q²_ext of 0.900 and root mean square error (RMSE) of 0.129. The accurate model based on this large data set could be useful to predict adsorption property of new compounds since such model covers a highly diverse structural space.     

Degradation kinetics of anthracene by ozone on mineral oxides

To further understand the role of substrates on the heterogeneous reactions of polycyclic aromatic hydrocarbons, the reactions of ozone with anthracene adsorbed on different mineral oxides (SiO₂, α-Al₂O₃ and α-Fe₂O₃) and on Teflon disc were investigated in dark at 20 °C. No reaction between ozone and anthracene on Teflon disc was observed when the ozone concentration was ～1.18 × 10¹⁴ molecules cm^?3. The reactions on mineral oxides exhibited pseudo-first-order kinetics for anthracene loss, and the pseudo-first-order rate constant (k_1,obs) displayed a Langmuir–Hinshelwood dependence on the gas-phase ozone concentration. The adsorption equilibrium constants for ozone (K_O3) on SiO₂-1, SiO₂-2, α-Al₂O₃ and α-Fe₂O₃ were (0.81 ± 0.26) × 10^?15 cm³, (2.83 ± 1.17) × 10^?15 cm³, (2.48 ± 0.77) × 10^?15 cm³ and (1.66 ± 0.45) × 10^?15 cm³, respectively; and the maximum pseudo-first-order rate constant (k_1,max) on these oxides were (0.385 ± 0.058) s^?1, (0.101 ± 0.0138) s^?1, (0.0676 ± 0.0086) s^?1 and (0.0457 ± 0.004) s^?1, respectively. Anthraquinone was identified as the main surface product of anthracene reacted with ozone. Comparison with previous research and the results obtained in this study suggest that the reactivity of anthracene with ozone and the lifetimes of anthracene adsorbed on mineral dust in the atmosphere are determined by the nature of the substrate.     

O3/BAF工艺系统中有机物生物降解数学模型

研究臭氧预氧化/曝气生物滤池（O₃/BAF）联合工艺深度处理实际城市污水二级出水过程中,后续BAF系统中有机物的生物降解数学模型。以有机底物浓度、填料层高度两个基本变量为控制条件,研究BAF的总体运行常数和填料特性常数,得出BAF有机物生物降解动力学方程为S_e/S₀=exp(－Kh/qSⁿ₀)。出水与进水COD浓度比值（S_e/S₀）的对数与反应器填料高度（h）之间可表达成一次函数关系。在不同的进水浓度（S₀）下,根据ln（S_e/S₀）~h和关系式m=K/qSⁿ₀,得到方程ln(q_m)=－nln(S₀)+lnK。BAF总体运行常数K和填料特性常数n分别为1.708和0.5063。该模型对BAF工艺有如下指导意义：可以根据设计流量、进水有机物浓度和出水浓度,初步确定BAF的尺寸（如横截面积、高度等）。     

pH对煤泥水絮凝沉降的影响

选择聚合氯化铝(PAC)/阴离子型聚丙烯酰胺(PHP)、氯化钙(CaCl2)/非离子型聚丙烯酰胺(NPAM)组合与NPAM、PHP、两性离子型聚丙烯酰胺(ZPAM)作为絮凝剂,在对道清选煤厂水采筛下原生煤泥和浮选尾矿的煤泥水进行组合药剂絮凝实验的基础上,考察了pH对煤泥水絮凝沉降的影响。实验结果表明,在不同的pH下,煤泥水的絮凝效果不同:在酸性条件下,宜单独使用有机高分子絮凝剂;在中性至碱性条件下,无机凝聚剂和有机絮凝剂联合使用效果较好。     

非水相硝基苯在含水层中的迁移释放规律

通过室内模拟实验,探讨了在非水相硝基苯污染含水层的条件下,其在含水层中的迁移及释放规律。迁移规律表明,非水相硝基苯并非在含水层中直接进行垂向迁移,而是一方面在自身重力作用下向含水层下部迁移,另一方面在地下水流的作用下随地下水同向运移,整体表现为随地下水流的侧向运移,并最终迁移至含水层底部。释放规律表明,非水相硝基苯在含水层迁移的过程中会向地下水大量释放,释放出的硝基苯在水流的作用下随地下水同向运移,污染源及迁移至含水层底部的非水相硝基苯均存在再次释放。     

氧化镁烟气脱硫反应特性研究

利用实验室规模的鼓泡式反应装置,对比了碳酸钙、氧化镁和氧化镁/硫酸镁脱硫剂的反应活性,证实脱硫液中高浓度硫酸镁的存在是保证镁法脱硫效率高于钙法的重要因素,并考察了硫酸镁浓度、脱硫剂(氧化镁)浓度、烟气量、SO2浓度和吸收液温度等因素对脱硫效率的影响。结果表明,脱硫反应可以根据pH分为2个不同阶段;反应过程中脱硫效率随着硫酸镁浓度的增加而显著升高;烟气量增加将会导致脱硫效率有所下降;入口SO2浓度升高,脱硫效率下降;氧化镁浓度、温度对脱硫效率影响不显著。结合实验现象进行推断,氧化镁脱硫的反应过程受SO2在气液两相界面的传质扩散和其水解产物在液相的扩散控制。