Impact of Polycyclic Aromatic Hydrocarbon Emissions from Medical Waste Incinerators on the Urban Atmosphere

Abstract

In this study, polycyclic aromatic hydrocarbon (PAH) emissions from two batch-type medical waste incinerators (MWIs), one with a mechanical grate and the other with a fixed grate, both operated by a medical center, were assessed. Both MWIs shared the same air-pollution control devices (APCDs), with an electrostatic precipitator and a wet scrubber installed in series. Results show that when APCDs were used, total PAHs and total benzo- [a]pyrene equivalent (total BaP_eq) emission concentrations of both MWIs were reduced from 2220 to 1870 µg/m³ and 50 to 12.4 µg/m³, respectively. We used the Industrial Source Complex Short Term model (ISCST) to estimate the ground-level concentrations of the residential area and the traffic intersection located at the down-wind side of the two MWIs. For the traffic intersection, we found both total PAHs and total BaP_eq transported from MWIs to both studied areas were not significant. For the residential area, similar results were found when APCDs were used in MWIs. When APCDs were not included, we found that total PAHs transported from MWIs accounted for <12%, but total BaP_eq accounted for >90%, of the on-site measured concentrations. These results suggest that the use of proper APCDs during incineration would significantly reduce the carcinogenic potencies associated with PAH emissions from MWIs to the residential area.     

Influence of water quality parameters on occurrence of polybrominated diphenyl ether in sediment and sediment to biota accumulation

Polybrominated diphenyl ether (PBDE) concentrations in sediment and fish from 12 principal rivers in Taiwan were investigated to determine their association with water quality parameters as well as the biota-sediment accumulation factor (BSAF) in fish with different living patterns. The highest PBDE concentration in sediment was found in the Bajhang River (261 ng g^?1 dry weight (d.w.)) and the lowest in the Beinan River and the Da-an River (0.17 ng g^?1 d.w.). The PBDE concentrations in fish samples ranged from 1.28 ng g^?1 d.w. (Oreochromis niloticus niloticus) in the Yanshuei River to 33.7 ng g^?1 d.w. (Varico rhinos barbatulus) in the Da-an River. We conclude that PBDEs contamination in sediment was significantly affected by NH₃–N, pH, and DO. The BSAF results showed a parabolic trend from low- to high-brominated BDEs. Fish easily accumulated the congeners BDE-47, -100, -119, -126, and -154 from sediment. The BSAF decreased in the following order: PeBDE > HxBDE > TeBDE > other BDEs. Principle component analysis showed that demersal fish have different PBDE sources than do pelagic fish. We conclude that living and feeding habits are critical factors affecting PBDE accumulation in fish.     

Assessing the potential exposure risk and control for airborne titanium dioxide and carbon black nanoparticles in the workplace

Purpose  

This study assessed the potential exposure risks for workers in the workplace exposed to airborne titanium dioxide nanoparticles (TiO₂-NPs) and carbon black nanoparticles (CB-NPs). The risk management control strategies were also developed for the NP engineering workplace.     

Detrital flows through the feeding pathway of the oyster (Crassostrea gigas) in a tropical shallow lagoon: δ13C signals

The spatial relationships and linkage of the detrital flows among the water column, the sediment and the oyster Crassostrea gigas cultured in the water column were examined by using stable carbon isotopes (δ¹³C) in a tropical shallow lagoon from October 1996 to June 1997. The lagoon is located in southwestern Taiwan and is isolated from the sea by sand barriers except at two tidal inlets. It receives freshwater mainly from two rivers. A total of 12 stations were set up along three transect lines, each running across the lagoon from riverine to tidal inlet localities. The δ¹³C values of the water-column POM exhibited a marked sea–river gradient, with values depleted from a high of −21.7‰ at seaward stations to a low of −28.2‰ at riverine stations; those in the sedimentary POM (<62 μm grain size) also revealed this trend, but to a lesser extent. Oysters of two known ages, 6 months old (“old oysters”) and newly settled individuals (“young oysters”), were transplanted from one station to each of the remaining stations, while some were left at the original station. Values of δ¹³C in the muscle of transplanted oysters changed in parallel with the sea–river gradient of δ¹³C in POM (decreasing from −16.0 to −18.5‰ in old oysters and from −16.8 to −21.9‰ in young ones). The spatial sea–river gradient of the oyster's δ¹³C is related not only to the distance between the site that the oyster inhabits and sea or riverine environment, but also to the tidal flow pattern that surrounds its feeding place. Although the δ¹³C value of the sedimentary POM was correlated with that of the water-column POM, the δ¹³C value of the oyster tissue was significantly correlated with that of the water-column POM, but not with that of the sedimentary POM. This suggests that the oyster feeds primarily on water-column rather than sedimentary POM. Received: 30 April 1999 / Accepted: 15 December 1999     

Relationships between pesticides and organic carbon fractions in sediments of the Danshui River estuary and adjacent coastal areas of Taiwan

In order to understand the fate of pesticides in marine environments, concentrations of pesticides and different carbonaceous fractions were determined for surface sediments in the Danshui River and nearby coastal areas of Taiwan. The major compounds detected were tetrachlorobenzene, HCHs, chlordane, aldrin, DDDs, DDEs and DDTs. Total concentrations of pesticides in the sediments ranged from not detectable to 23 ng g(-1), with the maximum value detected near the discharge point of the marine outfall from the Pali sewage treatment plant. These results confirm that pesticides persist in estuarine and nearby coastal environments of the Danshui River well after their ban. Concentrations of total pesticides significantly correlate with concentrations of total organic carbon and black carbon in these sediments, suggesting that total organic carbon and black carbon regulate the distribution of trace organic pollutants in fluvial and coastal marine sediments.     

Effects of CH4 and CO on the reduction of nitric oxide to nitrogen in a discharge reactor

Additives are often added to enhance the efficiency of NO removal. This study uses a radio frequency (rf) discharge to consider the effect of added CH4 and CO to simulated NO/N2/O2/H2O mixtures on the elevation of NO conversion and the reduction of NO into N2. The enhancement levels of NO conversion when using various additives were found to be in this order: +CH4 > +CO > no additive. NO conversion reached 99.3%, 86.2%, and 77.6% when adding CH4, CO, and without additive, respectively, at inlet additive/NO molar ratio (R) = 5 and at 120 W. Moreover, the fraction of total N atoms converted from NO into N2 (FN2) was very high, reaching 99.4% and 99.5% when adding CH4 and CO, respectively, at R = 1 and at 120 W. The better operating conditions are using CH4 as the additive at R > or = 1 and a power of > 60 W to reach a higher NO conversion with a higher FN2. However, it should be noted that this rf plasma approach is not practical at this stage because of its relative low pressure.     

Corrosion control when using passively treated abandoned mine drainage as alternative makeup water for cooling systems

Passively treated abandoned mine drainage (AMD) is a promising alternative to fresh water as power plant cooling water system makeup water in mining regions where such water is abundant. Passive treatment and reuse of AMD can avoid the contamination of surface water caused by discharge of abandoned mine water, which typically is acidic and contains high concentrations of metals, especially iron. The purpose of this study was to evaluate the feasibility of reusing passively treated AMD in cooling systems with respect to corrosion control through laboratory experiments and pilot-scale field testing. The results showed that, with the addition of the inhibitor mixture orthophosphate and tolyltriazole, mild steel and copper corrosion rates were reduced to acceptable levels (< 0.127 mm/y and < 0.0076 mm/y, respectively). Aluminum had pitting corrosion problems in every condition tested, while cupronickel showed that, even in the absence of any inhibitor and in the presence of the biocide monochloramine, its corrosion rate was still very low (0.018 mm/y).     

A long-term survey on anthropogenic impacts to the water quality of coral reefs, southern Taiwan

Before 2001, the ecological protection area in the Kenting National Park (KTNP), southern Taiwan, was poorly described. In this study, a set of four-year data (2001-2004) of seawater qualities at 19 sampling sites around the Nanwan Bay in the KTNP was used to explore anthropogenic impacts to ecological environment, especially coral reefs. The parameters of water quality were analyzed immediately after collection. The results showed that higher values of nutrients and suspended solids were attributed to the higher run-off around Nanwan Bay. The fluxes of nutrients and suspended solids were consistently correlated to rainfall. Hence, equations were developed to calculate nutrient fluxes and suspended solids by using only rainfall data. Our results show that suspended solids and ammonia were the dominant factors leading to the drop in coral coverage. In summary, the water quality in the intertidal zone of Nanwan Bay has been degraded and required greater attention.     

Thermal detoxification of hazardous metal sludge by applied electromagnetic energy

Industrial wastewater sludge was treated by microwave processes to enhance the stabilization of laden copper. The effects of additives, processing time, microwave adsorbents, moisture content, reaction atmosphere, and cooling gas were investigated. The stabilization results were significantly enhanced by metal powder additives, prolonged microwave processing time, proper moisture content, the addition of carbonaceous materials, and a reaction environment with inert gas. It was also found that the moisture content would increase the homogeneity of applied microwave energy, and thus achieve a better overall efficiency between stabilizing agents and copper. The added metal powders may reduce Cu(II) to Cu(0) in the sludge or TCLP. The resulting thermal energy of microwave radiation, and microarcing process and the oxidation heat of Al powder may also assist the transformation of Cu(II) into CuO and CuAl2O4 phases. Part of the sludge was vitrified within inert gas environment when the processing time was longer than 18 min and active carbon dosage was more than 3g. Reduction reactions also occurred in the hybrid microwave processes, leading to the reduction of sulfates and metal ions, and the formation of Cu2S and FeS. Moreover, the microwave radiation can also enhance the feasibility of co-treating of inorganic and organic solid waste.     

PAH emission from the incineration of three plastic wastes

A batch-type, controlled-air incinerator was used for the treatment of polyvinyl chloride (PVC), high-density polyethylene (HDPE), and polypropylene (PP) plastic wastes. The concentration and composition of 21 individual polycyclic aromatic hydrocarbons (PAHs) in the raw wastes, flue gas (gas and particle phases), and ash were determined. Stack flue-gas samples were collected by a PAH stack-sampling system. Twenty-one individual PAHs were analyzed primarily by a gas chromatograph/mass spectrometer (GC/MS). The CO concentration correlated well with the total PAH (R2 > .89), and thus can be used as a surrogate indicator for PAH emission. Excess amounts of air supply in the incineration of plastic wastes could decrease not only the concentration of the PAHs in the bottom ash but also the emission factor (EF) of the total PAH in the stack flue gas. Of the three plastic wastes, HDPE was found to have the highest mean EF of the total PAHs (462.3 mg/kg waste) from the stack flue gas. Incinerating PVC would result in a higher EF of PAHs (195.4 mg/kg waste) in the bottom ash. When PVC plastic wastes were incinerated, higher-ringed PAHs constituted a larger percentage in the bottom ash as compared to those from PP and HDPE plastics. By judging the output and input (O/I) ratio of the PAHs from the incineration trials of plastic wastes, the PAHs involved in incineration of three plastic wastes were almost entirely destroyed; and a low residual amount between 0.00018 and 0.00032 remained in the emission.