Interactions between soil texture and placement of dairy slurry application: II. Leaching of phosphorus forms

Managing phosphorus (P) losses in soil leachate folllowing land application of manure is key to curbing eutrophication in many regions. We compared P leaching from columns of variably textured, intact soils (20 cm diam., 20 cm high) subjected to surface application or injection of dairy cattle (Bos taurus L.) manure slurry. Surface application of slurry increased P leaching losses relative to baseline losses, but losses declined with increasing active flow volume. After elution of one pore volume, leaching averaged 0.54 kg P ha(-1) from the loam, 0.38 kg P ha(-1) from the sandy loam, and 0.22 kg P ha(-1) from the loamy sand following surface application. Injection decreased leaching of all P forms compared with surface application by an average of 0.26 kg P ha(-1) in loam and 0.23 kg P ha(-1) in sandy loam, but only by 0.03 kg P ha(-1) in loamy sand. Lower leaching losses were attributed to physical retention of particulate P and dissolved organic P, caused by placing slurry away from active flow paths in the fine-textured soil columns, as well as to chemical retention of dissolved inorganic P, caused by better contact between slurry P and soil adsorption sites. Dissolved organic P was less retained in soil after slurry application than other P forms. On these soils with low to intermediate P status, slurry injection lowered P leaching losses from clay-rich soil, but not from the sandy soils, highlighting the importance of soil texture in manageing P losses following slurry application.     

Interactions between soil texture and placement of dairy slurry application: I. Flow characteristics and leaching of nonreactive components

Land application of manure can exacerbate nutrient and contaminant transfers to the aquatic environment. This study examined the effect of injecting a dairy cattle (Bostaurus L.) manure slurry on mobilization and leaching of dissolved, nonreactive slurry components across a range of agricultural soils. We compared leaching of slurry-applied bromide through intact soil columns (20 cm diam., 20 cm high) of differing textures following surface application or injection of slurry. The volumetric fraction of soil pores >30 microm ranged from 43% in a loamy sand to 28% in a sandy loam and 15% in a loam-textured soil. Smaller active flow volumes and higher proportions of preferential flow were observed with increasing soil clay content. Injection of slurry in the loam soil significantly enhanced diffusion of applied bromide into the large fraction of small pores compared with surface application. The resulting physical protection against leaching of bromide was reflected by 60.2% of the bromide tracer was recovered in the effluent after injection, compared with 80.6% recovery after surface application. No effect of slurry injection was observed in the loamy sand and sandy loam soils. Our findings point to soil texture as an important factor influencing leaching of dissolved, nonreactive slurry components in soils amended with manure slurry.     

Accumulation of (137)Cs in Brazilian soils and its transfer to plants under different climatic conditions

The spatial distribution and behaviour of the global fallout (137)Cs in the tropical, subtropical and equatorial soil-plant systems were investigated at several upland sites in Brazil selected according to their climate characteristics, and to the agricultural importance. To determine the (137)Cs deposition density, undisturbed soil profiles were taken from 23 environments situated between the latitudes of 02 degrees N and 30 degrees S. Sampling sites located along to the equator exhibited (137)Cs deposition densities with an average value of 219Bqm(-2). Extremely low deposition densities of 1.3Bqm(-2) were found in the Amazon region. In contrast, the southern part of Brazil, located between latitudes of 20 degrees S and 34 degrees S, exhibited considerably higher deposition densities ranging from 140Bqm(-2) to 1620Bqm(-2). To examine the (137)Cs soil-to-plant transfer in the Brazilian agricultural products, 29 mainly tropical plant species, and corresponding soil samples were collected at 43 sampling locations in nine federal states of Brazil. Values of the (137)Cs concentration factor plant/soil exhibited a large range from 0.020 (beans) to 6.2 (cassava). Samples of some plant species originated from different collecting areas showed different concentration factors. The (137)Cs content of some plants collected was not measurable due to a very low (137)Cs concentration level found in the upper layers of the incremental soils. Globally, the soil-to-plant transfer of (137)Cs can be described by a logarithmic normal distribution with a geometric mean of 0.3 and a geometric standard deviation of 3.9.     

A novel, sexually selected trait in poeciliid fishes: female preference for mustache-like, rostral filaments in male Poecilia sphenops

Female choice can often drive the elaboration of male traits, leading to the evolution of secondary sexual traits. In the Mexican molly, Poecilia sphenops (Poeciliidae), some males exhibit a mustache-like structure on the upper maxilla, the function of which has not been previously recognized. The mustache consists of epidermal outgrowths at the edge of the scales that appear to have no sensory function. Trait expression varies within as well as among populations of P. sphenops, but is not linked to male body size polymorphism. In mate choice experiments, female P. sphenops exhibited a visual mating preference for males with mustaches, suggesting that the trait may be sexually selected. Since the mating behavior of P. sphenops involves contact of the male’s snout and the female genital region prior to copulation, we hypothesize that the mustache may also convey tactile signals to the female.     

Assessment of volatile organic compound removal by indoor plants—a novel experimental setup

Indoor plants can remove volatile organic compounds (VOCs) from the air. The majority of knowledge comes from laboratory studies where results cannot directly be transferred to real-life settings. The aim of this study was to develop an experimental test system to assess VOC removal by indoor plants which allows for an improved real-life simulation. Parameters such as relative humidity, air exchange rate and VOC concentration are controlled and can be varied to simulate different real-life settings. For example, toluene diffusion through a needle gave concentrations in the range of 0.10–2.35 μg/L with deviations from theoretical values of 3.2–10.5 %. Overall, the system proved to be functional for the assessment of VOC removal by indoor plants with Hedera helix reaching a toluene removal rate of up to 66.5 μg/m²/h. The mode of toluene exposure (semi-dynamic or dynamic) had a significant influence on the removal rate obtained by H. helix.     

Butyltin compounds in sediment and molluscs from the shipping strait between Denmark and Sweden

The distribution of tributyltin (TBT) contamination in the subtidal zone of the waters between Denmark and Sweden was investigated in relation to major international shipping lanes. Sediment and different benthic molluscs were sampled in transects along and perpendicularly to the shipping lanes in the Sound (?resund) and the Kattegat/Skagerrak region. The samples were analysed for TBT and its degradation products, dibutyltin (DBT) and monobutyltin (MBT), using GC-PFPD. In sediments, the TBT concentration ranged from <1 to 19 ng g(-1) dry weight (dw) with a strong correlation between the TBT concentration and the organic fraction in sediment (r(2)=0.90) in the samples collected in the Sound, where the highest concentrations were found. This relationship was not observed in the samples from the Kattegat because the TBT concentration in most sediment samples was below the limit of detection. In the molluscs, TBT and its degradation products were detected in all samples from the entire area with concentrations ranging from 8.1 ng g(-1) dw in Buccinum undatum to 1316 ng g(-1) dw in Nuculana pernula. The deposit-feeding bivalve N. pernula was found to have a particularly high accumulation potential for TBT. In addition, a strong correlation between TBT concentrations in sediment and N. pernula was found. Therefore this species seems to be an ideal organism for monitoring sediment contamination. The TBT concentration in N. pernula was found to decrease gradually along the shipping lanes from the Sound, through the Kattegat and into the Skagerrak.     

Pigeon homing: A repetition of the deflector loft experiment

Summary Pigeons brought up in closed cages deflecting the winds to the left or to the right show, on release, a bias of the mean vanishing directions to the left or right of the mean direction of untreated control birds. The results are in full accord with the findings of Baldaccini et al. (1975).Supported by the Deutsche Forschungsgemeinschaft     

Solute transport in crystalline rocks at Äspö — I: Geological basis and model calibration

Water-conducting faults and fractures were studied in the granite-hosted Äspö Hard Rock Laboratory (SE Sweden). On a scale of decametres and larger, steeply dipping faults dominate and contain a variety of different fault rocks (mylonites, cataclasites, fault gouges). On a smaller scale, somewhat less regular fracture patterns were found. Conceptual models of the fault and fracture geometries and of the properties of rock types adjacent to fractures were derived and used as input for the modelling of in situ dipole tracer tests that were conducted in the framework of the Tracer Retention Understanding Experiment (TRUE-1) on a scale of metres. After the identification of all relevant transport and retardation processes, blind predictions of the breakthroughs of conservative to moderately sorbing tracers were calculated and then compared with the experimental data. This paper provides the geological basis and model calibration, while the predictive and inverse modelling work is the topic of the companion paper [J. Contam. Hydrol. 61 (2003) 175].The TRUE-1 experimental volume is highly fractured and contains the same types of fault rocks and alterations as on the decametric scale. The experimental flow field was modelled on the basis of a 2D-streamtube formalism with an underlying homogeneous and isotropic transmissivity field. Tracer transport was modelled using the dual porosity medium approach, which is linked to the flow model by the flow porosity. Given the substantial pumping rates in the extraction borehole, the transport domain has a maximum width of a few centimetres only. It is concluded that both the uncertainty with regard to the length of individual fractures and the detailed geometry of the network along the flowpath between injection and extraction boreholes are not critical because flow is largely one-dimensional, whether through a single fracture or a network. Process identification and model calibration were based on a single uranine breakthrough (test PDT3), which clearly showed that matrix diffusion had to be included in the model even over the short experimental time scales, evidenced by a characteristic shape of the trailing edge of the breakthrough curve. Using the geological information and therefore considering limited matrix diffusion into a thin fault gouge horizon resulted in a good fit to the experiment. On the other hand, fresh granite was found not to interact noticeably with the tracers over the time scales of the experiments.While fracture-filling gouge materials are very efficient in retarding tracers over short periods of time (hours–days), their volume is very small and, with time progressing, retardation will be dominated by altered wall rock and, finally, by fresh granite. In such rocks, both porosity (and therefore the effective diffusion coefficient) and sorption K_ds are more than one order of magnitude smaller compared to fault gouge, thus indicating that long-term retardation is expected to occur but to be less pronounced.     

Comparative goal-oriented assessment of conventional and alternative sewage sludge treatment options

Phosphorous (P) is a limited and non-substitutable resource. Sewage sludge contains significant amounts of P and is therefore a widely applied fertilizer. Due to its organic and inorganic contaminants, sewage sludge is also combusted in industrial facilities as well as in waste incinerators. This study compares five common methods and one novel alternative based on a thermo-chemical process to treat and dispose of sewage sludge with regard to environmental impact, resource recovery, and materials dissipation. The comparison is based on material flow analysis, energy balances, selected LCA impact analysis, and statistical entropy analysis. This work shows that the novel technology combines both advantages of the established practices: organic and inorganic pollutants are either destroyed or removed from the P containing material, and the P returned to the soil exhibits high plant-availability. The novel method also has low emissions. The additional energy requirements should be reduced. However, with regards to sewage sludge P recovery is more important than energy recovery.