Investigations of ash fouling with cattle wastes as reburn fuel in a small-scale boiler burner under transient conditions

Fouling behavior under reburn conditions was investigated with cattle wastes (termed as feedlot biomass [FB]) and coal as reburn fuels under a transient condition and short-time operation. A small-scale (30 kW or 100,000 Btu/hr) boiler burner research facility was used for the reburn experiments. The fuels considered for these experiments were natural gas (NG) for the ashless case, pure coal, pure FB, and blends of coal and FB. Two parameters that were used to characterize the ash "fouling" were (1) the overall heat-transfer coefficient (OHTC) when burning NG and solid fuels as reburn fuels, and (2) the combustible loss through ash deposited on the surfaces of heat exchanger tubes and the bottom ash in the ash port. A new methodology is presented for determining ash-fouling behavior under transient conditions. Results on the OHTCs for solid reburn fuels are compared with the OHTCs for NG. It was found that the growth of the layer of ash depositions over longer periods typically lowers OHTC, and the increased concentration of ash in gas phase promotes radiation in high-temperature zones during initial periods while decreasing the heat transfer in low-temperature zones. The ash analyses indicated that the bottom ash in the ash port contained a smaller percentage of combustibles with a higher FB percentage in the fuels, indicating better performance compared with coal because small particles in FB burn faster and the FB has higher volatile matter on a dry ash-free basis promoting more burn out.     

Identification and interpretation of representative ozone distributions in association with the sea breeze from different synoptic winds over the coastal urban area in Korea

To aid the studies of long-term impact assessment of cumulative ozone (O3) exposures, the representative 8-hr O3 pollution patterns have been identified over the Greater Seoul Area (GSA) in Korea. Principal component analysis and two-stage clustering techniques were used to identify the representative O3 patterns, and numerical and observational analyses were also used to interpret the identified horizontal distribution patterns. The results yielded three major O3 distribution patterns, and each of the three patterns was found to have strong correlations with local and synoptic meteorological conditions over the GSA. For example, pattern 1, accounting for 46% of O3 concentration distributions, mostly occurred under relatively weak westerly synoptic winds. The predominant features of this pattern were infrequent high O3 levels but a distinct gradient of O3 concentration from the western coastal area to the eastern inland area that was mainly induced by the local sea breeze. Pattern 2, accounting for 31% of O3 concentration distributions, was found with higher O3 levels in the western coastal area but lower in the eastern inland area. This is due to the modified sea breeze under the relatively stronger easterly opposing synoptic wind, affecting the high O3 occurrence in the western coastal area only. However, pattern 3, accounting for 21% of O3 concentration distributions, showed significantly higher O3 concentrations over the whole GSA mainly due to the retarded and slow-moving sea-breeze front under the weak opposing synoptic flow. Modeling study also indicated that local and synoptic meteorological processes play a major role in determining the high O3 concentration distribution patterns over the GSA.     

Managing scuba divers to meet ecological goals for coral reef conservation

Marine protected areas increasingly are challenged to maintain or increase tourism benefits while adequately protecting resources. Although carrying capacity strategies can be used to cope with use-related impacts, there is little understanding of divers themselves, their management preferences, and how preferences relate to conservation goals. By using a stated preference choice modeling approach, we investigated the choices divers make in selecting diving trips to marine protected areas as defined by use level, access, level of supervision, fees, conservation education, and diving expectations. Logit models showed that divers preferred a more restrictive management scenario over the status quo. Divers favored reductions in the level of site use and increased levels of conservation education. Divers did not favor fees to access protected areas, having less access to the resource, or extensive supervision. Finally, divers were much more willing to accept increasingly restrictive management scenarios when they could expect to see increased marine life.     

Effect of amorphous silica and silica sand on removal of chromium(VI) by zero-valent iron

The effect of two surfaces (amorphous silica and silica sand) on the reduction of chromium(VI) by zero-valent iron (Fe(0)) was investigated using batch reactors. The amendment of both surfaces significantly increased the rate and extent of Cr(VI) removal. The rate enhancement by amended surfaces is presumed to result from scavenging of Fe(0)-Cr(VI) reaction products by the provided surfaces, which minimized surface deactivation of Fe(0). The rate enhancing effect was greater for silica compared to sand, and the difference is attributed to silica's higher surface area, greater affinity for reaction products and pH buffering effect. For a given mass of Fe(0), the reactivity and longevity of Fe(0) to treat Cr(VI) increased with increasing dose of silica. Elemental analyses of the reacted iron and silica revealed that chromium removed from the solution was associated with both surfaces, with its mass distribution being approximately 1:1 per mass of iron and silica. The overall result suggests reductive precipitation was a predominant Cr(VI) removal pathway, which involves initial reduction of Cr(VI) to Cr(III), followed by formation of Cr(III)/Fe(III) hydroxides precipitates.     

Inhibition of residual <Emphasis Type="Italic">n</Emphasis>-hexane in anaerobic digestion of lipid-extracted microalgal wastes and microbial community shift

Converting lipid-extracted microalgal wastes to methane (CH₄) via anaerobic digestion (AD) has the potential to make microalgae-based biodiesel platform more sustainable. However, it is apparent that remaining n-hexane (C₆H₁₄) from lipid extraction could inhibit metabolic pathway of methanogens. To test an inhibitory influence of residual n-hexane, this study conducted a series of batch AD by mixing lipid-extracted Chlorella vulgaris with a wide range of n-hexane concentration (～10 g chemical oxygen demand (COD)/L). Experimental results show that the inhibition of n-hexane on CH₄ yield was negligible up to 2 g COD/L and inhibition to methanogenesis became significant when it was higher than 4 g COD/L based on quantitative mass balance. Inhibition threshold was about 4 g COD/L of n-hexane. Analytical result of microbial community profile revealed that dominance of alkane-degrading sulfate-reducing bacteria (SRB) and syntrophic bacteria increased, while that of methanogens sharply dropped as n-hexane concentration increased. These findings offer a useful guideline of threshold n-hexane concentration and microbial community shift for the AD of lipid-extracted microalgal wastes.     

A comparative study on per capita waste generation according to a waste collecting system in Korea

As cities are becoming increasingly aware of problems related to conventional mobile collection systems, automated pipeline-based vacuum collection (AVAC) systems have been introduced in some densely populated urban areas. The reasons are that in addition to cost savings, AVAC systems can be efficient, hygienic, and environmentally friendly. Despite difficulties in making direct comparisons of municipal waste between a conventional mobile collection system and an AVAC system, it is meaningful to measure the quantities in each of these collection methods either in total or on a per capita generation of waste (PCGW, g/(day*capita)) basis. Thus, the aim of this study was to assess the difference in per capita generation of household waste according to the different waste collection methods in Korea. Observations on household waste show that there were considerable differences according to waste collection methods. The value of per capita generation of food waste (PCGF) indicates that a person in a city using AVAC produces 60 % of PCGF (109.58 g/(day*capita)), on average, compared with that of a truck system (173.10 g/(day*capita)) as well as 23 %p less moisture component than that with trucks. The value of per capita generation of general waste (PCGG) in a city with an AVAC system showed 147.73 g/(day*capita), which is 20 % less than that with trucks delivered (185 g/(day*capita)). However, general waste sampled from AVAC showed a 35 %p increased moisture content versus truck delivery.     

Properties of alkali-activated systems with stone powder sludge

This article investigates the effects of stone powder sludge on the microstructure and strength development of alkali-activated fly ash and blast furnace slag mixes. Stone powder sludge produced from a crushed aggregate factory was used to replace fly ash and granulated blast furnace slag at replacement ratios of 0%, 10%, 20%, and 30% by mass. The unit weight and compressive strength of the samples were measured, and scanning electron microscopy/energy dispersive spectroscopy and X-ray diffraction (XRD) analyses were performed. The test results indicated that the compressive strength of alkali-activated blast furnace slag mixes using stone powder sludge was higher than that of the alkali-activated blast furnace slag control mix, but the compressive strength of alkali-activated fly ash mixes decreased with increasing replacement ratio of stone powder sludge. Microscopy results indicated that for alkaliactivated blast furnace slag samples, broken surfaces were more evident than for the alkali-activated fly ash samples. For all XRD diagrams, broad and diffuse peaks were observed around 2θ = 35° (d = 2.96–3.03 Å), implying amorphous or short-ordering structure phases.     

Assessment of fates of estrogens in wastewater and sludge from various types of wastewater treatment plants

We measured five estrogens in the wastewater samples from the municipal wastewater treatment plants (M-WWTPs), livestock wastewater treatment plants (L-WWTPs), hospital WWTPs (H-WWTPs) and pharmaceutical manufacture WWTPs (P-WWTPs) in Korea. The L-WWTPs showed the highest total concentration (0.195-10.4 μg L⁻¹) of estrogens in the influents, followed by the M-WWTPs (0.028-1.15 μg L⁻¹), H-WWTPs (0.068-0.130 μg L⁻¹) and P-WWTPs (0.015-0.070 μg L⁻¹). Like the influents, the L-WWTPs (0.003-0.729 μg L⁻¹) and the M-WWTPs (0.001-0.299 μg L⁻¹) also showed higher total concentration of estrogens in the effluents than the H-WWTPs (0.002-0.021 μg L⁻¹) and P-WWTPs (0.011 μg L⁻¹ in one sample). The L-WWTPs (37.5-543 μg kg⁻¹, dry weight) showed higher total concentrations in sludge than the M-WWTPs (3.16-444 μg kg⁻¹, dry weight) like the wastewater. The distribution of estrogens in the WWTPs may be affected by their metabolism in the human body, their transition through biological treatment processes, and their usage for livestock growth. Unlike the concentration results, the daily loads of estrogens from the M-WWTPs were the highest, which is related to the high capacities of WWTPs.     

Hydro-thermal reaction according to the CaO/SiO2 mole-ratio in silico-manganese slag

Journal of Material Cycles and Waste Management - SiMn slag is a by-product of the production of ferroalloy, and has a chemical composition that could be used as a cement admixture. It is not...