Properties of alkali-activated systems with stone powder sludge

This article investigates the effects of stone powder sludge on the microstructure and strength development of alkali-activated fly ash and blast furnace slag mixes. Stone powder sludge produced from a crushed aggregate factory was used to replace fly ash and granulated blast furnace slag at replacement ratios of 0%, 10%, 20%, and 30% by mass. The unit weight and compressive strength of the samples were measured, and scanning electron microscopy/energy dispersive spectroscopy and X-ray diffraction (XRD) analyses were performed. The test results indicated that the compressive strength of alkali-activated blast furnace slag mixes using stone powder sludge was higher than that of the alkali-activated blast furnace slag control mix, but the compressive strength of alkali-activated fly ash mixes decreased with increasing replacement ratio of stone powder sludge. Microscopy results indicated that for alkaliactivated blast furnace slag samples, broken surfaces were more evident than for the alkali-activated fly ash samples. For all XRD diagrams, broad and diffuse peaks were observed around 2θ = 35° (d = 2.96–3.03 Å), implying amorphous or short-ordering structure phases.     

Influence of boundary conditions on CMAQ simulations over the Iberian Peninsula

The influence of chemical boundary conditions (BC) on the response of the Community Multiscale Air Quality (CMAQ) model over the Iberian Peninsula was investigated in this study. Three strategies to supply boundary conditions in the context of the Integrated Assessment Modelling System for the Iberian Peninsula (SIMCA) were tested. Alternative methods consist in providing BC from (1) fixed, time-independent, concentration profiles, (2) concentrations predicted in a CMAQ mother domain (48 km, 1 h resolution) and (3) concentration values from the GEOS-Chem chemical-transport global model (2 × 2.5°, 3 h resolution). High resolution (3 km) simulated concentrations of the main pollutants (NO₂, NO, SO₂, O₃, PM₁₀ and PM_2.5) were compared through a comprehensive statistical analysis including observational data from 165 monitoring stations all over the Iberian Peninsula. It was found that model sensitivity to BC for nitrogen and sulphur oxides was limited, being restricted to the vicinity of model boundaries. However, significant domain-wide differences were found when modelling ozone and PM depending on the BC provided to run the tests. Although model performance was affected by spatial and seasonal factors, the results indicate that model-derived, dynamic BC improved CMAQ predictions when compared to those based on static concentrations prescribed in the boundaries. Aggregated statistics suggest that the GEOS-Chem produced the best results for O₃ and PM_2.5 while NO₂ and PM₁₀ were slightly better predicted under the CMAQ nesting approach. Besides the statistical evaluation some other relevant issues in the context of Integrated Assessment Modelling (IAM) are discussed to gain a better insight into the suitability of the methods analyzed and limitations of downscaling methods. Despite being useful to get a better understanding of the role of BC in SIMCA, this study contributed to highlight model deficiencies and therefore to point out future research needs to improve IAM activities in the Iberian Peninsula.     

The influence of metal speciation on the bioavailability and sub-cellular distribution of cadmium to the terrestrial isopod, Porcellio dilatatus

Cadmium is a non-essential toxic metal that is able to bioaccumulate in both flora fauna and has the potential to biomagnify in some food chains. However, the form in which cadmium is presented to consumers can alter the bioavailability and possibly the internal distribution of assimilated Cd. Previous studies in our laboratory highlighted differences in Cd assimilation among isopods when they were provided with a plant-based food with either Cd biologically incorporated into plant tissue or superficially amended with ionic Cd(2+). Cd is known for its high affinity for sulphur ligands in cysteine residues which form the basis for metal-binding proteins such as metallothionein. This study compares Cd assimilation efficiency (AE) in Porcellio dilatatus fed with food amended with either cadmium cysteinate or cadmium nitrate in an examination of the influence of Cd speciation on metal bioavailability followed by an examination of the sub-cellular distribution using a centrifugal fractionation protocol. As hypothesized the AE of Cd among isopods fed with Cd(NO(3))(2) (64%, SE=5%) was higher than AE for isopods fed with Cd(Cys)(2) (20%, SE=3%). The sub-cellular distribution also depended on the Cd species provided. Those isopods fed Cd(Cys)(2) allocated significantly more Cd to the cell debris and organelles fractions at the expense of allocation to metal-rich granules (MRG). The significance of the difference in sub-cellular distribution with regard to toxicity is discussed. This paper demonstrates that the assimilation and internal detoxification of Cd is dependent on the chemical form of Cd presented to the isopod.     

Environmental implications of planned obsolescence and product lifetime: a literature review

The aim of this paper was to explore the implications of planned obsolescence (PO) and the associated product lifetime on the environmental impact of products. To achieve this task, a literature review was performed to assess both the historical context and recent situation of planned obsolescence. A search in scholarly journals was performed to evaluate to what extent product lifetime and PO have been discussed in the recent literature. Based on the findings, selected cases of PO are discussed and trends in the practice of limiting product lifetime are identified. Factors considered to have a significant influence on product lifetime have been identified and discussed. The discussion of case studies made it possible to establish the links between product design, manufacturing and associated impacts of lifetime. The role of the actors along the value chain is also considered to propose a business scheme, where the influences of consumer behaviour and design choices are crucial. Finally, strategies to facilitate the definition of different scenarios are given. These strategies may serve to increase the reliability of environmental assessment throughout a product life cycle.     

Methane generation in tropical landfills: simplified methods and field results

This paper deals with the use of simplified methods to predict methane generation in tropical landfills. Methane recovery data obtained on site as part of a research program being carried out at the Metropolitan Landfill, Salvador, Brazil, is analyzed and used to obtain field methane generation over time. Laboratory data from MSW samples of different ages are presented and discussed; and simplified procedures to estimate the methane generation potential, Lo, and the constant related to the biodegradation rate, k are applied. The first order decay method is used to fit field and laboratory results. It is demonstrated that despite the assumptions and the simplicity of the adopted laboratory procedures, the values Lo and k obtained are very close to those measured in the field, thus making this kind of analysis very attractive for first approach purposes.     

Effect of Fe (III) on acid degradation of methylparathion

A study was undertaken to determine the transformation kinetic of methylparathion (O, O, -dimethyl O-4 nitrophenylphosphorotioate) in the presence of Fe(III) between pH 2 and 7. The Fe(III) was not electroactive under the conditions used in this study, and polarographic signals were exhibited by methylparathion and main degradation product only. Data suggest that hydrolysis of methylparathion in an acid medium is catalyzed by Fe(III) and the pesticide did not degrade in this medium without this cation. Methylparathion degradation was observed at all the pHs studied and was independent of the predominant chemical form of Fe(III) in the aqueous medium. The reaction was first-order with pH-dependent rate constant (k) values ranging from 3.3 x 10(- 3) h(- 1) to 7.0 x 10(- 3) h(- 1). The k values increased as pH decreased, suggesting that Fe(III) acted as an electrophile in the reaction mechanism.     

Nutrient baselines of Cerrado low-order streams: comparing natural and impacted sites in Central Brazil

The aquatic systems responsible for water supply in the Brazilian Federal District (FD) have been threatened by anthropogenic pressures, especially considering the expressive demographic increase in the region during the last decades. The purposes of this research were: (a) to assess the water quality in streams located in the FD by monitoring physical–chemical variables; (b) to define baselines for these variables among different ecological status categories. The 14 investigated streams were sampled between 2006 and 2009, in the dry (August–September, 2006, 2008, 2009) and rainy (March–April, 2008, 2009) seasons. All sampling sites were classified in four categories (“very impacted”, “impacted”, “in transition” and “natural”) using an adaptation of a rapid habitat assessment protocol. Differences in water quality among sites were generally well predicted in the four ecological status categories defined by the protocol, which showed a gradient in nutrient concentrations from reference sites classified as “natural” (medians: electrical conductivity?=?7.3 μS cm^?1; nitrate?=?0.040 mg L^?1; ammonium?=?0.039 mg L^?1; soluble reactive phosphorus (SRP)?=?<0.001 mg L^?1; total phosphorus (TP)?=?0.006 mg L^?1; ) to those classified as “very impacted” (medians: electrical conductivity?=?87.7 μS cm^?1; nitrate?=?0.247 mg L^?1; ammonium?=?0.219 mg L^?1; SRP?=?0.010 mg L^?1; TP?=?0.035 mg L^?1). Point sources inputs were the main factor for water quality deterioration. The nutrient baselines reported were relatively low when compared to data collected from reference areas in Brazil (e.g., São Paulo State) or temperate regions, especially for TP.     

Effect of some heavy metals and soil humic substances on the phytochelatin production in wild plants from silver mine areas of Guanajuato, Mexico

Phytochelatins (PCs) were determined in the wild plants, focusing on their relationship with the levels of heavy metals and humic substances (HS) in soil. Ricinus communis and Tithonia diversifolia were collected from several sites in Guanajuato city (Mexico), which had long been the silver and gold mining center. The analysis of PCs in root extracts was carried out by liquid chromatography (derivatization with monobromobimane). Total Ag, Cd, Cu and Pb in plant roots and in soil samples, as well as soil HS were determined. The association of metals with HS in soils was evaluated by size exclusion chromatography (SEC) with UV and ICP-MS detection. The results obtained revealed the induction of PCs in R. communis but not in T. diversifolia. The levels of Cd and Pb in plant roots presented strong positive correlation with PC-2 (r = 0.9395, p = 0.005; r = 0.9573, p = 0.003, respectively), indicating that these two metals promote PCs induction in R. communis. On the other hand, the inverse correlation was found between soil HS and metal levels in roots of R. communis (Cu > Pb > Cd > Ag), in agreement with the decreasing affinity of these metals to HS. Importantly, the inverse correlation between soil HS and plant PC-2 was observed (r = −0.7825, p = 0.066). These results suggest that metals strongly bound to HS could be less bioavailable to plants, which in turn would limit their role in the induction of PCs. Indeed, the SEC elution profiles showed Pb but not Cd association with HS and the correlation between metal in soil and PC-2 in plant was statistically significant only for Cd (r = 0.7857, p = 0.064). Based on these results it is proposed that the role of heavy metals in PCs induction would depend on their uptake by R. communis, which apparently is controlled by the association of metals with soil HS. This work provides further evidence on the role of environmental conditions in the accumulation of heavy metals and phytochelatin production in plants.     

Traffic and catalytic converter - related atmospheric contamination in the metropolitan region of the city of Rio de Janeiro, Brazil

In this work, 24-h PM10 samples were collected in Rio de Janeiro, Brazil, and analysed for trace elements (Cd, Ce, Cu, La, Mo, Ni, Pb, Pd, Rh, Sb and Sn). The sampling was carried out at five locations (Bonsucesso; Centro, downtown city; Copacabana; Nova Igua?u and Sumaré) with different traffic densities and anthropogenic activities. An analytical method based on the EPA method for the determination of trace elements in airborne particulate matter (PM), using ultrasonic-assisted extraction and inductively coupled plasma mass spectrometry (ICP-MS) was applied. Our results suggest that vehicular traffic is the most important source of environmental pollution at the studied sites. The presence of Mo, Pd and Rh in the analysed filters reflects an additional source of pollution caused by the erosion and deterioration of automotive catalytic converters.