Assessment of the uncertainty of using an inverse-dispersion technique to measure methane emissions from animals in a barn and in a small pen

Dispersion techniques are useful for assessing the effectiveness of management practices in mitigating methane (CH₄) emissions from animal operations. In this paper, the accuracy of an inverse-dispersion technique was examined for two common situations: 1) emissions from animals in a barn and 2) emissions from animals in a pen. For both situations, the accuracy of emission estimates generally increased with increasing fetch (scaled to barn height, h, or to pen width, X_s) between the source and the concentration measurement. The gas recovery ratio increased from 0.66 at 5 h to 0.93–1.03 at 10 h–25 h for the barn, and decreased from 1.59 at 0 X_s to 0.99 at 5 X_s and from 1.54 at 0 X_s to 1.09 at 5 X_s for the two small pen scenarios, due to the declining sensitivity of the dispersion model to errors in wind complexity and errors in the assumed source configuration. However, the relative uncertainty of the measured concentration increased with fetch due to the decreasing gas concentrations. Hence, improving the accuracy of emission estimates is a compromise between the source configuration sensitivity and the concentration measurement sensitivity. Fetches of about twice the size of the pen and about 10 times the height of the barn are suggested.     

Verification of diffusive and pumped samplers for volatile organic compounds using a controlled atmosphere test facility

There is a requirement to verify the performance of sorbent-based passive or active samplers and to extend their use, where possible, to monitor volatile organic compounds (VOCs) that are known to be photochemical ozone pre-cursors or are relevant to the activities of the petrochemical industry. We report measurements of the 14-day diffusive uptake rates for the VOCs: i-butane (2-methyl propane), n-butane, i-pentane (2-methyl butane), n-pentane, n-hexane, benzene, toluene, and m-xylene (at environmental level concentrations) for industry standard axial samplers (Perkin–Elmer-type samplers) containing the sorbents Carbopack-X, -Z, -B or Tenax-TA. We also present data on back-diffusion, blank levels, and storage for the above sorbents, and describe the simultaneous use of the sorbent Carbopack-X for pumped sampling of certain VOCs. The results were obtained by dosing samplers in a controlled atmosphere test facility (CATFAC) operating under well-defined conditions of concentration, nominal temperature of 20 °C, wind speed of 0.5 m s^?1, and relative humidities of 0% and 80%. Field measurements were also obtained to provide supplementary data to support the laboratory study. Results are compared to existing published data, where these are available.     

Economic damages of ozone air pollution to crops using combined air quality and GIS modelling

This study aims at presenting a combined air quality and GIS modelling methodological approach in order to estimate crop damages from photochemical air pollution, depict their spatial resolution and assess the order of magnitude regarding the corresponding economic damages. The analysis is conducted within the Greater Thessaloniki Area, Greece, a Mediterranean territory which is characterised by high levels of photochemical air pollution and considerable agricultural activity. Ozone concentration fields for 2002 and for specific emission reduction scenarios for the year 2010 were estimated with the Ozone Fine Structure model in the area under consideration. Total economic damage to crops turns out to be significant and estimated to be approximately 43 M€ for the reference year. Production of cotton presents the highest economic loss, which is over 16 M€, followed by table tomato (9 M€), rice (4.2 M€), wheat (4 M€) and oilseed rape (2.8 M€) cultivations. Losses are not spread uniformly among farmers and the major losses occur in areas with valuable ozone-sensitive crops. The results are very useful for highlighting the magnitude of the total economic impacts of photochemical air pollution to the area’s agricultural sector and can potentially be used for comparison with studies worldwide. Furthermore, spatial analysis of the economic damage could be of importance for governmental authorities and decision makers since it provides an indicative insight, especially if the economic instruments such as financial incentives or state subsidies to farmers are considered.     

Emissions of gaseous and particulate pollutants in a port and harbour region in India

Ports can generate large quantity of pollutants in the atmosphere due to various activities like loading and unloading,transportation, and construction operations. Determination of the character and quantity of emissions from individual sources is an essential step in any project to control and minimize the emissions.In this study a detailed emission inventory of total suspendedparticulate matter (TSP), particulate matter less than 10 m(PM₁₀), sulfur dioxide (SO₂) and nitrogen oxides (NO_x) for a port and harbour project near Mumbai is compiled. Results show that the total annual average contributions of TSP and PM₁₀ from all the port activitieswere 872 and 221 t yr^-1, respectively. Annual average emissions of gaseous pollutants SO₂ and NO_xwere 56 and 397 t yr^-1, respectively, calculatedby using emission factors for different port activities. The maximum TSP emission (419 t yr ^-1) was from paved roads, while the least (0.4 t yr^-1) was from bulk handling activity. The maximum PM₁₀ emission (123 t yr^-1) was from unpaved roads and minimum (0.2 t yr^-1) from bulk handling operations. Similarly the ratio of TSP and PM₁₀ emission was highest (5.18) from paved roads and least (2.17) from bulk handling operations. Regression relation was derivedfrom existing emission data of TSP and PM₁₀ from variousport activities. Good correlation was observed between TSP andPM₁₀ having regression coefficient >0.8.     

Monitoring of Seasonal Vegetables for Pesticide Residues

Market samples (60) of six seasonal vegetables were monitoredduring 1996–1997 to determine the magnitude of pesticidalcontamination. The estimation of insecticide residuesrepresenting four major chemical groups i.e. organochlorine,organophosphorous, synthetic pyrethroid and carbamate, was doneby adopting a multiresidue analytical technique employingGC-ECD and GC-NPD systems with capillary columns. The testedsamples showed 100% contamination with low but measurableamounts of residues. Among the four chemical groups, theorganophosphates were dominant followed by organochlorines,synthetic pyrethroids and carbamates. About 23% of the samplesshowed contamination with organophosphorous compounds abovetheir respective MRL values. More extensive studies coveringdifferent regions of Haryana state are suggested to get a clearidea of the magnitude of vegetable contamination with pesticideresidues.     

The impact of handpump corrosion on water quality in rural areas of West African sub-region

Water, even in its natural environment, contains some level of impurities. Water is nearly a universal solvent. It contains dissolved solids and gases, and hosts a number of micro-organisms. The exploitation of groundwater by means of boreholes for supplying small user groups and rural communities with water has been widely applied in certain parts of the world for several decades. In recent years this practice has spread all over the globe, and hundred of thousands of boreholes have beendrilled to tap low-yield aquifers. It is evident that such boreholes require pumps for lifting thewater. In developing countries these are usually handpumps, butsolar as well as other systems with submersible pumps are also used, depending upon the energy sources available and the financial means of the beneficiaries. This article gives a general overview of groundwater quality with regard to itsphysico-chemical composition. The results presented originatefrom the experience gained from handpump equipped boreholes within the UNICEF through German Centre for Technical EducationTransfer executed inter-regional UNDP-Handpumps Project inWest African Regions. Particular attention is paid to presenting corrosion onthe water quality of wells in terms of iron concentrationand other parameters. Furthermore, the corrosion attack ongalvanised iron, the effect of biofilms on the corrosionrate, and the difference between internal and externalcorrosion of rising mains are shown.     

Analysis of pollutant levels in central Hong Kong applying neural network method with particle swarm optimization

Air pollution has emerged as an imminent issue in modernsociety. Prediction of pollutant levels is an importantresearch topic in atmospheric environment today. For fulfillingsuch prediction, the use of neural network (NN), and inparticular the multi-layer perceptrons, has presented to be acost-effective technique superior to traditional statisticalmethods. But their training, usually with back-propagation (BP)algorithm or other gradient algorithms, is often with certaindrawbacks, such as: 1) very slow convergence, and 2) easilygetting stuck in a local minimum. In this paper, a newlydeveloped method, particle swarm optimization (PSO) model, isadopted to train perceptrons, to predict pollutant levels, andas a result, a PSO-based neural network approach is presented. The approach is demonstrated to be feasible and effective bypredicting some real air-quality problems.     

Formation of organic by-products during chlorination of natural waters

Natural water from six sources in Mytilene, Greece, was chlorinated in order to identify and quantify some of the organic by-products formed. The compounds examined were trihalomethanes, haloacetic acids, haloacetonitriles, haloketones, chloral hydrate and chloropicrin. The factors tested were time and chlorine dose. The presence of bromide ion in some of the waters studied resulted in significant changes in the by-product speciation, with enhanced brominated species formation. In addition, UV absorbance, measured at three wavelengths, led to correlation of organic matter content with the concentrations of by-products produced. The species formed, varying among different water sources, increased with increasing chlorine dose. Most of the species also increased with increasing contact time, although there were some exceptions due to hydrolysis reactions.     

Multi-objective, decision-based assessment of a water quality monitoring network in a river system

Water quality monitoring network design has historically tended to use experience, intuition and subjective judgement in locating monitoring stations. Better design procedures to optimize monitoring systems need to simultaneously identify significant planning objectives and consider a number of social, economic and environmental constraints. The consideration of multiple objectives may require further decision analysis to determine the preference weights associated with the objectives to aid in the decision-making process. This may require the application of an optimization study to extract such information from decision makers or experts and to evaluate the overall effectiveness of locating strategies. This paper assesses the optimal expansion and relocation strategies of a water quality monitoring network using a two-stage analysis. The first stage focuses on the information retrieval of preference weights with respect to the designated planning objectives. With the aid of a pre-emptive goal programming model, data analysis is applied to obtain the essential information from the questionnaire outputs. The second stage then utilizes a weighted multi-objective optimization approach to search for the optimal locating strategies of the monitoring stations in the river basin. Practical implementation is illustrated by a case study in the Kao-Ping River Basin, south Taiwan.     

Nitrogen isotope ratios in pine bark as an indicator of N emissions from anthropogenic sources

The article describes the use of Scots pine bark to identifynitrogen sources in eastern Germany, as well as background areas in Russia and Bulgaria, by using natural isotope ratios of total nitrogen (N_t) and individual N compoundssuch as ammonium (NH₄ ⁺), nitrate (NO₃ ^-)and amid nitrogen (amide-N). The samples collected were analysed using an elemental analyser in connection with a gas isotope mass spectrometer (EA-IRMS). Natural ¹⁵N abundances in pine bark from impact areas suggest that the ammonium accumulated on the surface of the bark is releasedfrom livestock management. Bark of Scots pines growing near agricultural land had highly depleted ¹⁵N_t values (between –8 and –12), while bark from background areas (unpolluted areas) displayed slightly negative ¹⁵N_t values (mean ¹⁵N_t = –3.8). It is assumed that part of the N adsorbed on the bark surface is mainly derived from ammonia(mean ¹⁵N_t = –40.3) escaping from livestock housing and during the application of manure. This assumption is confirmed by experiments under controlled conditions in which manure samples were spread on soil. In addition, temporal and spatial variations of ¹⁵N_t abundances in pine bark from various locations in eastern Germany as wellas pine stands in Nature Park Dübener Heath are discussed.