Human factors and tidal influences on water quality of an urban river in Can Tho, a major city of the Mekong Delta, Vietnam

In this study, we focused on water quality in an urban canal and the Mekong River in the city of Can Tho, a central municipality of the Mekong Delta region, southern Vietnam. Water temperature, pH, electrical conductivity, BOD₅, COD_Cr, Na⁺, Cl^?, NH₄ ⁺?N, SO₄ ^2??S, NO₃ ^??N, and NO₂ ^??N for both canal and river, and tide level of the urban canal, were monitored once per month from May 2010 to April 2012. The urban canal is subject to severe anthropogenic contamination, owing to poor sewage treatment. In general, water quality in the canal exhibited strong tidal variation, poorer at lower tides and better at higher tides. Some anomalies were observed, with degraded water quality under some high-tide conditions. These were associated with flow from the upstream residential area. Therefore, it was concluded that water quality in the urban canal changed with a balance between dilution effects and extent of contaminant supply, both driven by tidal fluctuations in the Mekong River.     

Emission of dioxins/furans and other U-POPs from test burns of non-POP pesticides in a hazardous waste incinerator

This paper presents the results of test burns for obsolete pesticides (OPs) of the permethrin group in a high temperature incinerator (HTI) in Southeast Asia. Three test burn runs were conducted, a baseline run when no OP was fed to the incinerator, and two test runs with different mixtures of OP compounds (formula 1 and 2, refer to Table 1 for detail) containing chlorine in the feeding wastes. The unintentional formed persistent organic pollutants (U-POPs) including 17 dioxins/furans, 12 dioxin-like PCBs and 12 chlorobenzenes (CBs) were monitored in all input materials and all discharges (flue gas, scrubbing liquid and solid residues). The results show relatively high levels of the U-POPs in the flue gas emission with total dioxins/furans of 4.4, 3.4, and 8.4 ng I-TEQ/m³ in the baseline, test run 1 and test run 2, respectively, which are above international acceptable emission levels. The PCB levels in flue gas were, respectively, 0.01, 0.3 and 0.4 ng I-TEQ/m³. The baseline thus had similar U-POPs levels with the OP test runs.In stack emission, approximately 90% of the U-POPs and 100% of CBs were present in gas phase. The emission factors, mass of pollutants per metric ton (tonne) of input waste, of U-POPs associated with fly ash (from bag house) were the highest, followed by flue gas and bottom ash while those associated with scrubbing liquid were relatively low. Among the waste input material only the black toner power contained U-POPs, but at low levels. The profiles of the dioxins/furans and PCBs in the toner waste were significantly different from that in the discharges. Despite the overall good destruction and removal efficiency of permethrin (better than 90%) the high emission of U-POPs and CBs from the test burn is of another more serious concern. To our best knowledge the findings of this study are the first of this kind for the Southeast Asia. The findings emphasize that if not properly conducted a standard destruction technology of a non-POP chemical can lead to a release of a range of more dangerous U-POPs into the environment.     

Exposure Programme on Atmospheric Corrosion Effects of Acidifying Pollutants in Tropical and Subtropical Climates

Many national exposure programmes have been performed in tropical and subtropical climates during the last 50 years. However, ambitious programmes involving more than a few countries are scarce. In this paper a recently formed network of test sites is described involving 12 test sites in Asia (India, Vietnam, Thailand, Malaysia and China including Hong Kong) and four test sites in Africa (South Africa, Zambia and Zimbabwe). This effort is part of the 2001–2004 Swedish International Development Agency (SIDA) funded Programme on Regional Air Pollution in Developing Countries (RAPIDC). Corrosion attack after one (2002–2003) year of exposure (carbon steel, zinc, copper, limestone and paint coated steel) are presented together with environmental data (SO₂, NO₂, HNO₃, O₃, particles, amount and pH of precipitation, temperature and relative humidity) for all the test sites. The obtained corrosion values are substantially higher than expected for limestone, higher than expected for carbon steel and lower than expected for zinc compared to values calculated using the best available dose–response functions.     

Potential application of high pressure carbon dioxide in treated wastewater and water disinfection: Recent overview and further trends

Recently emerging disadvantages in conventional disinfection have heightened the need for finding a new solution. Developments in the use of high pressure carbon dioxide for food preservation and sterilization have led to a renewed interest in its applicability in wastewater treatment and water disinfection. Pressurized CO₂ is one of the most investigated methods of antibacterial treatment and has been used extensively for decades to inhibit pathogens in dried food and liquid products. This study reviews the literature concerning the utility of CO₂ as a disinfecting agent, and the pathogen inactivation mechanism of CO₂ treatment is evaluated based on all available research. In this paper, it will be argued that the successful application and high effectiveness of CO₂ treatment in liquid foods open a potential opportunity for its use in wastewater treatment and water disinfection. The findings from models with different operating conditions (pressure, temperature, microorganism, water content, media …) suggest that most microorganisms are successfully inhibited under CO₂ treatment. It will also be shown that the bacterial deaths under CO₂ treatment can be explained by many different mechanisms. Moreover, the findings in this study can help to address the recently emerging problems in water disinfection, such as disinfection by-products (resulting from chlorination or ozone treatment).     

High photocatalytic removal of NO gas over SnO2 nanoparticles under solar light

Environmental Chemistry Letters - Tin oxide nanoparticles (SnO2 NPs) with a diameter less than 10 nm are usually used in waste water treatment via the photocatalytic reaction. However,...     

Arsenic in groundwaters of the Lower Mekong

Increasing incidence and awareness of arsenic in many alluvial aquifers of South-east Asia has raised concern over possible arsenic in the Lower Mekong Basin. Here, we have undertaken new research and reviewed many previous small-scale studies to provide a comprehensive overview of the status of arsenic in aquifers of Cambodia and the Cuu Long Delta of Vietnam. In general natural arsenic originates from the Upper Mekong basin, rather than from the local geology, and is widespread in soils at typical concentrations of between 8 and 16 ppm; (dry weight). Industrial and agricultural arsenic is localised and relatively unimportant compared to the natural alluvial arsenic. Aquifers most typically contain groundwaters of no more than 10 μg L⁻¹, although scattered anomalous areas of 10 to 30 μg L⁻¹ are also quite common. The most serious, but possibly ephemeral arsenic anomalies, of up to 600 μg L⁻¹, are associated with iron and organic-rich flood-plain sediments subject to very large flood-related fluctuations in water level, resulting in transient arsenopyrite dissolution under oxidizing conditions. In general, however, high-arsenic groundwaters result from the competing interaction between sorption and dissolution processes, in which arsenic is only released under reducing and slightly alkaline conditions. High arsenic groundwaters are found both in shallow water-tables, and in deeper aquifers of between 100 and 120 m depth. There is no evidence of widespread arsenicosis, but there are serious localised health-hazards, and some risk of low-level arsenic ingestion through indirect pathways, such as through contaminated rice and aquaculture. An almost ubiquitous presence of arsenic in soils, together with the likelihood of greatly increased groundwater extraction in the future, will require continuing caution in water resources development throughout the region.     

A dynamic simulation of methane fermentation process receiving heterogeneous food wastes and modelling acidic failure

Microbial response on volatile fatty acids (VFAs) is a key for methane fermentation processes since accumulation of VFAs often causes an acidic failure, especially treating such organics as food wastes composed of mostly readily biodegradable materials. To evaluate the impact of VFA accumulation, a lab-scale continuous experiment was performed for 110 days with sequential feeding of heterogeneous food wastes. When the volumetric loading rate was increased from 6 to 8 kg-COD/m³/day, a sudden decrease of methane production was observed with an accumulation of acetate and propionate in the fermenter. After discontinuation of feeding for 10 days, the digestate in the fermenter was centrifuged and washed with tap water to reduce the VFAs to be acceptable concentration below 1000 mg-COD/L. Nevertheless, no recovery of methane production was observed and VFA concentrations consistently increased. To model the event, a modification of ADM1 was made assuming the methanogens in the fermenter were irreversibly inactivated under very high VFA. Also considering the different nature of the fed food wastes over 11 samples, decomposition kinetics of individual food wastes were manipulated. The modified ADM1 with methanogenic activity decay reasonably reproduced the responses for soluble material concentrations and methane gas production rate over the experimental period.     

金华市义乌江沉积物磁性特征与重金属污染

对浙江省金华市义乌江采集的边滩沉积物柱样,进行了系统的环境磁学、粒度、地球化学分析,以探讨环境磁学方法诊断河流沉积物重金属污染的可行性.结果表明,柱样磁性特征由亚铁磁性矿物主导,其垂向变化受到粒度和早期成岩作用的一定影响.柱样中重金属Cr、Ni、Cu、Zn、Cd、Pb含量及其富集因子除底部外,自下而上呈增加趋势,指示了柱样上部存在人为来源的重金属污染.柱样沉积物磁性特征与重金属含量及其富集因子的垂向变化存在相似性,其中磁化率(χ)、频率磁化率(χfd%)和硬剩磁(HIRM)与Cr、Cu、Zn、Cd、Pb的含量具有显著的正相关关系,反映了磁性矿物与重金属具有相同的来源,或者细颗粒磁性矿物对重金属的吸附作用.上述结果表明,磁学方法可用于指示义乌江的重金属污染.但由于义乌江属于开放性的河流环境系统,磁性特征变化受多重因素影响,增加了利用磁学手段定量诊断重金属污染的复杂性.     

Microcystin accumulation and biochemical responses in the edible clam Corbiculaleana P. exposed to cyanobacterial crude extract

We investigated the accumulation and effects of cyanobacterial crude extract(CCE)containing microcystins(MCs) on the edible clam Corbicula leana P. Toxic effects were evaluated through the activity of antioxidant and detoxification enzymes: catalase(CAT),superoxide dismutase(SOD), and glutathione-S-transferases(GSTs) from gills, foot, mantle and remaining soft tissues. Clams were exposed to CCE containing 400 μg MC-LReq/L for10 days and were then kept in toxin-free water for 5 days. Clam accumulated MCs(up to 3.41 ± 0.63 μg/g dry weight(DW) of unbound MC and 0.31 ± 0.013 μg/g DW of covalently bound MC). Detoxification and antioxidant enzymes in different organs responded differently to CCE during the experiment. The activity of SOD, CAT, and GST in the gills and mantle increased in MC-treated clams. In contrast, CAT and GST activity was significantly inhibited in the foot and mostly only slightly changed in the remaining tissues. The responses of biotransformation, antioxidant enzyme activity to CCE and the fast elimination of MCs during depuration help to explain how the clam can survive for long periods(over a week) during the decay of toxic cyanobacterial blooms in nature.