Treatment of chemical mechanical polishing wastewater by electrocoagulation: system performances and sludge settling characteristics

Treatment of copper chemical mechanical polishing (CMP) wastewater from a semiconductor plant by electrocoagulation is investigated. The CMP wastewater was characterized by high suspended solids (SS) content, high turbidity (NTU), chemical oxygen demand (COD) concentration up to 500 mgl(-1) and copper concentration up to 100 mgl(-1). In the present study, electrocoagulation was employed to treat the CMP wastewater with an attempt to simultaneously lower its turbidity, copper and COD concentrations. The test results indicated that electrocoagulation with Al/Fe electrode pair was very efficient and able to achieve 99% copper ion and 96.5% turbidity removal in less than 30 min. The COD removal obtained in the treatment was better than 85%, with an effluent COD below 100 mgl(-1). The effluent wastewater was very clear and its quality exceeded the direct discharge standard. In addition, sludge settling velocities after electrocoagulation were measured and the data were employed to verify the empirical sludge settling velocity models. Finally, the sludge settling characteristic data were also utilized to establish the relation between the solids flux (G) and the initial solids concentration.     

Tributyltin distribution in the coastal environment of Peninsular Malaysia

The occurrence of tributyltin (TBT) is reported in the coastal waters of a few selected sites in Peninsular Malaysia. Water, bivalves and sediment samples collected were analysed specifically for TBT using sensitive analytical methods which involved a solvent extraction procedure with appropriate clean-up followed by graphite furnace atomic absorption spectrometric measurements. The levels of TBT in the seawater in unexposed areas were found in the range from <3.4 to 20 ng litre(-1) as compared to coastal areas with high boat and ship activities where TBT levels in seawater were generally above 30 ng litre(-1), with the highest level found at 281.8 ng litre(-1). TBT levels in the tissues of random cockle and soft-shell clam samples from local markets were found in the range from <0.5 to 3.7 ng g(-1) wet weight. The levels of TBT found in green mussel samples both from the market (23.5 ng g(-1) wet weight) and those from a mussel farm (14.2 ng g(-1) wet weight) indicate slight accumulation of TBT. In sediments, TBT levels were found ranging from <0.7 ng g(-1) dry weight in unexposed coastal sites to as high as 216.5 ng g(-1) dry weight for a site within a port area.     

用水解酸化-好氧接触氧化法处理含油污水

通过对耐盐微生物的驯化培养,采用水解酸化-好氧接触氧化工艺,对一定矿化度条件下含油污水进行了处理。试验证明,在矿化度为2～5g/L时,利用耐盐驯化的微生物,采用水解酸化-好氧接触氧化工艺处理污水,CODcr去除率可达80%以上。该系统运行稳定,运行成本较低。     

直角拐弯通道中空气冲击波的传播及数值模拟

针对地下通道中空气冲击波的传播,通过试验研究,得到了空气冲击波在直角拐弯通道中传播的衰减系数.同时,应用流体网格法进行了数值模拟,获得了通道直角拐弯前后空气冲击波传播的波形图和流场图.并将两方面的研究成果进行了对比,证明了试验和数值研究方法及研究成果的一致性.     

花园城市建设中的绿地系统问题研究——以南昌市为例

分析了南昌市绿化的地理背景、存在的差距和主要问题。从重建城市生态及完善城市防灾体系的角度，因地制宜地提出了发展特色鲜明的城市绿地系统的相应对策与措施。     

放射性核素在海水、底质及海洋生物间的转移--Ⅱ.生物过程的作用

本实验把扁藻、三角褐指藻、文蛤、毛蚶、对虾、罗非鱼等海洋生物引入人工水池小生境后,研究~(137)Cs、~(134)Cs、~(65)Zn、~(60)Co、~(59)Fe、~(54)Mn等核素在这一体系中行为的变化.结果表明,引入扁藻.三角褐指藻后,首先改变了~(54)Mn的存在状态,使其不易富集在藻体上;引入实验动物一个月后,并没有减少原先浮游藻类、底质对核素的吸附,但水体中相当部分的~(54)Mn、~(60)Co已转移至动物体中,池底粪粒沉淀物中的~(54)Mn、~(65)Zn、~(60)Co、~(59)Fe的含量也相当高,从而大大改变了核素在人工水池小生境中的转移规律.     

汞对毛苕——根瘤菌共生固氮的影响

本文以浓度梯度法研究了重金属离子二价汞对豆科根瘤菌和寄主毛苕生长结瘤固氮酶活性的影响。研究表明,根瘤菌各菌株间对Hg~(2 )的忍耐程度有差异。当Hg~(2 )浓度为2ppm时,多数菌株仍能正常生长;5ppm时,受不同程度的抑制;10ppm时,受到严重抑制,有些菌株完全不能生长;20ppm以上,所有供试菌株完全不能生长。在水培条件下,当Hg~(2 )达10ppm、土培为50ppm时,毛苕的结瘤固氮受影响;水培20ppm、土培200ppm以上时,植物根部完全不结瘤。本工作初次阐明了汞对某些根廇菌-寄主毛苕的毒害,为鉴别污染程度和农业环境质量评价提供了科学依根。     

0D/3D direct Z-scheme heterojunctions hybridizing by MoS2 quantum dots and honeycomb conjugated triazine polymers (CTPs) for enhanced photocatalytic performance

Herein, a novel direct Z-scheme photocatalyst was accomplished by hybridization of 0D MoS₂ quantum dots (MSQDs) and 3D honeycomb-like conjugated triazine polymers (CTP) (namely, CTP-MSQD). The unique 0D/3D hierarchical structure significantly enhanced the exposure of active sites and light harvesting property, while the formed p-n junction enabled the direct strong interface coupling without the necessity of any mediators. The optimized CTP-MSQD3 exhibited continuously increased visible-light-driven photocatalytic activity and strong durability both in Cr(VI) reduction and H₂ evolution, featured a rate of 0.069 min⁻¹ and 1070 µmol/(hr∙g), respectively, which were 8 times than those of pure 3D-CTP (0.009 min⁻¹ and 129 µmol/(hr∙g)). We believe that this work provides a promising photocatalyst system that combines a 0D/3D hierarchical structure and a Z-scheme charge flow for efficient and stable photocatalytic conversion.     

氧瓶燃烧法与冷原子吸光光度法测定煤中痕量汞

本文介绍了以氧瓶燃烧法处理煤样,氯化亚锡还原汞离子,用冷原子吸收法测定汞的含量。同时,对氧瓶燃烧法处理煤样的可靠性进行了考察。     

某排污扩散器水力特性的实验研究

对某实际排污工程多喷头扩散器的水力特性进行了系统的实验研究。内容包括：在不同污水排放是、环境流速和潮位情况下，扩散器各喷头的流量分配，喷口流速分布；扩散器管路的冲洗，水流阻力特性等；以及扩散器近区稀释特性分析，结论对实际排污系统设计有一定的参考价值。