Higher Plants As Bioindicators Of Sulphur Dioxide Emissions In Urban Environments

The evaluation of certain vascular plants that grow in the city of Madrid as biomonitors of SO₂ air pollution in urban environments has been carried out. Total concentration of sulphur in leaves of the chosen higher plants as well as other parameters in close relation to this contaminant (visible injury symptoms, chlorophyll a- and b-content and peroxidase activity) have been determined in order to study the spatial distribution and temporal changes in SO₂ deposition. Results obtained show that coniferous species such as Pinus pinea, were more sensitive to SO₂ atmospheric concentration than leafy species as Quercux ilex subspecies ballota and, in the same way, bush species, such asPyracantha coccinea and Nerium oleander, were more sensitive than wooded species, such as Cedrus deodaraandPinus pinea, respectively. There is a higher accumulation of sulphur in vegetable species located near highways and dense traffic incidence roads and near areas with high density of population. The minimum values for accumulation of SO₂ were registered in winter and spring seasons (from January to April) due to the vegetative stop; while maximum values are obtained during the summer season (from June to September), due to the stoma opening. The highest increments in sulphur concentration, calculated as the difference between two consecutive months, are obtained in May and June for all considered species except forCedrus deodara and Pyracantha coccinea, both species have few seasonal changes during the whole year. Some species are more sensitive to natural washing than others, showing a decrease in sulphur concentration after rainfall periods.     

Flow-injection analysis with fluorescence detection for the determination of trace levels of ammonium in seawater

A method using flow-injection, gas-diffusion, derivatisation and then fluorescent detection has been established for ammonium ion determination in seawater. The fluorescent derivative formed by reacting ortho-phthaldialdehyde (OPA) and sulfite with ammonia gives high sensitivity while removing potential interferences. This is required to measure the low concentrations of ammonium often seen in the open ocean. The experimental conditions (flow-rate, reagent concentrations, membrane configurations, etc.) were manipulated to improve performance. For a sample throughput of 30 samples h(-1), the limit of detection was 7 nM, the coefficient of variation was 5.7% at 800 nM, and the calibration curve was linear to at least 4 micromol L(-1). Interferences were minimised by a gaseous diffusion step. Volatile small molecular-weight amines as interferents were discriminated against by this method. They neither passed through the membrane as efficiently as ammonia, nor reacted as readily with OPA when sulfite was the reductant. Contamination by ammonia from laboratory and shipboard sources complicates application of the method to natural waters, especially measurement of low concentrations (<100 nM) in open-ocean waters. Steps to overcome contamination are described in detail. Some results are presented for ammonium determination in Southern Ocean and Huon Estuary (Tasmania) waters.     

The organic composition of diesel particulate matter, diesel fuel and engine oil of a non-road diesel generator

Diesel-powered equipment is known to emit significant quantities of fine particulate matter to the atmosphere. Numerous organic compounds can be adsorbed onto the surfaces of these inhalable particles, among which polycyclic aromatic hydrocarbons (PAHs) are considered potential occupational carcinogens. Guidelines have been established by various agencies regarding diesel emissions and various control technologies are under development. The purpose of this study is to identify, quantify and compare the organic compounds in diesel particulate matter (DPM) with the diesel fuel and engine oil used in a non-road diesel generator. Approximately 90 organic compounds were quantified (with molecular weight ranging from 120 to 350), which include alkanes, PAHs, alkylated PAHs, alkylbenzenes and alkanoic acids. The low sulfur diesel fuel contains 61% alkanes and 7.1% of PAHs. The identifiable portion of the engine oil contains mainly the alkanoic and benzoic acids. The composition of DPM suggests that they may be originated from unburned diesel fuel, engine oil evaporation and combustion generated products. Compared with diesel fuel, DPM contains fewer fractions of alkanes and more PAH compounds, with the shift toward higher molecular weight ones. The enrichment of compounds with higher molecular weight in DPM may be combustion related (pyrogenic).     

Interlaboratory evaluation of endotoxin analyses in agricultural dusts--comparison of LAL assay and mass spectrometry

Endotoxin exposure is associated with wheeze and asthma morbidity, while early life exposure may reduce risk of allergy and asthma. Unfortunately, it is difficult to compare endotoxin results from different laboratories and environments. We undertook this study to determine if lipopolysaccharide (LPS) extraction efficiency could account for differences among laboratories. We generated and collected aerosols from chicken and swine barns, and corn processing. We randomly allocated side-by-side filter samples to five laboratories for Limulus assay of endotoxin. Lyophilized aliquots of filter extracts were analyzed for 3-hydroxy fatty acids (3-OHFAs) as a marker of LPS using gas chromatography-mass spectrometry. There were significant differences in endotoxin assay and GC-MS (LPS) results between laboratories for all dust types (p < 0.01). Patterns of differences between labs varied by dust type. Relationships between assay and GC/MS results also depended on dust type. The percentages of individual 3-OHFA chain lengths varied across labs (p < 0.0001) suggesting that each lab recovered a different fraction of the LPS available. The presence of large amounts of particle associated LPS and absence of a freezing thawing cycle were associated with lower correlations between LPS and bioactivity, consistent with an absence of Limulus response to cell-bound endotoxin. These data suggest that extraction methods affect endotoxin measurements. The LAL methods may be most suitable when comparing exposures within similar environments; GC-MS offers additional information helpful in optimizing sample treatment and extraction. GC-MS may be of use when comparing across heterogeneous environments and should be considered for inclusion in future studies of human health outcomes.     

Environmental quality control and environmental games

Conclusion  In this paper we have considered a specific environmental game emphasizing both control-prevention efforts and the propensity to pollute by a firm which adopts a given pollution abatement technology. A random payoff game was constructed and solved under a risk neutral assumption and quadratic utilities for both the firm and the environmental controller. The game thus defined, provides a wide range of interpretations and potential approaches for selecting a control-inspection policies to prevent environmental risks. There are of course many facets to this problem, which could be considered and have not been considered in sufficient depth. For example, more complex control mechanisms and liabilities, the effects of insurance and risk sharing, the application of cooperative efforts and subvention of pollution abatement investments (through tax incentives and their like), etc. have not been considered [5,7]. These are topics for further research. The basic presumption of this paper is that it is very difficult to fully enforce pollution prevention by firms, as a result, some controls are needed to ensure that firms be controlled so that appropriate efforts are carried.     

Influence of aluminium on the restoration potential of a terrestrial vascular plant,Portulaca Oleracea L. as a biomonitoring tool of fresh water aquatic environments

In the present study, the influence of aluminium on the regeneration potential of leaf and stem-cuttings of Portulaca oleracea was studied in order to identify a terrestrial plant species as an alternate biomonitoring toolof fresh water environment. The leaves and stem cuttings of theterrestrial plant, P. oleracea grew well in the distilled water producing adventitious and lateral roots. The aluminium treated leaves and stem cuttings showed a reduction in the growthof the adventitious and lateral roots and increase in the decay of leaves and stem cuttings with increasing aluminium concentration. The tolerance index calculated for the leaves and the stem cuttings showed that the leaves were more sensitivethan stems to aluminium. Since all the parameters studied showedconcentration dependent changes, the terrestrial plant, P. oleracea can be considered a suitable biomonitoring tool of fresh water environment besides its usage in the Al toxicity testing.     

Aerosol Scavenging: Model Application and Sensitivity Analysis in the Indian Context

Sulfate aerosols have been found to bethe major contributors to precipitation acidity. Thus,in view of the long-term ecological repercussions theyhave on aquatic ecosystems and their acidity-potential,the present analysis focuses on a case study applicationof the layer-averaged aerosol-scavenging model (Okita et al., 1996) for predicting values of the wet scavengingcoefficient and sulfate concentrations in precipitationsamples on the basis of the information available forsome selected Indian cities. Through sensitivityanalysis (Pandey et al., 1997) the scavengingcoefficient has been found to be very strongly dependenton precipitation intensity. Comparison of modelpredictions has been done with the measured values forDelhi, Mumbai, Calcutta and Chennai in India.