Water Transformation in the Media of Biofilters Controlled by Rhodococcus fascians in Treating an Ethyl Acetate-Contaminated Airstream

Abstract

Biofilters do not provide much water for bacteria to grow. To use them efficiently and properly, it is essential to understand the kinetics of water transformation and to control moisture levels. This study aims to clarify whether the metabolism of microorganisms will improve the water-holding capacity of media or will intensify drying. This experiment was conducted in duplicate, that is, both with and without bacterial inoculation. Both the constant water content mode and the declining water content mode show that microbial growth in a log phase will enhance drying. In contrast, the bacteria growing in a logarithmic decline phase will improve water-holding capacity. Basically, water evaporation can result from the latent heat obtained from microbial respiration or from the physical temperature difference between the unsaturated air and the wet media. Two ways that biofilters can gain water are from water incorporated into bacteria cells and from water obtained from the oxidation of volatile organic compounds (VOCs).     

Abatement of Sulfur Hexafluoride Emissions from the Semiconductor Manufacturing Process by Atmospheric-Pressure Plasmas

Abstract

Sulfur hexafluoride (SF₆) is an important gas for plasma etching processes in the semiconductor industry. SF₆ intensely absorbs infrared radiation and, consequently, aggravates global warming. This study investigates SF₆ abatement by nonthermal plasma technologies under atmospheric pressure. Two kinds of nonthermal plasma processes—dielectric barrier discharge (DBD) and combined plasma catalysis (CPC)—were employed and evaluated. Experimental results indicated that as much as 91% of SF₆ was removed with DBDs at 20 kV of applied voltage and 150 Hz of discharge frequency for the gas stream containing 300 ppm SF₆, 12% oxygen (O₂), and 40% argon (Ar), with nitrogen (N₂) as the carrier gas. Four additives, including Ar, O₂, ethylene (C₂H₄), and H₂O_(g), are effective in enhancing SF₆ abatement in the range of conditions studied. DBD achieves a higher SF₆ removal efficiency than does CPC at the same operation condition. But CPC achieves a higher electrical energy utilization compared with DBD. However, poisoning of catalysts by sulfur (S)-containing species needs further investigation. SF₆ is mainly converted to SOF₂,SO₂F₄, sulfur dioxide (SO₂), oxygen difluoride (OF₂), and fluoride (F₂). They do not cause global warming and can be captured by either wet scrubbing or adsorption. This study indicates that DBD and CPC are feasible control technologies for reducing SF₆ emissions.     

Investigation of Selective Catalytic Reduction Impact on Mercury Speciation under Simulated NOx Emission Control Conditions

Abstract

Selective catalytic reduction (SCR) technology increasingly is being applied for controlling emissions of nitrogen oxides (NO_x) from coal-fired boilers. Some recent field and pilot studies suggest that the operation of SCR could affect the chemical form of mercury (Hg) in coal combustion flue gases. The speciation of Hg is an important factor influencing the control and environmental fate of Hg emissions from coal combustion. The vanadium and titanium oxides, used commonly in the vanadia-titania SCR catalyst for catalytic NO_x reduction, promote the formation of oxidized mercury (Hg²⁺).

The work reported in this paper focuses on the impact of SCR on elemental mercury (Hg⁰) oxidation. Bench-scale experiments were conducted to investigate Hg⁰ oxidation in the presence of simulated coal combustion flue gases and under SCR reaction conditions. Flue gas mixtures with different concentrations of hydrogen chloride (HCl) and sulfur dioxide (SO₂) for simulating the combustion of bituminous coals and subbituminous coals were tested in these experiments. The effects of HCl and SO₂ in the flue gases on Hg⁰ oxidation under SCR reaction conditions were studied. It was observed that HCl is the most critical flue gas component that causes conversion of Hg⁰ to Hg²⁺ under SCR reaction conditions. The importance of HCl for Hg⁰ oxidation found in the present study provides the scientific basis for the apparent coal-type dependence observed for Hg⁰ oxidation occurring across the SCR reactors in the field.     

Application of a Sediment Quality Index to the Lower Laurentian Great Lakes

A sediment quality index (SQI) was developed using an equation incorporating three elements; scope--the % of variables that did not meet guidelines; area frequency--the % of failed tests divided by the total number of tests in a group of sites; and amplitude - the magnitude by which failed variables exceeded guidelines. The SQI calculation produces a numerical score with a maximum value of 100 representing the highest sediment quality. A modified SQI was also developed using only the scope and amplitude elements, which computed a score per site with no grouping. The SQI was applied to assessment of sediment quality in Lakes Erie and Ontario using Canadian Federal and Ontario Provincial guidelines for 34 compounds, Spatial trends in sediment quality in both lakes reflected overall trends for most individual contaminant classes, including mercury and polychlorinated biphenyls. In Lake Erie, there was a trend toward lower SQI values from the eastern basin to the western basin, and from the northern area to the southern area of the central basin. Sediment quality in the eastern basin and the northern area of the central basin was classified as excellent (>95); sediments in other areas of Lake Erie ranged from fair to good. In Lake Ontario, the poorest sediment quality was associated with the three major depositional basins; sediment quality among the three basins was quite consistent. The SQI values based on all three elements (scope, frequency and amplitude) for the Niagara basin. Mississauga Basin and Rochester Basin were 67 (fair), 65 (fair) and 70 (fair), respectively. Comparison of SQI values for all lower lake basins showed generally poorer sediment quality in Lake Ontario, compared to Lake Erie.     

A study on the evaluations of emission factors and uncertainty ranges for methane and nitrous oxide from combined-cycle power plant in Korea

In this research, in order to develop technology/country-specific emission factors of methane (CH₄) and nitrous oxide (N₂O), a total of 585 samples from eight gas-fired turbine combined cycle (GTCC) power plants were measured and analyzed. The research found that the emission factor for CH₄ stood at “0.82 kg/TJ”, which was an 18 % lower than the emission factor for liquefied natural gas (LNG) GTCC “1 kg/TJ” presented by Intergovernmental Panel on Climate Change (IPCC). The result was 8 % up when compared with the emission factor of Japan which stands at “0.75 kg/TJ”. The emission factor for N₂O was “0.65 kg/TJ”, which is significantly lower than “3 kg/TJ” of the emission factor for LNG GTCC presented by IPCC, but over six times higher than the default N₂O emission factor of LNG. The evaluation of uncertainty was conducted based on the estimated non-CO₂ emission factors, and the ranges of uncertainty for CH₄ and N₂O were between ?12.96 and +13.89 %, and ?11.43 and +12.86 %, respectively, which is significantly lower than uncertainties presented by IPCC. These differences proved that non-CO₂ emissions can change depending on combustion technologies; therefore, it is vital to establish country/technology-specific emission factors.     

Effects of growth substrate on triclosan biodegradation potential of oxygenase-expressing bacteria

Triclosan is an antimicrobial agent, an endocrine disrupting compound, and an emerging contaminant in the environment. This is the first study investigating triclosan biodegradation potential of four oxygenase-expressing bacteria: Rhodococcus jostii RHA1, Mycobacterium vaccae JOB5, Rhodococcus ruber ENV425, and Burkholderia xenovorans LB400. B. xenovorans LB400 and R. ruber ENV425 were unable to degrade triclosan. Propane-grown M. vaccae JOB5 can completely degrade triclosan (5 mg L⁻¹). R. jostii RHA1 grown on biphenyl, propane, and LB medium with dicyclopropylketone (DCPK), an alkane monooxygenase inducer, was able to degrade the added triclosan (5 mg L⁻¹) to different extents. Incomplete degradation of triclosan by RHA1 is probably due to triclosan product toxicity. The highest triclosan transformation capacity (T_c, defined as the amount of triclosan degraded/the number of cells inactivated; 5.63 × 10⁻³ ng triclosan/16S rRNA gene copies) was observed for biphenyl-grown RHA1 and the lowest T_c (0.20 × 10⁻³ ng-triclosan/16S rRNA gene copies) was observed for propane-grown RHA1. No triclosan degradation metabolites were detected during triclosan degradation by propane- and LB + DCPK-grown RHA1. When using biphenyl-grown RHA1 for degradation, four chlorinated metabolites (2,4-dichlorophenol, monohydroxy-triclosan, dihydroxy-triclosan, and 2-chlorohydroquinone (a new triclosan metabolite)) were detected. Based on the detected metabolites, a meta-cleavage pathway was proposed for triclosan degradation.     

Remediation of Cr(VI) from chromium slag by biocementation

Here we demonstrate a calcifying ureolytic bacterium Bacillus sp. CS8 for the bioremediation of chromate (Cr(VI)) from chromium slag based on microbially induced calcite precipitation (MICP). A consolidated structure like bricks was prepared from chromium slags using bacterial cells, and five stage Cr(VI) sequential extraction was carried out to know their distribution pattern. Cr(VI) mobility was found to significantly be decreased in the exchangeable fraction of Cr slag and subsequently, the Cr(VI) concentration was markedly increased in carbonated fraction after bioremediation. It was found that such Cr slag bricks developed high compressive strength with low permeability. Further, leaching behavior of Cr(VI) in the Cr slag was studied by column tests and remarkable decrease in Cr(VI) concentration was noticed after bioremediation. Cr slags from columns were characterized by SEM–EDS confirming MICP process in bioremediation. The incorporation of Cr(VI) into the calcite surface forms a strong complex that leads to obstruction in Cr(VI) release into the environment. As China is facing chromium slag accidents at the regular time intervals, the technology discussed in the present study promises to provide effective and economical treatment of such sites across the country, however, it can be used globally.     

Contamination of polychlorinated biphenyls and organochlorine pesticides in breast milk in Korea: Time-course variation,influencing factors,and exposure assessment

Breast milk is a noninvasive specimen to assess maternal and infant exposure to polychlorinated biphenyls (PCBs) and organochlorine pesticides (OCPs). In this study, 206 breast milk samples were collected from 87 participants during lactation, at <7, 15, 30, or 90 days postpartum in four cities in Korea. The total concentrations of PCBs (ΣPCB) and OCPs (ΣOCP) ranged from <LOQ to 84.0 (median: 12.1) ng g⁻¹ lipid weight and from <LOQ to 559 (median: 144) ng g⁻¹ lipid weight, respectively. The residue levels of these contaminants measured in our study were relatively lower than those reported for European, African and Asian populations. Within a month postpartum typically after day seven the levels of ΣPCB and ΣOCP significantly increased. Some OCP compounds were correlated with maternal age, BMI, parity, and delivery mode. Certain types of dietary habits such as seafood and noodle consumption were significantly associated with ΣPCB and ΣOCP. The estimated daily intakes (EDIs) of ΣPCB and ΣOCP were 45.2–127 ng kg⁻¹ bw day⁻¹ and 625–1259 ng kg⁻¹ bw day⁻¹ during lactation, respectively, which are lower than the threshold values proposed by the US EPA and Health Canada. The exposure of Korean infants to chlordanes via breast milk had a potential health risk which deserves further investigation.     

Destruction of Bacteria and Toxic Organic Chemicals by a Corona Discharge

A detailed analysis of international trends in air pollution control and waste management markets forecasts considerable growth and expansion due to increased economic activity, more stringent regulations requiring pollution control, and the increased amounts of solid waste being generated worldwide.     

Extreme Values in TSP Distribution Functions

The highest values in annual TSP distributions fall below the best-fit, log-normal straight line more than one would expect from ordinary sampling statistics but not dramatically so. The lowest values in annual TSP distributions overwhelmingly fall below the best-fit, log-normal straight line. The most highly improbable high values above the best-fit line in such distributions are very questionable and probably do not represent true air quality values. The most improbable cases of highest values falling below the best-fit, log-normal line are the result of data artifacts at the opposite end of the data distribution. They do not represent low probabilities and probably do represent true air quality values. The most improbable low values are all of highly doubtful validity.