焦化废水处理工程调试运行研究

针对焦化废水处理调试运行存在的问题,以实际运行中的焦化废水处理工程为例,介绍了其调试运行过程.指出焦化废水调试及稳定运行的控制要点,并提出调试运行过程中可能出现的问题及解决措施,为同类废水的调试和运行提供参考.     

Ru-Ta/Ti阳极电解深度处理垃圾渗滤液

采用Ru-Ta/Ti三元电极为阳极,以不锈钢电极为阴极对垃圾渗滤液生物处理出水进行了电解处理研究,以COD为控制指标.重点研究了电解电压、电解时间、pH值、曝气量、电解质的添加等因素对电解处理效果的影响.研究结果表明:电压为7 V、处理时间为30 min、pH=9、曝气量为0.04m3/h、添加电解质为MnⅡ的条件下电...     

适用于废水处理的DSA电极的研究进展

电化学氧化技术因其具有氧化能力强、可控性高、运行费用低及对环境友好的特点,引起了人们极大的关注.处于核心地位的DSA（Dimensionally Stable Anodes）电极是电化学工作者研究的重点.Ti基氧化铅、氧化铱、锡锑氧化物等电极是目前最有研究价值的DSA电极,文章介绍了这些电极的一些最新的研究成果.     

适用于废水处理的DSA电极的研究进展

电化学氧化技术因其具有氧化能力强、可控性高、运行费用低及对环境友好的特点,引起了人们极大的关注。处于核心地位的DSA（Dimensionally Stable Anodes）电极是电化学工作者研究的重点。Ti基氧化铅、氧化铱、锡锑氧化物等电极是目前最有研究价值的DSA电极,文章介绍了这些电极的一些最新的研究成果。     

Dyes adsorption using a synthetic carboxymethyl cellulose-acrylic acid adsorbent

Removal of noxious dyes is gaining public and technological attention. Herein grafting polymerization was employed to produce a novel adsorbent using acrylic acid and carboxymethyl cellulose for dye removal. Scanning electron microscopy and Fourier-transform infrared spectroscopy verified the adsorbent formed under optimized reaction conditions. The removal ratio of adsorbent to Methyl Orange, Disperse Blue 2BLN and malachite green chloride reached to 84.2%, 79.6% and 99.9%, respectively. The greater agreement between the calculated and experimental results suggested that pseudo second-order kinetic model better represents the kinetic adsorption data. Equilibrium adsorptions of dyes were better explained by the Temkin isotherm. The results implied that this new cellulose-based absorbent had the universaiity for removal of dyes through the chemical adsorption mechanism.     

顶空毛细柱气相色谱法测定水中七种苯系物研究

选用Elite-FFAP色谱柱,利用顶空-毛细柱气相色谱技术对水中的苯、甲苯、乙苯、对二甲苯、间二甲苯、邻二甲苯、苯乙烯七种挥发性苯系物进行同时测定,并对样品的平衡温度、保温时间、程序升温的条件控制、水中含盐量等影响因素进行了探讨,优化了检测条件,使七种挥发性苯系物得到不错的分离。样品平衡温度控制在70℃,样品平衡时间19 min,进样口温度180℃,检测器温度230℃,10 mL水样中加入4 g NaCl的条件下,分离效果最佳。     

亚甲基蓝分光光度法测定废水硫化物的不确定度评定研究

分析了应用亚甲基蓝分光光度(GB/T16489-1996)测定废水硫化物测试过程中不确定度影响因素,主要来源为硫化物标准溶液、标准曲线拟合、随机效应、分光光度计和取样体积这五部分。本测量合成相对标准不确定度0.025 9;其中由测定样品质量引入的不确定度为0.024 7;由样品体积引入的不确定度为0.007 7。本次废水中硫化物测量结果为:0.110±0.006 mg/L,k=2(包含概率约为95%)。     

氟磺隆水解动力学研究

采用试验室内模拟试验的方法,研究不同pH的缓冲溶液和不同自然水体对氟磺隆水解的影响。实验结果表明,不同pH缓冲溶液和不同自然水体对氟磺隆水解速率均有不同程度的影响。在碱性条件下氟磺隆的水解速率最快,半衰期为0.2 d,酸性条件下次之,半衰期为6.0 d,在中性条件下水解较慢,半衰期为15.7 d,而在不同自然水体中氟磺隆的降解速率为:伊通河水稻田水青湖水蒸馏水。     

数字城市防震减灾

数字城市减灾战略的提出城市发展战略的各种研讨,总是要讨论安全城市概念中重要的灾害安全的涵义。同样,讨论安全战略的场合中,或者在讨论国家安全战略的著作中,也要讨论自然灾害或地震安全,或防灾减灾战略方面的内容。就是在国家长期科     

Effect of pipes in heat pump system on electric vehicle energy saving

ABSTRACT

Refrigerant pressure drop and temperature change in pipes are normally ignored in the thermodynamic analysis of traditional vehicle air conditioning system, this will result in serious errors. In this Paper, pressure drop and temperature difference are simulated in different pipes of electric vehicle (EV) heat pump system to analysis the effects of pipes in the actual EV heat pump system. The results indicate that the greater the mass flow, the faster pressure drop increases, the temperature difference decreases. Pressure drop of saturated liquid refrigerant is smaller than that of saturated gas refrigerant at the same saturation pressure and mass flow rate. The higher the refrigerant pressure (no phase change), the slower pressure drop decreases, the faster the temperature difference decreases. Pressure drop decreases with the increment of bending angle of the pipe. For EV heat pump system, suitable valves and less branches are helpful for energy saving of the system. Shortening the pipe between compressor and condenser can reduce temperature change obviously. Pressure drop per unit length in the pipe between evaporator and compressor is large especially in heating mode because of lower refrigerant density. It even reaches to over 100 times of that in the pipe between condenser and throttle valve in heating mode and has negative effects on the performance of the system. If the evaporator is closer to the compressor and the number of branches is less, then pressure drop will decrease a lot, which will be advantageous for energy saving of the heat pump system.