Diffusive gradients in thin films using molecularly imprinted polymer binding gels for in situ measurements of antibiotics in urban wastewaters

• Selective molecularly imprinted polymer (MIP) binding gel was prepared. • MIP-DGT showed excellent uptake performance for antibiotics. • In situ measurement of antibiotics in wastewaters via MIP-DGT was developed. • The MIP-DGT method was robust, reliable, and highly sensitive. Urban wastewater is one of main sources for the introduction of antibiotics into the environment. Monitoring the concentrations of antibiotics in wastewater is necessary for estimating the amount of antibiotics discharged into the environment through urban wastewater treatment systems. In this study, we report a novel diffusive gradient in thin films (DGT) method based on molecularly imprinted polymers (MIPs) for in situ measurement of two typical antibiotics, fluoroquinolones (FQs) and sulfonamides (SAs) in urban wastewater. MIPs show specific adsorption toward their templates and their structural analogs, resulting in the selective uptake of the two target antibiotics during MIP-DGT deployment. The uptake performance of the MIP-DGTs was evaluated in the laboratory and was relatively independent of solution pH (4.0–9.0), ionic strength (1–750 mmol/L), and dissolved organic matter (DOM, 0–20 mg/L). MIP-DGT samplers were tested in the effluent of an urban wastewater treatment plant for field trials, where three SA (sulfamethoxazole, sulfapyridine, and trimethoprim) and one FQ (ofloxacin) antibiotics were detected, with concentrations ranging from 25.50 to 117.58 ng/L, which are consistent with the results measured by grab sampling. The total removal efficiency of the antibiotics was 80.1% by the treatment plant. This study demonstrates that MIP-DGT is an effective tool for in situ monitoring of trace antibiotics in complex urban wastewaters.     

Concentrations and accumulation rates of polychlorinated biphenyls in soil along an urban–rural gradient in Shanghai

Environmental Science and Pollution Research - This study proposed an in situ soil experimental system to quantify concentration and accumulation rates of polychlorinated biphenyl (PCB) congeners...     

碘量法测定水中溶解氧有关问题的探讨及改进

碘量法测定溶解氧时,采用NH3·H2O—KI代替NaOH(KOH)—KI固定溶解氧,用H2SO4—H3PO(41+1)混合酸代替H2SO4溶解沉淀,使沉淀沉降速度加快,分界线明显,沉淀溶解也更完全。同时做样品空白实验,校正了氧化还原性物质产生的干扰,对废水有明显的抗干扰能力。通过对蒸馏水、自来水、池塘水、废水进行溶解氧测定,结果均非常满意。     

Determination of Steroid Estrogens in Wastewater Treatment Plant of A Controceptives Producing Factory

Steroid estrogens such as estrone (E1), 17β-estradiol (E2), estriol (E3), and 17α-ethynylestradiol (EE2) have been suspected to be the main contaminants, which can affect the endocrine system of animals. Many authors have investigated these chemicals in the domestic wastewater treatment plants (WTP). However, wastewater from industries producing steroid contraceptives has not got ample attention. From the environmental point of view, the four steroids are very significant because even very low concentrations (ng/L) can cause reproductive disturbances in human, livestock and wildlife. The main purpose of the present investigation was to develop an analytical method for the determination of the four steroid estrogens present in WTP of a pharmacy factory, mainly producing contraceptive medicine in Beijing, China. Analysis was performed by solid-phase extraction (SPE) system and liquid chromatography combined with tandem mass spectrometry (LC/MS/MS). The average recoveries from effluent samples ranged from 88% to 103% and the precision of the method ranged from 9% to 4%. Based on 0.5-L wastewater samples, the limit of quantification (LOQ) was determined at 0.7 ng/L for E1, 0.8 for E2, 0.9 ng/L for E3, and 0.5 ng/L for EE2 in influent, and 1.0 ng/L for E2 and EE2, and 2.0 ng/L for E1 and E3 in effluent. In the influent samples, average concentrations of 80, 85, 73 and 155 ng/L were determined for E1, E2, E3 and EE2, respectively, showing that they were removed in this WTP to the extent of 79, 73, 85 and 67%, respectively.     

固定源排污许可证监测管理制度研究

依靠排污许可证管理,固定源执行由行业排放标准为主正逐步过渡到"国家行业排放标准——单一源排放标准"双层排放标准,并以执行更全面和精准的单一源排放标准为主,对应的监测要求及考核方式更加多样化。对监测管理制度进行设计,明确固定源制定自行监测方案和守法监测的主体责任,厘清许可证核发部门、属地监测、执法部门的监管职责。系统设计"固定源制定并提交自行监测方案-核发部门审核-方案纳入排污许可证中成为规定-依规定自行监测和记录-固定源提交执行报告-监管部门审计式审核-执法监测和执法检查"的全过程管理机制,设计标准化的监管计划程序落实证后监管与执法监测,明晰监管部门的有限责任。     

我国环境监测方法标准体系的现状与发展构想

综述了我国环境监测方法标准体系的发展历程和现状,分析了环境监测方法标准在数量和内容及技术水平等方面不能满足环境管理需要、方法标准体系不健全、科学性有待提高等问题,提出加强环境监测方法标准的顶层设计、构建天地一体化的环境监测方法标准体系、实行动态管理并加强质控、加强监测科研借鉴国际经验等发展构想。     

A mini review of fluoride-induced apoptotic pathways

Fluorine or fluoride can have toxic effects on bone tissue and soft tissue at high concentrations. These negative effects include but not limited to cytotoxicity, immunotoxicity, blood toxicity, and oxidative damage. Apoptosis plays an important role in fluoride-induced toxicity of kidney, liver, spleen, thymus, bursa of Fabricius, cecal tonsil, and cultured cells. Here, apoptosis activated by high level of fluoride has been systematically reviewed, focusing on three pathways: mitochondrion-mediated, endoplasmic reticulum (ER) stress-mediated, and death receptor-mediated pathways. However, very limited reports are focused on the death receptor-mediated apoptosis pathways in the fluoride-induced apoptosis. Therefore, understanding and discovery of more pathways and molecular mechanisms of fluoride-induced apoptosis may contribute to designing measures for preventing fluoride toxicity.     

HRT对固定床厌氧反应器运行效果的影响

为了考察水力停留时间(HRT)对炭纤维载体固定床厌氧反应器运行效果的影响,在进水COD分别为20 000~25 000 mg/L和40 000~45 000 mg/L2个浓度范围下,研究了不同HRT对反应器运行效果的影响。结果表明,通过HRT的调整,在达到相同有机负荷(OLR)下,进水COD为20 000~25 000 mg/L的COD去除率和产气量,明显比进水COD为40 000~45 000 mg/L的运行效果好;进水COD为20 000~25 000 mg/L,HRT为14 h,相应的OLR为41.09 kgCOD/(m3.d)时,COD去除率仍然维持在68%以上,沼气容积产气率达到14.55 m3/(m3.d)。炭纤维载体固定床厌氧反应器具有较高的COD去除率、产气效率以及抵抗低pH、高负荷冲击的能力,运行过程中没有发生反应器堵塞的现象。     

可用于水体污染控制的氨氮转化菌筛选及部分降解特性的实验研究

从南京禄口水产养殖基地淡水鱼塘取淤泥作为分离菌株的土源,采用选择性富集培养法,从中分离到能以硫酸铵为氮源的菌株7株,对7个菌株进行氨氮降解实验,它们氨氮转化率分别为14.8%、19.7%、53.4%、94.2%、29.1%、63.5%和41.7%,其中AN-4菌株的转化率最高且生长良好。通过AN-4菌株16S rRNA基因序列分析以及生理生化方法,鉴定此菌株为克雷伯氏菌属(Klebsiellasp.)。对菌株AN-4转化氨氮的特性及温度、pH值、氨氮初始浓度和菌株接种量对其氨氮转化率的影响研究,结果表明,菌株AN-4降解氨氮的最适条件为:温度为30℃和pH值为8.0;当氨氮初始浓度为30mg/L时,AN-4菌株在24 h内的氨氮降解率可达85%以上,且能耐受高达200 mg/L的氨氮浓度;AN-4活化菌液浓度为108cfu/mL,当接种量为3×106cfu/mL时,AN-4菌株在24 h内的氨氮降解率为87.75%。综合上述结果,符合淡水养殖水环境条件,说明AN-4菌株适合在水产养殖中应用,为将菌株AN-4应用于水产养殖环境修复提供了理论依据。     

国内外可持续发展评价方法对比分析

国际、国内很多组织都对可持续性评价方法进行过研究分析,但大多是特定的案例研究.目前国内外对可持续发展评价方法没有一个全面系统的分析比较,使得不同地区比较起来很困难.本文对各种评价方法如环境可持续性指数法、生态足迹法、能值分析法和指标综合评价法的来源、理论和应用作了介绍.得出各方法适用范围:可持续性指数法适合于国家间的综合评价;生态足迹和能值分析法适合于各种范围,包括国家、区域、地区和小系统;指标体系综合评价法对于小范围更合适.同时对各种方法的优势和缺陷进行了分析讨论,得出:可持续性指数法信息量大,但是计算复杂;生态足迹法计算过程简单,但是缺失一些可持续性信息;能值分析法考虑问题全面,但是其原理涉及热力学知识,很难被一些学者认同;指标体系评价法变通性较大,可随着评价系统的变化而进行调整,但是主观性较强.通过分析指出不同方法适用范围并指出每种分析方法的优势和不足,为以后选择合适的分析方法评价对象的可持续性提供依据.