稠油火驱开采技术节能减排效果分析

火驱作为稠油热采的有效接替技术,与注蒸汽开采技术相比,具有采收率高,能耗低,CO_2排放少的优势。文章从火驱驱油机理特征阐述了火驱与注蒸汽技术的不同点,从燃料开采能耗、热效率、注入剂资源、数据对比四个方面分析火驱比注蒸汽热效率高,无燃料开采成本,能耗是注蒸汽的50%;从CO_2气体排放方式和排放量对比可知,火驱能够减少温室气体排放,为油田节能减排、环保生产起到积极作用。     

Bio-immobilization of Cu and Zn in recirculated bioreactor landfill

Purpose  

To protect the environmental quality of soil, groundwater, and surface water near the landfill site, it is necessary to make an accurate assessment of the heavy metal mobility. This study aims to present the bio-immobilization behavior of heavy metals in landfill and provide some reference suggestion for the manipulation of heavy metal pollution control after closure.     

多孔富铁填料曝气过滤除磷机理研究

采用多孔富铁填料的曝气过滤装置具有优良的除磷性能,理论分析研究了多孔富铁填料的除磷机理,通过铁细菌测定、电镜扫描、红外光谱分析等实验对其除磷机理进行了验证。结果表明,多孔富铁填料除磷为化学除磷过程,铁的形态转化中存在铁细菌的氧化作用,沉淀物以碱式磷酸铁为主。     

ASBBR-二级SBBR-化学除磷组合工艺处理榨菜腌制废水

针对榨菜腌制废水高盐高氮磷高有机物浓度的特征,提出"厌氧序批式生物膜反应器(ASBBR)-二级序批式生物膜反应器(SBBR)-化学除磷"组合处理工艺,在前期对组合工艺中单元工艺的关键工况参数研究的基础上,考察组合工艺的处理效能。实验结果表明,采用该组合工艺,可使进水COD、NH4+-N、TN及PO43--P分别为10 000、345、550和38.5mg/L的榨菜腌制废水,处理出水COD、NH4+-N、TN及PO43--P分别达到93.6、12.3、18和0.1 mg/L,去除率分别为99.1%、96.4%、96.7%和99.9%,出水达到污水综合排放一级标准。     

介质阻挡放电联合催化臭氧化降解甲苯

采用介质阻挡放电区后结合MnOx/Al2O3/发泡镍去除甲苯,考察甲苯进气方式、臭氧产生方法及湿度对甲苯与O3同时去除的影响。结果表明,O3是等离子体区后催化降解甲苯的主要物种,介质阻挡放电联合催化臭氧化可实现甲苯及O3的同时高效去除。输入电压为9.0 kV时,甲苯的去除效率达92.8%,在80 min内O3的去除效率维持在99%以上。水蒸气对催化剂催化分解臭氧的活性没有直接的影响,O3浓度较高时湿度对甲苯降解效率的影响很小。GC-MS分析结果表明,甲苯降解的主要气相副产物有烷烃、酸、酮和含苯环有机物,提出了甲苯的降解途径。     

Fenton氧化-活性炭吸附耦合处理焦化废水生化尾水的研究

研究了Fenton氧化、活性炭吸附、Fenton氧化一活性炭吸附等方法,对焦化废水生化尾水的处理效果,分析了Fenton氧化一活性炭吸附法处理焦化废水生化尾水的工艺条件。结果表明,Fenton氧化与活性炭吸附耦合处理焦化废水生化尾水的最优条件是：H2O2投加量为5mL／L,FeSO4·7H2O投加量为200mg／L,活性炭投加量为2g／L,反应pH=4．0,反应时间为20min。在此条件下,COD去除率可达82．6％,出水水质符合《污水综合排放标准》（GB8978--1996）一级标准。     

Identification and quantitative detection of Legionella spp. in various aquatic environments by real-time PCR assay

In this study, a SYBR green quantitative real-time PCR was developed to quantify and detect the Legionella spp. in various environmental water samples. The water samples were taken from watershed, water treatment plant, and thermal spring area in Taiwan. Legionella was detected in 13.6 % (24/176), and the detection rate for river water, raw drinking water, and thermal spring water was 10, 21.4, and 16.6 %, respectively. Using real-time PCR, concentration of Legionella spp. in detected samples ranged between 9.75?×?10⁴ and 3.47?×?10⁵?cells/L in river water, 6.92?×?10⁴ and 4.29?×?10⁵?cells/L in raw drinking water, and 5.71?×?10⁴ and 2.12?×?10⁶?cells/L for thermal spring water samples. The identified species included Legionella pneumophila (20.8 %), Legionella jordanis (4.2 %), Legionella nautarum (4.2 %), Legionella sp. (4.2 %), and uncultured Legionella sp. (66.6 %). The presence of L. pneumophila in aquatic environments suggested a potential public health threat that must be further examined.     

Characterization of PM(2.5) collected during broadcast and slash-pile prescribed burns of predominately ponderosa pine forests in northern Arizona

Prescribed burning, in combination with mechanical thinning, is a successful method for reducing heavy fuel loads from forest floors and thereby lowering the risk of catastrophic wildfire. However, an undesirable consequence of managed fire is the production of fine particulate matter or PM(2.5) (particles ≤2.5 μm in aerodynamic diameter). Wood-smoke particulate data from 21 prescribed burns are described, including results from broadcast and slash-pile burns. All PM(2.5) samples were collected in situ on day 1 (ignition) or day 2. Samples were analyzed for mass, polycyclic aromatic hydrocarbons (PAHs), inorganic elements, organic carbon (OC), and elemental carbon (EC). Results were characteristic of low intensity, smoldering fires. PM(2.5) concentrations varied from 523 to 8357 μg m(-3) and were higher on day 1. PAH weight percents (19 PAHs) were higher in slash-pile burns (0.21 ± 0.08% OC) than broadcast burns (0.07 ± 0.03% OC). The major elements were K, Cl, S, and Si. OC and EC values averaged 66 ± 7 and 2.8 ± 1.4% PM(2.5), respectively, for all burns studied, in good agreement with literature values for smoldering fires.     

两点进水条件下多种A2/O工艺的运行效果

在两点进水的条件下采用A2/O工艺处理化工园区废水厌氧水解出水,分析配水比对A2/O工艺处理效果的影响,以及在最优配水条件下,各类A2/O工艺处理废水的实际效果.结果表明,在厌氧段-缺氧段的配水比为30%～70%时,A2/O工艺的处理效果最好.在两点进水条件下的各类A2/O工艺中,倒置A2/O和改良A2/O比常规A2/...     

Effect of liquid-to-solid ratio on semi-solid Fenton process in hazardous solid waste detoxication

The liquid-to-solid ratio (L/S) of semi-solid Fenton process (SSFP) designated for hazardous solid waste detoxication was investigated. The removal and minimization effects of o-nitroaniline (ONA) in simulate solid waste residue (SSWR) from organic arsenic industry was evaluated by total organic carbon (TOC) and ONA removal efficiency, respectively. Initially, Box-Behnken design (BBD) and response surface methodology (RSM) were used to optimize the key factors of SSFP. Results showed that the removal rates of TOC and ONA decreased as L/S increased. Subsequently, four target initial ONA concentrations including 100 mg kg⁻¹, 1 g kg⁻¹, 10 g kg⁻¹, and 100 g kg⁻¹ on a dry basis were evaluated for the effect of L/S. A significant cubic empirical model between the initial ONA concentration and L/S was successfully developed to predict the optimal L/S for given initial ONA concentration for SSFP. Moreover, an optimized operation strategy of multi-SSFP for different cases was determined based on the residual target pollutant concentration and the corresponding environmental conditions. It showed that the total L/S of multi-SSFP in all tested scenarios was no greater than 3.8, which is lower than the conventional slurry systems (L/S ? 5). The multi-SSFP is environment-friendly when it used for detoxication of hazardous solid waste contaminated by ONA and provides a potential method for the detoxication of hazardous solid waste contaminated by organics.