Ozone Formation in California's San Joaquin Valley: A Critical Assessment of Modeling and Data Needs

ABSTRACT

Data from the 1990 San Joaquin Valley Air Quality Study/ Atmospheric Utility Signatures, Predictions, and Experiments (SJVAQS/AUSPEX) field program in California's San Joaquin Valley (SJV) suggest that both urban and rural areas would have difficulty meeting an 8-hr average O₃ standard of 80 ppb. A conceptual model of O₃ formation and accumulation in the SJV is formulated based on the chemical, meteorological, and tracer data from SJVAQS/ AUSPEX. Two major phenomena appear to lead to high O₃ concentrations in the SJV: (1) transport of O₃ and precursors from upwind areas (primarily the San Francisco Bay Area, but also the Sacramento Valley) into the SJV, affecting the northern part of the valley, and (2) emissions of precursors, mixing, transport (including long-range transport), and atmospheric reactions within the SJV responsible for regional and urban-scale (e.g., downwind of Fresno and Bakersfield) distributions of O₃. Using this conceptual model, we then conduct a critical evaluation of the meteorological model and air quality model. Areas of model improvements and data needed to understand and properly simulate O₃ formation in the SJV are highlighted.     

Using flue gas desulfurization gypsum to remove dissolved phosphorus from agricultural drainage waters

High levels of accumulated phosphorus (P) in soils of the Delmarva Peninsula are a major source of dissolved P entering drainage ditches that empty into the Chesapeake Bay. The objective of this study was to design, construct, and monitor a within-ditch filter to remove dissolved P, thereby protecting receiving waters against P losses from upstream areas. In April 2007, 110 Mg of flue gas desulfurization (FGD) gypsum, a low-cost coal combustion product, was used as the reactive ingredient in a ditch filter. The ditch filter was monitored from 2007 to 2010, during which time 29 storm-induced flow events were characterized. For storm-induced flow, the event mean concentration efficiency for total dissolved P (TDP) removal for water passing through the gypsum bed was 73 ± 27% confidence interval (α = 0.05). The removal efficiency for storm-induced flow by the summation of load method was 65 ± 27% confidence interval (α = 0.05). Although chemically effective, the maximum observed hydraulic conductivity of FGD gypsum was 4 L s(-1), but it decreased over time to <1 L s(-1). When bypass flow and base flow were taken into consideration, the ditch filter removed approximately 22% of the TDP load over the 3.6-yr monitoring period. Due to maintenance and clean-out requirements, we conclude that ditch filtration using FGD gypsum is not practical at a farm scale. However, we propose an alternate design consisting of FGD gypsum-filled trenches parallel to the ditch to intercept and treat groundwater before it enters the ditch.     

Modeling urban films using a dynamic multimedia fugacity model

A thin film coats impervious urban surfaces that can act as a source or sink of organic pollutants to the greater environment. We review recent developments in the understanding of film and film-associated pollutant behavior and incorporate them into an unsteady-state version of the fugacity based Multimedia Urban Model (MUM), focusing on detailed considerations of surface film dynamics. The model is used to explore the conditions under which these atmospherically-derived films act as a temporary source of chemicals to the air and/or storm water. Assuming film growth of 2.1 nm d⁻¹ (Wu et al., 2008a), PCB congeners 28 and 180 reach air-film equilibrium within hours and days, respectively. The model results suggest that the film acts as a temporary sink of chemicals from air during dry and cool weather, as a source to air in warmer weather, and as a source to storm water and soil during rain events. Using the downtown area of the City of Toronto Canada, as a case study, the model estimates that nearly 1 g d⁻¹ of ∑₅PCBs are transferred from air to film to storm water.     

Vitalizing effects of being outdoors and in nature

Five studies utilizing survey, experimental, and diary methods assessed the effects of being outdoors on subjective vitality. In Study 1, we used a vignette method to examine whether being outdoors was associated with vitality, above and beyond the influences of physical activity and social interactions. Study 2 explored the effects of being outdoors on vitality through an experimental design contrasting indoor and outdoor walks. In Study 3, participants were exposed to photographic scenes of either nature or buildings. Results showed that only the nature scenes enhanced subjective vitality. Studies 4 and 5 used a diary methodology to examine within-person variations in subjective energy as a function of being outdoors, again controlling for physical and social activity. Being outdoors was associated with greater vitality, a relation that was mediated by the presence of natural elements. Limitations of these studies are discussed, as well as their implications for research on energy and vitalization.     

Iophenoxic acid derivatives as markers of oral baits to wildlife

The bait-marker iophenoxic acid (IPA) and its derivatives are increasingly used for evaluating and optimizing the cost-effectiveness of baiting campaigns on wildlife, particularly on game species such as the wild boar. We aimed to determine whether concentrations of the three main IPA derivatives ethyl, methyl and propyl-IPA measured on thoracic liquid extracts (TLE) of hunted wild boars may be representative of two exposure doses, 40 and 200 mg, from 20 to 217 days after ingestion. Then we developed a method of detection of the three IPA derivatives by LC/ESI-MS-MS in muscle and liver to evaluate the suitability of these two other tissues for monitoring the marked bait consumption and for measuring available residues in the meat of marked animals. Three semi-captive wild boars received 40 mg of each IPA derivative, three received 200 mg, and three, as controls, did not receive IPA. Blood serum was sampled 20, 197 or 217 days after IPA exposure according to animals and to the derivative. Wild boars were shot by gun after the different times of serum sampling times, and TLE, muscle and liver were sampled. Our results suggest that TLE is not a relevant tissue for quantitatively expressing IPA exposure. Due to interference, no analytical method was validated on TLE containing digestive material. On the other hand, quantifications in the muscle and particularly in the liver could discriminate wild boars that had ingested the two IPA doses from 20 days until 7 months after exposure, especially for the two long term markers ethyl and propyl-IPA. So IPA quantifications in the liver sampled on hunted animals appear to be a reliable tool for monitoring bait consumption in the field at a large scale. Nevertheless, whatever the ingested dose, ethyl- and propyl-IPA concentrations measured in the muscle and the liver of tested animals until 217 days after exposure, remained higher than 0.01 mg/kg, the Maximal Residue Limit (MRL) is recommended for molecules for which no toxicological data are available. Based on the range of IPA residues available in these two tissues, implications for humans consuming marked animals are discussed.     

Analysis of an APCA Baghouse Operation and Maintenance Survey

Baghouse operation and maintenance is probably the most serious problem area of fabric filter operations. Committee TC-1 (Particulates) of the Air Pollution Control Association recently surveyed baghouse installations in'the United States for the purpose of gathering information on operation and maintenance procedures and problems. One hundred thirty-three questionnaires were completed and returned. In this paper, the results of a comprehensive analysis of these data are described and interpreted. A multiple-choice type of compilation of the responses has been used to permit statistical interpretation of the results. Due to the length of the questionnaire and the tables which resulted from the analysis, these are described but not included in the following paper. They are available from the TC-1 Committee c/o APCA.     

Some Factors in Minimizing Precipitator Costs

This paper is directed to those individuals involved in design of electrostatic precipitators. The Deutsch-Anderson model is usually employed by industry for the design of electrostatic precipitators. The so-called process design variable in this approach is the total capture area in the precipitator. Unfortunately, little is available on the equipment design of this unit, i.e., the geometric arrangement of the plates that constitute the capture area and the external dimensions of the physical structure that houses the precipitator components. These are important economic considerations, and it is to this subject that this paper is directed. It is relatively easy to predict equipment costs for “off-the-shelf” electrostatic precipitators; it is more difficult to closely predict the cost for a custom-made unit, which is more often the case encountered in practice. Once the capture area is calculated, the total precipitator cost becomes a strong function of the outer casing and outer accessories of the physical system. In this paper, a model is presented that can help minimize precipitator cost. An illustrative example complements the development of the model.     

Distribution of antidepressants and their metabolites in brook trout exposed to municipal wastewaters before and after ozone treatment--evidence of biological effects

This study examined the tissues distribution of selected serotonin reuptake inhibitors (SSRIs) in brook trout exposed for 3 months to continuous flow-through primary-treated effluent before and after ozone treatment. A reliable analytical method was developed for the quantification of trace amounts of antidepressants in small tissue homogenate extracts. Levels of six antidepressants and four of their N-desmethyl metabolites were determined using liquid chromatography-tandem mass spectrometry. Significant amounts of the SSRIs were found in fish tissue-in decreasing order: liver>brain>muscle. Sertraline and its metabolite desmethylsertraline were the predominant substances observed in most tissues (0.04-10.3 ng g(-1)). However, less SSRIs (0.08-1.17 ng g(-1)) were bioaccumulated in the ozonated effluent. The early molecular effects of these SSRIs on the Na/K-dependent ATPase pump activity in brain synaptosomes where also investigated in vitro and in fish exposed to the municipal effluents. With respect to their potential biological effects, in vitro exposure to selected SSRIs induced a reduction of the brain Na/K-ATPase activity in synaptosomes in a dose-dependent manner. Results showed that Na/K-ATPase activity was readily inhibited by exposure to municipal effluent before and, to a lesser extent, after ozone treatment. Moreover, the Na/K-ATPase activity was significantly and negatively correlated with brain tissue concentrations of fluoxetine (r=-0.57; p<0.03), desmethylsertraline (r=-0.84; p<0.001), and sertraline (r=-0.82; p<0.001). The present study reveals that SSRIs are readily available in fish, biologically active and corroborates previous findings on the serotonergic properties of municipal effluents to aquatic organisms.     

Framework for integrating sustainability into remediation projects

The US Sustainable Remediation Forum (SURF) created this Framework to enable sustainability parameters to be integrated and balanced throughout the remediation project life cycle, while ensuring long‐term protection of human health and the environment and achieving public and regulatory acceptance. Parameters are considerations, impacts, or stressors of environmental, social, and economic importance. Because remediation project phases are not stand‐alone entities but interconnected components of the wider remediation system, the Framework provides a systematic, process‐based approach in which sustainability is integrated holistically and iteratively within the wider remediation system. By focusing stakeholders on the preferred end use or future use of a site at the beginning of a remediation project, the Framework helps stakeholders form a disciplined planning strategy. Specifically, the Framework is designed to help remediation practitioners (1) perform a tiered sustainability evaluation, (2) update the conceptual site model based on the results of the sustainability evaluation, (3) identify and implement sustainability impact measures, and (4) balance sustainability and other considerations during the remediation decision‐making process. The result is a process that encourages communication among different stakeholders and allows remediation practitioners to achieve regulatory goals and maximize the integration of sustainability parameters during the remediation process. © 2011 Wiley Periodicals, Inc.     

Experimental evaluation of emission factors of cement kilns burning hazardous wastes

Cement industry is an interesting way to eliminate combustible wastes. Thermal valorization is maximal, conditions of combustion are especially favorable to the destruction and the trapping of pollutants, and there are neither ultimate residues (slag) nor aqueous rejects. Moreover the properties of the cement are not modified. Nevertheless the increased use of substitution fuel may lead to deal with unusual amounts of heavy metals. Tests were realized on several rotary cement kilns with varying substitution ratios of fossil fuels by wastes. Mass balances were fitted over the whole plant, and emission factors were explained.