Radiological study of exposure levels in El Maghara underground coal mine

Coal is largely composed of organic matter, but it is the inorganic matter in coal minerals and trace elements that have been cited as possible causes of health, environmental and technological problems associated with the use of coal. Some trace elements in coal are naturally radioactive. These radioactive elements include uranium (U), thorium (Th) and their numerous decay products, including radium (Ra) and radon (Rn). Although these elements are less chemically toxic than other coal constituents, such as arsenic, selenium or mercury, questions have been raised concerning the possible risk from radiation. In order to accurately address these questions and to predict the mobility of radioactive elements during the coal fuel cycle, it is important to determine the specific activity, distribution and form of radioactive elements in coal. The assessment of the radiation exposure from coal burning is critically dependent on the specific activity of radioactive elements in coal and in the fly ash that remains after combustion. The El-Maghara coal mine is the only producing coal mine in Egypt. It is located in the middle of the Sinai desert about 250 km north-east of Cairo, where a coal-fired power plant is intended to be built. In this study, a pre-operational radiological baseline of the site and the occupational radiation exposures due to radon progeny in the mine were determined. The specific activities of 226Ra, 232Th and 40K in soil and coal dust samples collected along the main gallery ranges were found to be 6-22.9, 9.6-47.3 and 77-489 Bq kg-1, respectively. Soil samples collected around the mine showed concentrations of 226Ra, 232Th and 40K in the ranges 2.7-20.2, 3.2-12.6 and 14.6-201 Bq kg-1, respectively. All of the mean values of radon progeny were lower than the action levels for working places recommended in the International Commission on Radiological Protection (ICRP) 65.     

Activities of 210Po and 210Pb in the water column at Kuala Selangor, Malaysia

Natural radionuclides, such as (210)Po and (210)Pb were measured in the water samples collected from six stations at Kuala Selangor, Malaysia. Results for (210)Po and (210)Pb in dissolved and particulate phases have showed the difference in distribution and chemical behavior. The fluctuation activities of (210)Po and (210)Pb depend on wave action, geology and degree of fresh water input occurring at study areas and probably due to different sampling dates. The distribution coefficient, K(d), values of (210)Po and (210)Pb ranged from 2.0 x 10(3)lg(-1) to 265.15 x 10(5)lg(-1), and from 3.0 x 10(3)lg(-1) to 558.16 x 10(5)lg(-1), respectively. High K(d) values of (210)Po and (210)Pb indicated that a strong adsorption of (210)Po and (210)Pb onto suspended particles, and the sinking of both nuclides on the seabed at study locations were controlled by the characteristics of suspended particles.     

Occupational exposure of phosphate mine workers: airborne radioactivity measurements and dose assessment

Under the Egyptian program for radiation safety and control, airborne radioactivity measurements and radiological dose assessment were conducted in some phosphate and uranium mines. Abu-Tartor mine is one of the biggest underground phosphate mines in Egypt. Airborne radioactivity, radon ((222)Rn) and its short-lived decay products (progenies) and thoron ((220)Rn), were measured in selected locations along the mine. The environmental gamma and workers dose equivalent rate (mSv/y) were measured inside and outside the mine using thermo-luminescence dosimeters (TLD). The results were presented and discussed. The calculated annual effective dose due to airborne radioactivity is the main source of occupational exposure and exceeding the maximum recommended level by ICRP-60 inside the mine tunnels. A number of recommendations are suggested to control the occupational exposures.     

A review of botanical phytochemicals with mosquitocidal potential

Identification of novel effective mosquitocidal compounds is essential to combat increasing resistance rates, concern for the environment and food safety, the unacceptability of many organophosphates and organochlorines and the high cost of synthetic pyrethroids. An increasing number of researchers are reconsidering botanicals containing active phytochemicals in their efforts to address some of these problems. To be highly competitive and effective, the ideal phytochemical should possess a combination of toxic effects and residual capacity. Acute toxicity is required at doses comparable to some commercial synthetic insecticides while chronic or sub-chronic toxicity is required to produce growth inhibition, developmental toxicity and generational effects. In this article, we review the current state of knowledge on larvicidal plant species, extraction processes, growth and reproduction inhibiting phytochemicals, botanical ovicides, synergistic, additive and antagonistic joint action effects of mixtures, residual capacity, effects on non-target organisms, resistance, screening methodologies, and discuss promising advances made in phytochemical research.     

Effects of workplace thermal conditions on safe work behavior

The effect of workplace thermal conditions on worker safety has not previously been adequately investigated, due in part to the difficulty of defining a suitable safety performance measure. This report describes a study conducted in two industrial plants to determine if a correlation exists between the safety-related behavior of workers and workplace thermal conditions. Both heat exposure measurements and behavioral observations were taken over a 14-month period, for a total of over 17,000 observations. The results indicate that temperatures below and above those typically preferred by most people have a significantly detrimental effect on the safety-related behavior of workers. This is demonstrated by an index based on the ratio of observed unsafe behaviors to the total number of observed behaviors. The relationship between this index of unsafe behavior and the ambient temperature formed a U-shaped curve. The minimum unsafe behavior index occurred within the zone of preferred temperature (approximately 17°C to 23°C, WBGT). Other factors such as metabolic workload and time during the shift also had significant effects on worker safety-related behavior.     

Selection of an effective sludge dewatering system for a small wastewater treatment plant

The Jahra Plant was commissioned in 1981 as a secondary treatment plant employing the extended aeration process. The plant has been upgraded since that time by constructing additional tertiary filtration units to improve effluent quality. The plant has a design capacity of 66 000 m³/d. At present, the daily inflow to the plant is about 47 000 m³/d of domestic sewage. The sludge produced at the Jahra Plant can be classified as excess activated sludge which combines the primary and secondary solids. At present, there are 30 drying beds receiving about 100 m³ of sludge dally. Sewage-sludge production represents about 0.5% of the total flow treated at the plant and is increasing yearly with increases in population and water consumption. Present dewatering systems are not adequate to cope with expansion in sewage treatment. Increasing the capacity of the existing plant would require more drying beds that could exacerbate existing odor problems. Some dewatering systems, such as the belt filter press and the centrifuge, have been tested to determine the most effective one under local conditions. Appropriate polymer doses for thickening have been determined. This paper describes present sludge dewatering units and operating techniques which have been developed during the operation of this facility.     

基于测试数据的室内超宽带信道建模研究

基于室内超宽带信道测量研究建立了基于簇的时延抽头模型以及与距离和载频有关的新颖的路径损耗模型,建立了路径损耗同时与距离和频率的依赖关系.同时,研究发现视距和非视距接收信号幅度分别满足莱斯和瑞利分布.该模型对超宽带无线系统仿真和设计有重要的指导意义.     

Sequestration of toxic Pb（II） ions by chemically treated rubber （Hevea brasiliensis ） leaf powder

Rubber leaf powder (an agricultural waste) was treated with potassium permanganate followed by sodium carbonate and its performance in the removal of Pb(II) ions from aqueous solution was evaluated. The interactions between Pb(II) ions and functional groups on the adsorbent surface were confirmed by Fourier transform infrared (FT-IR) spectroscopy, scanning electron microscopy (SEM) coupled with X-ray energy dispersive spectroscopy (EDX). The effects of several important parameters which can affect adsorption capacity such as pH, adsorbent dosage, initial lead concentration and contact time were studied. The optimum pH range for lead adsorption was 4–5. Even at very low adsorbent dosage of 0.02 g, almost 100% of Pb(II) ions (23 mg/L) could be removed. The adsorption capacity was also dependent on lead concentration and contact time, and relatively a short period of time (60–90 min) was required to reach equilibrium. The equilibrium data were analyzed with Langmuir, Freundlich and Dubinin-Radushkevich isotherms. Based on Langmuir model, the maximum adsorption capacity of lead was 95.3 mg/g. Three kinetic models including pseudo first-order, pseudo second-order and Boyd were used to analyze the lead adsorption process, and the results showed that the pseudo second-order fitted well with correlation coefficients greater than 0.99.     

Crash data analysis: collective vs. individual crash level approach

INTRODUCTION: Traffic safety literature has traditionally focused on identification of location profiles where "more crashes are likely to occur" over a period of time. The analysis involves estimation of crash frequency and/or rate (i.e., frequency normalized based on some measure of exposure) with geometric design features (e.g., number of lanes) and traffic characteristics (e.g., Average Annual Daily Traffic [AADT]) of the roadway location. In the recent past, a new category of traffic safety studies has emerged, which attempts to identify locations where a "crash is more likely to occur." The distinction between the two groups of studies is that the latter group of locations would change based on the varying traffic patterns over the course of the day or even within the hour. METHOD: Hence, instead of estimation of crash frequency over a period of time, the objective becomes real-time estimation of crash likelihood. The estimation of real-time crash likelihood has a traffic management component as well. It is a proactive extension to the traditional approach of incident detection, which involves analysis of traffic data recorded immediately after the incident. The units of analysis used in these studies are individual crashes rather than counts of crashes. RESULTS: In this paper, crash data analysis based on the two approaches, collective and at individual crash level, is discussed along with the advantages and shortcomings of the two approaches.