Improved Titrilog Sensitivity

ABSTRACT

A method was developed to reproducibly measure environmental tobacco smoke (ETS) components generated by different cigarettes. Measurements were carried out in an unventilated, controlled environment chamber. True ETS (the aged and diluted combination of exhaled mainstream plus sidestream smoke) was generated by human smokers. To reliably quantitate components normally present at trace levels, the comparisons were carried out at elevated ETS concentrations—greater than 40 times those typically encountered in “real-world” settings.

The method was applied to four commercially available cigarettes and a cigarette prototype that primarily heats tobacco. Forty-three properties and components of the gas and particulate phases of ETS generated by the different cigarettes were measured. Good precision of measurement was obtained both within and between tests. Statistically significant differences in the concentration of ETS components were observed among the different commercial cigarettes and between the commercial and prototype cigarettes. Most ETS components from the prototype cigarette were reduced by >90% when compared to the commercial cigarettes. The method was used to determine the effect of cigarette design changes on the generation of ETS.     

Solid waste treatment opportunities in the Palestinian authority areas

Municipal services in the Palestinian Authority (PA) areas, including the West Bank and Gaza Strip (WBGS), are facing serious difficulties that have been intensified following the outbreak of the Palestinian uprising in late September 2000. The solid waste management services, being the most essential services provided by the municipalities and village councils, are mostly affected by the ongoing harsh situation and hence proper solutions that take into account the actual amount of generated municipal solid waste and its composition is a pre-requisite for planning proper treatment. Hence, a study was carried out to identify the actual status of solid waste in eight West Bank districts. A social survey was also conducted to collect information concerning the level of public awareness among communities surveyed to the perception of solid waste recycling and reuse. The results of the survey conducted in 2001–2002 were later reviewed during July–October 2008 to assess if the trend of domestic solid waste generation had changed. Based on the survey and post-assessment, it is found that political and economic conditions have both significantly impacted the trend of generated municipal solid waste and since no improvements in either condition are forthcoming, it is concluded that survey results could be used in a planning study. A possible handling of the generated wastes may entail transferring the recyclable waste to Israeli recycling industries, and in constructing three composting plants in different accessible locations in the West Bank.     

Organ targeted prenatal gene therapy—how far are we?

Prenatal gene therapy aims to deliver genes to cells and tissues early in prenatal life, allowing correction of a genetic defect, before long-term tissue damage has occurred. In contrast to postnatal gene therapy, prenatal application can target genes to a large population of dividing stem cells, and the smaller fetal size allows a higher vector-to-target cell ratio to be achieved. Early-gestation delivery may allow the development of immune tolerance to the transgenic protein which would facilitate postnatal repeat vector administration if needed. Targeting particular organs will depend on manipulating the vector to achieve selective tropism and on choosing the most appropriate gestational age and injection method for fetal delivery. Intra-amniotic injection reaches the skin, and other organs that are bathed in the fluid however since gene transfer to the lung and gut is usually poor more direct injection methods will be needed. Delivery to the liver and blood can be achieved by systemic delivery via the umbilical vein or peritoneal cavity. Gene transfer to the central nervous system in the fetus is difficult but newer vectors are available that transduce neuronal tissue even after systemic delivery. Copyright © 2011 John Wiley & Sons, Ltd.     

Current Technology for Continuous Monitoring of Particulate Emissions

Particulate matter is characterized by its physical and chemical properties. Federal and state emission standards identify two important physical properties, opacity (visible emissions) and particulate mass concentration. In addition, particle size and particle composition are characteristics that play a significant role in the assessment of health effects, visibility, and control strategy. Systems to monitor these particle characteristics are in various stages of development. Opacity monitors have the longest history of commercial availability and of applicability to various source emissions. Particulate mass monitors have a short history as commercially available systems and are under evaluation in various source applications. Particle size monitors are mainly in the advanced prototype development stage undergoing evaluation. Particle composition monitors are in the early stages of development as research prototypes. Real time size monitoring systems will eventually be wedded to real time particle composition analyzers to give a monitoring system for particle size distributions of chemical constituents.     

A laboratory study on the MSW mechanical behavior in triaxial apparatus

Shear strength characterization of MSW materials is a mandatory task when performing analyses related to landfill design and landfill geometry improvements. Despite the considerable amount of research focusing on MSW mechanical behavior there remain certain aspects which are not completely understood and deserve attention in particular the case of the undrained behavior of MSW. This paper presents the results of a comprehensive laboratory testing program using a large-scale triaxial apparatus at the Federal University of Bahia, Salvador, Brazil. The effect of factors such as confining pressure, unit weight, fiber content, rate of loading and over-consolidation on the MSW mechanical response were investigated. Tested samples presented typical MSW shear/strain curves (concave upward) in all the tests, despite the pore water pressure reaching levels almost equal to the confining pressure. The obtained results show that increasing confining stress, unit weight, loading rate, fiber content and over-consolidation lead to an increase in the MSW shear strength. The importance of the fibrous components in the waste behavior is highlighted and graphs showing the variation of the MSW shear strength with fiber content in different drainage conditions are shown. The authors believe these results could be of interest to many companies, especially considering the new trend of plastic material recycling (prior landfilling) for energy recovery purposes.     

Effect of teeth amalgam on mercury levels in the colostrums human milk in Lenjan

Human milk is usually the only source of food for infants during the first 4 to 5 months of their life. Maternal environmental mercury exposure is directly related to fish consumption or amalgam filling. In this research, 38 human milk samples were collected from mothers of Lenjan area who were not occupationally exposed with mercury. Mercury concentration in human milk was determined by AMA254 Mercury Analyzer. A level of mercury was examined in relation to somatometric, demographic and dental amalgam parameters. Obtained results showed that only dental amalgam significantly increased the mercury level in human milk (p < 0.001). The mean mercury concentrations in milk of mothers without teeth fillings (n = 13), with one to three teeth fillings (n = 10), and four to eight teeth fillings (n = 15) were 2.87, 5.47, and 13.33 μg/l, respectively. The result of this study also showed a positive correlation of mercury milk levels with the number of teeth fillings of the mother (p < 0.05, r = 0.755). The estimated weekly intake of mercury of a breastfed infant in this study was, in some cases, higher than provisional tolerance weekly intake recommended by FAO/WHO, which pose a threat to their health.     

Organochlorine pesticide and polychlorinated biphenyl residues in feathers of birds from different trophic levels of South-West Iran

Persistent organochlorine pesticides (OCPs), such as dichlorodiphenyltrichloroethane (DDT) and its metabolites, hexachlorobenzene (HCB), alpha, beta and gamma-hexachlorocyclohexane (HCH) isomers, together with polychlorinated biphenyl (PCB) congeners (IUPAC Nos. 28, 52, 101, 138, 153 and 180), were determined in tail feathers from 37 birds belonging to 18 species, all originating from the South-West of Iran (Khuzestan, coast of the Persian Gulf). This is the first report on organochlorine contaminants in feathers from museum collections and it is an indication of the concentrations of OCPs and PCBs in the past (1991-1996). Median concentrations of HCHs, DDTs, PCBs and HCB were 22, 14, 11 and 10 ng/g feather, respectively. Significant correlations (p<0.05) were calculated between OCPs (except HCB) and PCBs in the bird feathers. p,p'-DDE and gamma-HCH were the most abundant OCPs, while CB 180, CB 138 and CB 101 were the predominant PCB congeners in almost all species. Significant differences (p<0.05) in the mean concentrations of DDTs and PCBs were detected among species grouped according to their feeding habits. Levels of DDTs and PCBs were highest in the carnivorous species and lowest in the herbivorous species. Levels of OCPs and PCBs in feathers of bids in the 1990s were generally below the thresholds reported to affect reproduction.     

Development of a Smoke Guide for the Evaluation of White Plumes

A smoke guide for use with white plumes has been developed by suspending size-graded industrial diamond dust in transparent plastic blocks. The guide consists of a series of four blocks containing dusts with white light transmittances of 20, 40, 60, and 80 per cent and scattering characteristics similar to those of white (oil) plumes commonly used for training smoke inspectors. The luminances of experimental plumes and guides with like transmittances are compared when viewed under different illuminating and viewing conditions. Similar tests with a U. S. Public Health Service Black Smoke Guide are also described.     

Organochlorine contaminants in the hair of Iranian pregnant women

In the present study, the hair of pregnant women was sampled between November 2007 and January 2008 in Ahvaz and Noushahr cities and the countryside of Noushahr, Iran. They were analyzed for organochlorine pesticides (OCPs), such as dichlorodiphenyltrichloroethane (DDT) and its metabolites, hexachlorobenzene (HCB), α-, β-, and γ-hexachlorocyclohexane (HCH) isomers and seven polychlorinated (PCBs) congeners (IUPAC Nos. 28, 52, 101, 118, 138, 153 and 180). Significant differences between the concentrations of investigated pollutants were found between the locations (p < 0.05). For HCHs, the γ-HCH isomer was measured at higher mean concentrations (6 ng g⁻¹ hair) compared to the β-HCH isomer (0.03 ng g⁻¹), which generally is the most prevalent HCH in biological matrices. Very high mean concentrations of p,p′-DDT in countryside of Noushahr (24 ng g⁻¹) combined with lower values (0.6) of ratio p,p′-DDE/p,p′-DDT in the hair samples suggest recent exposure to “fresh” DDT in this region. Significant differences in OCPs and PCBs were found between primiparous and multiparous mothers (p < 0.05). There was no correlation between levels of OCPs and PCBs in the hair of Iranian pregnant women and their age. There was a significant difference (p < 0.05) in the organochlorine levels, including HCHs, between mothers who have eaten fish once a week and those who consumed fish more than once per week in Noushahr.