Greenhouse gas mitigation and offset options for suckler cow farms: an economic comparison for the Swiss case

We assessed the economic suitability of 4 greenhouse gas (GHG) mitigation options and one GHG offset option for an improvement of the GHG balance of a representative Swiss suckler cow farm housing 35 Livestock units and cultivating 25 ha grassland. GHG emissions per kilogram meat in the economic optimum differ between the production systems and range from 18 to 21.9 kg CO₂-eq./kg meat. Only GHG offset by agroforestry systems showed the potential to significantly reduce these emissions. Depending on the production system agroforestry systems could reduce net GHG emissions by 66% to 7.3 kg CO₂-eq./kg meat in the most intensive system and by 100% in the most extensive system. In this calculation a carbon sequestration rate of 8 t CO₂/ha/year was assumed. The potential of a combination of the addition of lipids to the diet, a cover of the slurry tank and the application of nitrification inhibitors only had the potential to reduce GHG emissions by 12% thereby marginal abatement costs are increasing much faster than for agroforestry systems. A reduction of the GHG emissions to 7.5 kg CO₂-eq./kg meat—possible with agroforestry only—raised costs between 0.03 CHF/kg meat and 0.38 CHF/kg meat depending on the production system and the state of the system before the reduction. If GHG emissions were reduced maximally average costs ranged between 0.37 CHF/kg meat, if agroforestry had the potential to reduce net GHG emissions to 0 kg CO₂-eq., to 1.17 CHF/kg meat if also other options had to be applied.     

电石炉炉气电改袋除尘技术

介绍了某厂3台20 000kVA内燃式电石炉炉气除尘系统由原来采用的电式除尘器改为袋式除尘器技术,同时将原系统内的增湿塔改造为强制风冷及预荷电、预除尘设备,这样不但可以降低烟气温度使其满足袋式除尘器对进口烟气温度的要求,同时使微细粉尘荷电凝聚,提高了后续袋式除尘器对颗粒的捕集效率,并降低了袋式除尘器的阻力损失。改造后的系统运行稳定,烟气出口排放浓度满足国家环保要求。     

Population dynamics and regulation in the cave salamander <Emphasis Type="Italic">Speleomantes strinatii</Emphasis>

Time series analysis has been used to evaluate the mechanisms regulating population dynamics of mammals and insects, but has been rarely applied to amphibian populations. In this study, the influence of endogenous (density-dependent) and exogenous (density-independent) factors regulating population dynamics of the terrestrial plethodontid salamander Speleomantes strinatii was analysed by means of time series and multiple regression analyses. During the period 1993–2005, S. strinatii population abundance, estimated by a standardised temporary removal method, displayed relatively low fluctuations, and the autocorrelation function (ACF) analysis showed that the time series had a noncyclic structure. The partial rate correlation function (PRCF) indicated that a strong first-order negative feedback dominated the endogenous dynamics. Stepwise multiple regression analysis showed that the only climatic factor influencing population growth rate was the minimum winter temperature. Thus, at least during the study period, endogenous, density-dependent negative feedback was the main factor affecting the growth rate of the salamander population, whereas stochastic environmental variables, such as temperature and rainfall, seemed to play a minor role in regulation. These results stress the importance of considering both exogenous and endogenous factors when analysing amphibian long-term population dynamics.     

A direct observation study of nighttime safety belt use in Indiana

INTRODUCTION: Nearly all direct observation studies of safety belt use are conducted exclusively during daylight hours. Recent work has suggested that safety belt use at night may differ from daytime belt use. METHODS: An observational study of nighttime safety belt use, utilizing specialized night vision equipment, was conducted in Indiana surrounding the Click It or Ticket 2006 safety belt mobilization activities. A pre- and a post-mobilization statewide direct observation survey was conducted at night coinciding with daytime safety belt use data collection conducted by the state of Indiana. Daytime and nighttime belt use rates were compared. RESULTS: The comparisons across the mobilization period revealed a significant increase during the day, but a significant decrease at night. Comparisons between daytime and nighttime belt use revealed no overall difference during the pre wave, but a significant difference during the post wave. Finally, many common daytime trends in belt use were also found at night, with the exception of the typical age and seating position effects. DISCUSSION: The mobilization activities had a positive effect on daytime belt use, but no effect on nighttime belt use, likely resulting in the differences between daytime and nighttime belt use observed during the post wave. IMPACT ON INDUSTRY: The findings of this study suggest that safety belt mobilizations implemented only during the day do not influence nighttime safety belt use. Changes to how these programs are implemented or additional programs specifically targeting belt use at night should be considered, along with continued monitoring of nighttime belt use.     

A juvenile lizard specimen with well-preserved skin impressions from the Upper Jurassic/Lower Cretaceous of Daohugou, Inner Mongolia, China

Lizards are now relatively well known from the Yixian Formation of northeastern China. In this study, we describe a juvenile lizard from a fossil horizon at Daohugou, Inner Mongolia. These beds predate the Yixian Formation, and are probably Late Jurassic or earliest Cretaceous in age. The new specimen thus documents the first lizard material from the Daohugou locality and is the earliest lizard skeleton from China. Comparisons with developmental stages of modern lizards suggest the Daohugou lizard is a hatchling. Although tiny, the specimen is notable in preserving exquisite skin impressions showing the variation in scalation across the body, the shape and position of the cloacal outlet, and details of the manus and pes. These are the earliest recorded lepidosaurian skin traces. In its general proportions and the possession of paired frontals, the small Daohugou lizard resembles both the Yixian taxon Yabeinosaurus tenuis and the questionable Jeholacerta formosa, but it differs from the latter in scalation and, based on other characters, may be distinct from both.     

A new THOR shoulder design: a comparison with volunteers, the Hybrid III, and THOR NT

OBJECTIVE: Since the shoulders are rarely seriously injured in frontal or oblique collisions, they have been given low priority in the development of frontal impact crash test dummies. The shoulder complex geometry and its kinematics are of vital importance for the overall dummy kinematics. The shoulder complex also influences the risk of the safety belt slipping off the shoulder in oblique forward collisions. The first aim of this study was to develop a new 50th percentile male THOR shoulder design, while the second was to compare the new shoulder, mounted on a THOR NT dummy, with volunteer, THOR NT, and Hybrid III range of motion and stiffness data. The third aim was to test the repeatability of the new shoulder during dynamic testing and to see how the design behaves with respect to belt slippage in a 45 degrees far-side collision. METHODS: The new 50th percentile THOR shoulder design was developed with the aid of a shell model of the seated University of Michigan Transportation Research Institute (UMTRI) 50th percentile male with coordinates for joints and bony landmarks (Schneider et al., 1983). The new shoulder design has human-like bony landmarks for the acromion and coracoid processes. The clavicle curvature and length are also made similar to that of a male human, as is the range of motion in the anterior-posterior, superior-inferior, and medial-lateral directions. The new shoulder design was manufactured and tested under the same conditions that T?rnvall et al. (2005b) used to compare the shoulder range of motion for the volunteers, Hybrid III, and THOR Alpha. The new design was also tested in two dynamic test configurations: the first was a 0 degrees full-frontal test and the second was a 45 degrees far-side test. The dummy tests were conducted with an R-16 seat with a three-point belt, the Delta V was 27.0+/-0.5 km/h and the maximum peak acceleration was approximately 14.6+/-0.5 g for each test. RESULTS: A new shoulder design with geometry close to that of humans was developed to be retrofitted to the THOR NT dummy. The results showed that the range of motion for the new shoulder complex during static loading was larger by at least a factor of three, for the maximum load (200 N/arm), than that of either the Hybrid III or the THOR NT; this means it was more similar to the volunteers' range of motion. It was observed that the THOR NT with the new shoulder did not slide out of the shoulder belt during a far-side collision. The performance of the new shoulder was reasonably repeatable and stable during both the static tests and the sled tests. CONCLUSION: A new shoulder for the THOR NT has been designed and developed, and data from static range of motion tests and sled tests indicate that the new shoulder complex has the potential to function in a more human-like manner on the THOR dummy.     

Direct evidence of hybodont shark predation on Late Jurassic ammonites

Sharks are known to have been ammonoid predators, as indicated by analysis of bite marks or coprolite contents. However, body fossil associations attesting to this predator–prey relationship have never been described so far. Here, I report a unique finding from the Late Jurassic of western France: a complete specimen of the Kimmeridgian ammonite Orthaspidoceras bearing one tooth of the hybodont shark Planohybodus. Some possible tooth puncture marks are also observed. This is the first direct evidence of such a trophic link between these two major Mesozoic groups, allowing an accurate identification of both organisms. Although Planohybodus displays a tearing-type dentition generally assumed to have been especially adapted for large unshelled prey, our discovery clearly shows that this shark was also able to attack robust ammonites such as aspidoceratids. The direct evidence presented here provides new insights into the Mesozoic marine ecosystem food webs.     

Cranial shape transformation in the evolution of the giant panda (Ailuropoda melanoleuca)

In this study, landmark-based methods of geometric morphometrics are used for investigating the main aspects of cranial shape transformation in the evolution of the giant panda, Ailuropoda melanoleuca. Specifically, we explore if the highly derived cranial adaptations for bamboo feeding of the living panda were developed early in the panda's lineage. Results obtained show that the overall cranial morphologies of the oldest known panda, the "pygmy" Ailuropoda microta, and the late Pleistocene Ailuropoda baconi are both very similar to that of their closest living relative, A. melanoleuca, which agrees with a previous proposal based on qualitative criteria. However, we also describe several differences between the crania of A. microta, A. baconi, and A. melanoleuca, including the development of the postorbital process, the orientation of the occipital region, and the expansion of the braincase. As a result, the cranial morphology of A. microta shows a less specialized morphology toward a fibrous and durophagous diet compared to the giant panda. These results are confirmed by a comparative analysis of the dimensions of the upper teeth in bears, which has revealed differences in relative tooth size between A. microta and A. melanoleuca, most probably as a result of mosaic evolution. Therefore, we conclude that cranial shape did not remain essentially uniform in the Ailuropoda lineage, as previously thought, but underwent a number of changes during more than 2?Myr.     

Improvement of soil aggregate stability by repeated applications of organic amendments to a cultivated silty loam soil

The objective of this study was to compare the effects of repeated field applications of three urban compost amendments and one farmyard manure amendment over a 9-year period on aggregate stability in a silty loam soil initially characterized by low clay and initial organic matter contents and poor aggregate stability. Three different aggregate stability tests with increasing disruptive intensities (fast wetting > mechanical breakdown > slow wetting tests) and different disaggregation mechanisms, were used. All of the amendments, which were applied at approximately 4 Mg C ha⁻¹ every other year, increased the organic carbon content and improved the stability of the aggregates against the disruptive action of water, as determined by each of the stability tests. However, the year-to-year variations in the aggregate stability that related to factors other than the organic inputs were greater than the cumulative increase in aggregate stability relative to the control. The positive effects of the tested amendments on aggregate stability were linked to their contribution to soil organic C contents (r = 0.54 for the fast wetting test and r = 0.41-0.42 for the mechanical breakdown and slow wetting tests; p < 0.05). The addition of urban composts had a larger positive effect on aggregate stability than farmyard manure at the majority of sampling dates. The addition of biodegradable immature compost, such as municipal solid waste (MSW), improved the aggregate stability through an enhanced resistance to slaking. The addition of mature composts, such as the co-compost of sewage sludge and green wastes (GWS) or biowaste compost (BW), improved the aggregate stability by increasing interparticular cohesion. The MSW compost was the most efficient in improving aggregate stability during the first 6 years of the experiment (average improvements of +22%, +5% and +28% in the fast wetting, mechanical breakdown and slow wetting tests, respectively, compared to the control treatment); this result was likely due to the larger labile organic pool of the MSW compost that was highly effective at stimulating soil microbial activity. After the first 6 years, the two other composts, GWS and BW, became more efficient (average improvements of +25%, +61% and +33% in the fast wetting, mechanical breakdown and slow wetting tests, respectively, compared to the control treatment), which was probably linked to the greater increase in soil organic C contents. Therefore, the application of urban compost to silty soil that is susceptible to water erosion was effective at improving aggregate stability and thus could be used to enhance the resistance of soil to water erosion.     

A new captorhinid reptile, Gansurhinus qingtoushanensis, gen. et sp. nov., from the Permian of China

Captorhinids, a clade of Paleozoic reptiles, are represented by a rich fossil record that extends from the Late Carboniferous into the Late Permian. Representatives of this clade dispersed from the equatorial regions of Laurasia into the temperate regions of Pangea during the Middle and Late Permian. This rich fossil record shows that there was an evolutionary trend from faunivorous to omnivorous and herbivorous feeding habits within this clade. The discovery of well-preserved captorhinid materials in the Middle Permian of China allows us to determine that the new taxon, Gansurhinus qingtoushanensis, gen. et sp. nov, is a member of Moradisaurinae, a clade of captorhinids with multiple tooth rows arranged in parallel. The presence of this moradisaurine in the Middle Permian of south central Asia leads us to suggest that paleogeographic changes during the Permian, with part of what is today China becoming a large peninsula of Pangea, allowed these early reptiles as well as other terrestrial vertebrates to extend their geographic ranges to this region of the Late Paleozoic supercontinent.