Chemical composition of rainwater in the northeastern Romania, Iasi region (2003–2006)

Chemical composition of rainwater was studied in the northeastern Romania, Iasi region, and the concentrations of major inorganic and organic ions were measured in samples collected between April 2003 and December 2006. The pH of the rainwater is 5.92 (volume weighted mean average, VWM) suggesting a sufficient load of alkaline components neutralizing its acidity. On average, 97% of the acidity in the collected samples is neutralized by CaCO₃ and NH₃. Clear seasonal variations were observed for some of the identified ions (e.g., SO₄²⁻, NO₃⁻, Ca²⁺, NH₄⁺). The data obtained during this work revealed that both concentrations and fluxes of anthropogenic source-related ions (e.g., SO₄²⁻, NO₃⁻ and NH₄⁺) are among the highest reported for European sites. It is shown that meteorology and long-range transport processes may concur to their high levels.     

Levels, sources and spatiotemporal variation of nutrients and micropollutants in small streams of a Mediterranean River basin

In this study, nutrients, trace metals and priority pesticide compounds were investigated for the first time in water and sediment samples in streams of the Evrotas River basin (S.E. Greece) from 2006 to 2008. The most important sources of contamination were from the entry of pesticides and nutrients into surface waters and sediments as a result of the intensive agricultural activity as well as from the uncontrolled disposal of olive mill and citrus processing wastewaters. Aquatic risk assessment revealed that all insecticides detected showed high risk, suggesting adverse effects on the stream biota. Among the metals analyzed, Cr, Ni and Ba presented the highest concentrations in sediments, however, due to natural geological processes. Multivariate statistical techniques applied for data compression, exploration and interpretation proved to be useful tools for identifying the most critical pollutants affecting the surface water quality. The findings of this study suggest that the inclusion of streams with small catchment areas into WFD monitoring and assessment programs is essential, especially those of the Mediterranean region.     

Effectiveness of tertiary treatment processes in removing different classes of emerging contaminants from domestic wastewater

● Different advanced treatment processes were tested for ECs removal from wastewater. ● UV radiation showed low to moderate removal for 5 of the 38 micropollutants. ● Among tested membrane processes, nanofiltration showed the better performance. ● The use of PAC achieved high or partially removal for 31 out of the 38 compounds. ● The environmental and economical evaluation of a pilot-scale PAC unit is suggested. In this work, 38 different organic emerging contaminants (ECs), belonging to various chemical classes such as pharmaceuticals (PhCs), endocrine-disrupting chemicals (EDCs), benzotriazoles (BTRs), benzothiazoles (BTHs), and perfluorinated compounds (PFCs), were initially identified and quantified in the biologically treated wastewater collected from Athens’ (Greece) Sewage Treatment Plant (STP). Processes already used in existing STPs such as microfiltration (MF), nanofiltration (NF), ultrafiltration (UF), UV radiation, and powdered activated carbon (PAC) were assessed for ECs’ removal, under the conditions that represent their actual application for disinfection or advanced wastewater treatment. The results indicated that MF removed only one out of the 38 ECs and hence it was selected as pretreatment step for the other processes. UV radiation in the studied conditions showed low to moderate removal for 5 out of the 38 ECs. NF showed better results than UF due to the smaller pore sizes of the filtration system. However, this enhancement was observed mainly for 8 compounds originating from the classes of PhCs and PFCs, while the removal of EDCs was not statistically significant. Among the various studied technologies, PAC stands out due to its capability to sufficiently remove most ECs. In particular, removal rates higher than 70% were observed for 9 compounds, 22 were partially removed, while 7 demonstrated low removal rates. Based on our screening experiments, future research should focus on scaling-up PAC in actual conditions, combining PAC with other processes, and conduct a complete economic and environmental assessment of the treatment.     

The war in Kosovo

During the operation “Allied Force” in the spring of 1999, the burning or damaging of industrial and military targets in the Former Republic of Yugoslavia resulted in the release of a large number of chemicals into the atmosphere. The releases contained not only conventional air pollutants, but also Semi-Volatile Organic compounds (SVOs) which are known to be hazardous to health. Under suitable meteorological conditions, these chemicals can be transported across borders over large distances. In this paper, an analysis of measurements and dispersion calculations is presented which provides evidence of pollutant transport from the conflict area to Greece. The measuring program was carried out in Xanthi, Greece and included aerosol sampling and subsequent analysis for the determination of the concentration of SVOs including dioxins, furans, PCBs (PolyChlorinated Biphenyls), PAHs (Polycyclic Aromatic Hydrocarbons) and organic phthalates. This paper focuses on two episodes of organic phthalates that were observed during the conflict period. Pollution measurements are interpreted by means of air trajectories and dispersion calculations. For this purpose, the HYSPLIT_4 (HYbrid Single-Particle Langrangian Integrated Trajectory) modeling system is used to calculate the dispersion of toxic substances.     

Sediment and Suspended Matter Lead Contamination in the Gulf of Kavala, Greece

Sediment and suspended particulate matter samples from 24 stations in the Gulf of Kavala have been examined for lead contamination. Grain size analysis and organic matter content were also performed. Total – anthropogenic sediment lead concentrations and enrichment factors at stations close to harbors and chemical industries were found higher (up to 209–135μg/g and 4.12 respectively), in relation to concentrations from the rest of the coastal zone. In the above areas, increased suspended particulate lead in the bottom of the water column was also recorded (up to 109μg/g). Total sediment lead concentrations composed of high natural Pb background increased with decreasing grain size, suggesting their association with the fine fractions of the sediments (31.1–66.0% mud presence) and the organic matter content (6–9% higher values). Overall, higher total lead concentrations in the sediments, determined by this work, appear to be significantly different from those reported for the Gulf of Kavala in previous studies and similar to those detected in other highly contaminated eastern Mediterranean coastal areas.     

Chemical composition and mass closure of ambient PM10 at urban sites

The chemical composition of PM10 was studied during summer and winter sampling campaigns conducted at two different urban sites in the city of Thessaloniki, Greece (urban-traffic, UT and urban-industrial, UI). PM10 samples were chemically analysed for minerals (Si, Al, Ca, Mg, Fe, Ti, K), trace elements (Cd, Cr, Cu, Mn, Pb, V, Zn, Te, Co, Ni, Se, Sr, As, and Sb), water-soluble ions (Cl^?, NO₃^?, SO₄^2?, Na⁺, K⁺, NH₄⁺, Ca²⁺, Mg²⁺) and carbonaceous compounds (OC, EC). Spatial variations of atmospheric concentrations showed significantly higher levels of minerals, some trace metals and TC at the UI site, while at the UT site significantly higher levels of elements like Cd, Ba, Sn, Sb and Te were observed. Crustal elements, excepting Ca at the UI site, did not exhibit significant seasonal variations at any site pointing to constant emissions throughout the year. In order to reconstruct the particle mass, the determined components were classified into six classes as follows: mineral matter (MIN), trace elements (TE), organic matter (OM), elemental carbon (EC), sea salt (SS) and secondary inorganic aerosol (SIA). Good correlations with slopes close to 1 were found between chemically determined and gravimetrically measured PM10 masses for both sites. According to the chemical mass closure obtained, the major components of PM10 at both sites were MIN (soil-derived compounds), followed by OM and SIA. The fraction unaccounted for by chemical analysis comprised on average 8% during winter and 15% during summer at the urban-industrial site, while at the urban-traffic site the percentages were 21.5% in winter and 4.8% in summer.     

Defining chemical status of a temporary Mediterranean River

Although the majority of rivers and streams in the Mediterranean area are temporary, no particular attention is being paid for such systems in the Water Framework Directive (WFD). A typical temporal Mediterranean river, draining an intensively cultivated basin, was assessed for its chemical status. Elevated concentrations of nitrates and salts in river water as well as nutrients and heavy metals in river sediments have been attributed to agricultural land uses and practices and point sources of organic pollution. A scheme for the classification of the river's chemical status (within the ecological quality classification procedure) was applied by combining pollution parameters in groups according to related pressures. In light of the temporal hydrological regime and anthropogenic impacts, sediment chemical quality elements were considered, in addition to hydrochemical ones. Despite the extensive agricultural activities in the basin, the majority of the sites examined showed a good quality and only three of them were classified as moderate. For the classification of the chemical quality of temporary water bodies, there is a need to develop ecologically relevant salinity and sediment quality standards.     

The role of mechanical and biological treatment in reducing methane emissions from landfill disposal of municipal solid waste in the United Kingdom

In Europe, the European Union Landfill Directive aims to reduce the negative environmental impacts of landfilling. This is mainly to be achieved by reducing the quantity of organic matter deposited, through measures such as the separate collection and recycling of the organic waste stream or pretreatment of residual wastes before landfilling. Other than incineration or other thermal processes, mechanical biological treatment is playing an increasingly important role. This study was conducted to seek the benefits of municipal solid waste (MSW) pretreatment, as well as the differences in methane production from the landfilling of untreated and mechanically/biologically treated (MBT) MSW using GasSim simulation. Results demonstrated that methane production rates vary significantly among waste fractions. Those that contribute most to methane generation (organic material and potentially reusable or recyclable material) could be targeted and treated before landfilling. The statistic relationship from the first phase of the study indicated that to match the increasingly stringent landfill waste organic content allowance, local councils should prioritize the reduction/sorting of certain targeted fractions, such as paper, card, green waste, and other putrescibles from MSW. Moreover, mechanical treatment alone produces organic-rich waste called mechanically sorted organic residues (MSORs), which can be viewed as an organic content concentration process. Mechanically and biologically pretreated waste, on the other hand, differs significantly from untreated MSW and MSORs. This work demonstrated that if efficient mechanical-biological treatment is used, considerable reductions in biological activity, landfill gas production, and energy content/total organic carbon could be achieved. Using GasSim, reductions in methane production of >74% have been simulated if a 90% organic content reduction can be achieved during biological treatment on MSORs. A 50-60% organic content reduction by following biological treatment can turn MSOR properties only into normal MSW equivalent though considerably less volume.     

A comparative chemometric study for water quality expertise of the Athenian water reservoirs

The aim of the present study is to compare the application of unsupervised and supervised pattern recognition techniques for the quality assessment and classification of the reservoirs used as the source for the domestic and industrial water supply of the city of Athens, Greece. A new optimization strategy for sampling, monitoring, and water management is proposed. During the period of October 2006 to April 2007, 89 samples were collected from the three water reservoirs (Iliki, Mornos, and Marathon), and 13 parameters (metals and metalloids) were analytically determined. Generally, all the elements were found to fluctuate at very low levels, especially for Mornos that comprises the main water reservoir of Athens. Iliki and Marathon showed relatively elevated values, compared to Mornos, but below the legislative limits. Multivariate unsupervised statistical techniques, such as factor analysis/principal components analysis, and cluster analysis and supervised ones, like discriminant analysis and classification trees, were applied to the data set, and their classification abilities were compared. All the chemometric techniques successfully revealed the critical variables and described the similarities and dissimilarities among the sampling points, emphasizing the individual characteristics in every sample and revealing the sources of elements in the region. New data from posterior samplings (November and December 2007) were used for the validation of the supervised techniques. Finally, water management strategies were proposed concerning the sampling points and representative parameters.     

Integration & assessment of recycling into c-Si photovoltaic module’s life cycle

Photovoltaic (PV) energy generation devices have experienced a vigorous growth in production over the last decade in all major industrialised countries. In this research paper, the assessment of recycling and subsequent production of new crystalline silicon (c-Si) PV modules taking advantage of the recovered Si in terms of industrial symbiosis is being examined. With the aid of life cycle analysis method, the potential payback is thoroughly examined through a scenario application in the second useful phase of the PV module. Furthermore, key environmental performance indicators have been implemented in order to evaluate power and resource demands.