The Avoidance Responses of Daphnia magna to the Exposure of Organophosphorus Pesticides in an On-Line Biomonitoring System

In this study, avoidance behavior of the freshwater cladoceran Daphnia magna Straus was used as indicator to assess the early stress of accidental organophosphorus pesticide (OP) contamination. The movement behavior was detected by a multi-species biomonitoring system. There was obvious concentration–response relationship between the OP stress and the behavioral response even at sublethal exposure. A rising OP stress resulted in a significant decrease of response time to escape (RTE; p<0.05). In comparison of different OPs, it was found that there was a power regression between RTE and the toxic unit of OPs. Therefore, the avoidance behavior of D. magna was a sensitive indicator of sublethal OP stress, and the power relationship could be used to predict the early warning thresholds of more OPs in the on-line biomonitoring system.     

Efficacy of electrical resistivity and induced polarization methods for revealing fluoride contaminated groundwater in granite terrain

The accumulation of fluoride (F) in groundwater is a common phenomenon in India and worldwide. Its location can be identified through a direct hydrochemical analysis, which was carried out in Kurmapalli watershed (located 60 km SE of Hyderabad city), Nalgonda district, Andhra Pradesh, India affected by F contamination. The results of the hydrochemical analysis showed that F varied from 0.71 to 19.01 mg/l and its concentration exceeded the permissible limit (i.e., 1.5 mg/l) in 78% of the total 32 samples analyzed. The highest F value (19.01 mg/l) was found near Madnapur village, which is located in the central part of the watershed. Resistivity and induced polarization (IP) surveys were also carried out to reveal the zones where elevated F-contaminated groundwater exists. The objective of this paper was to highlight the utility of resistivity and IP surveys, using hydrochemical constituents as constraint, for the successful delineation of such contaminated/polluted groundwater zones in the granite area.     

Long-term effect of rice-based farming systems on soil health

Integrated rice–fish culture, an age-old farming system, is a technology which could produce rice and fish sustainably at a time by optimizing scarce resource use through complementary use of land and water. An understanding of microbial processes is important for the management of farming systems as soil microbes are the living part of soil organic matter and play critical roles in soil C and N cycling and ecosystem functioning of farming system. Rice-based integrated farming system model for small and marginal farmers was established in 2001 at Central Rice Research Institute, Cuttack, Odisha. The different enterprises of farming system were rice–fish, fish–fingerlings, fruits, vegetables, rice–fish refuge, and agroforestry. This study was conducted with the objective to assess the soil physicochemical properties, microbial population, carbon and nitrogen fractions, soil enzymatic activity, and productivity of different enterprises. The effect of enterprises induced significant changes in the chemical composition and organic matter which in turn influenced the activities of enzymes (urease, acid, and alkaline phosphatase) involved in the C, N, and P cycles. The different enterprises of long-term rice-based farming system caused significant variations in nutrient content of soil, which was higher in rice–fish refuge followed by rice–fish enterprise. Highest microbial populations and enzymatic properties were recorded in rice–fish refuge system because of waterlogging and reduced condition prolonged in this system leading to less decomposition of organic matter. The maximum alkaline phosphatase, urease, and FDA were observed in rice–fish enterprise. However, highest acid phosphatase and dehydrogenase activity were obtained in vegetable enterprise and fish–fingerlings enterprise, respectively.     

Modelling of lindane transport in groundwater of metropolitan city Vadodara,Gujarat, India

Migration pattern of organochloro pesticide lindane has been studied in groundwater of metropolitan city Vadodara. Groundwater flow was simulated using the groundwater flow model constructed up to a depth of 60 m considering a three-layer structure with grid size of 40?×?40?×?40 m³. The general groundwater flow direction is from northeast to south and southwest. The river Vishwamitri and river Jambua form natural hydrologic boundary. The constant head in the north and south end of the study area is taken as another boundary condition in the model. The hydraulic head distribution in the multilayer aquifer has been computed from the visual MODFLOW groundwater flow model. TDS has been computed though MT3D mass transport model starting with a background concentration of 500 mg/l and using a porosity value of 0.3. Simulated TDS values from the model matches well with the observed data. Model MT3D was run for lindane pesticide with a background concentration of 0.5?μg/l. The predictions of the mass transport model for next 50 years indicate that advancement of containment of plume size in the aquifer system both spatially and depth wise as a result of increasing level of pesticide in river Vishwamitri. The restoration of the aquifer system may take a very long time as seen from slow improvement in the groundwater quality from the predicted scenarios, thereby, indicating alarming situation of groundwater quality deterioration in different layers. It is recommended that all the industries operating in the region should install efficient effluent treatment plants to abate the pollution problem.     

Changes in contaminant mass discharge from DNAPL source mass depletion: evaluation at two field sites

Changes in contaminant fluxes resulting from aggressive remediation of dense nonaqueous phase liquid (DNAPL) source zone were investigated at two sites, one at Hill Air Force Base (AFB), Utah, and the other at Ft. Lewis Military Reservation, Washington. Passive Flux Meters (PFM) and a variation of the Integral Pumping Test (IPT) were used to measure fluxes in ten wells installed along a transect down-gradient of the trichloroethylene (TCE) source zone, and perpendicular to the mean groundwater flow direction. At both sites, groundwater and contaminant fluxes were measured before and after the source-zone treatment. The measured contaminant fluxes (J; ML(-2)T(-1)) were integrated across the well transect to estimate contaminant mass discharge (M(D); MT(-1)) from the source zone. Estimated M(D) before source treatment, based on both PFM and IPT methods, were approximately 76 g/day for TCE at the Hill AFB site; and approximately 640 g/day for TCE, and approximately 206 g/day for cis-dichloroethylene (DCE) at the Ft. Lewis site. TCE flux measurements made 1 year after source treatment at the Hill AFB site decreased to approximately 5 g/day. On the other hand, increased fluxes of DCE, a degradation byproduct of TCE, in tests subsequent to remediation at the Hill AFB site suggest enhanced microbial degradation after surfactant flooding. At the Ft. Lewis site, TCE mass discharge rates subsequent to remediation decreased to approximately 3 g/day for TCE and approximately 3 g/day for DCE approximately 1.8 years after remediation. At both field sites, PFM and IPT approaches provided comparable results for contaminant mass discharge rates, and show significant reductions (>90%) in TCE mass discharge as a result of DNAPL mass depletion from the source zone.     

Co-present Pb(II) accelerates the oxidation of organic contaminants by permanganate: Role of Pb(III)

• Simultaneous removal of organic contaminants and Pb(II) was achieved by Mn(VII). • Pb(II) enhanced Mn(VII) oxidation performance over a wide pH range. • Pb(II) did not alter the pH-rate profile for contaminants oxidation by Mn(VII). • Mn(VII) alone cannot oxidize Pb(II) effectively at pH below 5.0. • Pb(III) plays important roles on enhancing Mn(VII) decontamination process. The permanganate (Mn(VII)) oxidation has emerged as a promising technology for the remediation and treatment of the groundwater and surface water contaminated with the organic compounds. Nonetheless, only a few studies have been conducted to explore the role of the heavy metals (especially the redox-active ones) during the Mn(VII) oxidation process. In this study, taking Pb(II) as an example, its influence on the Mn(VII) decontamination performance has been extensively investigated. It was found that, with the presence of Pb(II), Mn(VII) could degrade diclofenac (DCF), 2,4-dichlorophenol, and aniline more effectively than without. For instance, over a wide pH range of 4.5–8.0, the dosing of 10 μmol/L Pb(II) accelerated the DCF removal rate from 0.006–0.25 min⁻¹ to 0.05–0.46 min⁻¹ with a promotion factor of 1.9–9.4. Although the UV-vis spectroscopic and high resolution transmission electron microscopy analyses suggested that Mn(VII) could react with Pb(II) to produce Mn(IV) and Pb(IV) at pH 6.0–8.0, further experiments revealed that Pb(II) did not exert its enhancing effect through promoting the generation of MnO₂, as the reactivity of MnO₂ was poor under the employed pH range. At pH below 5.0, it was interesting to find that, a negligible amount of MnO₂ was formed in the Mn(VII)/Pb(II) system in the absence of contaminants, while once MnO₂ was generated in the presence of contaminants, it could catalyze the Pb(II) oxidation to Pb(IV) by Mn(VII). Collectively, by highlighting the conversion process of Pb(II) to Pb(IV) by either Mn(VII) or MnO₂, the reactive Pb(III) intermediates were proposed to account for the Pb(II) enhancement effect.     

Factors influencing NOx emission of a stationary diesel engine fuelled with crude rice bran oil methyl ester blend – Taguchi approach

The main objective of this work is to control the NO_x emission of a stationary diesel engine fuelled with crude rice bran oil methyl ester blend with less sacrifice on smoke density and brake thermal efficiency (BTE) and also to investigate the factors influencing the objective. Fuel injection timing, percentage of exhaust gas recirculation and fuel injection pressure are chosen as the promising factors for the objective and NO_x emission, smoke density and BTE are considered as response variables. Tests were conducted as per Taguchi’s L₉ orthogonal array and the most influencing factor for each response variable and also the significance of each factor on the same was found out through analysis of variance (ANOVA). Response graph was drawn for each response variable and from the results of response graph and ANOVA the optimum combination of the factor levels in achieving the objective was obtained and the same was confirmed experimentally.     

A SIMPLIFIED MODEL FOR PREDICTING DAILY TRANSMISSION LOSSES IN A STREAM CHANNEL1

ABSTRACT: A simplified approach for modeling transmission losses in a stream is presented. A theory relating seepage from a channel with the depth of flow is simplified to a one-parameter relationship. A power relationship is then utilized for the stage-discharge relationship, which is coupled with the seepage relationship. This combined equation is integrated over the channel reach to arrive at a general model for seepage loss through the reach, with one parameter needing calibration. An example is provided showing the development of the relationship and the calibration technique for the parameter. The results are shown, emphasizing the use of the model for simulation of channel transmission losses at low and moderate flow conditions.     

Modelling adsorption of phosphate by soils while the solution concentration decreased with sorption

ＭｏｄｅｌｉｎｇａｄｓｏｒｐｔｉｏｎｏｆｐｈｏｓｐｈａｔｅｂｙｓｏｉｌｓｗｈｉｌｅｔｈｅｓｏｌｕｔｉｏｎｃｏｎｃｅｎｔｒａｔｉｏｎｄｅｃｒｅａｓｅｄｗｉｔｈｓｏｒｐｔｉｏｎＳｕｉＨｏｎｇｊｉａｎＲｅｓｅａｒｃｈＣｅｎｔｅｒｏｆＥｎｖｉｒｏｎｍｅｎｔ...