An appraisal of changes in seasonal water quality during passage through a shallow reservoir in Western Poland

Following restoration changes in Antoninek Reservoir physico-chemical and biological processes in the water column and bottom sediments were measured to outline mechanisms of changes in nitrogen, phosphorus and organic matter concentrations during water flow through this reservoir. Intensive mineralisation of organic matter in the shallow sediments stimulated primary production and influenced increasing ammonia and nitrite nitrogen concentrations. Two main factors affected concentrations of phosphorus: (1) its presence in the external loads of river waters entering the reservoir, more important in the colder seasons as the water discharge was higher and (2) from the internal loads coming from bottom sediments. The quality of the river water during its flow through this reservoir improved for most parameters and seasons. However, concentrations of nutrients were still high in waters flowing out from the reservoir and in some months they were higher in the outflow than in waters entering the reservoir.     

Optimisation of pressurised liquid extraction for elimination of sulphur interferences during determination of organotin compounds in sulphur-rich sediments by gas chromatography with flame photometric detection

A simple method for species-selective analysis of organotin compounds (OTCs) (butyl and phenyl) in sediments was developed. The sample preparation procedure was specifically optimised for sulphur-rich sediments to eliminate interferences from elemental sulphur and organosulphur compounds. Tin species were extracted from sediment samples using pressurised liquid extraction technique (PLE), ethylated - with simultaneous extraction to isooctane - in aqueous phase with sodium tetraethylborate (NaBEt(4)) and separated/detected by gas chromatography with flame photometric detection (GC-FPD). PLE operational variables (extraction temperature and pressure, solvent composition and number of static extraction steps) and extract handling routine were fine-tuned to minimise the amount of extracted interferents while keeping OTCs recovery at an acceptable level. Best results were obtained after extraction of sediment samples with methanol/water (75% v/v methanol) solution of acetic acid/sodium acetate with tropolone addition (0.6 g l(-1)). Derivatisation of low temperature, high-pressure (50 degrees C, 13.8 MPa) extracts gives isooctane extracts which are clean enough to be directly analysed by GC-FPD without any further cleanup. Interferences from elemental sulphur were completely eliminated while concentrations of other interferents were reduced to the level not impairing quantitation of OTCs under the study. No negative effects in terms of chromatographic column deterioration were observed after repeated injections of such extracts. Two certified reference materials, BCR646 and PACS-2, were analysed to assess performance of the method. Recoveries of all OTCs under the study, except MBT, were in the range of 91-114%. MBT extraction efficiency was low (34-47%) therefore the method is unsuitable for precise determinations of this compound.     

Electrochemical and FTIR studies of the mutual influence of lead(II) or iron(III) and phenol on their adsorption from aqueous acid solution by modified activated carbons

Cyclic voltammetry and spectral FTIR studies of the influence of activated carbon surface modification on the co-adsorption of metal cation (lead or iron) and phenol from aqueous acidic solution were carried out. The diversity in surface chemical structure was achieved by applying different procedures of inorganic matter removal and by modifying the carbon samples in various ways: heating under vacuum, aminoxidation in an ammonia-oxygen atmosphere, oxidation with concentrated nitric acid. The quantities of adsorbed metal ions (Pb(2+) or Fe(3+)) and phenol from solutions containing cation or phenol separately or in a mixture were determined. The adsorption capacity from acidic aqueous acidic solution depends on the chemical properties of the activated carbon surface (e.g., decrease in phenol adsorption with relative lower basicity of the adsorbent). The electrochemical parameters of electrodes made from the carbon samples were estimated, and some possible electrochemical reactions were determined from voltammograms recorded in acid electrolyte solution containing adsorbed species (separately or as a mixture). Relationships were found between metal ion adsorption and electrochemical behavior of Pb(2+)/Pb(4+) and Fe(3+)/Fe(2+) couples on the one hand, and the presence of phenol in the solutions tested and the influence of surface chemistry of the carbon electrodes on electrochemical processes on the other. The changes in adsorption capacity with respect to the adsorbates used and the changes in FTIR spectra of the carbons as a result of adsorption and/or coupling phenol molecules are discussed.     

NMR study of the humification process during sewage sludge treatment

Humic acids, extracted from sludge at the biologic-mechanical sewage treatment plant in Jastrzebie Zdroj, have been investigated by means of (1)H, (13)C and (31)P NMR spectroscopy. Sludge samples for studies were taken from the primary settling tank, the nitrification chamber, the digestion chamber and the sludge drying beds. The (1)H NMR analysis of humic acid extracted from sludge at various stages of sewage treatment confirmed the presence of the functional groups that are characteristic for humic substances, and the analysis showed changes in their relative intensities. The (13)C NMR indicated that the aromatisation of the humic acid increased during sewage treatment. Moreover, the analysis of the (31)P NMR spectra allowed us to observe the changes in the phosphorus groups of the studied humic acids.     

Co-combustion of dried sewage sludge and coal in a pulverized coal boiler

More than 1.1 million tons of municipal and industrial sewage sludge is produced annually in Poland. Most of this sewage sludge is landfilled or used for recultivation and fertilization of soil. After accession of Poland to the EU, large investments are planned for wastewater treatment, so it is expected that the amount of sewage sludge produced in Poland will grow in the near future. It is well known that the combustion of sewage sludge is becoming a more and more popular utilization method of such waste. Unfortunately, the current situation in Poland makes it impossible to incinerate the sewage sludge because of a lack of incinerators. One possible solution for Poland is the co-firing of dried sewage sludge in existing coal-fired utility boilers. This article presents results of initial Polish industrial trials of dried municipal sewage sludge and hard coal co-combustion in an OP-230 pulverized coal boiler. Such a solution was shown to be technically viable and not to require changes to the existing technological system. Cocombustion of sewage sludge with coal in power plants seems to be the best solution for sludge utilization in the near future in Poland.     

Assessment of aluminum bioavailability in alum sludge for agricultural utilization

Inorganic aluminum ions, [Al(H₂O)₆]³⁺, [Al(OH)(H₂O)₅]²⁺, and [Al(OH)₂(H₂O)₄]⁺, are toxic to a number of crops. The aim of this study was to estimate the danger of soil contamination of bioavailable aluminum and heavy metals forms because of alum sludge which was a by-product of water, and wastewater treatment technology using aluminum coagulant is introduced into the soil. Aluminum and selected heavy metal fractionation was carried out in the post-coagulation sludge collected at a water treatment plant (where aluminum was used as a coagulant), fermented sewage sludge at a municipal wastewater treatment plant (which did not apply aluminum coagulant), and soil from water treatment plant as well as the mixtures of sludge and soil. It has been found that post-coagulation sludge used as natural fertilizer is a secondary source of bioavailable aluminum, especially when aluminum coagulants are used during water and wastewater treatment. The evaluation of applicability of the sludge to very weak acidic and acidic agricultural soils was carried out. The authors shall debate the question whether, in this case, the Regulation of EU and Polish Government on sewage sludge should also take the bioavailable aluminum into account and add to the list of the elements whose allowable contents are limited.     

Mercury Air Emission from Coal-Fired Public Power Sector: Uncertainty and Its Monthly Distribution. Case Study from Poland

The paper presents two aspects concerned with the mercury air emission inventory from coal-fired public power and energy plants: an uncertainty analysis, using Monte Carlo simulation (Journal of the American Statistical Association, 44(247), 335–341 1949) and the monthly distributions applying the Denton-Cholette approach (Dagum & Cholette 2006). The analysis determines uncertainty about the estimates mercury air emission from 1990 to 2012 including the development of air pollution control (APC) technologies in the Polish public power and energy sector, also the monthly distributions in comparison with previously obtained results (H?awiczka 2008). The uncertainty of mercury (Hg) content in fuel is 31.6% for hard coal and 42.4% for brown coal. The confidence interval for the estimated emission changed from [kg] (16,082.2; 16,242.2) in 1990 to (10,525.9;10,671.1) in 2012. However, the Denton-Cholette approach overestimates the emissions for the warmer periods of the year, but it could, however, in our view, be applied to attain the monthly distributions.     

Wild boar (Sus scrofa) as a bioindicator of organochlorine compound contamination in terrestrial ecosystems of West Pomerania Province, NW Poland

The aim of this study was to detect the presence and determine the residue levels of DDT, lindane, endrin and polychlorinated biphenyls (PCBs) in the liver of wild boars from the area of West Pomerania, NW Poland; to determine the activity of glutathione S-transferase (GST) as a biomarker of biological response and to assess the toxicological risk for consumers of the wild boar offal. The presence of pesticide residues and PCBs was found in all examined liver samples. The highest concentration was observed for endrin, and then, the descending order was PCBs >DDTs >lindane >dl-PCBs. The mean hepatic concentrations of endrin, PCBs, DDTs and lindane were 117.28, 78.59, 67.95 and 7.24 ng/g lipid weight, respectively. Among the dioxin-like PCB congeners, 118 and 156 were dominant in liver samples. The mean toxic equivalent (TEQ) level calculated for dl-PCBs was 2.10?±?1.11 pg WHO-PCB-TEQ/g. There was a statistically significant (p?<?0.05) negative correlation between the concentration of lindane, DDTs and PCBs (as a sum of indicator congeners) in the liver and in the activity of GST. However, GST activities showed no significant correlation with any of the dl-PCBs. In five boar liver samples, the levels of certain organochlorine compounds exceeded the maximum residue levels (MRLs). In one sample, the MRLs were exceeded simultaneously for PCBs, endrin and DDTs and in another one—for endrin and DDTs. In the remaining three samples, only PCB levels were exceeded.