Evaluation of existing equations for temporal scour depth around circular bridge piers

Scour is defined as the processes of removal of sediment particles from water stream bed by the erosive action of activated water, and also carries sediment away from the hydraulic structures. Scour is the main cause of pier failure. Numerous equations are available for estimating temporal and equilibrium scour depth. The present study describes the phenomenon of temporal scour depth variation at bridge piers and deals with the methods for its estimation. The accuracy of six temporal scour depth equations are also checked in this study. After graphical and statistical analysis, it was found that the relationship proposed by Oliveto and Hager (J Hydraul Eng (ASCE) 128(9):811–520, 2002) predicts temporal scour depth better than other equations. Three equations of equilibrium time of scour are also used for computing equilibrium time. Equilibrium time equation proposed by Choi and Choi (Water Environ J 30(1–2):14–21, 2016) gives better agreements with observed values.     

Recycling polymeric waste from electronic and automotive sectors into value added products

The environmentally sustainable disposal and recycling of ever increasing volumes of electronic waste has become a global waste management issue. The addition of up to 25% polymeric waste PCBs (printed circuit boards) as fillers in polypropylene (PP) composites was partially successful: while the tensile modulus, flexural strength and flexural modulus of composites were enhanced, the tensile and impact strengths were found to decrease. As a lowering of impact strength can significantly limit the application of PP based composites, it is necessary to incorporate impact modifying polymers such as rubbery particles in the mix. We report on a novel investigation on the simultaneous utilization of electronic and automotive rubber waste as fillers in PP composites. These composites were prepared by using 25 wt.% polymeric PCB powder, up to 9% of ethylene propylene rubber (EPR), and PP: balance. The influence of EPR on the structural, thermal, mechanical and rheological properties of PP/PCB/ EPR composites was investigated. While the addition of EPR caused the nucleation of the β crystalline phase of PP, the onset temperature for thermal degradation was found to decrease by 8%. The tensile modulus and strength decreased by 16% and 19%, respectively; and the elongation at break increased by ~71%. The impact strength showed a maximum increase of ~18% at 7 wt.%–9 wt.% EPR content. Various rheological properties were found to be well within the range of processing limits. This novel eco-friendly approach could help utilize significant amounts of polymeric electronic and automotive waste for fabricating valuable polymer composites.

Open image in new window

     

Biosorption of chromium (VI) from aqueous solutions and ANN modelling

The use of sustainable, green and biodegradable natural wastes for Cr(VI) detoxification from the contaminated wastewater is considered as a challenging issue. The present research is aimed to assess the effectiveness of seven different natural biomaterials, such as jackfruit leaf, mango leaf, onion peel, garlic peel, bamboo leaf, acid treated rubber leaf and coconut shell powder, for Cr(VI) eradication from aqueous solution by biosorption process. Characterizations were conducted using SEM, BET and FTIR spectroscopy. The effects of operating parameters, viz., pH, initial Cr(VI) ion concentration, adsorbent dosages, contact time and temperature on metal removal efficiency, were studied. The biosorption mechanism was described by the pseudo-second-order model and Langmuir isotherm model. The biosorption process was exothermic, spontaneous and chemical (except garlic peel) in nature. The sequence of adsorption capacity was mango leaf > jackfruit leaf > acid treated rubber leaf > onion peel > bamboo leaf > garlic peel > coconut shell with maximum Langmuir adsorption capacity of 35.7 mg g^?1 for mango leaf. The treated effluent can be reused. Desorption study suggested effective reuse of the adsorbents up to three cycles, and safe disposal method of the used adsorbents suggested biodegradability and sustainability of the process by reapplication of the spent adsorbent and ultimately leading towards zero wastages. The performances of the adsorbents were verified with wastewater from electroplating industry. The scale-up study reported for industrial applications. ANN modelling using multilayer perception with gradient descent (GD) and Levenberg-Marquart (LM) algorithm had been successfully used for prediction of Cr(VI) removal efficiency. The study explores the undiscovered potential of the natural waste materials for sustainable existence of small and medium sector industries, especially in the third world countries by protecting the environment by eco-innovation.     

Improvement in rice straw pulp bleaching effluent quality by incorporating oxygen delignification stage prior to elemental chlorine-free bleaching

Environmental degradation by industrial and other developmental activities is alarming for imperative environmental management by process advancements of production. Pulp and paper mills are now focusing on using nonwood-based raw materials to protect forest resources. In present study, rice straw was utilized for pulp production as it is easily and abundantly available as well as rich in carbohydrates (cellulose and hemicelluloses). Soda-anthraquinone method was used for pulp production as it is widely accepted for agro residues. Bleaching process during paper production is the chief source of wastewater generation. The chlorophenolic compounds generated during bleaching are highly toxic, mutagenic, and bioaccumulative in nature. The objectives of study were to use oxygen delignification (ODL) stage prior to elemental chlorine-free (ECF) bleaching to reduce wastewater load and to study its impact on bleached pulp characteristics. ODL stage prior to ECF bleaching improved the optical properties of pulp in comparison to only ECF bleaching. When ODL stage was incorporated prior to bleaching, the tensile index and folding endurance of the pulp were found to be 56.6 ± 1.5 Nm/g and 140, respectively, very high in comparison to ECF alone. A potential reduction of 51, 57, 43, and 53% in BOD₃, COD, color, and AOX, respectively was observed on adding the ODL stage compared to ECF only. Generation of chlorophenolic compounds was reduced significantly. Incorporation of ODL stage prior to bleaching was found to be highly promising for reducing the toxicity of bleaching effluents and may lead to better management of nearby water resources.

Open image in new window

Graphical abstract ?

     

Field crops (Ipomoea aquatica Forsk. and Brassica chinensis L.) for phytoremediation of cadmium and nitrate co-contaminated soils via rotation with Sedum alfredii Hance

Environmental Science and Pollution Research - Phytoremediation coupled with crop rotation (PCC) is a feasible strategy for remediation of contaminated soil without interrupting crop production....     

Trace elements in surface sediments of the Hooghly (Ganges) estuary: distribution and contamination risk assessment

Our objective was to evaluate distribution and accumulation of trace elements (TEs) in surface sediments along the Hooghly (Ganges) River Estuary, India, and to assess the potential risk with view to human health. The TE concentrations (mg kg^?1 dry weight) exhibited a wide range in the following order: Al (31.801 ± 15.943) > Fe (23.337 ± 7584) > Mn (461 ± 147) > S (381 ± 235) > Zn (54 ± 18) > V (43 ± 14) > Cr (39 ± 15) > As (34 ± 15) > Cu (27 ± 11) > Ni (24 ± 9) > Se (17 ± 8) > Co (11 ± 3) > Mo (10 ± 2) > Hg (0.02 ± 0.01). Clay, silt, iron, manganese and sulphur were important for the accumulation of TE in the sediments as confirmed by factor analysis and Pearson correlation. The accumulation and dispersal of TEs were most likely to be governed by both tide-induced processes and anthropogenic inputs from point and non-point sources. Enrichment factor analysis and geoaccumulation index revealed serious contamination of the sediments with Se and As, while comparing the consensus-based sediment quality guidelines (SQGs), adverse biological effects to benthic fauna might be caused by As, Cu, Ni and Cr. This investigation may serve as a model study and recommends continuous monitoring of As, Se, Cu, Ni and Cr to ascertain that SQGs with respect to acceptable levels of TEs to safeguard geochemical health and ecology in the vicinity of this estuary.     

Bioreduction of hexavalent chromium by Exiguobacterium indicum strain MW1 isolated from marine water of Paradip Port,Odisha, India

Hexavalent chromium-tolerant (1500?mg/L) bacterium MW1 was isolated from harbour water of Paradip Port and evaluated for Cr(VI) reduction potential. The isolate was identified as Exiguobacterium indicum by biochemical and 16S rRNA gene sequence methods. Salt tolerance of the bacterium was evaluated in a wide range of NaCl concentrations (0.5–13%, w/v). The Cr(VI) reduction of the strain was evaluated and optimised with varied Cr(VI) concentrations (100–1000?mg/L), pH (5.0–9.0), temperature (30–40°C) and shaking velocity (100–150?rpm) in two different minimal media (M9 and Acetate). Under optimised conditions, after 192?h of incubation nearly 92%, 50% and 46% reduction in the M9 minimal medium and 91%, 47% and 40% reduction in the acetate minimal medium were observed for 100, 500 and 1000?mg/L of Cr(VI), respectively. The exponential rate equation for Cr(VI) reduction yielded higher rate constant value, that is, 1.27?×?10^?2?h^?1 (M9) and 1.17?×?10^?2?h^?1 (Acetate) in case of 100?mg/L and became lower for 500 and 1000?mg/L Cr(VI) concentrations. Further, the association of bacterial cells with reduced product was ascertained by Fourier transform infrared spectrometer, UV–Vis–DRS and field-emission scanning electron microscope–energy-dispersive X-ray analyses. The above study suggests that the higher reducing ability of the marine bacterium E. indicum MW1 will be suitable for Cr(VI) reduction from saline effluents.     

Evidence of new particle formation during post monsoon season over a high-altitude site of the Western Ghats,India

The formation of ultrafine particles, their growth, and associated characteristic features has been studied during new particle formation events over a high-altitude station of the Western Ghats during the 2014 post-monsoon season. Most of the events were observed during noon time where particle bursts in the nucleation-mode size range from 5 to 25 nm followed by sustained growth in size. This phenomenon persists for ～4–8 h with a growth rate of 1–2 nm h^–1. Peak concentrations of nucleation-mode particles during the event generally vary from 2300 to 5000 cm^–3. The mean growth rate is 1.4 ± 0.42 nm h^–1, particle formation rate is 1.14 ± 0.22 cm^–3 s^–1, coagulation sink is 0.35 ± 0.22 cm^–3 s^–1, and condensational sink is 15.4 ± 2.6?×?10^–3 s^–1. All these values are comparable with earlier results from Indian region. Comparison of size-segregated particle number concentration during days of new particle formation events and those without new particle formation were carried out showing a distinct variation in nucleation and Aitken mode with least variability associated with the accumulation mode.     

Some happy,others sad: exploring environmental justice in solid waste management in Kinshasa,The Democratic Republic of Congo

This paper explores the concept of environmental justice (EJ) in solid waste management (SWM) in Kinshasa, the Democratic Republic of Congo (DRC). It evaluates the extent to which EJ occurs in SWM and discusses the factors accounting for this state of affairs. The paper examines the relevant theoretical framework(s) and mechanisms that would facilitate the attainment of EJ in Kinshasa. It is argued that solid waste (SW) often ends up in the poorest and least powerful communities in the cities of the DRC. A qualitative research methodology, which includes exhaustive critical review of the literature, system analysis, reflections from best practices through case studies and discussion with stakeholders, was used for this study. Findings revealed that SWM in Kinshasa is a duty entrusted to publicly-funded municipal authorities. There are evidences of a clear divide between the rich and poor neighbourhoods in the manner SW is managed. This is an inequality that has only recently begun to be recognised as injustice practices in SWM. It is argued that a politico-cultural mechanism on remedying SWM inequities could enable changes that will address EJ in Kinshasa. Such a solution will go directly against the prevailing notion “some happy, others sad”.     

Experimental investigation of a solar water distillation-cum-drying unit

In this communication, a new design of solar-energy-based water distillation cum drying unit with parabolic reflector has been designed, fabricated, and tested. Bitter gourd and potato slices are chosen as a drying commodity. Thermal performance of the developed system has been evaluated based on the experimental results and using linear regression analysis. Heat transfer coefficients (convective, evaporative, and radiative) for solar distillation system have been observed to be 2.48–4.09, 13.25–52.38, and 8.75–9.66 W/m²°C, respectively. Overall thermal efficiency and exergy efficiency for the distillation system has been found to be 18.77% and 1.2%, respectively. The convective heat transfer coefficient for potato slices are observed higher for initial hours and decreases as the day progresses. The average convective heat transfer coefficients for bitter gourd and potato slices have been observed as 2.18 and 5.04 W/m²°C, respectively. Experimental error in terms of percent uncertainty for bitter gourd and potato slices are found to be 42.93% and 37.06%, respectively. The present design of solar distillation and drying in a single unit could be beneficial for the development of remote, arid, and rural areas.