废LCD面板有机材料水热资源化产乙酸

LCD面板主要由附着偏光片及液晶等有机材料的玻璃面板构成。有机材料的去除及资源化利用是废LCD面板处理的第一步。在水热条件下对废LCD面板进行了降解产酸研究。研究考察了反应温度、反应时间、氧化剂用量、水用量及pH值等对水热产乙酸产率及选择性的影响。通过正交实验确定了水热产乙酸的最佳操作条件：反应温度325℃,反应时间5min,氧化剂（30％H2O2）0．6mL,用水量2mL,近中性环境（pH6-6．5去离子水）。此条件下,乙酸产率及选择性分别为68．83％及70．56％。结果表明,以废LCD面板有机材料为原料,采用水热技术进行产乙酸反应,可实现其资源化再利用。     

季节性城市生活垃圾成分分析及厌氧消化特性研究

城市生活垃圾的成分及特性随着季节和人类在不同季节的生活习惯而变化,针对我国北方城市研究了一年中不同季节的城市生活垃圾成分特点,对影响厌氧发酵过程的相关成分如总有机碳（TOC）、总氮（TN）、蛋白质、脂肪和还原糖等进行了测定分析。通过厌氧消化实验,测得不同季节城市生活垃圾pH值、日产气量、沼气甲烷含量、甲烷累积量、挥发性脂肪酸（VFAs）和氧化还原电位（ORP）等参数的变化规律,分析相应变化的影响因素。结果表明,二、三季度的含水率分别为64．81％和67．50％,高于一、四季度,一季度发酵原料中蛋白质和脂肪含量分别为12．56％和8．86％,明显高于其他3个季度。一季度甲烷累积量最高,达到17616mL,单位发酵原料的产气量为204．8mL／g,也是4个季度中最高的,说明蛋白质、脂肪等有机成分含量对厌氧发酵过程及结果影响比较明显。为进一步的城市生活垃圾厌氧消化制取生物燃气的工艺条件提供依据。     

A Multipurpose Flare Stack for Control of Chemical Process Wastes

Abstract

To test the effectiveness of California’s vehicle inspection/ maintenance (I/M) program, exclusive of vehicle-owner intervention, a fleet of more than 1,100 vehicles that previously had failed California’s Smog Check test were sent to randomly selected Smog Check stations in the Los Angeles area for covert inspections and repairs. The two-speed idle test was used for repairs. For those vehicles that were repaired at the first inspection, their FTP emission reductions were 25%, 14%, and 11% for hydrocarbons (HC), carbon monoxide (CO), and nitrogen oxides (NO_x), respectively, although emissions testing for NO_x was not performed at the Smog Check stations. Idle HC and CO emissions increased for 35% and 43% of the vehicles, respectively, after repairs. This data set shows that most vehicles that fail the Smog Check inspection are only marginal emitters, with 61% and 44% of the total potential for HC and CO emission reductions, respectively, coming from only 10% of the vehicles that currently fail the inspection. When the vehicles were rank-ordered by idle emissions from dirtiest to cleanest, emission reduction costs for the highest-emitting 10% of the fleet averaged $l,100/ton and $250/ton for HC and CO, respectively, attributing all the costs to each pollutant exclusively. For the remaining vehicles, costs increased dramatically.     

Measurement of Automobile Exhaust GAS Hydrocarbons

While snowflakes fell and Christmas carols heralded the imminent holiday, over 3000 delegates to the Third National Conference on Air Pollution were told to “Control Now for Clean Air.”

They were told this in many ways by many people—by the Vice President of the United States; by the Secretary of the Department of Health, Education, and Welfare who summoned the Conference; and by senators, congressmen, governors, and mayors.

Then eight panel sessions convened to discuss and to determine how to control now for clean air. Speakers from every section of American life addressed themselves to this subject; when they were finished, the eight session chairmen summarized what had been said, what had been, learned. These summaries appear on the following pages.     

The Effect of Nucleating Particulates on Photochemical Aerosol Formation

The role of nucleating particulates in the formation of photochemical aerosols has been studied in a steady, laminar flow of ultrafiltered air containing NO₂ and octene-1 in the concentration range of (30 to 170 ppm) when subjected to intense irradiation under isothermal conditions. The particulates consisted of monodisperse polystyrene latex (d = 0.36 μ.) in concentrations similar to those in the atmosphere (6 × 10¹ to 3 × 10³ cm^–3); the irradiation intensity varied between (6 to 40 × 10³ lumen/liter) and the mean exposure duration between 30 and 180 sec. Samples of the flow prior to and after its photoactivation were withdrawn either by an Aerosol Spectrometer (AS) or by a Royco Aerosol Photometer (PH). While these indications refer thus to the same system, they differ, because the photometric data include all colloidal components in the airborne state, whereas the counts obtained from the AS deposits refer only to the nucleated latex particles. The following pattern becomes evident: The photochemical reaction yields fractional products (less than three percent) which have the tendency to agglomerate (or polymerize) due to their relatively low volatility—independent of the presence or absence of nucleating particulates. In their presence, this reaction becomes kinetically more probable and thus faster, hence the accumulant formation occurs preferably on the nuclei and causes their growth such that, e.g., a 10-fold higher nuclei concentration will produce under the same conditions 10 times the accumulant mass while autonucleation is suppressed. The growth process appears thus principally different from that of fog formation by H₂O-condensation, whereas for identical super saturation it is inversely proportional to the nuclear concentration. In the absence of nuclei autonucleation, i.e., self-agglomeration, occurs at a much lesser reaction rate and higher photon demand. The growth rate of the nuclei, when present, depends on the concentration of the oxidation catalyst (NO₂), its interaction with the nuclei surface is indicated. Under identical conditions the mass of nuclear accumulant is directly proportional to the concentration of the reactive hydrocarbon, while the growth rate depends on the light intensity and the exposure duration. The findings indicate that density and nature of particulate matter present in an air mass prior or during photo-activation are—aside from the chemical reactant levels—of major significance in aerosol formation.     

Sulfur Dioxide Removal and Recovery from Pulp Mill Power Plants

The use of soda ash liquor to scrub SO₂ rich power plant flue gases was studied using an Airetron pilot scrubber with a maximum capacity of 3000 cfm. The relative effects of the major operating variables— temperature, soda ash concentration, and the gas/liquid flow ratio—on the absorption phenomenon were determined. Orthogonal factorial experiments were used to derive a response function relating mass transfer values to operating variables. The economics of a full scale NSSC installation are discussed.     

Instrumenting Light Aircraft for Air Pollution Research

Light aircraft and helicopters have been occasionally used to conduct aerial traverses for a single pollutant or atmospheric tracer. The continuous analyzer or sample collector is temporarily tied down with a seat belt or hand held. Flight variables are visually observed and written on the recorder chart, a notebook or possibly voice-recorded on a portable tape recorder. The versatile airborne instrumentation package described can measure and record up to 27 pollutant and flight variables from a Cessna Skymaster center-line thrust, light twin. Real-time analysis instrumentation include non-dispersive infrared analyzers for CO₂, CO, and hydrocarbons, conductivity and coulometric analyzers for sulfur dioxide and sulfur-containing gases, and Charlson-Ahlquist visual range nephelometer. A Battelle “bulk sampler” is used to collect particulates for weighing and microscopic examination. Indicated air speed, altitude, rate of climb, magnetic heading, temperature, and relative humidity are continuously measured. All variables are sequentially recorded on a 7-track, 200 bit per second, 27-channel, magnetic tape data logging system. Measured variables are recorded once each 0.3 to 0.8 sec—equivalent to 33-100 ft of traversedepending upon the number of variables recorded (i.e., between 9 and 27) when flying at 90 mph. Tape data are reduced directly by IBM 360 computer to a digital print-out or from tape to an X-Y analog plot.     

The Effect of Fuel Composition on Atmospheric Aerosol Due to Auto Exhaust

Aerosols attributable to automobile exhaust can be classified as two types—primary aerosol (initially present in the exhaust) and secondary aerosol (generated photochemically from hydrocarbons and nitrogen oxides in the exhaust). In this study, investigation was made of possible effects of motor-fuel composition on the formation of these aerosols. Secondary aerosol, of principal interest in this work, was produced by irradiating auto exhaust in Battelle-Columbus’ 610 ft³ environmental chamber. A limited number of determinations of primary aerosol in diluted auto exhaust was made at the exit of a 36 ft dilution runnel. Determination of both primary and secondary aerosol was based on light-scattering measurements.

Exhaust was generated with seven full-boiling motor gasolines, both leaded and nonleaded, in a 1967 Chevrolet which was not equipped with exhaust-emission control devices. Changes in fuel composition produced a maximum factor of three difference in light scattering due to primary aerosol. Aerosol yields, for consecutive driving cycles on the same fuel, vary considerably; as a result, ranking the fuels on the basis of average primary aerosol yield was not very meaningful. In addition to fuel composition, the more important independent variables are initial SO₂ concentration, relative humidity and initial hydrocarbon concentration. Statistical analysis of the data indicates that the seven test fuels can be divided into two arbitrary groups with regard to secondary aerosol-forming potential. The fuels in the lower light-scattering group had aromatic contents of 15 and 21%, while those in the higher light-scattering group had aromatic contents of 25, 48, and 55%. Although the fuels can be grouped on the basis of a compositional factor, the grouping of fuels with aromatic content ranging from 25 to 55% indicates that this compositional factor cannot be equated simply with aromatic content. In an associated study of the aerosol-forming potential of individual hydrocarbons prominent in auto exhaust, it was observed that aromatics produce substantially more photochemical aerosol than olefins and paraffins. However, experiments with binar/hydrocarbon mixtures containing aromatjcs, as well as in these exhaust experiments, a strong dependence of aerosol yield on the aromatic components is is not observed. Thus, the data indicate that the dependence of secondary aerosol formation on fuel factors is a complex one and cannot be predicted solely on the basis of a sirigle hydrocarbon component reactivity scale.

The two types of automobile aerosol did not have the same dependence on fuel, composition. The variation in total light scattering attributable to primary plus secondary aerosol was less than that due to either component alone. It therefore was concluded that the light scattering due to automobile exhaust emissions in these experiments was not significantly affected by changing fuel composition.     

Automotive Exhaust Emission Levels by Geographic Area and Vehicle Make A Nationwide Survey

Gross average automotive exhaust emissions data collected by the Atlantic Richfield Clean Air Caravan during the summer of 1970 showed only slight geographical variations when the specific makes were ignored. When considering specific makes, significant differences were found on an average emissions basis. Vehicle population—emission distributions showed wide variations in the 50% population levels and in the percent of vehicles with emissions greater than specified values. Hydrocarbon (HC) and carbon monoxide (CO) data are given on a gross basis for the 1970, 1968-69, 1966-67, and pre-1966 model year group vehicles. Average HC and CO emissions and vehicle population-Idle emissions distribution curves are included for specific make vehicles in selected areas.