诱导喷嘴改进滤筒清灰效果的数值模拟

采用计算流体动力学数值模拟方法,对规格为325 mm×660 mm滤筒在采用高效诱导喷嘴(超音速引流喷嘴和气流散射器)喷吹时的内部流场进行研究。通过分析喷吹气流在滤筒内的压力分布云图和喷嘴处的速度分布图,得出模拟结果与脉冲喷吹实验结果基本一致,验证了数值模拟的可靠性和实验的准确性。进而从微观上分析得出采用诱导喷嘴可使气流更加稳定的进入滤筒内部,以此确保滤筒长度方向上内壁清灰压力的均匀性,对滤筒清灰效果有明显的改善作用,为解决滤筒的清灰问题提供了一定的指导。     

石油降解菌的筛选优化及其对油污土壤的修复特性

分别以牛肉膏蛋白胨-布氏哈斯培养基、蓝色凝胶培养基作为初筛和复筛培养基,从石油污染土壤中筛选出2株可产生微生物表面活性剂的石油烃降解菌。并将菌株投加到油污土壤中进行修复研究,考查了不同影响因素对修复效果的影响。研究结果表明,(1)2株菌对中度石油污染土壤有较好的修复效果,向油污土壤中直接投加菌株修复70 d时对石油烃的去除率为52%;(2)向油污土壤中投加降解菌并同时补充氮营养液,修复70 d时对土壤中总石油烃的去除率可达到75%;对土壤中正构烷烃的去除率为66%;(3)与土壤的含水率及土著菌的降解效果相比,向油污土壤中投加降解菌以及补充氮磷营养液是影响石油污染土壤修复效果的关键因素。     

Design and characterization of human exposure to generated sulfate and soot particles in a pilot chamber study

A number of literatures have documented adverse health effects of exposure to fine particulate matter (PM_2.5), and secondary sulfate aerosol and black carbon may contribute to health impacts of PM_2.5 exposure. We designed an exposure system to generate sulfate and traffic soot particles, and assessed the feasibility of using it for human exposure assessment in a pilot human exposure study. In the designed exposure system, average mass concentrations of generated sulfate and soot particles were 74.19μg/m³ and 11.54μg/m³ in the chamber and did not vary significantly during two-hour human exposure sessions. The size ranges of generated sulfate were largely between 20 to 200 nm, whereas those of generated soot particles were in the size ranges of 50 to 200nm. Following two-hour exposure to generated sulfate and soot particles, we observed significant increases in fractional exhaled NO (FeNO) in young and health subjects. Building on established human exposure system and health response follow-up methods, future full-scale studies focusing on the effects of mixed particulates and individual PM_2.5 components would provide data in understanding the underpinning cardio-respiratory outcomes in relation to air pollution mixture exposure.

Implications: Controlled exposure is a useful design to measure the biological responses repeatedly following particulate exposures of target components and set exposure at target levels of health concerns. Our study provides rational and establishes method for future full-scale studies to focus on examining the effects of mixed particulates and individual PM_2.5 components.     

类氧化硅气凝胶吸附材料的制备及其吸附性能

以有机硅高沸物和Na₂SiO₃·9H₂O为原料,采用溶胶-凝胶法制备出疏水性的类氧化硅气凝胶吸附材料。采用透射电子显微镜、傅里叶变换红外分析仪和比表面与空隙度分析仪对该吸附材料的结构进行表征。表征结果显示,该吸附材料呈海绵状多孔结构,比表面积为294.48 m²/g,孔径分布较宽（为2 ~140 nm）,平均孔径为8.95 nm。实验结果表明：采用该吸附材料常温下静态吸附处理质量浓度为10 mg/L的罗丹明B（RhB）溶液,在类氧化硅气凝胶吸附材料加入量50 g/L、静态吸附时间5 h的最佳静态吸附工艺条件下,RhB去除率为98.8%,吸附后RhB质量浓度为0.124 mg/L;采用该吸附材料常温下动态吸附处理质量浓度为15 mg/L的RhB溶液,吸附4 h后开始穿透,吸附7 h后完全穿透。穿透时间较长,表明该吸附材料具有较大的吸附容量。     

Estimation methods and monitoring network issues in the quantitative estimation of land-based COD and TN loads entering the sea: a case study in Qingdao City,China

At present, the monitoring network of China cannot provide sufficient data to estimate land-based pollutant loads that enter the sea, and estimation methods are imprecisely used. In this study, the selection of monitoring stations, monitoring frequency, and pollutant load estimation methods was studied in Qingdao City, a typical coastal city in China, taken as an example. Land-based pollutant loads from Qingdao were estimated, and load distribution, density, and composition were analyzed to identify the key pollution source regions (SRs) that need to be monitored and controlled. Results show that the administrative land area of Qingdao can be divided into 25 sea-sink source regions (SSRs). A total of 14 more rivers and 62 industrial enterprises should be monitored to determine the comprehensive pollutant loads of the city. Furthermore, the monitoring frequency of rivers should not be less than three times/year; a monitoring frequency of five or more times is preferable. The findings on pollutant load estimation with the use of different estimation methods substantially vary; estimation results with the use of ratio-based methods were 10 and 22 % higher than those with the use of monitoring-based methods in terms of chemical oxygen demand (COD) and total nitrogen (TN), respectively. None-point sources contributed the majority of the pollutant loads at about 70 % of the total COD and 60 % of the total TN.     

CuO/γ-Al_2O_3类Fenton试剂降解丁基黄药

CuO/γ-Al2O3类Fenton试剂是降解丁基黄药的优良试剂。该试剂与传统的Fenton试剂相比,提高了反应的pH值,可在较高pH（4~5）条件下反应,而传统的Fenton试剂的适宜pH值一般在3以下。采用单因素实验和正交实验相结合的方法研究了pH、催化剂投加量、过氧化氢投加量以及反应时间对丁基黄药降解效果的影响,并对催化剂的使用寿命进行了探讨。研究结果表明,反应的最佳条件为：pH为4~5,催化剂投加量为6 g/L,过氧化氢用量为30 mg/L,反应30min。在此反应条件下,丁基黄药的降解率达98%以上;影响丁基黄药降解效果的因素大小顺序为：pH〉反应时间〉H2O2用量〉催化剂投加量,其中pH对CuO/γ-Al2O3类Fenton试剂降解丁基黄药的影响最为显著。     

热解吸对污染土壤中不同形态汞的去除作用

选取贵州省万山矿区的汞污染土壤样品进行不同形态汞的热解吸去除行为研究。研究了热解吸过程中∑Hg的去除效果及动力学,以及温度和时间对污染土壤中不同形态汞的去除作用。结果表明,热解吸修复技术可有效去除土壤中的汞,土壤中∑Hg的热解吸过程符合二级动力学方程。固定热解吸时间在10 min时,随着热解吸温度的升高,土壤中水溶态汞、盐酸溶态汞和碱溶态汞含量呈现先下降后上升再下降的趋势,王水溶汞和盐酸溶态汞始终呈现下降趋势,说明不同形态的汞之间发生了转化。热解吸温度为250℃时,随着热解吸时间的增加,环境风险大的水溶态汞、盐酸溶态汞、碱溶态汞和硝酸溶态汞的去除率大幅增加,土壤的有机质损失较少,说明在低温下,延长热解吸时间,对生物毒性强的形态汞有良好的修复效果,且此温度下处理后的土壤更容易恢复农田耕作。     

初始温度对人粪便好氧堆肥过程的影响

温度是好氧堆肥过程中需要控制的一个重要因素。不同的初始温度直接影响了堆肥过程中微生物活性及有机物的降解。为了研究初始温度对粪便好氧堆肥过程的影响,采用序批式好氧堆肥反应器,以新鲜锯末为载体,控制含水率在55%~60%的范围左右并强制通风的好氧条件下,进行了初始温度分别为25、35、45和55℃,20 d为一个周期好氧堆肥实验,研究了不同初始温度条件下堆肥过程有机物降解、氮的迁移转化及种子发芽指数的变化。结果表明,初始的高温度会抑制堆肥反应的进行,但初始温度越高,水解效果越显著;初始的高温有利于COD的去除,最终COD的去除率分别为88.2%、89.3%、92.0%和89.9%。初始高温对种子发芽率有抑制作用,同时延迟了堆肥的腐熟期。     

高温滤袋的有效清灰强度

对Φ120 mm×1 000 mm氟美斯滤袋的最大侧壁压力峰值、除尘器运行阻力进行实验测试,并结合滤袋破损情况探究高温滤袋的有效清灰强度。结果表明,最大侧壁压力峰值在一定范围内对滤袋有较好的清灰效果且对滤袋的损伤较小。对粉煤灰而言,滤袋沿长度方向的平均最大侧壁压力峰值为876 Pa时的强度能满足除尘器的清灰要求,随着滤袋的最大侧壁压力峰值增大,除尘器清灰效果越好,当平均最大侧壁压力峰值超过2 713 Pa时,清灰效果仅轻微提升;且局部最大侧壁压力峰值大于5 282 Pa时滤袋破损,造成过度清灰。     

基于DO控制实现SBR短程硝化过程

采用序批式反应器(SBR)处理模拟氨氮废水,研究了固定供氧模式下氨氮降解过程和溶解氧变化规律,并对DO控制实现短程硝化机理进行了探讨.实验结果表明,当DO＜1 mg/L时,体系产生亚硝酸盐积累,当亚硝化反应结束后,DO出现跃升现象,并且pH值对短程硝化有一定影响,充足的碱度和较高的pH值有利于建立以DO为控制参数实现短程硝化过程控制.短程硝化启动后,亚硝酸盐积累率达90％以上,并且经过度曝气5d后,系统仍保持稳定运行.