Determination of 15 phthalate esters in air by gas-phase and particle-phase simultaneous sampling

Based on previous research, the sampling and analysis methods for phthalate esters (PAEs) were improved by increasing the sampling flow of indoor air from 1 to 4 L/min, shortening the sampling duration from 8 to 2 hr. Meanwhile, through the optimization of chromatographic conditions, the concentrations of 9 additional PAE pollutants in indoor air were measured. The optimized chromatographic conditions required a similar amount of time for analysis as before, but gave high responsivity, the capability of simultaneously distinguishing 15 kinds of PAEs, and a high level of discrimination between individual sample peaks, as well as stable peak generation. The recovery rate of all gas-phase and particle-phase samples of the 15 kinds of PAEs ranged from 91.26% to 109.42%, meeting the quantitative analysis requirements for indoor and outdoor air sampling and analysis. For the first time, investigation of the concentration levels as well as characteristics of 15 kinds of PAEs in the indoor air from four different traffic micro-environments (private vehicles, busses, taxis and subways) was carried out, along with validation of the optimized sampling and analytical method. The results show that all the 9 additional PAEs could be detected at relatively high pollution levels in the indoor air from the four traffic micro-environments. As none of the pollution levels of the 15 kinds of PAEs in the indoor air from the 4 traffic micro-environments should be neglected, it is of great significance to increase the types of PAEs able to be detected in indoor air.     

关于渗透通风条件建筑结构对室内PM2.5浓度水平影响评价模型探讨

我国京津冀地区近年频遭大气PM_2.5污染侵扰,相关研究表明,既使关闭建筑外窗,大气中PM_2.5仍可以通过渗透通风方式进入室内污染环境.为定量评价建筑渗透通风及无室内污染源条件下建筑结构（如外窗缝隙结构、房间建筑结构等）对室内ρ（PM_2.5）的影响规律,基于北京市东城区、朝阳区6个不同建筑结构的房间室内外ρ（PM_2.5）实时监测数据,重点比较分析了建筑结构对室内外ρ（PM_2.5）关联特性的影响规律.此外,根据颗粒物穿透特性及沉降特性机理,提出了反映建筑外窗缝隙结构（如缝高、缝深）的无量纲特征参数A_P与反映房间建筑结构（如层高、开间、进深）的无量纲特征参数A_k.在前期提出的室内ρ（PM_2.5）预测模型基础上,进一步构建了二者（A_P与A_k）对室内ρ（PM_2.5）影响的评价模型,并通过实测数据验证了模型的正确性.结果表明:当室外PM_2.5污染程度与气象条件一定时,建筑结构对I/O[室内外ρ（PM_2.5）之比]影响较大,其范围在0.4~0.7之间;随着建筑外窗气密性等级的提高,对应室内ρ（PM_2.5）呈显著的下降趋势.建筑外窗缝隙结构对室内ρ（PM_2.5）影响程度远大于房间建筑结构,敏感性分析结果表明,当建筑外窗缝高每降低50%或缝深每提高50%,对应室内ρ（PM_2.5）约可下降33.6%与31.9%.研究显示,气密性等级较高的建筑外窗缝隙缝高往往较小、缝深较长,渗透通风条件下对控制室内ρ（PM_2.5）水平作用更显著。      

北京市燃煤源排放控制措施的污染物减排效益评估

为分析北京市燃煤源排放控制措施的污染物减排效益,基于MEIC（中国多尺度排放清单模型）,采用情景分析法,评估了北京市电厂能源清洁化与末端治理、燃煤锅炉改造和城区平房区居民采暖改造等措施的污染物减排效益.结果表明,相对于无控情景,2013年北京市电厂能源清洁化与末端治理减少PM_2.5、PM₁₀、SO₂和NO_x排放量为1.28×104、2.10×104、5.13×104和4.98×104 t,分别占无控情景的85%、86%、87%、74%;北京市燃煤锅炉改造减少PM_2.5、PM₁₀、SO₂、NO_x排放量为1.09×104、2.68×104、11.64×104和5.81×104 t,分别占无煤改气情景的83%、89%、83%、83%;北京市老旧平房区的居民采暖改造减少PM_2.5、PM₁₀、SO₂和NO_x排放量分别为630、870、2 070和790 t,均占无煤改电情景的8%.研究显示,北京市从1998年开始采取的各种减排措施有效地减少了污染物的排放,对北京市空气质量改善具有重要意义.      

不同浓度锌离子污染土的工程力学性能试验研究

通过直剪试验、压缩试验和三轴试验对人工制备最优含水率下不同浓度锌离子污染土的工程力学性能进行测试,研究了不同锌离子浓度污染土的抗剪强度和压缩特性。结果表明:随着锌离子浓度的增加,污染土的内摩擦角和压缩系数增加,内聚力和压缩模量下降,而污染土的孔隙比随着锌离子浓度的增加先减小后增大;在不同垂直压力下,随着压力的增加,污染土的压缩系数整体先减小后增大,压缩模量先增大后减小。     

多层阻尼复合板常温贮存5年性能研究

目的分析多层阻尼复合板常温贮存5年的性能变化。方法对多层阻尼复合板进行常温下贮存5年的减振性能研究,通过贮存前后的正弦扫描试验和随机振动试验,获得贮存前后多层阻尼复合板的减振性能和模态变化,进行对比分析。结果阻尼复合板常温贮存5年后,径向模态有较大的下降,法向模态变化较少,组件上的加速度响应基本无变化。结论该多层阻尼复合板常温贮存5年后仍然满足要求。     

呼和浩特市可镇污水处理厂工程设计

呼和浩特市可镇污水处理厂近期建设规模1.0×104m3/d,远期总规模2.5×104m3/d。污水处理主体工艺采用组合式A2/O生化池+砂滤,污泥处理采用污泥贮池+带式浓缩脱水一体机,尾水采用液氯消毒,设计出水水质执行GB 18918—2002《城镇污水处理厂污染物排放标准》一级A排放标准。介绍了该工程的工艺流程、设计参数,总结分析了工艺设计的技术特点。同时阐述了针对低温条件下的运行保障措施和要求,为寒冷地区同类污水处理厂的设计提供参考和借鉴。     

废弃SCR脱硝催化剂的再生及其脱硝性能研究

对废弃脱硝催化剂处理后重新加工再生,研究了添加剂对其粉体成型和再生催化剂脱硝活性的影响,探讨了反应温度、空速、n(NH3)∶n(NO)摩尔比、氧含量、H2O和SO2对再生催化剂NH3选择性催化还原(SCR)NO的影响。结果表明:最佳再生条件是使用5%羧甲基纤维素和10%无机粘结剂辅助成型;废弃催化剂再生利用率高达90%;再生催化剂抗压强度为4.73 MPa,优于商用催化剂;空速5 000 h-1、氨氮摩尔比1、氧含量6%时,脱硝活性温度窗口为310⁴50℃,350℃时活性最高为94%;350℃时,单独通入1 000×10-6SO2或10%H2O对再生催化剂活性均有一定抑制作用,最低活性分别为70%和81%,停止通入SO2或H2O后其活性逐渐恢复;同时通入1 000×10-6SO2和10%H2O,再生催化剂活性下降至63%并于1 h内保持相对稳定,停止通入SO2和H2O 2 h后,活性逐渐恢复到73%。     

Decrease of NH4+-N by bacterioplankton accelerated the removal of cyanobacterial blooms in aerated aquatic ecosystem

We used aerated systems to assess the influence of the bacterioplankton community on cyanobacterial blooms in algae/post-bloom of Lake Taihu, China. Bacterioplankton community diversity was evaluated by polymerase chain reaction-denaturing gradient gel electrophoresis(PCR-DGGE) fingerprinting. Chemical analysis and nitrogen dynamic changes illustrated that NH4+-N was nitrified to NO2-N and NO3-N by bacterioplankton. Finally, NH4+-N was exhausted and NO3-N was denitrified to NO2-N, while the accumulation of NO2-N indicated that bacterioplankton with completely aerobic denitrification ability were lacking in the water samples collected from Lake Taihu. We suggested that adding completely aerobic denitrification bacteria(to denitrify NO2-N to N2)would improve the water quality. PCR-DGGE and sequencing results showed that more than 1/3 of the bacterial species were associated with the removal of nitrogen, and Acidovorax temperans was the dominant one. PCR-DGGE, variation of nitrogen, removal efciencies of chlorophyll-a and canonical correspondence analysis indicated that the bacterioplankton significantly influenced the physiological and biochemical changes of cyanobacteria. Additionally, the unweighted pair-group method with arithmetic means revealed there was no obvious harm to the microecosystem from aeration. The present study demonstrated that bacterioplankton can play crucial roles in aerated ecosystems, which could control the impact of cyanobacterial blooms in eutrophicated fresh water systems.     

Effects of physical and chemical characteristics of surface sediments in the formation of shallow lake algae-induced black bloom

Surface sediments are closely related to lake black blooms. The dissolved oxygen （DO） distribution and its penetration depth in surface sediments as well as the migration and transformation of redox sensitive elements such as Fe and S at the sediment-water interface are important factors that could influence the formation of the black bloom. In this study, dredged and undredged sediment cores with different surface properties were used to simulate black blooms in the laboratory. The Micro Profiling System was employed to explore features of the DO and ∑H2S distribution at the sediment-water interface. Physical and chemical characteristics in sediments and pore waters were also analyzed. The results showed that sediment dredging effectively suppressed the black blooms. In the undredged treatment, DO penetration depth was only 50 μm. Fe^2＋ concentrations, ∑H2S concentrations, and ∑H2S production rates were remarkably higher in surface sediments and pore waters compared to control and dredged treatments. Furthermore, depletion of DO and accumulation of Fe^2＋ and ∑H2S in surface sediments and pore waters provided favorable redox environments and necessary material sources for the blooms. The study results proved that physical and chemical characteristics in surface sediments are important factors in the formation of the black bloom, and could provide scientific guidance for emergency treatment and long-term pre-control of black blooms.     

无人机大气环境应急监测系统设计探讨

环境应急监测是有效预防与应对突发性环境污染事故的重要基础。基于无人机平台的大气环境应急监测系统,作业效率高,机动灵活,使用方便、监测范围广,为突发性大气污染事件的应急监测提供了一种新的技术平台与工具选择,也为无人机的应用开辟了一个全新的领域。文章提出了基于无人机平台的大气环境应急监测系统的设计框架,分析了系统组成,并对系统功能和操作规程进行了初步设计,对于设计中存在的一些问题进行了探讨,并从技术发展角度,提出了未来该领域有待持续深入研究的主要方向:(1)机载大气环境监测仪器设备研制;(2)基于无人机平台的环境应急监测系统与环境应急指挥平台的一体化集成研究;(3)持续推动监测数据分析处理软件系统的研究。