Nitrogen oxides from waste incineration: control by selective non-catalytic reduction

An experimental study of the selective non-catalytic reduction (SNCR) process was carried out to determine the efficiency of NOx removal and NH3 mass balance, the NOx reducing reagent used. Experimental tests were conducted on a full-scale SNCR system installed in a hospital waste incineration plant. Anhydrous NH3 was injected at the boiler entrance for NOx removal. Ammonia was analyzed after each flue-gas treatment unit in order to establish its mass balance and NH3 slip in the stack gas was monitored as well. The effective fraction of NH3 for the thermal NOx reduction was calculated from measured values of injected and residual NH3. Results show that a NOx reduction efficiency in the range of 46.7-76.7% is possible at a NH3/NO molar ratio of 0.9-1.5. The fraction of NH3 used in NOx removal was found to decrease with rising NH3/NO molar ratio. The NH3 slip in the stack gas was very low, below permitted limits, even at the higher NH3 dosages used. No direct correlation was found between the NH3/NO molar ratio and the NH3 slip in the stack gas since the major part of the residual NH3 was converted into ammonium salts in the dry scrubbing reactor and subsequently collected in the fabric filter. Moreover, another fraction of NH3 was dissolved in the scrubbing liquor.     

Antimony distribution and environmental mobility at an historic antimony smelter site, New Zealand

A historic antimony smelter site at Endeavour Inlet, New Zealand has smelter residues with up to 17 wt.% antimony. Residues include coarse tailings (cm scale particles, poorly sorted), sand tailings (well sorted) and smelter slag (blocks up to 30 cm across). All of this material has oxidised to some degree over the ca. 100 years since the site was abandoned. Oxidation has resulted in acidification of the residues down to pH 2-5. Smelter slag contains pyrrhotite (FeS) and metallic antimony, and oxidation is restricted to surfaces only. The coarse tailings are the most oxidised, and few sulfide grains persist. Unoxidised sand tailings contain 10-20 vol.% stibnite (Sb2S3) containing up to 5% As, with subordinate arsenopyrite (FeAsS), and minor pyrite (FeS2). The sand tailings are variably oxidised on a scale of 2-10 cm, but original depositional layering is preserved during oxidation and formation of senarmontite (Sb2O3). Oxidation of sand tailings has resulted in localised mobility of both Sb and As on the cm scale, resulting in redistribution of these metalloids with iron oxyhydroxide around sand grain boundaries. Experiments demonstrate that Sb mobility decreases with time on a scale of days. Attenuation of both As and Sb occurs due to adsorption on to iron oxyhydroxides which are formed during oxidation of the smelter residues. There is no detectable loss of Sb or As from the smelter site into the adjacent river, <50 m away, which has elevated Sb (ca. 20 microg/l) and As (ca. 7 microg/l) from mineralised rocks upstream. Despite the high concentrations of Sb and As in the smelter residues, these metalloids are not being released into the environment.     

Mechanisms of lead, copper, and zinc retention by phosphate rock

The solid-liquid interface reaction between phosphate rock (PR) and metals (Pb, Cu, and Zn) was studied. Phosphate rock has the highest affinity for Pb, followed by Cu and Zn, with sorption capacities of 138, 114, and 83.2 mmol/kg PR, respectively. In the Pb-Cu-Zn ternary system, competitive metal sorption occurred with sorption capacity reduction of 15.2%, 48.3%, and 75.6% for Pb, Cu, and Zn, respectively compared to the mono-metal systems. A fractional factorial design showed the interfering effect in the order of Pb>Cu>Zn. Desorption of Cu and Zn was sensitive to pH change, increasing with pH decline, whereas Pb desorption was decreased with a strongly acidic TCLP extracting solution (pH = 2.93). The greatest stability of Pb retention by PR can be attributed to the formation of insoluble fluoropyromorphite [Pb(10)(PO(4))(6)F(2)], which was primarily responsible for Pb immobilization (up to 78.3%), with less contribution from the surface adsorption or complexation (21.7%), compared to 74.5% for Cu and 95.7% for Zn. Solution pH reduction during metal retention and flow calorimetry analysis both supported the hypothesis of retention of Pb, Cu, and Zn by surface adsorption or complexation. Flow calorimetry indicated that Pb and Cu adsorption onto PR was exothermic, while Zn sorption was endothermic. Our research demonstrated that PR can effectively remove Pb from solutions, even in the presence of other heavy metals (e.g. Cu, Zn).     

Free market ideology and deregulation in Colorado’s oil fields: Evidence for triple movement activism?

Unconventional oil and gas extraction (UOGE) has spurred an unprecedented boom in onshore production in the US. Despite a surge in related research, a void exists regarding inquiries into policy outcomes and perceptions. To address this, support for federal regulatory exemptions for UOGE is examined using survey data collected in 2015 from two Northern Colorado communities. Current regulatory exemptions for UOGE can be understood as components of broader societal processes of neoliberalization. Free market ideology increases public support for federal regulatory exemptions for UOGE. Perceived negative impacts do not necessarily drive people to support increased federal regulation. Utilizing neo-Polanyian theory, interaction between free market ideology and perceived negative impacts is explored. Free market ideology appears to moderate people’s views of regulation: increasing the effect of perceived negative impacts while simultaneously increasing support for deregulation. To conclude, the ways in which free market ideology might normalize the impacts of UOGE activity are discussed.     

Determining the carbon-to-chlorophyll ratio of natural phytoplankton

For field samples, regression analyses of plots of chemically determined particulate organic carbon on chlorophyll are often employed to estimate the algal carbon-to-chlorophyll ratio (F) in the presence of appreciable amounts of nonalgal particulate organic carbon. Spurious results will be obtained, however, if the temporal rate of change of the algae or the nonplant matter reverses its sign during the sampling interval and the samples cannot be ordered correctly in time or space. Previously recognized sources of bias inherent in the chemical approach are also discussed. The great uncertainty of our present knowledge of F is pointed out. It is shown that the concentration of microscopically visible, nonliving particles in the sea isnot known. Renewed studies are suggested as a means of improving on the chemical approach to determining F. The general argument holds for the ratios of nitrogen (particle volume, etc.)-to-chlorophyll, carbon (nitrogen, particle volume, etc.)-to-ATP, and similar conversion factors.Contribution No. 932 from the Department of Oceanography, University of Washington, Seattle, Washington 98195, USA. The article is a revised and expanded version of a paper contributed at the Joint Oceanographic Assembly, September 1976, at Edinburgh, Scotland, UK.     

Environmental prevalence,fate, impacts,and mitigation of microplastics—a critical review on present understanding and future research scope

Environmental Science and Pollution Research - Microplastics are considered to be ubiquitous and widespread emerging contaminants. They are persistent in the nature and pose considerable harm to...     

A multi-process phytoremediation system for removal of polycyclic aromatic hydrocarbons from contaminated soils

To improve phytoremediation processes, multiple techniques that comprise different aspects of contaminant removal from soils have been combined. Using creosote as a test contaminant, a multi-process phytoremediation system composed of physical (volatilization), photochemical (photooxidation) and microbial remediation, and phytoremediation (plant-assisted remediation) processes was developed. The techniques applied to realize these processes were land-farming (aeration and light exposure), introduction of contaminant degrading bacteria, plant growth promoting rhizobacteria (PGPR), and plant growth of contaminant-tolerant tall fescue (Festuca arundinacea). Over a 4-month period, the average efficiency of removal of 16 priority PAHs by the multi-process remediation system was twice that of land-farming, 50% more than bioremediation alone, and 45% more than phytoremediation by itself. Importantly, the multi-process system was capable of removing most of the highly hydrophobic, soil-bound PAHs from soil. The key elements for successful phytoremediation were the use of plant species that have the ability to proliferate in the presence of high levels of contaminants and strains of PGPR that increase plant tolerance to contaminants and accelerate plant growth in heavily contaminated soils. The synergistic use of these approaches resulted in rapid and massive biomass accumulation of plant tissue in contaminated soil, putatively providing more active metabolic processes, leading to more rapid and more complete removal of PAHs.     

Modelling episodic acidification of surface waters: the state of science

Field studies of chemical changes in surface waters associated with rainfall and snowmelt events have provided evidence of episodic acidification of lakes and streams in Europe and North America. Modelling these chemical changes is particularly challenging because of the variability associated with hydrological transport and chemical transformation processes in catchments. This paper provides a review of mathematical models that have been applied to the problem of episodic acidification. Several empirical approaches, including regression models, mixing models and time series models, support a strong hydrological interpretation of episodic acidification. Regional application of several models has suggested that acidic episodes (in which the acid neutralizing capacity becomes negative) are relatively common in surface waters in several regions of the US that receive acid deposition. Results from physically based models have suggested a lack of understanding of hydrological flowpaths, hydraulic residence times and biogeochemical reactions, particularly those involving aluminum. The ability to better predict episodic chemical responses of surface waters is thus dependent upon elucidation of these and other physical and chemical processes.     

Bioavailability of persistent organic pollutants in soils and sediments--a perspective on mechanisms, consequences and assessment

It has been observed that as soil-pollutant contact time increases, pollutant bioavailability and extractability decreases. This phenomenon has been termed 'ageing'. Decreased chemical extractability with increased soil-chemical contact time is evident where both 'harsh' techniques, e.g. dichloromethane Soxhlet extraction, and 'non-exhaustive' techniques, e.g. butanol shake extraction, have been used. It has also been observed that the amount of chemical extracted by these techniques varies considerably over time. Similarly, decreases in bioavailability with increased soil-pollutant contact time have been described in bacterial, earthworm and other organism studies. From these investigations, it has been shown that the fraction of pollutant determined to be bioavailable can vary between organisms. Thus, there is an immediate definition problem, what is bioavailability? Additionally, if bioavailability is to be assessed by a chemical means, which organisms should (or can) be mimicked by the extraction procedure? This review provides a background to the processes inherent to ageing, a discussion of its consequences on bioavailability and ends with some reflections on the appropriateness of chemical extraction techniques to mimic bioavailability