The Determination of Heavy Metals in the Ligurian Sea. III. Distribution of Copper, Iron, and Nickel in the 0-200 Metre Layer in Open Sea

Dissolved Cu, Fe and Ni were determined in sea water samples from 9 stations in the Ligurian Sea located along the two traverses Imperia-Capo Corso and Nice-Calvi and at depths between 0 and 200 m. The samples were preconcentrated from small volumes of sea water by complexation with ammonium pyrrolidine-dithiocarbammate (APDC), extraction with CCl₄ and determination by AAS with electrothermal atomisation. The geographical distribution shows that in the central part of the inner traverse there is a maximum of Cu and Fe concentration; the vertical distribution shows no significant depletion of the dissolved elements in the epithalassa.

The results allow for a first approach to the more general problem of the distribution of the trace elements in the Ligurian Sea.     

Symptoms prevalence among office workers of a sealed versus a non-sealed building: Associations to indoor air quality

ObjectivesAn increasing number of complaints related to time spent in artificially ventilated buildings have been progressively reported and attributed, at least in part, to physical and chemical exposures in the office environment. The objective of this research was to investigate the association between the prevalence of work-related symptoms and the indoor air quality, comparing a sealed office building with a naturally ventilated one, considering, specially, the indoor concentration of TPM, TVOCs and the main individual VOCs.MethodsA cross-sectional study was performed to compare the prevalence of sick building syndrome (SBS) symptoms among 1736 office workers of a sealed office building and 950 of a non-sealed one, both in Rio de Janeiro's downtown. The prevalence of symptoms was obtained by a SBS standardized questionnaire. The IAQ of the buildings was evaluated through specific methods, to determine the temperature, humidity, particulate matter and volatile organic compound (VOC) concentrations.ResultsUpper airways and ophthalmic symptoms, tiredness and headache were highly prevalent in both buildings. Some symptoms were more prevalent in the sealed building: “eye dryness” 33.3% and 27.1% (p: 0.01); “runny nose” 37.3% and 31.3% (p: 0.03); “dry throat” 42% and 36% (p: 0.02); and “lethargy” 58.5% and 50.5% (p: 0.03) respectively. However, relative humidity and indoor total particulate matter (TPM) concentration as well as total volatile organic compounds (TVOCs) were paradoxically greater in the non-sealed building, in which aromatic compounds had higher concentration, especially benzene. The analysis between measured exposure levels and resulting symptoms showed no association among its prevalence and TPM, TVOCs, benzene or toluene concentration in none of the buildings.ConclusionsOther disregarded factors, like undetected VOCs, mites, molds and endotoxin concentrations, may be associated to the greater prevalence of symptoms in the sealed building.     

Bioremediation model for atrazine contaminated agricultural soils using phytoremediation (using Phaseolus vulgaris L.) and a locally adapted microbial consortium

The objective of the present study was to examine a biological model under greenhouse conditions for the bioremediation of atrazine contaminated soils. The model consisted in a combination of phytoremediation (using Phaseolus vulgaris L.) and rhizopheric bio-augmentation using native Trichoderma sp., and Rhizobium sp. microorganisms that showed no inhibitory growth at 10,000 mg L^?1 of herbicide concentration. 33.3 mg of atrazine 50 g^?1 of soil of initial concentration was used and an initial inoculation of 1 × 10⁹ UFC mL^?1 of Rhizobium sp. and 1 × 10⁵ conidia mL^?1 of Trichoderma sp. were set. Four treatments were arranged: Bean + Trichoderma sp. (B+T); Bean + Rhizobium sp. (BR); Bean + Rhizobium sp. + Trichoderma sp. (B+R+T) and Bean (B). 25.51 mg of atrazine 50 g^?1 of soil (76.63%) was removed by the B+T treatment in 40 days (a = 0.050, Tukey). This last indicate that the proposed biological model and methodology developed is useful for atrazine contaminated bioremediation agricultural soils, which can contribute to reduce the effects of agrochemical abuse.     

Single adsorption of diclofenac and ronidazole from aqueous solution on commercial activated carbons: effect of chemical and textural properties

Environmental Science and Pollution Research - The importance of the textural and physicochemical characteristics upon the adsorption capacity of the commercial activated carbons (ACs) Coconut,...     

Changes in soil organic carbon contents and nitrous oxide emissions after introduction of no-till in Pampean agroecosystems

We reviewed published results to estimate no-till effects on SOC and denitrification in the Argentine Pampas and the potential of no-till to mitigate the global warming effect. On an equivalent mass basis, 42 paired data sets were used for SOC comparisons of no-till vs. plow till (moldboard plow or disk plow), 18 paired data for comparison of no-till vs. reduced till (chisel plow or harrow disk), and 20 paired data for comparison of plow till vs. reduced till. Twenty-six denitrification data sets were used for evaluation of tillage system and fertilization effects on N2O emission. Changes in SOC under no-till were not correlated to time since initiation of experiments. Averaged over years a 2.76 Mg ha(-1) SOC increase (P = 0.01) was observed in no-till systems compared with tilled systems, but no differences were detected between plow and reduced till. The SOC under tillage explained most of the SOC variation under no-till (R2= 0.94, P = 0.01). The model had a positive intercept and predicted a relatively higher increase of SOC in areas of low organic matter level. The conversion of the whole pampean cropping area to no-till would increase SOC by 74 Tg C, about twice the annual C emissions from fossil fuel consumption of Argentina. Emissions of N2O were greater under no-till with a mean increase of 1 kg N ha(-1) yr(-1) in denitrification rate for humid pampean scenarios. The increased emissions of N2O might overcome the mitigation potential of no-till due to C sequestration in about 35 yr, and therefore no-till might produce global warming.     

Bioassays for the evaluation of reclaimed opencast coal mining areas

Environmental Science and Pollution Research - This study aimed to use bioassays (single and multispecies) with organisms from different trophic levels to assess soil quality in reclaimed coal...     

Gaps,biases, and future directions in research on the impacts of anthropogenic land-use change on aquatic ecosystems: a topic-based bibliometric analysis

Environmental Science and Pollution Research - Anthropogenic land use change (ALUC) satisfies human needs but also impacts aquatic ecosystems. Aquatic ecosystems are intrinsically linked with...     

PM2.5 exposure as a risk factor for multiple sclerosis. An ecological study with a Bayesian mapping approach

Environmental Science and Pollution Research - Some environmental factors are associated with an increased risk of multiple sclerosis (MS). Air pollution could be a main one. This study was...     

Energy efficiency during conventional and novel sintering processes: the case of Ti–Al2O3–TiC composites

The conventional (hot pressing or HP) and the novel (spark plasma sintering or SPS) consolidation techniques were compared when processing Ti–Al₂O₃–TiC powders obtained by self-propagating high-temperature synthesis (SHS). It was found that the two different methods are able to produce similar materials, in some cases (Vickers hardness and wear rate) slightly better for SPSed samples. However, SPS does not need sintering temperatures as high as HP to obtain fully dense products. Most significantly, processing times were strongly reduced when adopting the SPS technique instead of HP, i.e. 4–7 min and about 5 h, respectively. Finally, when the total energies required during each SPS or HP experiment were compared, it was found that the use of the SPS technology allowed for an energy saving in the order of 90–95%. This fact makes SPS significantly advantageous from environmental and economical points of view compared to HP.