工业烟气氨法-络合法同时脱硫脱硝

在脱硫脱硝喷淋装置上采用氨法-络合法处理工业烟气。考察了吸收液pH、Fe(Ⅱ)EDTA浓度、初始烟气浓度、液气比对烟气同时脱硫脱硝效果的影响。实验结果表明:吸收液的酸碱度通过影响Fe(Ⅱ)与EDTA的络合形式进而影响NO去除率;SO_2去除率主要受吸收液pH和初始SO_2质量浓度的影响;当吸收液pH大于8、吸收液Fe(Ⅱ)EDTA浓度大于0.100 mol/L、初始SO_2质量浓度小于1 500 mg/m3、初始NO质量浓度为1 200 mg/m3时,SO_2去除率均在95%以上,NO去除率为54%;当液气比由1 L/m3增大至4 L/m3时,有效脱硫时间和有效脱硝时间分别增长了7 min和4 min。     

高铁酸盐处理有机废水的研究进展

综述了高铁酸盐去除水中藻类、细菌、烃类衍生物、药品、农药、染料等有机污染物的国内外最新研究进展,并对高铁酸盐的高效利用进行了探讨。高铁酸盐可破坏藻类和细菌细胞的完整性,将大分子芳香烃衍生物氧化为低毒的小分子中间体,将小分子链烃衍生物矿化,破坏药品、农药及染料的不饱和双键。无机矿物在溶液中负载高铁酸盐或将高分子有机物与固体高铁酸盐混合造粒,将是高铁酸盐高效利用领域的研究热点。     

TiO2载体对Mn-Ce/TiO2催化剂脱硝活性的影响

以TiO₂为载体,选取过渡金属元素Mn为活性组分,稀土金属元素Ce为活性助剂,采用分步共混法制备了Mn-Ce/TiO₂催化剂（活性组分负载量16%）,系统研究了TiO₂载体的晶型和晶粒尺寸对催化剂脱硝活性的影响。实验结果表明：分别以锐钛矿型和金红石型TiO₂为载体制备的催化剂,其低温脱硝活性相差不大,活性组分均以无定型态高度分散于载体中,以金红石型TiO₂为载体制备的催化剂中部分TiO₂转变为锐钛矿型;以不同晶粒尺寸TiO₂载体制备的催化剂的低温脱硝活性相差较大,比表面积较大、晶粒尺寸较小的TiO₂载体制备的催化剂,其脱硝活性低于晶粒尺寸较大的TiO₂载体制备的催化剂。     

Formation of persistent chlorinated aromatic compounds in simulated and real fly ash from iron ore sintering

Effects of carbon concentration and Cu additive in simulated fly ash (SFA) and real fly ash (RFA) on the formation of polychlorinated dibenzofurans (PCDFs), polychlorinated dibenzo-p-dioxins (PCDDs), chlorobenzenes, and polychlorinated biphenyls which were all regarded as persistent chlorinated aromatics in iron ore sintering were investigated. In the annealing process of SFA with various carbon contents, the yield of chlorinated aromatics and the I-TEQ obtained their maximum at 10 wt% carbon content. Active carbon in SFA acted as the carbon source as well as an adsorbent which led to higher production of PCDD/F in solid phase at 10 wt% carbon content. The increase of carbon content will be beneficial on the formation of 2,3,7,8-Chloro-substituted PCDF compared with 2,3,7,8-Chloro-substituted PCDD. In addition, the CuCl₂·2H₂O was a much more powerful catalyst in the formation of chlorinated aromatic compounds compared with elementary Cu, since it served as both a catalyst and a chlorine donor. However, the RFA behaved similarly with SFA with elementary Cu in the formation of chlorinated aromatic compounds. The effect of carbon content and copper additives on formation of 2,3,7,8-chloro-substituted congeners displayed similar characteristics with the tetra- to octa-PCDD/F isomers and even the total PCDD/Fs.     

环境污染物导致氧化应激的关键信号通路及其检测方法

环境污染物能够以多种途径进入生物体内,在体内产生含氧自由基等活性氧物质,并通过多种信号通路及酶反应引起氧化应激,造成生物体内的脂质过氧化、蛋白质损伤、DNA表达改变、酶失活等,从而引发心血管疾病、风湿类疾病、感染及癌症等的发生。本文对环境污染物致氧化应激产生的原因、涉及的信号通路及酶反应、造成的危害,以及常见的基于细胞模型的氧化应激检测方法进行了综述,期望为评价环境污染物和检测氧化损伤提供参考。     

珠江三角洲4种淡水养殖鱼类重金属的残留及食用风险评价

为全面了解珠江三角洲淡水水产品中重金属污染现状,评估其生态风险与食用安全,于2014年8月至2015年8月采集罗非鱼、草鱼、乌鳢及鳜鱼主要养殖鱼类样品共计57份,采用原子荧光光谱仪(AFS),电感耦合等离子体质谱(ICP-MS)仪进行分析测定,并采用单因子污染指数(Pi)、重金属污染指数(MPI)、每周可耐受摄入量(PTWI)以及食入健康风险指标(Ri总)分别评估其污染程度、食用安全性与健康风险。结果表明,样品中Cr、Ni、Cu、Zn、As、Cd、Hg、Pb的含量范围分别为0.020~3.240,0.020~0.800,0.110~1.100,0.190~19.970,0.030~1.480,nd~0.606,0.003~0.118,0.040~0.803 mg·kg-1(湿重),Cr、As、Cd、Pb在水产品中超标率大小依次为As(7.0%),Pb(7.0%),Cd(5.3%),Cr(1.8%)。Pi结果表明,目前珠江三角洲养殖水域水产品中Cu与Zn残留处于正常范围内,Cr和Hg有少量样品为轻度污染,Pb、Cd与As存在重度污染样品,所占比例为2.86%、6.02%和5.74%。MPI结果显示不同水产品污染程度为乌鳢>鳜鱼>罗非鱼>草鱼,总体上各种水产品MPI依然处于较低的水平;食用安全性结果显示,目前成人每周摄入水产品是安全的,但乌鳢Cr,罗非鱼As含量较高分别达到PTWI的37.76%和19.51%,表明水产品中Cr、As残留可能存在一定的食用安全隐患。健康风险模型结果显示,所有样品均未超过国际辐射防护委员会(ICRP)的推荐的最大可接受水平(5×10-6a-1)。综合分析珠江三角洲淡水养殖主要水产品可知,其尚未出现明显的污染安全问题,但As与Cr等元素的潜在风险值得进一步关注。     

基于机器视觉的鱼类行为特征提取与分析

近年来,水污染问题备受关注。生物式水质监测成为目前国家环境保护工作的重要任务之一。为准确监测水质污染情况,本文以青鳉鱼(Oryzias latipes)为研究对象,采用非接触式的机器视觉监测技术,提取青鳉鱼的生理特征(呼吸频率)和运动特征(胸鳍和尾鳍的摆动频率),并分析这些特征与水质之间的关系。本文采用支持向量机(Support Vector Machine,SVM)准确提取鱼鳃,并根据鱼鳃呼吸面积大小变化计算出鱼的呼吸频率。基于形态学细化算法提取青鳉鱼骨架,求出胸鳍和尾鳍的摆动频率。结果显示:不同浓度铜离子暴露实验测得的青鳉鱼生理特征和运动特征与实际情况一致;通过对不同铜离子浓度下的毒性实验数据对比,发现了青鳉鱼的生理特征和运动特征会随不同的铜离子浓度发生相应变化,可以作为水质监测的评价标准。     

菲和镉单一及复合污染条件下在毛蚶体内的富集动力学研究

采用室内半静态双箱动力学模型实验,研究了菲和镉单一及复合污染条件下在毛蚶(Anadara subcrenata)体内的生物富集,通过对富集与释放过程中毛蚶体内菲和Cd的富集量进行非线性曲线拟合,获得了菲和Cd单一及复合污染条件下在毛蚶体内的吸收速率常数k1、释放速率常数k2、生物富集因子BCF、生物半衰期B1/2和平衡状态下最大富集量CA max等动力学参数。实验结果表明,菲和Cd在实验前期富集速率较高,8 d以后富集速率减缓,释放阶段与富集阶段相似。毛蚶对菲的BCF值为37.80,远大于Cd的BCF值13.12,且生物半衰期时间更长,菲更容易在生物体内富集。菲和Cd联合暴露条件下,在毛蚶体内的CA max和BCF值均大于单一作用,说明二者同时暴露时,毛蚶对菲和镉的吸收富集均有所增强。实验模型拟合度较好,输出值和实测值之间无显著性差异,拟合方程和拟合参数可信。     

Public participation in municipal solid waste source-separated collection in Guilin,China: status and influencing factors

Currently, China is facing critical problems regarding the management of municipal solid waste (MSW). The failure of existing pilot programs in implementing MSW source-separated collection highlights the need to analyze the factors significantly influencing public participation in this activity. To this end, a comprehensive analysis of MSW source-separated collection in Guilin, which is representative of wider areas located in inland China and with a GDP around the national average, was conducted. The research consisted of in-person interviews involving a questionnaire and theoretical analyses in terms of public perception, public awareness, public attitude, and willingness to pay. The analytical results identify the status of waste source-separated collection and influencing factors in implementation, and provides exercisable suggestions for decision makers in both China and more generally in industrializing countries to design promotion programs and education campaigns.     

Improvement of sludge dewaterability with modified cinder via affecting EPS

The relationship between the improvement of sludge dewaterability and variation of organic matters has been studied in the process of sludge pre-conditioning with modified cinder, especially for extracellular polymeric substances (EPS) in the sludge. During the conditioning process, the decreases of total organic carbon (TOC) and soluble chemical oxygen demand (SCOD) were obviously in the supernatant especially for the acid modified cinder (ACMC), which could be attributed to the processes of adsorption and sweeping. The reduction of polysaccharide and protein in supernatant indicated that ACMC might adsorb EPS so that the tightly bound EPS (TB-EPS) decreased in sludge. In the case of ACMC addition with 24 g·L^–1, SRF of the sludge decreased from 7.85 × 10¹² m·kg^–1 to 2.06 × 10¹² m·kg^–1, and the filter cake moisture decreased from 85% to 60%. The reconstruction of “floc mass” was confirmed as the main sludge conditioning mechanism. ACMC promoted the dewatering performance through the charge neutralization and adsorption bridging with the negative EPS, and provided firm and dense structure for sludge floc as skeleton builder. The passages for water quick transmitting were built to avoid collapsing during the high-pressure process.

Open image in new window