Atmospherically deposited major and trace elements in the winter snowpack along a gradient of altitude in the Central Pyrenees: The seasonal record of long-range fluxes over SW Europe

The chemistry of high mountain snowpacks is a result of the long-range atmospheric transport and deposition of elements. Pyrenean snowpacks contain information about the fluxes of elements over SW Europe in winter. Here we analysed Al, Ti, Mn, Fe, Ni, Cu, Zn, As, Se, Cd and Pb in the 2004–05 winter snowpack in the Central Pyrenees, at an altitude range of 1820–3200 m a.s.l. Ni, As, Se and Cd were not detected in most cases. The concentrations of the remaining elements were comparable to those found in other high mountain areas in Europe and North America considered representative of regional background of atmospheric deposition in populated areas. In contrast, our measurements were higher than those of polar areas, which represent the global background. Single measurements of concentrations and snow accumulation were subject to considerable spatial variability, which may be attributable to strong wind drift and other post-depositional processes. The major ions chemistry of the snow indicated three possible origins for the solutes: terrigenous dust, sea salt spray and polluting S and N aerosols. We found no association between Cu, Zn and Pb and any of these possible sources. This observation therefore indicates that these elements were not preferentially bound to any particular kind of aerosol. Snow collected at altitudes of up to 2050 m a.s.l. presented higher concentrations of several elements than snow above this altitude, thereby indicating a local influence. Snow collected above 2300 m a.s.l. was therefore more representative of broad regional inputs. At these higher altitudes, snow was not enriched in Al, Ti, Mn, Fe or As compared with the composition of the upper continental crust and the local lithology, and these elements (except Mn) appeared almost exclusively in the particulate fraction. This observation indicates that Al, Ti, Mn, Fe and As were present mainly as part of dust particles of terrigenous origin. In contrast, Cu, Zn, and Pb presented medium to high enrichment factors and showed a higher proportion of soluble forms, thereby indicating their polluting character.     

A high-resolution historical sediment record of nutrients,trace elements and organochlorines (DDT and PCB) deposition in a drinking water reservoir (Lake Brêt,Switzerland) points at local and regional pollutant sources

The ¹³⁷Cs and ²¹⁰Pb dating of a 61-cm long sediment core retrieved from a drinking water reservoir (Lake Brêt) located in Switzerland revealed a linear and relatively high sedimentation rate (～1 cm year^?1) over the last decades. The continuous centimeter scale measurement of physical (porewater and granulometry), organic (C_org, P, N, HI and OI indexes) and mineral (C_min and lithogenic trace elements) parameters therefore enables reconstructing the environmental history of the lake and anthropogenic pollutant input (trace metals, DDT and PCBs) at high resolution. A major change in the physical properties of the lowermost sediments occurred following the artificial rise of the dam in 1922. After ca. 1940, there was a long-term up-core increase in organic matter deposition attributed to enhance primary production and anoxic bottom water conditions due to excessive nutrient input from a watershed predominantly used for agriculture that also received domestic effluents of two wastewater-treatment plants. This pattern contrasts with the terrigenous element input (Eu, Sc, Mg, Ti, Al, and Fe) which doubled after the rising of the dam but continuously decreased during the last 60 years. By comparison, the trace metals (Cu, Pb and Hg) presented a slight enrichment factor (EF) only during the second part of the 20th century. Although maximum EF Pb (>2) occurred synchronously with the use of leaded gasoline in Switzerland (between ca. 1947 and 1985) the Hg and Cu profiles exhibited a relatively similar trend than Pb during the 20th century, therefore excluding the alkyl-lead added to petrol as the dominant (atmospheric) source of lead input to Lake Brêt. Conversely, the Cu profile that did not follow the decrease registered in Pb and Hg during the last 10 years, suggests an additional source of Cu probably linked to the impact of agricultural activities in the area. In absence of heavy industries in the catchment, the atmospheric deposition of DDT and PCBs via surface runoff followed the historical emissions of POPs in Switzerland. Such result highlights the regional contamination of freshwater resources by the large-scale emission of toxic industrial chemicals in the 1960s and 1970s as well as the efficiency of the regulatory measures subsequently taken.     

Evaluation of Saccharomyces cerevisiae strains as probiotic agent with aflatoxin B1 adsorption ability for use in poultry feedstuffs

In this study the aflatoxin B₁ (AFB₁) removal capacity, the tolerance to salivary and gastrointestinal conditions, autoaggregation and coaggregation with pathogenic bacteria of Saccharomyces cerevisiae strains isolated from broiler feces, were evaluated. Only four of twelve isolated strains were identified as Saccharomyces cerevisiae using molecular techniques. The results obtained in AFB₁ binding studies indicated that the amount of AFB₁ removed was both strain and mycotoxin-concentration dependent. Therefore, a theoretical model was applied in order to select the most efficient strain to remove AFB₁ in a wide range of mycotoxin concentration. The results indicated that S. cerevisiae 08 and S. cerevisiae 01 strains were the most efficient microorganisms in the mycotoxin removal. Viability on simulated salivary and gastrointestinal conditions was investigated and S. cerevisiae 08 strain showed the best results, achieving 98% of total survival whereas S. cerevisiae 01 reached only 75%. Autoaggregation and coaggregation assays showed S. cerevisiae 08 as the most appropriate strain, mainly because it was the unique strain able to coaggregate with the four bacterial pathogens assayed. Consequently, S. cerevisiae 08 is the best candidate for future in vivo studies useful to prevent aflatoxicosis. Further quantitative in vitro and in vivo studies are required to evaluate the real impact of yeast-binding activity on the bioavailability of AFB₁ in poultry. However, this study could be useful in selecting efficient strains in terms of AFB₁ binding and provide an important contribution to research into microorganisms with potential probiotic effects on the host.     

Bait-lamina assay as a tool to assess the effects of metal contamination in the feeding activity of soil invertebrates within a uranium mine area

As part of the tier 2 of a site-specific risk assessment, this study was the first reporting an intensive in situ application of the bait-lamina assay; two exposure periods (7 and 14 days) were tested during four seasons in ten different sites, within a uranium mine area and at two different depths. The most contaminated sites (by deposition of sludge from the effluent treatment pond) were discriminated after 14 days of exposure because extremely low percentages of feeding activity were recorded. Previous sub-lethal ecotoxicological assays, already had demonstrated that the habitat function of these soils is compromised. Nevertheless, seasonality has proved to have a significant influence on responses. Thus to strength conclusions about the impact of contaminants, the in situ bait-lamina assay should be performed on different annual seasons, at least for temperate regions. It was also found that some environmental parameters (e.g. soil moisture and litter) can act as confounding factors in the bait-lamina assay.     

Analysis and modelling of the pollutant emissions from European cars regarding the driving characteristics and test cycles

Within the European research project ARTEMIS, significant works have been conducted to analyse the hot emissions of pollutant from the passenger cars regarding the driving cycles and to propose modelling approaches taking into account large but heterogeneous datasets recorded in Europe. The review and analysis of a large range of test cycles enabled first the building-up of a set of contrasted cycles specifically designed for characterizing the influence of the driving conditions. These cycles were used for the measurement of the pollutants emission rates from nine passenger cars on a chassis dynamometer.Emissions measured on 30 vehicles tested on cycles adapted to their motorization (i.e., cycles for high- or low-powered cars, inducing thus a significant difference in the dynamic) were also considered for analysing the influence of the cycles and of the kinematic parameters on the hot emission rates of the regulated pollutants (CO, HC, NO_x, CO₂, PM). An analyses of variance demonstrated the preponderance of the driving type (urban, rural road, motorway), of the vehicle category (fuel, emission standard) and emitting status (high/normal emitter) and thus the pertinence of analysing and modelling separately the corresponding emissions. It also demonstrated that Urban driving led systematically to high diesel emission rates and to high CO₂, HC and NO_x emissions from petrol cars. Congested driving implied high CO₂ (diesel and petrol) and high diesel NO_x emission. On motorway, the very high speeds generated high CO₂, while unsteady speeds induced diesel NO_x and petrol CO over-emissions. A search for pertinent kinematic parameters showed that urban diesel emissions were mostly sensitive to stops and speed parameters, while petrol emissions were rather sensitive to acceleration parameters. On the motorway, diesel NO_x and CO₂ emissions rates increased with the speed variability and occurrence of high speeds, while CO₂ and CO over-emission from petrol cars were linked to the occurrence of strong acceleration at high speeds.A modelling approach based on partial least square regression was tested, which demonstrates its ability to discriminate satisfactorily the emissions according to dynamic related parameters and in particular when considering the two-dimensionnal distribution of instantaneous speed and acceleration.Finally, a strategy was proposed to analyse the large but heterogeneous set of hot emission data collected within the ARTEMIS project. The approach consisted in analysing the similarity of the numerous cycles as regards their kinematic, grouping them into reference test patterns through an automatic clustering, and then computing reference emissions for these patterns. These principles enabled the development of a method to compute the emissions at a low spatial scale, i.e. the so-called traffic situation approach, which was implemented in the European Artemis model for estimating the cars’ pollutant emissions.     

Non-destructive quantification of water gradient in sludge composting with Magnetic Resonance Imaging

Sludge from a slaughter-house wastewater plant, and mixtures of bulking agent (crushed wood pallet) and sludge were studied by Nuclear Magnetic Resonance (NMR). The NMR spin–spin relaxation (T₂) and spin–lattice relaxation (T₁) signals for sludge, wet crushed wood pallet and mixtures of sludge and bulking agent were decomposed into three relaxation time components. Each relaxation time component was explained by a non-homogeneous water distribution on a microscopic length scale and by the porosity of the material. For all samples, the T₂ relaxation time value of each component was directly related to the dry matter content. The addition of wet crushed wood to sludge induced a decrease in the relaxation time, explained by water transfer between the sludge and the wood.Magnetic Resonance Imaging (MRI) and respirometric measurements were performed on sludge and wood mixtures. MR images of the mixtures were successfully obtained at different biodegradation states. Based on specific NMR measurements in an identified area located in the MRI cells, the results showed that grey levels of MR images reflected dry matter content. This preliminary study showed that MRI would be a powerful tool to measure water distribution in sludge and bulking agent mixtures and highlights the potential of this technique to increase the understanding of sludge composting.     

Homogenous catalyzed ozonation of simazine. Effect of Mn(II) and Fe(II).

Simazine, [2-chloro, 4,6-bis(ethylamino)-1,3,5-s-triazine], a common herbicide typically found in surface and ground water was ozonised by using catalytic amounts of Mn(II) and Fe(II). An optimum value for metal concentration was found in the process. Some inhibition of the simazine degradation rate was observed when these metals were added above the optimum concentration. The pH of the reaction media played a significant role in the simazine oxidation rate. Thus, an increase in simazine conversion was observed when the pH was raised from 5 to 9. However, the catalytic effect of added manganese was negligible at the highest pH used in this study (pH 9). The beneficial influence of Fe(II) was also observed when utilising the combination of ozone and hydrogen peroxide. Contrarily, Mn(II) presented a negative influence on simazine conversion when using this oxidation technology.     

Extent and variation of sound enhancement inside burrows of the frog Eupsophus emiliopugini (Leptodactylidae)

Variation of the amplification effect of burrows of the leptodactylid frog Eupsophus emiliopugini on conspecific calls generated externally was investigated. Advertisement calls broadcast through a loudspeaker placed in the vicinity of a burrow were monitored with small microphones positioned inside and outside the cavity. For 150 presentations of calls of 15 individuals in 12 burrows, 134 were amplified and 16 were attenuated (range –6–13 dB). The fundamental resonant frequency of burrows, measured with broadcast noise and pure tones, averaged 814 Hz (range 302–1361 Hz) and covaried with burrow length. The dominant frequency of the calls of burrow occupants (average 1062 Hz, range 636–1459 Hz) was not correlated with the fundamental resonant frequency of these cavities. In burrows with low resonant frequencies, externally broadcast calls with high dominant frequencies were attenuated, or amplified to a lower extent than calls with lower dominant frequencies. The dominant frequencies of the calls experienced shifts towards the burrows’ fundamental resonant frequencies. The amplification of calls inside burrows of E. emiliopugini exhibits manifest variability, with considerable potential for facilitating acoustic interactions in this species. Received: 18 July 1999 / Received in revised form: 19 July 1999 / Accepted: 25 July 1999