Identification of some plasticizers compounds in landfill leachate

In this work it was described a simple method for extraction of plasticizer compounds (mainly phthalate esters and bisphenol A (BPA)) from landfill leachate samples. The samples were submitted to an extraction procedures based on precipitation, solid phase extraction (SPE) and ionic exchange chromatography (IEC). Firstly the landfill leachate sample was acidified by addition of HCl concentrated, in order to precipitate the organic compounds that are less soluble in water. The precipitate was washed with several solvents. The aqueous phase was then submitted to SPE with XAD-4 resin and IEC with Amberlyst A-27 resin. The instrumental analysis was performed by gas chromatography with mass spectrometer detector (GC/MSD) and the compounds were identified by the GC/MSD library (Wiley) and by using some standard substances. These methodologies allow the isolation and identification of the following compounds: dioctylphthalate, diisobutilphthalate, BPA, benzoic acid, palmitic acid and diisopentylphthalate. The methods are very simple, rapid and selective, for plasticizers extraction from landfill leachate matrices.     

An analysis of the problems of developing environmental education in Brazilian Federal protected areas

This paper describes the problems encountered in developing environmental education in Federal protected areas in Brazil. Results of a survey on the current status of environmental education in four categories of Federal protected areas; namely national parks, biological reserves, ecological stations and environmental protection areas, are described and discussed. The study suggests that the development of environmental education in protected areas in the country has several limitations: financial resources, lack of training, material resources and a lack of policy on environmental education. It also identifies that some of these problems seem to be inter-related with those of the National System of Conservation Units of the country which may result in a retarding of the development of environmental education in such areas.     

Allelopathic potential and systematic evaluation of organic extracts from Canavalia ensiformis leaves (Jack beans)

This article describes the assessment of possible allelopathic potential of organic extracts obtained from leaves of Canavalia ensiformis under laboratory conditions. Furthermore, a systematic evaluation of these extracts was carried out using specific protocols developed in capillary electrophoresis (CE) to determine some groups of secondary metabolites. After the identification and quantification of compounds, the effects of compounds on germination of some common weeds was investigated, which are becoming a real problem in pastures in the state of Pará, Brazil.     

Effectiveness of the Local Adaptation Plan of Action to support climate change adaptation in Nepal

A key challenge in climate change adaptation in developing countries as a whole, and to handling global change in particular, is to link local adaptation needs on the one hand, with national adaptation initiatives on the other, so that vulnerable households and communities can directly benefit. This study assesses the impact of the Nepal government’s efforts to promote its Local Adaptation Plan of Action (LAPA) and its applicability to other least developed countries (LDCs). Based on data gathered from two field studies in Nepal, the research shows that the Nepal’s LAPA has succeeded in mobilizing local institutions and community groups in adaptation planning and recognizing their role in adaptation. However, the LAPA approach and implementation have been constrained by sociostructural and governance barriers that have failed to successfully integrate local adaptation needs in local planning and increase the adaptive capacity of vulnerable households. This paper describes the mechanisms of suitable governance strategies for climate change adaptation specific to Nepal and other LDCs. It also argues the need to adopt an adaptive comanagement approach, where the government and all stakeholders identify common local- and national-level mainstreaming strategy for knowledge management, resource mobilization, and institutional development, ultimately using adaptation as a tool to handle global change.     

Corporate Social Responsibility (CSR) practices developed by Brazilian companies: an exploratory study

In a world where companies have major influence over the economy, politics, and environment, they must be held accountable for their actions. With this in mind, the publication of sustainability reports is in a company’s best interest, since the disclosure of Corporate Social Responsibility (CSR) and sustainable practices can bring enormous advantages, largely related to a company’s image. The amount of information presented in sustainability reports turns them into valuable sources for research data, allowing analyses related to CSR and management practices, stakeholder relations, language used, among others. However, there is no a paper in the literature that analyzes theses information jointly for the Brazilian companies, and then we decided to explore this theme. This research aimed to identify advances and gaps of CSR practices performed by Brazil companies, through the analysis of 30 sustainability reports published between 2014 and 2015. The main findings indicate that, in general, the analyzed companies are experienced in sustainability reporting; however, there is still room for improvements, including a better mapping and reporting of practices involving the integration of CSR to organizational structure, stakeholder engagement, and continuous improvement practices.     

Critical analysis of the waste management performance of two uranium production units in Brazil--part II: Caetite production center

This paper discusses the environmental waste management of the Heap-Leach Uranium Production Facility of Caetité located in a semi-arid region in Brazil. A comparison is made with the first uranium production site of the country located in Poços de Caldas. It is demonstrated that differences in the operational process along with different environmental conditions can lead to different impacts. In the present case groundwater is the potential most sensitive environmental medium despite the well-established consensus in the literature that radon and aerosol emissions may turn-out to be the most relevant environmental aspects of an installation located at this type of region. Most of the ²²⁶Ra content in the ore remains in the leached ore that is deposited with the waste rock. A lack in appropriate prediction of the hydrological balance has been causing unanticipated emissions of liquid effluents into the environment. Chemical treatment of this effluent may be needed. Contamination of groundwater in the short term by the waste ponds is not to be expected but it can be a relevant issue in the long term. As a consequence, careful closure schemes will need to be put in place. Finally, the overall costs with remediation in the Caetité production center are lower than those observed at the Poços de Caldas mining site.     

A net water production model for ultrafiltration including flow direction reversal and chemically assisted backwashing.

Flow direction reversal (FDR) was proposed as a novel method to increase net water production (NWP) during cross-flow ultrafiltration. The design of the pilot-plant study allowed measurement of specific flux recovery after each chemically assisted backwash (BW) combined with FDR and after each FDR at the midpoint of each BW/FDR cycle. The percent recovery of specific flux was higher following FDR (55%) than combined BW and FDR (53%) at lower chemical dosages; however, the percent increase in specific flux recovery by FDR was much lower (20%) when the chemical dose was doubled. A mathematical model was developed to predict the NWP achieved by any combination ofBW/ FDR and FDR frequency. For example, the advantage of introducing FDR was demonstrated at the lower chlorine dose, whereby the percent increase in NWP by alternating 15-minute intervals of BW/FDR with FDR over BW/ FDR alone was 10% for 30-minute BW/FDR intervals and 2% for 15-minute BW/FDR intervals.     

The influence of environmental factors on the molluscicidal activity of Euphorbia milii latex

Abstract

The present study was undertaken to investigate the influence of biotic (snail size and presence of food during the test) and abiotic factors (temperature, water hardness and concentration of organic materials) on the molluscicidal activity of Euphorbia milii latex. Bioassays were conducted with B. glabrata (10 snails per concentration) and snail lethality was evaluated after 24 hr and 48 hr of exposure to lyophilized latex solutions. Neither the degree of water hardness, nor the presence of food during the test affected latex‐induced snail mortality. The snail size had a minor influence on E.milii‐induced snail lethality. Newly‐hatched (shell diameter ≤ 1mm) as well as young (3–8 mm) snails were slightly less susceptible than older (10–25 mm) mollusks. On the other hand, the molluscicidal effect of E.milii latex was modified by environmental factors such as temperature (i.e. LC₅₀ and LC₉₀ values were halved for every 10°C rise in temperature) and concentration of organic materials in the water (i.e. the higher the concentration of organic matter, the higher the LC₅₀ value). The efficacy of E.milii latex as a molluscicide can be modified by factors such as water temperature and concentration of organic materials, and to a lesser extent by snail size.     

On the Observations and Environmental Modeling in Xingó Hydropower Plant - Northeast Brazil: Present and Future Hydroclimatic Features

Environmental Modeling & Assessment - The São Francisco River Basin plays a critical role in the hydroelectrical operational planning of Brazil. Understanding the hydroclimatic dynamic...     

The influence of axle position and the use of accessories on the activity of upper limb muscles during manual wheelchair propulsion

Introduction. Wheelchair configuration is an important factor influencing the ergonomics of the user–device interface and, from a biomechanical point of view, small changes in chair setup may have a positive influence on the demand on the upper limbs during manual propulsion. This study aimed to investigate the influence of the position of the rear wheels’ axle and the use of accessories on the activity of upper limb muscles during manual wheelchair propulsion. Methods. Electromyography signals of the biceps, triceps, anterior deltoids and pectoralis major were collected for 11 able-bodied subjects in a wheelchair propulsion protocol with four different wheelchair configurations (differing in axle position and the use of accessories) on a straightforward sprint and a slalom course. Results. With accessories, moving the axle forward led to a decrease in the activity of all muscles in both the straightforward sprint (significant differences in triceps, anterior deltoids and biceps) and the slalom course (significant difference in anterior deltoids and biceps). However, when propelling the chair without accessories, no difference was found related to axle position. Conclusion. Changes in wheelchair configuration can influence the ergonomics of manual wheelchair propulsion. Reducing the biomechanical loads may benefit users’ mobility, independence and social participation.