Design optimization and standardization of an environmental availability test under both acidic and alkaline conditions

The objective of this study was to design a procedure for an environmental availability test under both acidic and alkaline conditions for solid wastes and recycled materials and products. The procedure was designed on the basis of the Dutch availability test NEN 7371. Bottom ash from a municipal solid waste incinerator and copper slag were used as test materials. The influences of the type and intensity of liquid stirring apparatus and the open area ratio of the top of the leaching vessel were investigated experimentally, and partial least-squares modeling was applied as multivariate data analysis for the simultaneous evaluation of the three leaching conditions. Interlaboratory validation was then carried out with the participation of seven laboratories in accordance with JIS Z 8402-2/ISO 5725-2. Both repeatability and reproducibility were found to be acceptable, but precise calibration of the pH electrode is required. The proposed procedure will provide sufficient accuracy as a standard test method.     

Thermal destruction of wastes containing polychlorinated naphthalenes in an industrial waste incinerator

A series of verification tests were carried out in order to confirm that polychlorinated naphthalenes (PCNs) contained in synthetic rubber products (Neoprene FB products) and aerosol adhesives, which were accidentally imported into Japan, could be thermally destroyed using an industrial waste incinerator. In the verification tests, Neoprene FB products containing PCNs at a concentration of 2800 mg/kg were added to industrial wastes at a ratio of 600 mg Neoprene FB product/kg-waste, and then incinerated at an average temperature of 985 °C. Total PCN concentrations were 14 ng/m³N in stack gas, 5.7 ng/g in bottom ash, 0.98 ng/g in boiler dust, and 1.2 ng/g in fly ash. Destruction efficiency (DE) and destruction removal efficiency (DRE) of congener No. 38/40, which is considered an input marker congener, were 99.9974 and 99.9995 %, respectively. The following dioxin concentrations were found: 0.11 ng-TEQ/m³N for the stack gas, 0.096 ng-TEQ/g for the bottom ash, 0.010 ng-TEQ/g for the boiler dust, and 0.072 ng-TEQ/g for the fly ash. Since the PCN levels in the PCN destruction test were even at slightly lower concentrations than in the baseline test without PCN addition, the detected PCNs are to a large degree unintentionally produced PCNs and does not mainly stem from input material. Also, the dioxin levels did not change. From these results, we confirmed that PCNs contained in Neoprene FB products and aerosol adhesives could be destroyed to a high degree by high-temperature incineration. Therefore, all recalled Neoprene FB products and aerosol adhesives containing PCNs were successfully treated under the same conditions as the verification tests.     

Chemical and bioassay monitoring of PCB-contaminated soil remediation using solvent extraction technology

Illegal dumping of polychlorinated biphenyl (PCB) capacitors was discovered in Kobe, Japan, in 2001, leaving about 68 m(3) (92 tons) of soil contaminated with approximately 6.6 kg of PCBs. Solvent extraction technology carried out in 2002-2003 using isopropyl alcohol remedied the affected soil at the site. Forty-seven batch treatments were conducted during full-scale treatment. On average, 8.4 extraction cycles per batch were needed to achieve the clean-up goal for PCBs (i.e., the Japanese environmental quality standard for soil). Analytical results showed that the average PCB concentration (88 microg g(-1)-dry soil) in untreated soil samples of all the batches was decreased to 1.2 microg g(-1)-dry soil in treated soil samples, yielding a removal efficiency of 98.6%. Dioxin responsive-chemical activated luciferase gene expression assay (DR-CALUX) and enzyme-linked immunosorbent assay (ELISA) adopting a monoclonal antibody against 2,3',4,4',5-pentachlorobiphenyl (PCB #118) were used to rapidly screen soil samples before and after solvent extraction. The DR-CALUX and ELISA results were in good agreement with World Health Organization toxicity equivalent values and analytically determined PCB concentrations, respectively. Regular monitoring during the treatment period confirmed that the applied technology met Japanese environmental and control regulations concerning treatment and disposal of contaminated soils and treatment residues. After full-scale treatment, the amount of PCBs recovered from the solvent purification system approximated the estimated amount of PCBs spilled.     

Temporal trends and sources of PCDD/Fs, pentachlorophenol and chlornitrofen in paddy field soils along the Yoneshiro River basin, Japan

In order to understand the long-term behaviors of polychlorinated dibenzo-p-dioxins (PCDDs), polychlorinated dibenzofurans (PCDFs), pentachlorophenol (PCP), and 2,4,6-trichlorophenyl-4′-nitrophenyl ether (chlornitrofen, CNP) in paddy soil, we measured their concentrations in paddy soil samples collected in 1982 and 1984 (1980s) and in 2000 and 2002 (2000s) from the Yoneshiro River basin, Japan. The concentrations of PCP and CNP decreased from the 1980s to the 2000s, whereas the concentrations of PCDD/Fs and their toxic equivalency (WHO2006-TEQ) remained. The major sources of PCDD/Fs in the paddy soil samples were attributed to impurities in PCP and CNP as a result of comparisons of homologue and congener profiles and principal component analysis. Based on the results of comparison of total input and remaining amount, it is estimated that more than 99% of PCP and CNP applied to the paddy fields had disappeared, whereas most of the applied PCDD/Fs and TEQ remained.     

Unit-charging programs for municipal solid waste in Japan

Unit-charging programs known as pay-as-you-throw (PAYT) for municipal solid waste in Japan were surveyed. The number of municipalities that have implemented PAYT for combustible waste totaled 954 (30%) in 2003. The introduction of PAYT programs peaked in the early 1970s and again in the 1990s. PAYT has tended to be adopted by municipalities with small populations (less than 30,000). PAYT charging systems can be roughly divided into two groups: simple unit-pricing programs and two-tiered pricing programs. It is difficult to see the relationship between PAYT and waste reduction by simple inspection of the overall changes throughout Japan. Case studies of four municipalities showed that the implementation of PAYT programs reduced the amount of residual waste generated by 20% to 30%. In combination with other measures, especially the recycling of containers and packaging, PAYT programs can bring about a dramatic reduction in waste.     

Abiotic reduction of antimony(V) by green rust (Fe(4)(II)Fe(2)(III)(OH)(12)SO(4).3H(2)O)

Green rust (Fe(4)(II)Fe(2)(III)(OH)(12)SO(4).3H(2)O) is an intermediate phase in the formation of iron (oxyhydr)oxides such as goethite, lepidocrocite, and magnetite. It is widely considered that green rust occurs in many soil and sediment systems. Green rust has been shown to reduce sorbed Se(VI), Cr(VI), and U(VI). In addition, it is also reported that green rust does not reduce As(V) to As(III). In this study, we have investigated for the first time the interaction between Sb(V) and green rust using XAFS and HPLC-ICP-MS. Most of the added Sb(V) was adsorbed on green rust, and Sb(III), a reduced form, was observed in both solid and liquid phases. Thus, it was shown that green rust has high affinity for Sb(V), and that Sb(V) was reduced to more toxic Sb(III) by green rust despite the high stability of the Sb(V) species even under reducing condition as reported in previous studies. Therefore, green rust can be one of the most important reducing agents for Sb(V), which can influence the Sb mobility in suboxic environments where green rust is formed.     

Geographical distribution of persistent organochlorines in air, water and sediments from Asia and Oceania, and their implications for global redistribution from lower latitudes

Persistent organochlorines in air, river water and sediment samples were analysed from eastern and southern Asia (India, Thailand, Vietnam, Malaysia, Indonesia) and Oceania (Papua New Guinea and Solomon Islands) to elucidate their geographical distribution in tropical environment. The concentrations of organochlorines in these abiotic samples collected from Taiwan, Japan and Australia were also monitored for comparison. Atmospheric and hydrospheric concentrations of HCHs (hexachlorocyclohexanes) and DDTs (DDT and its metabolites) in the tropical developing countries were apparently higher than those observed in the developed nations, suggesting extensive usage of these chemicals in the lower latitudes. CHLs (chlordane compounds) and PCBs (polychlorinated biphenyls) were also occasionally observed at higher levels in the tropics, implying that their usage area is also expanding southward. Distribution patterns of organochlorines in sediments showed smaller spatial variations on global terms, indicating that the chemicals released in the tropical environment are dispersed rapidly through air and water and retained less in sediments. The ratios of organochlorine concentrations in sediment and water phases were positively correlated with the latitude of sampling, suggesting that persistent and semivolatile compounds discharged in the tropics tend to be redistributed on a global scale.     

Development of a testing method for asbestos fibers in treated materials of asbestos containing wastes by transmission electron microscopy

Appropriate treatment of asbestos-containing wastes is a significant problem. In Japan, the inertization of asbestos-containing wastes based on new treatment processes approved by the Minister of the Environment is promoted. A highly sensitive method for testing asbestos fibers in inertized materials is required so that these processes can be approved. We developed a method in which fibers from milled treated materials are extracted in water by shaking, and are counted and identified by transmission electron microscopy. Evaluation of this method by using asbestos standards and simulated slag samples confirmed that the quantitation limits are a few million fibers per gram and a few μg/g in a sample of 50 mg per filter. We used this method to assay asbestos fibers in slag samples produced by high-temperature melting of asbestos-containing wastes. Fiber concentrations were below the quantitation limit in all samples, and total fiber concentrations were determined as 47–170 × 10^?6 f/g. Because the evaluation of treated materials by TEM is difficult owing to the limited amount of sample observable, this testing method should be used in conjunction with bulk analytical methods for sure evaluation of treated materials.