Use of CALPUFF for exposure assessment in a near-field,complex terrain setting

CALPUFF is an atmospheric source-receptor model recommended by the U.S. Environmental Protection Agency for use on a case-by-case basis in complex terrain and wind conditions. The ability of the model to provide useful information for exposure assessments in areas with those topographical and meteorological conditions has received little attention. This is an important knowledge gap for use of CALPUFF outside of regulatory applications, such as exposure analyses conducted in support of risk assessments and health studies. We compared deposition of cadmium (Cd), lead (Pb), and zinc (Zn) calculated with CALPUFF as a result of emissions from a zinc smelter with corresponding concentrations of the metals measured in attic dust and soil samples obtained from the surrounding area. On a point-by-point analysis, predictions from CALPUFF explained 11% (lead) to 53% (zinc) of the variability in concentrations measured in attic dust. Levels of heavy metals in soil interpolated to 100 residential addresses from the distribution of concentrations measured in soil samples also agreed well with deposition predicted with CALPUFF: R² of 0.46, 0.76, and 079 for Pb, Cd, and Zn, respectively. Community-average concentrations of Cd, Pb, and Zn measured in soil were significantly (p < 0.0001) and strongly correlated (R² ranged from 0.77 to 0.98) with predicted deposition rates. These findings demonstrate that CALPUFF can provide reasonably accurate predictions of the patterns of long-term air pollutant deposition in the near-field associated with emissions from a discrete source in complex terrain. Because deposition estimates are calculated as a linear function of air concentrations, CALPUFF is expected to be reliable model for prediction of long-term average, near-field ambient air concentrations in complex terrain as well.     

Simulating the fine and coarse inorganic particulate matter concentrations in a polluted megacity

A three dimensional chemical transport model (PMCAMx) is applied to the Mexico City Metropolitan Area (MCMA) in order to simulate the chemical composition and mass of the major PM₁ (fine) and PM_1–10 (coarse) inorganic components and determine the effect of mineral dust on their formation. The aerosol thermodynamic model ISORROPIA-II is used to explicitly simulate the effect of Ca, Mg, and K from dust on semi-volatile partitioning and water uptake. The hybrid approach is applied to simulate the inorganic components, assuming that the smallest particles are in thermodynamic equilibrium, while describing the mass transfer to and from the larger ones. The official MCMA 2004 emissions inventory with improved dust and NaCl emissions is used. The comparison between the model predictions and measurements during a week of April of 2003 at Centro Nacional de Investigacion y Capacitacion Ambiental (CENICA) “Supersite” shows that the model reproduces reasonably well the fine mode composition and its diurnal variation. Sulfate predicted levels are relatively uniform in the area (approximately 3 μg m^?3), while ammonium nitrate peaks in Mexico City (approximately 7 μg m^?3) and its concentration rapidly decreases due to dilution and evaporation away from the urban area. In areas of high dust concentrations, the associated alkalinity is predicted to increase the concentration of nitrate, chloride and ammonium in the coarse mode by up to 2 μg m^?3 (a factor of 10), 0.4 μg m^?3, and 0.6 μg m^?3 (75%), respectively. The predicted ammonium nitrate levels inside Mexico City for this period are sensitive to the physical state (solid versus liquid) of the particles during periods with RH less than 50%.     

Modeling the surface–atmosphere exchange of ammonia

New parameterizations for surface–atmosphere exchange of ammonia are presented for application in atmospheric transport models and compared with parameterizations of the literature. The new parameterizations are based on a combination of the results of three years of ammonia flux measurements over a grassland canopy (dominated by Lolium perenne and Poa trivialis) near Wageningen, the Netherlands and existing parameterizations from literature. First, a model for the surface–atmosphere exchange of ammonia that includes the concentration at the external leaf surface is derived and validated. Second, a parameterization for the stomatal compensation point (expressed as Γ_s, the ratio of [NH₄⁺]/[H⁺] in the leaf apoplast) that accounts for the observed seasonal variation is derived from the measurements. The new, temperature-dependent Γ_s describes the observed seasonal behavior very well. It is noted, however, that senescence of plants and field management practices will also influence the seasonal variation of Γ_s on a shorter timescale. Finally, a relation that links Γ_s to the atmospheric pollution level of the location through the ‘long-term’ NH₃ concentration in the air is proposed.     

Use of Calluna vulgaris to detect signals of nitrogen deposition across an urban–rural gradient

Densely populated cities can experience high concentrations of traffic-derived pollutants, with oxides of nitrogen and ammonia contributing significantly to the overall nitrogen (N) budget of urban ecosystems. This study investigated changes in the biochemistry of in situ Calluna vulgaris plants to detect signals of N deposition across an urban–rural gradient from central London to rural Surrey, UK. Foliar N concentrations and δ¹⁵N signatures were higher, and C/N ratios lower, in urban areas receiving the highest rates of N deposition. Plant phosphorus (P) concentrations were also highest in these areas, suggesting that elevated rates of N deposition are unlikely to result in progressive P-limitation in urban habitats. Free amino acid concentrations were positively related to N deposition for asparagine, glutamine, glycine, phenylalanine, isoleucine, leucine and lysine. Overall, relationships between tissue chemistry and N deposition were similar for oxidised, reduced and total N, although the strength of relationships varied with the different biochemical indicators. The results of this study indicate that current rates of N deposition are having substantial effects on plant biochemistry in urban areas, with likely implications for the biodiversity and functioning of urban ecosystems.     

Spatial variability of carbonaceous aerosols and associated source tracers in two cites in the Midwestern United States

Semi-continuous and 24-h averaged measurements of fine carbonaceous aerosols were made concurrently at three sites within each of two U.S. Midwestern Cities; Detroit, Michigan and Cleveland, Ohio; during two, one-month intensive campaigns conducted in July of 2007 and January & February of 2008. A comparison of 24-h measurements revealed substantial intra-urban variability in carbonaceous aerosols consistent with the influence of local sources, and excesses in both PM_2.5 organic carbon (OC) and elemental carbon (EC) were identified at individual sites within each city. High time-resolved black carbon (BC) measurements indicated that elemental carbon concentrations were higher at sites adjacent to freeways and busy surface streets, and temporal patterns suggested that excess EC at sites adjacent to freeways was dominated by mobile source emissions while excesses in EC away from traffic corridors was dominated by point/area source emissions. The site-to-site variability in OC concentrations was approximately 7% within the neighborhood scale (0.5–4 km) and between 4 and 27% at the urban scale (4–100 km). In contrast, measurements of organic source tracers, in conjunction with a Chemical Mass Balance (CMB) source-apportionment model, indicated that the spatial variation in the contribution of both mobile and stationary sources to PM_2.5 OC often exceeded the variation in OC mass concentration by a factor of 3 or more. Markers for mobile sources, biomass smoke, natural gas, and coal combustion differed by as much as 60% within the neighborhood scale and by greater than 200% within the urban scale. The observations made during this study suggest that the urban excess of carbonaceous aerosols is much more complex than has been previously reported and that a more rigorous, source-oriented approach should be taken in order to assess the risk associated with exposure to carbonaceous aerosols within the industrialized environments of the Midwestern United States.     

Sea salt concentrations across the European continent

The oceans are a major source for particles that play an important role in many atmospheric processes. In Europe sea salt may contribute significantly to particulate matter concentrations. We have compiled sodium concentration data as a tracer for sea salt for 89 sites in Europe to provide more insight in the distribution of sea salt across Europe. The annual average sea salt concentrations above land were estimated to range between 0.3 and almost 13 μg m^?3. Maximum concentrations are found at the Irish coast. At coastal sites along the Atlantic and North Sea coast concentrations tend to be around 5 μg m^?3. More inland locations up to about 300 km away from the coast tend to show concentrations between 2 and 5 μg m^?3, whereas sites further away from the coast are characterized by lower concentrations. An analysis of the representativity of the data with respect to a long term average showed that the long average is associated with a standard deviation of around 15%. The compilation of observations provides an improved overview of sea salt concentrations in Europe as well as an improved basis for model validation. Verification of the results of the LOTOS-EUROS model learned that the model represents well the spatial variability of the observed sea salt concentrations very well. However, the absolute concentrations are significantly overestimated due to large uncertainties in the emission and dry deposition parameterizations. Using the high explained variability in the gradients across Europe, the bias-corrected modelled distribution serves as a best estimate of the sea salt distribution across Europe for 2005.     

Overcoming latecomer disadvantage through learning processes: Taiwan’s venture into wind power development

Research into national innovation systems (NISs) has received extensive academic and policy attention, and is especially relevant with latecomer countries seeking to innovate in challenging industrial environments. In playing catch up with their early industrializing counterparts, methods of learning take on increased importance in determining industrial success for latecomers. The wind turbine technology innovation system is one that is highly dependent on both the extent of the national learning processes and the strength of the national social-institutional setting. This research investigates the case of Taiwan, a country which has embarked on a program to build its national innovative capacity in wind turbine technologies with specific emphasis on Taiwan’s social sector. Within this system, the spotlight will be on four types of learning processes that interplay during wind turbine development: learning by searching, learning by doing, learning by using, and learning by interacting. Through a case study of the emergence of Taiwan’s burgeoning large-scale wind power technology initiatives, the paper aims to add to the understanding on how methods of learning impact upon the success of innovation systems. The findings show that the industry’s future prospects are constrained because of the limited learning by interacting processes between turbine component producers, turbine owners, and researchers and because of weaknesses in the institutional framework. This research also recognizes the importance that culture has on dominant forms of learning.     

Food security and ecological footprint of coastal zone of Bangladesh

This paper presents the present status of food security and ecological footprint, an indicator of environmental sustainability of the coastal zones of Bangladesh. To estimate the present status of the food security and ecological footprint of the coastal zone of Bangladesh, primary and secondary data were collected, and the present status of food security and environmental degradation (in terms of ecological footprint) were calculated. To estimate the household food security, primary data were also collected from all the households in a representative selected village. A quantitative method for computation of food security in grain equivalent based on economic returns (price) is developed, and a method of measuring sustainable development in terms of ecological footprint developed by Wackernagel is used to estimate the environmental sustainability (Wackernagel and Rees in Our ecological footprint: reducing human impact on the earth. New Society, Gabrioala, BC, 1996; Chambers et al. in Sharing nature’s interest-ecological footprint as an indicator of sustainability. Earthscan, London, 2000). Overall status of food security at upazila levels is good for all the upazilas except Shoronkhola, Shyamnager and Morrelgonj, and the best is the Kalapara upazila. But the status of food security at household levels is poor. Environmental status in the coastal zones is poor for all the upazilas except Kalapara and Galachipa. The worst is in the Mongla upazila. Environmental status has degraded mainly due to shrimp culture. This study suggests that control measures are needed for affected upazilas and any further expansion of the shrimp aquaculture to enhance the food security must take into account the environmental aspects of the locality under consideration.