Assessment of spiking procedures for the introduction of a phenanthrene-LNAPL mixture into field-wet soil

Laboratory based studies on the fate of organic contaminants in soil typically requires the test compound(s) to be spiked into the test medium. Consequently, such studies are inherently dependent on the homogeneity of the contaminant within the spiked soil. Three blending methods were compared for the addition of a phenanthrene-transformer oil mixture into field-wet soil. Spiking homogeneity, reproducibility and artefacts were assessed based on dichloromethane and hydroxypropyl-beta-cyclodextrin chemical extractability, and bacterial mineralization. Spiking using a stainless-steel spoon, consistently produced good spike homogeneity as determined by sample oxidation, chemical extraction and mineralization, and was consistently more reliable than either the Waring blender or modified bench drill. Overall, neither transformer oil-concentration nor blending method influenced chemical extractability or mineralization of the PAH following 1 day equilibration. In general, spiking procedures require validation prior to use, as homogeneity cannot be assured.     

Environmental and Biological Assessment of Exposure to Benzene in Petroleum Workers

Occupational exposure to benzene was measured in two gasoline marketing terminals and five major refineries in Singapore. A total of 280 workers were monitored over two years. This assessment was carried out with two primary objectives: (1) To find out the extent of occupational exposure to benzene in the petroleum industry in Singapore, (2) To identify suitable biomarkers for monitoring of low levels of benzene exposure. The exposure was measured in five different categories of petroleum and petrochemical workers, i.e., truck drivers, despatch assistant, process operators, oil movements operators and laboratory technicians. The results revealed wide variations in exposure, from 0.01 to 13.6 ppm for personal time weighted average (TWA) exposure over the whole workshift. The exposure of truck drivers appeared to be the highest, with geometric mean (GM) of 1.98 ppm (ranged from 0.25 to 13.6 ppm). The average benzene exposure for process operators was relative low with a GM of 0.04 ppm. Lowest benzene exposure was found in the laboratory technicians, with a GM of 0.02 ppm. As cigarette smoking is known to affect metabolism of benzene, data analyses on the relationships with environmental exposure were conducted only on the 190 nonsmokers. The results showed that urinary trans, trans-muconic acid (ttMA), unmetabolized benzene in urine (UBZ) and benzene in blood (BBZ) were better biomarkers for low level benzene exposure as compared to urinary phenolic metabolites in urine, such as hydroquinone, phenol and catechol.     

Arsenic-speciation in arsenate-resistant and non-resistant populations of the earthworm,Lumbricus rubellus

Arsenic speciation was determined in Lumbricus rubellus Hoffmeister from arsenic-contaminated mine spoil sites and an uncontaminated site using HPLC-MS, HPLC-ICP-MS and XAS. It was previously demonstrated that L. rubellus from mine soils were more arsenate resistant than from the uncontaminated site and we wished to investigate if arsenic speciation had a role in this resistance. Earthworms from contaminated sites had considerably higher arsenic body burdens (maximum 1,358 mg As kg-1) compared to the uncontaminated site (maximum 13 mg As kg-1). The only organo-arsenic species found in methanol/water extracts for all earthworm populations was arsenobetaine, quantified using both HPLC-MS and HPLC-ICP-MS. Arsenobetaine concentrations were high in L. rubellus from the uncontaminated site when concentrations were expressed as a percentage of the total arsenic burden (23% mean), but earthworms from the contaminated sites with relatively low arsenic burdens also had these high levels of arsenobetaine (17% mean). As arsenic body burden increased, the percentage of arsenobetaine present decreased in a dose dependent manner, although its absolute concentration rose with increasing arsenic burden. The origin of this arsenobetaine is discussed. XAS analysis of arsenic mine L. rubellus showed that arsenic was primarily present as As(III) co-ordinated with sulfur (30% approx.), with some As(v) with oxygen (5%). Spectra for As(III) complexed with glutathione gave a very good fit to the spectra obtained for the earthworms, suggesting a role for sulfur co-ordination in arsenic metabolism at higher earthworm arsenic burdens. It is also possible that the disintegration of As(III)-S complexes may have taken place due to (a) processing of the sample, (b) storage of the extract or (c) HPLC anion exchange. HPLC-ICP-MS analysis of methanol extracts showed the presence of arsenite and arsenate, suggesting that these sulfur complexes disintegrate on extraction. The role of arsenic speciation in the resistance of L. rubellus to arsenate is considered.     

The biodegradation of cable oil components: impact of oil concentration, nutrient addition and bioaugmentation

The effect of cable oil concentration, nutrient amendment and bioaugmentation on cable oil component biodegradation in a pristine agricultural soil was investigated. Biodegradation potential was evaluated over 21 d by measuring cumulative CO₂ respiration on a Micro-Oxymax respirometer and ¹⁴C-phenyldodecane mineralisation using a ¹⁴C-respirometric assay. Cable oil concentration had a significant effect upon oil biodegradation. Microbial respiratory activity increased with increasing cable oil concentration, whereas ¹⁴C-phenydodecane mineralisation decreased. Bioaugmentation achieved the best cable oil biodegradation performance, resulting in increases in cumulative CO₂ respiration, and maximum rates and extents of ¹⁴C-phenyldodecane mineralisation. Generally, nutrient amendment also enhanced cable oil biodegradation, but not to the extent that degrader amendment did. Cable oil biodegradation was a function of (i) cable oil concentration and (ii) catabolic ability of microbial populations. Bioaugmentation may enhance cable oil biodegradation, and is dependent upon composition, cell number and application of catabolic inocula to soil.     

The effect of soil:water ratios on the induction of isoproturon, cypermethrin and diazinon mineralisation

The rate of pesticide biodegradation does not remain constant with time, and is dependent on the physico-chemical properties of the soil and of the pesticide as well as on the biology of the soil. Prolonged or repeated contact between soil microbes and pesticides has been shown to result in an increase in the rate and extent of biodegradation. This work assessed the impact of the soil:water ratio on measurement of catabolic induction for ¹⁴C-isoproturon, ¹⁴C-diazinon and ¹⁴C-cypermethrin. Slurrying (1:1 and 1:3 soil:water) with agitation resulted in significantly higher rates and extents of mineralisation than the non-slurried system (P ? 0.05; 1:0 soil:water), except for the mineralisation of ¹⁴C-diazinon where the greatest extent of mineralisation occurred in non-slurried soil. Slurrying without agitation resulted in the significant lower mineralisation in all cases (P ? 0.05). There was a significant interaction between the soil:water ratio and length of contact (P ? 0.05). Whilst the use of slurried systems can enhance the extent and rate of mineralisation, there is no improvement in reproducibility, and so for the measurement of catabolic induction, the use of field conditions will lead to a more environmentally relevant measurement.     

Development of phenanthrene catabolism in natural and artificial soils

The characteristics of natural soils often vary from those of artificial soil (e.g. OECD), which may lead to substantial differences in the bioavailability of test substances. The aim of this investigation was to characterise the development of phenanthrene catabolism in both natural and artificial soils with varying total organic carbon (TOC) content after 1, 14, 42 and 84 d soil-phenanthrene contact time. Indigenous catabolic activity was measured via the addition of 14C-phenanthrene using the respirometric soil slurry assay. Notably, the lag phases, fastest rates and total extents of 14C-phenanthrene degradation were relatively comparable in soils with similar TOC content after 1 d contact time. However, natural soils generally exhibited significantly shorter lag phases, faster rates and higher extents of mineralisation, than their artificial counterparts after 42 and 84 d contact time. Such findings suggest that the extrapolation of results from artificial soils to real/natural soils may not be straightforward.     

Rapid quantification of polycyclic aromatic hydrocarbons in hydroxypropyl-beta-cyclodextrin (HPCD) soil extracts by synchronous fluorescence spectroscopy (SFS)

Synchronous fluorescence spectroscopy (SFS) was directly applied to rapidly quantify selected polycyclic aromatic hydrocarbons (PAHs: benzo[a]pyrene and pyrene) in aqueous hydroxypropyl-beta-cyclodextrin (HPCD) soil extract solutions from a variety of aged contaminated soils containing four different PAHs. The method was optimized and validated. The results show that SFS can be used to analyse benzo[a]pyrene and pyrene in HPCD based soil extracts with high sensitivity and selectivity. The linear calibration ranges were 4.0x10(-6)-1.0x10(-3)mM for benzo[a]pyrene and 6.0x10(-6)-1.2x10(-3)mM for pyrene in 10mM HPCD aqueous solution alone. The detection limits according to the error propagation theory for benzo[a]pyrene and pyrene were 3.9x10(-6) and 5.4x10(-6)mM, respectively. A good agreement between SFS and HPLC was reached for both determinations of PAHs in HPCD alone and in soil HPCD extracts. Hence, SFS is a potential means to simplify the present non-exhaustive hydroxypropyl-beta-cyclodextrin (HPCD)-based extraction technique for the evaluation of PAH bioavailability in soil.     

Assessing the chemical and biological accessibility of the herbicide isoproturon in soil amended with biochar

Decamethylcyclopentasiloxane (D5) is a cyclic volatile methyl siloxane (cVMS) commonly found in commercially available products. D5 is expected to enter the terrestrial environment through the deposit of biosolids from sewage treatment plants onto agricultural fields for nutrient enrichment. Little to no information currently exists as to the risks of D5 to the terrestrial environment. In order to evaluate the potential risk to terrestrial organisms, the toxicity of a D5 contaminated biosolid in an agricultural soil was assessed with a battery of standardized soil toxicity tests.D5 was spiked into a surrogate biosolid and then mixed with a sandy loam soil to create test concentrations ranging from 0 to 4074 mg kg⁻¹. Plant (Hordeum vulgare (barley) and Trifolium pratense (red clover)) and soil invertebrates (Eisenia andrei (earthworm) and Folsomia candida (springtail)) toxicity tests were completed to assess for lethal and sub-lethal effects. Plant testing evaluated the effects on seedling emergence, shoot and root length, and shoot and root dry mass. Invertebrate test endpoints included adult lethality, juvenile production, and individual juvenile dry mass (earthworms only). Soil samples were collected over time to confirm test concentrations and evaluate the loss of chemical over the duration of a test. The toxicity of the D5 was species and endpoint dependent, such that no significant adverse effects were observed for T. pratense or E. andrei test endpoints, however, toxicity was observed for H. vulgare plant growth and F. candida survival and reproduction. Chemical losses of up to 50% were observed throughout the tests, most significantly at high concentrations.     

Interactions between earthworms and arsenic in the soil environment: a review

Chemical pollution of the environment has become a major source of concern. In particular, many studies have investigated the impact of pollution on biota in the environment. Studies on metalliferous contaminated mine spoil wastes have shown that some soil organisms have the capability to become resistant to metal/metalloid toxicity. Earthworms are known to inhabit arsenic-rich metalliferous soils and, due to their intimate contact with the soil, in both the solid and aqueous phases, are likely to accumulate contaminants present in mine spoil. Earthworms that inhabit metalliferous contaminated soils must have developed mechanisms of resistance to the toxins found in these soils. The mechanisms of resistance are not fully understood; they may involve physiological adaptation (acclimation) or be genetic. This review discusses the relationships between earthworms and arsenic-rich mine spoil wastes, looking critically at resistance and possible mechanisms of resistance, in relation to soil edaphic factors and possible trophic transfer routes.