Ethylene: An Urban Air Pollutant

Ethylene is an unusual air pollutant in that it is a plant hormone. Motor vehicle exhaust is a primary source. In the Washington, D. C, area, ethylene concentrations ranged from 700 ppb in the city center to 39 ppb in areas outside the circumferential beltway. Plants grown in these concentrations of ethylene, using controlled environment chambers, exhibited typical symptoms of ethylene toxicity: reduced growth, premature senescence, and reduced flowering and fruit production. When plants were grown in carbon-filtered ambient air, which was also filtered through KMnO₄ to remove ethylene by oxidation, growth, flowering, and fruit production increased. These observations demonstrate that ethylene air pollution is a continual source of stress for plant growth and development in an urban environment.     

The Formation of Mg3Ca(S04)4 during the Sulfation Reaction of Dolomite

Abstract

Inspection and maintenance programs for motor vehicles in the United States increasingly use loaded mode mass emissions testing (IM240). A method was developed to predict mass emission rates and mass emission changes, particularly from repair benefits, using a low-cost, portable four-gas non-dispersive infrared (NDIR) vehicle exhaust gas analyzer. A single vehicle was tested several times with the analyzer while on the dynamometer and undergoing successive repairs. Excellent correlations for CO and HC were observed. Five vehicles were measured using an on-road driving loop before and after emissions-related repairs, while another three vehicles were tested with no repairs performed. The on-road concentration data used to guide the repair process were converted to grams per gallon; when divided by estimated miles per gallon, this gave grams per mile emissions for comparison to IM240. Correlation coefficients (r²) of 0.87 for CO and 0.76 for HC were achieved for the 13 tests. The linear correlations between IM240 and emissions measured by this method would allow repair facilities to perform a relatively inexpensive test for diagnostic purposes and to estimate repair effectiveness without the need for a dynamometer.     

A Wind Tunnel Study of Gaseous Pollutants in City Street Canyons

Steady state mean concentrations of tracer gas were measured in a 400:1 scale model of an idealized city with variable geometry placed within a wind tunnel at various orientations to the mean flow for a free stream velocity of 6.8 ft/sec. The tracer gas was released from two parallel line sources to simulate lanes of traffic in an effort to quantify the persistence of pollution as well as the mean values realized at street levels. An aerodynamically rough turbulent boundary layer of neutral thermal stratification was employed to simulate the atmosphere. Values of concentration measured in the model city were converted to prototype concentrations in ppm and compared to National Ambient Air Quality Standards. It was shown that single isolated structures may cause favorable mixing of pollution downwind but very high concentrations exist in the immediate leeward vicinity of the building. Two favorable geometries for city blocks tested were found to reduce pedestrian exposure to pollution both near heavy traffic congestion and downwind. It was concluded that the pollutant dilution was controlled by the mean flow rather than by turbulent diffusion and that the lateral spread of the plume was slight as one proceeded downwind of the line source. The combination of favorable geometry and higher dilution velocities may bring pollution levels down to existing Air Quality Standards. The body of information presented in this paper should interest city planners and air quality monitoring personnel, as well as those researchers attempting to study and model flow in city street canyons. It provides order of magnitude estimates on pedestrian and office worker exposure to pollutants under a wide range of conditions.     

Weekday-Weekend Pollutant Studies of the Los Angeles Basin

Pollutant data from the Los Angeles Basin were analyzed for weekday-weekend differences for the smog months of June through September 1972 and 1973. The pollutants investigated were oxidant, NO, NO₂, total hydrocarbons (HC), CO, and particulates. In order to maintain the diurnal variation, the concentration percentiles were calculated for each weekday and weekend hour.     

Objective Evaluation of Emergency Plans for Oxidant Control

Emergency plans for oxidant controls provide the basis for taking preventive action to protect public health. Historic oxidant data (1970 to Sept. 1974) from the South Coast Air Basin (SCAB), were evaluated to assess episode characteristics in an area where emergency strategies are most likely to be enforced. These findings, together with an objective study of a test case episode (June 1974) using a photochemical air quality simulation model, suggest that the currently conceived emergency plans for oxidant control are unlikely to be effective. It is concluded that, because of the chemical and mefeorofogfcal complexities of the episodes, they are extremely difficult both to predict and concurrently to control over their short-lived duration.     

Results of Field Measurements of Industrial Particulate Sources and Electrostatic Precipitator Performance

This paper presents results of source size distribution measurements over the size range from 0.1 μm to 5 μm for six classes of particulate sources and fractional efficiency measurements on five full scale electrostatic precipitators and one pilot scale precipitator. The precipitators all showed moderately high to high particulate collection efficiencies for particles having diameters larger than a few micrometers or smaller than a few hundredths of a micrometer and a minimum in collection efficiency for particles having diameters of a few tenths of a micrometer.     

Variance Design and Air Pollution Control

Confronted with shortages of low sulfur content residual fuel oil and, consequently, faced with the threat of social and economic upheaval, several air pollution control authorities in the Northeastern states were forced to relax hard-won air quality standards during the winter of 1972. The authorities did so by granting variances to their sulfur content standards for residual fuel oil. This paper examines the institutional characteristics of these variance policies from an economic incentive standpoint. After setting up desirable structural criteria for institutional design of such crisis policies, the authors examine the experience of the winter of 1972 and arrive at policy guidelines which recommend themselves for consideration in future periods of fuel oil shortages.     

Status and Problems of Regenerable Flue Gas Desulfurization Processes

Fourteen sulfur and/or sulfuric acid producing regenerate FGD processes were discussed at the 1974 FGD Symposium in Atlanta. During the period elapsed since then, considerable status change has occurred on many of these regenerable processes. Other regenerable processes which were not as well known during 1974 have surfaced in 1975. The problems of obtaining reducing gases (hydrogen sulfide, carbon monoxide, and hydrogen) for the reduction of sulfur dioxide product streams to elemental sulfur have become severe due to shortages of natural gas or other petroleum based feedstock. A new sulfur producing process which employs CO and H₂ directly (rather than the H₂S required for liquid and vapor base Claus reactions) is gaining attention. This paper discusses briefly: (1) the announced status of the many regenerable FGD processes, (2) the problem of reductant gas supply, and (3) the effect on FGD processes of using coal based reducing gas instead of reformed natural gas.     

Characterization of Particulates from Power Plants

The emphasis on participate control from industrial processes has been shifted recently towards fine particulates, having diameters less than 3 microns. There exists an urgent need for more scientific information of fine particle characterization.^1,2 Coal and oil fired power plants are among the largest anthropogenic point sources of particulate matter.³ Limited knowledge is available on particle size distribution and trace metal composition in power plant emissions.^4-7 The morphological properties of particle emissions have been largely neglected. In this report we present some information on particle characteristics for an oil-fired and coal-fired power plant.     

Desulfurization of Flue Gases in A Fluidized Bed of Modified Limestone

This publication concerns the dry removal of SO₂ from gases using limestone absorbents. It reports bench-scale experiments made with commercial samples of powdered limestone (CaCO₃) activated by addition of a cheap substance, namely CaCl₂. The absorption was carried out in a fluidized bed traversed by the flue gases, between 600° and 900° C. The degree and rate of transformation of CaCO₃ to CaSO₄ in the presence of SO₂ and air have been compared for unmodified and modified absorbents. Initial rates of reaction, and the variation of the rate of absorption with time have been measured. The influence of the SO₂ content of the gas has been assessed. At 700° C, the maximum degree of transformation of activated limestone to sulfate exceeds 90%, whereas untreated CaCO₃ transforms only to 16–20%. At the same temperature, more than 90% of SO₂ contained In a gas carrying 0.35% SO₂ is removed. Because of the much smaller quantity of solid absorbent required, dry absorption processes based on the modified absorbents might get renewed interest. The modified absorbents might also be used for in situ absorption in fluidized bed combustion, in which the temperatures are in the range studied in the present paper.