实施注采一体管柱技术 节能降耗减污增效

超稠油蒸汽吞吐注采一体管柱技术,是对多项稠油开采工艺技术进行实践、总结、分析而来。该项技术,解决了作业频繁的问题,实现了不动管柱直接转抽,并可以多次注汽、转抽;由此而改变传统的蒸汽吞吐注采工艺技术,做到注、采、焖、放一体管柱,减少作业工序和降低井筒热损失,降低环境污染及电能消耗,实现超稠油不动管柱开采,有效降低超稠油开采成本,提高了油井的生产实效,并取得可观的经济效益和环境效益,实现节能、降耗、减污、增效的清洁生产目标。     

茶多酚对蟾蜍坐骨神经干兴奋传导及骨骼肌收缩的影响

采用不同浓度的茶多酚溶液作用于蟾蜍坐骨神经-腓肠肌标本,发现10μg/L茶多酚就可极显著地增强腓肠肌的收缩张力,且随着其浓度的加大而张力增加,直至茶多酚浓度超过160μg/L时,肌肉张力开始回落,间接证明了茶多酚能够促进肌细胞内质网钙库中Ca2+向细胞质的释放.实验还发现,茶多酚能够显著地缩短蟾蜍坐骨神经-腓肠肌标本单收缩的潜伏期,但不影响动作电位单独在神经和肌肉细胞上的传导速度.这是由于茶多酚能提高蟾蜍神经-肌肉接头处微终板电位(MEPP)的频率和振幅,从而提高终板膜的兴奋性,使动作电位在神经-肌肉接头处的传递速度加快,缩短了突触延搁的时间.由此推测,这种兴奋性的加强还是源于茶多酚可促进神经纤维轴突末梢Ca2+内流,使细胞质中Ca2+浓度增加,导致乙酰胆碱释放量增加所致.     

Selective removal of 2,4-dichlorophenol from contaminated water using non-covalent imprinted microspheres

A molecularly imprinted polymer (MIP) for selective removal of 2,4-dichlorophenol (2,4-DCP) in water was prepared as microspheres by the reverse microemulsion polymerization method based on the non-covalent interactions between 2,4-DCP, oleic acid, and divinylbenzene in acetonitrile. Microspheres have been characterized by Fourier transform infrared spectrometer (FTIR) and energy dispersive X-ray spectrometer (EDS) studies with evidence of 2,4-DCP linkage in polymer particles and scanning electron microscopy (SEM) to study their morphological properties. The proper adsorption and selective recognition ability of the MIP were studied by an equilibrium-adsorption method. The MIP showed outstanding affinity towards 2,4-DCP in aqueous solution and the optimum pH value for binding has been found around the neutral range. The molecular recognition of 2,4-DCP was analyzed in detail by using molecular modeling software. In addition, by investigating the variation in the adsorption ability of the MIP, it clearly showed excellent reproducibility.     

半干法烧结烟气脱硫灰中亚硫酸钙氧化研究

针对半干法烧结烟气脱硫灰因CaSO3含量高难以有效综合利用的问题,采用静态和动态氧化实验,结合热重-差热分析探讨了半干法烧结烟气脱硫灰中CaSO3的氧化效果.实验结果表明,在沮度为45～90℃,以MnO2、Fe2O3、V2O3为催化剂时,脱硫灰中CaSO3的氧化率不超过3%,催化效果好差为MnO2Fe2O3V2O5;在温度为400～500℃、气固比(空气体积流量与脱硫灰质量比)为0.02～0.06m3/(g·h)、反应时间为30～60min、无外加催化剂时.脱硫灰中CaSO,3的氧化率为40.4%～100.0%;温度在450℃以上时,CaSO3氧化率均在80%以上.     

Quantitative structure-toxicity relationship study of lethal concentration to tadpole (Bufo vulgaris formosus) for organophosphorous pesticides

In the present study more than 1,000 structural parameters of 41 organophosphorus pesticides (OPs) were calculated using the software ChemOffice 8.03 and Dragon 2.1. Then, with multivariate linear regression and best subset regression analyses, different equations were derived to calculate the lethal toxicity, LC(50), for these 41 organophosphorous pesticides found in tadpoles (Bufo vulgaris formosus). An equation was developed for all selected OPs, especially those with relatively low toxicity levels (LC(50)>4.5mM) that accounted for 89.09% of the variability in the toxic effect. The equation indicated that the main contributions to OPs toxicity with tadpoles were the electrostatic contribution qH(+) (maximum net positive H atomic charge), spatial autocorrelation (MATS7 m) and hydrophobicity (lgK(ow)), with the two former being the most important parameters. For OPs with high toxicity, however, different structural parameters were introduced. The following equation was developed with LC(50)<4.5mM. These equations implied that with different levels of toxicity there could have different mechanisms in the tadpole. Furthermore, the results showed that molecular structural parameters had a particular value in modeling chemical reactivity within a homologous series of compounds.     

彗星试验检测地下水有机污染物的遗传毒性效应

应用人外周血淋巴细胞和小鼠淋巴细胞彗星试验,对长治市5个样点的地下水有机浓集物进行了遗传毒性研究。结果表明,各水样中有机浓集物在3个染毒剂量50,200,800 m L·管-1条件下均可对人外周血淋巴细胞和小鼠淋巴细胞DNA产生不同程度的遗传损伤,并且随着浓度的升高,DNA损伤程度明显增加,各实验组与溶剂对照组相比有P<0.05或P<0.01显著差异。研究表明,上述2种淋巴细胞彗星试验可有效地检测地下水体有机污染物的遗传毒性。     

高氯离子、低COD废水中COD的测定

建立了适用于高氯离子、低COD废水中COD的重铬酸钾测定方法。分别采用甘油、二氯丙醇、β,β′-二氯异丙醚和氯化钙配制模拟高氯废水,考察了氧化剂重铬酸钾溶液浓度、掩蔽剂加入量(以m(HgSO_4)∶m(Cl~-)表示)对测定效果的影响。实验结果表明:以低浓度(0.05 mol/L)重铬酸钾溶液为氧化剂时,测定数据波动范围小,相对误差也低(-1.4%~+0.4%);对于高氯低COD废水的COD测定,当COD大于100 mg/L时按m(HgSO_4)∶m(Cl~-)=10∶1加入硫酸汞掩蔽剂,当COD小于100 mg/L时按m(HgSO_4)∶m(Cl~-)=20∶1加入硫酸汞掩蔽剂,并采用浓度为0.05 mol/L的重铬酸钾溶液作为氧化剂,能较好地消除氯离子对COD测定的干扰,相对误差在5%以内;将优化后的测定条件应用于实际环氧氯丙烷生产废水COD的测定,重现性良好,当m(HgSO_4)∶m(Cl-)分别为10∶1和20∶1时,相对误差分别为+3.3%和+2.9%,COD平均回收率分别为103.4%和102.9%。     

酸析—微电解—Fenton试剂氧化联合工艺预处理苯达松废水

采用酸析—微电解—Fenton试剂氧化联合工艺预处理苯达松废水。考察了酸析pH、铸铁粉加入量、微电解时间、双氧水加入量、Fenton试剂氧化时间等因素对废水处理效果的影响。实验结果表明：最佳工艺条件为酸析pH 3.0,铸铁粉加入量1.0 g/L,微电解时间2 h,Fenton试剂氧化时间4 h,双氧水加入量25 mL/L;在最佳工艺条件下处理初始COD为22 500 mg/L、BOD₅/COD为0.08、色度为2 500倍的苯达松废水,总COD去除率为96.2%,出水COD为858 mg/L,出水色度为150倍,BOD₅/COD为0.38;采用微电解—Fenton试剂氧化联合工艺预处理酸析后的苯达松废水,处理效果远高于单独微电解和单独Fenton试剂氧化工艺。     

纳米片自组装原位N掺杂(BiO)2CO3分级微球的可控合成及其优异可见光催化性能

以二氰二胺和柠檬酸铋为原料,采用一步水热法合成原位N掺杂(BiO)2CO3纳米片自组装分等级微球结构。采用XRD、SEM、XPS、FT-IR、UV-Vis DRS和PL等对合成的材料进行表征,结果表明,不同二氰二胺加入量会对(BiO)2CO3的形貌结构、禁带宽度以及电子-空穴复合率产生显著影响。二氰二胺在水热过程水解柠檬酸铋,同时N原子原位掺杂进入(BiO)2CO3晶格。N掺杂使(BiO)2CO3的光响应范围大幅拓展至可见光,通过价带XPS获得了掺杂N元素减小(BiO)2CO3禁带宽度的证据。在可见光照射下,原位N掺杂(BiO)2CO3分等级微球结构表现出对液相罗丹明B和气相NO优异的可见光催化降解活性,高于N掺杂TiO2和C掺杂TiO2。研究结果对拓展N掺杂作用向非TiO2体系的转变具有重要意义。     

固化/稳定化处理污泥填埋气液转化模式

固化/稳定化污泥进行填埋产生填埋气,产气规律是指导填埋气收集处理系统设计的重要依据。通过构建大型填埋柱模拟填埋实验,研究不同固化材料添加量污泥气液转化规律。实验结果表明,原泥和固化污泥产气规律分为2种类型:前期产气速率呈线性增加,达到最大速率后产气速率呈指数降低。低添加量的固化污泥,产气分3个阶段,分别为产气抑制期、增长期和衰减期。高添加量固化污泥,产气只有一个阶段,产气速率随着时间推移逐渐减小,产气量很小。固化污泥降解过程就是有机质含量降低,气体产量、含水率增加相互转化过程,达到固化材料添加量25%时,水分和气体产生量均很小,降解受到很强抑制,产气150 d左右稳定,产气量很小,无需单独设置气体收集系统。