Effects of combustion parameters on polychlorinated dibenzodioxin and dibenzofuran homologue profiles from municipal waste and coal co-combustion

Variation in polychlorinated dibenzo-p-dioxin and polychlorinated dibenzofuran (PCDD and PCDF) homologue profiles from a pilot scale (0.6 MW_t, 2×10⁶ Btu/h), co-fired-fuel [densified refuse derived fuel (dRDF) and high-sulfur Illinois coal] combustion system was used to provide insights into effects of combustion parameters on PCDD and PCDF pollutant formation. A 24-run, statistically designed test matrix varied dRDF and/or coal firing rates (at a constant targeted energy release rate) along with a range of process variables including calcium hydroxide injection, hydrogen chloride (HCl) concentration, flue gas temperature, quench, and residence time such that the results would be relatable to a wide variety of combustion conditions. Statistical analysis of the molar homologue profiles enabled interpretation based on non-confounding variables. A multivariate, generalized additive model, based on transformations of the design variables, described 83% of the variation of the profiles characterized by log ratios of the homologue molar concentrations. This method identifies the operating parameters that are most significant in determining the PCDD/F homologue profiles. The model can be exercised to predict homologue profiles through input of these system-specific operating parameters. For example, both higher HCl and sulfur dioxide concentrations favor higher relative formation of the lower chlorinated PCDF homologues.     

Chemical composition and source apportionment of PM2.5 particles in the Sihwa area, Korea

To investigate the chemical characteristics of fine particles in the Sihwa area, Korea, atmospheric aerosol samples were collected using a dichotomous PM10 sampler and two URG PM2.5 cyclone samplers during five intensive sampling periods between February 1998 and February 1999. The Inductively Coupled Plasma (ICP)-Atomic Emission Spectrometry (AES)/ICP-Mass Spectrometry (MS), ion chromatograph (IC), and thermal manganese dioxide oxidation (TMO) methods were used to analyze the trace elements, ionic species, and carbonaceous species, respectively. Backward trajectory analysis, factor analysis, and a chemical mass balance (CMB) model were used to estimate quantitatively source contributions to PM2.5 particles collected in the Sihwa area. The results of PM2.5 source apportionment using the CMB7 receptor model showed that (NH4)2SO4 was, on average, the major contributor to PM2.5 particles, followed by nontraffic organic carbon (OC) emission, NH4NO3, agricultural waste burning, motor vehicle emission, road dust, waste incineration, marine aerosol, and others. Here, the nontraffic OC sources include primary anthropogenic OC emitted from the industrial complex zone, secondary OC, and organic species from distant sources. The source impact of waste incineration emission became significant when the dominant wind directions were from southwest and west sectors during the sampling periods. It was found that PM2.5 particles in the Sihwa area were influenced mainly by both anthropogenic local sources and long-range transport and transformation of air pollutants.     

EDTA-assisted phytoextraction of lead from lead-contaminated soils by Echinochloa crusgalli var. frumentacea

The herbaceous plant Echinochloa crusgalli var. frumentacea is highly resistant to a wide range of heavy metal concentrations. In this study we tested the phytoextraction capacity of E. crusgalli var. frumentacea. Specifically, we compared the effect of EDTA on lead (Pb) accumulation in two groups of plants: those sown in lead contaminated soil and those transplanted to the contaminated soil as seedlings. The result of the time development of the Pb concentrations in the plants in the seedling and seed groups shows that for the seedling group, the effect of adding EDTA to the Pb-contaminated soil was even more pronounced in the shoots than the roots, which showed Pb concentrations 32-fold higher. Compared to the seedling group, the Pb concentrations in the roots of plants in the seed group were approximately 5 times higher in controls and 2 to 10 times higher in the presence of EDTA. Collectively, these results might be considered that EDTA elevates the bioavailability of Pb in soil and this native species is particularly suited to use in Pb phytoextraction.     

Size removal on polyester fabrics by plasma source ion implantation device

Plasma treatment was evaluated as an alternative clean desizing technology in this work. As indicated by weight loss, O2 plasma treatment efficiently removed sizing agents such as polyvintyl alcohol (PVA), polyacrylic acid esters and their mixture (MIX) on polyethylene terephthalate (PET) fabrics. SEM pictures of the plasma treated samples directly proved the disappearance of the sizing agents. XPS analysis showed apparent changes in chemical composition and functional groups of the PET surface after O2 plasma treatment. Carbon content decreased due to the removal of sizing agents while oxygen content increased. O2 plasma treatment also increased hydrophilic functional groups of sizing agents, which is confirmed by C1s and O1s deconvolution analyses. After O2 plasma treatment, the PET fabric was subjected to conventional desizing process at different temperatures. Except for the PET fabric sized with PVA, plasma-treated fabrics showed more efficient desizing results when compared with untreated fabrics. Furthermore, the desizing effluent from the treated fabric gave lower TOC, COD and BOD values.     

Calculation of search volume on cruise-searching planktivorous fish in foraging model

Search volume of cruising planktivorous fish was calculated based on its detailed behavior Th examine the factors influencing search volume, a series of experiments were conducted by varying ambient conditions, such as structural complexity light intensity and turbidity Pseudorasbora parva were used in experiment as predator and Daphnia pulex was selected as prey The shape of scanning area of P parva showed elliptic and the search volume changed drastically depending on ambient conditions. Compared with the results of previous foraging model, the search volumes of the fish under previous study were larger (1.2 to 2.4 times) than those from our study These results on the changes in feeding rate can be useful in determining microhabitat requirement of P parva and othercyprinids with a similar foraging behavior The calculated search volume is compared with other foraging model andthe effect of zooplankton-planktivore interactions on aquatic ecosystem is discussed.     

Relationships between presenteeism and work-related musculoskeletal disorders among physical therapists in the Republic of Korea

This study investigated the relationship between presenteeism and work-related musculoskeletal disorders (WMSDs) among physical therapists (PTs) in the Republic of Korea. Questionnaires were given to 600 PTs in the Republic of Korea. General and occupational characteristics and the prevalence of presenteeism and absenteeism were self-reported on the questionnaire. Stepwise regression analyses were used to evaluate the effects of presenteeism and other variables on general and occupational characteristics. Of the 490 PTs who responded, 399 (81.4%) reported at least one WMSD. There was a low incidence rate of absenteeism, but work impairment scores indicate there was a high incidence of presenteeism. In the stepwise regression analyses, the incidence of WMSDs was highest in cases of presenteeism. The results of this study demonstrate that there is a high incidence rate of WMSDs in Republic of Korean PTs, that WMSDs are related to presenteeism and that PTs demonstrate high presenteeism and low absenteeism.     

Characterizations of biochar from hydrothermal carbonization of exhausted coffee residue

The aim of this study was to produce renewable energy from exhausted coffee residue, which is a form of biomass. As coffee preference continues to increase, the importation of coffee beans has been increasing sharply. However, the amount of coffee that is actually consumed is only about 0.2% of coffee beans, while the spent coffee beans are discarded in the form of exhausted coffee residue. Hydrothermal carbonization is a method of producing an improved fuel from renewable energy sources by changing the physical and chemical properties of biochars. Biochars were obtained from a variety of reaction temperatures during hydrothermal carbonization and analyzed using elemental analysis, ultimate analysis, and calorific value measurement. The atomic C/O and C/H ratios of all obtained biochars decreased and were found to be similar to those of lignite and sub-bituminous coal. The highest energy recovery efficiency of biochar indicates that the optimum reaction temperature for hydrothermal carbonization was between 210 and 240 °C, which produced biochars with calorific value of approximately 26–27 MJ/kg. The spectra of biochars obtained from Fourier transform infrared spectroscopy (FTIR) showed fewer C–O and aliphatic C–H functional groups, but more carbonyl C=O functional groups and aliphatic CH _x groups. The results of this study indicate that hydrothermal carbonization can be used as an effective means to generate highly energy-efficient renewable fuel resources from coffee residue. The thermogravimetric analysis provided the changing combustion characteristics due to increased fixed carbon content.     

Sensitivity of a molecular marker based positive matrix factorization model to the number of receptor observations

To investigate the impact of the number of observations on molecular marker-based positive matrix factorization (MM-PMF) source apportionment models, daily PM_2.5 samples were collected in East St. Louis, IL, from April 2002 through May 2003. The samples were analyzed for daily 24-h average concentrations of elemental and organic carbon, trace elements, and speciated particle-phase organic compounds. A total of 273 sets of observations were used in the model and consisted of all valid sets of observations from the year long data set minus one sixth of the measurements, which were collected every 6th day and were analyzed by different chemical analysis techniques. In addition to the base case of 273 samples, systematic subsets of the data set were analyzed by PMF. These subsets of data included 50% of the observations (135–138 days), 33% of the observations (90–92 days) and 20% of the observations (52–56 days). In addition, model runs were also examined that used 48-h, 72-h, 6-day, and weekly average concentrations as model inputs. All MM-PMF model runs were processed following the same procedures to explore the stability of the source attribution results. Consistent with previous MM-PMF results for East St. Louis, the main sources of organic aerosol were found to be mobile sources, secondary organic aerosols (SOAs), resuspended soil and biomass combustions, as well as an n-alkane dominated point source and other combustion sources. The MM-PMF model was reasonably stable when the number of observations in the input was reduced to ninety, or approximately 33% of observations present in the base case. In these cases, the key factors including resuspended soil, mobile and secondary factors, which accounted for more than 70% of the measured OC concentrations, were stable as defined by a relative standard deviation (RSD) of less than 30%. Similar results were obtained from the smaller data subsets, but resulted in larger uncertainties, with several of these factors yielding RSD of greater than 30%. The three factors with the largest OC contributions were more stable than the other minor factors, even when the number of observations was nominally 50 days. Secondary organic aerosol (SOA) was the most stable factor observed in the model runs. Since it is unclear if these results can be broadly applied to all MM-PMF models, additional studies of this nature are needed to assess the broader applicability of these conclusions. Until such studies are implemented, this paper provides a foundation to design future studies in sampling strategies for source apportionment using MM-PMF.     

Clay charge reversal effects on aqueous polymer sorption on lateritic soils

The effects of charge reversal about the measured point of zero charge (pH(0) approximately 5.2) of untreated and treated Sete Lagoas lateritic soil of Brazil on aqueous polymer sorption was investigated. The polymers are anionic sodium carboxymethyl cellulose (CMCA), nonionic polyethylene oxide (PEO), and cationic polyacrylamide (PAM). They were prepared at aqueous concentrations and pH ranges of 0.1-2.0 g l(-1) and 2-9, respectively. Soil treatment involved the removal of iron oxides by treatment with dithionate-bicarbonate-citrate. Batch sorption test results show that the presence of iron oxides in lateritic soil tends to suppress sorption of CMCA (especially at pH=pH(0)) and PEO (for the whole pH range) but has uncertain effects on cationic PAM sorption. CMCA sorption on the untreated soil improves on either side of pH(0), in direct proportionality to solution concentration, except at pH<4.0, where disassociation of the polymer molecules may decrease sorption energy. Increase in the sorption of non-cationic polymers (CMCA and PEO) at pH>pH(0) is attributable to dispersion of clay, cation bridging and polymer molecular reconfiguration. For cationic PAM, electrostatic bonding to negatively charged soil particle surfaces accounts for the sorption increase. For treated soil samples, polymer sorption pattern is similar to those expected for the montmorillonitic clayey soils of temperate zones. These results indicate that the pH(0) of lateritic soils, within the regime that exists in the field, should be considered in assessing the potential effectiveness of polymer dust suppressants for tropical lateritic soils.     

Characteristics in oxidative degradation by ozone for saturated hydrocarbons in soil contaminated with diesel fuel

Although alkanes are relatively less reactive to chemical oxidation compared to alkenes, the chemical oxidation of alkanes has not been adequately explored in the context of environmental remediation efforts. Laboratory-scale column experiments were therefore conducted with soil artificially contaminated by diesel fuel as a surrogate for alkanes of environmental relevance. Particular attention was paid to saturated hydrocarbons refractory to volatilization. Reaction conditions involve 1485mgkg(-1) of the initial concentration of diesel range organics (DRO) and a constant ozone concentration of 119+/-6mgl(-1) at the flow rate of 50mlmin(-1). The observed removal of DRO reached 94% over 14h of continuous ozone injection. Ozone oxidation demonstrated effective removal of non-volatile DRO in the range of C(12)-C(24). Each alkane compound displayed comparable degradation kinetics, suggesting virtually no selectivity of ozone reactions with alkanes in soil. A pseudo-first order kinetic model closely simulated the removal kinetics, yielding a reaction rate constant of 0.213 (+/-0.021)h(-1) and a half-life of 3.3 (+/-0.3)h under the experimental conditions used in this study. An estimate of ozone demand was 32mg of O(3) (mgDRO)(-1).